固定化改性蒙脱土对苯酚吸附性能的研究

利用十六烷基三甲基溴化铵对天然蒙脱土进行改性,并用聚乙烯醇对改性蒙脱土进行固定化处理,然后进行柱状吸附和振荡条件的吸附试验。研究结果表明,HDTMA改性蒙脱土固定化后能有效吸附苯酚,不同环境条件对苯酚的柱状吸附能力产生不同的影响。在pH4~8的范围内,固定化改性蒙脱土对苯酚的吸附效果无显著性差异,pH在10以上,其吸附能力明显下降;温度对吸附效果影响不大;进水苯酚浓度越高,改性蒙脱土对苯酚的吸附量越大,但出水苯酚浓度也高;苯酚的流速越小,吸附容量越高,吸附效果越好。     

镉试剂2B固相萃取光度法测定水中微量银

研究了镉试剂2B固相萃取测定银的方法。在pH为9.5的硼砂-氢氧化钠缓冲介质中,乳化剂-OP存在下,镉试剂2B与银反应生成2∶1稳定络合物,该络合物可用pH使用范围为1~12的W atersX terraTMRP18固相萃取小柱富集,小柱上富集的络合物用乙醇(内含0.01 mol/L、pH为9.5的四氢吡咯-醋酸缓冲溶液)洗脱后用光度法测定,在洗脱剂介质中最大吸收波长为555 nm,摩尔吸光系数为1.04×105L/(mol.cm)。银质量浓度在0.01~1.0μg/mL内符合比尔定律,方法用于环境水样中银含量的测定,结果令人满意。     

有机离子载入-复焙烧失法制备新型净水材料

探索了一种制备介孔复合净水材料的新方法——载入有机离子一复焙烧失法。通过实验得到的最佳工艺参数为：有机载入剂为CTMAB,有机载入剂(质量浓度5g/L)加入量4mL／g,有机离子交换反应时间2h,反应温度40℃,复焙烧失温度230℃,复焙烧失时间1．5h。在最佳工艺条件下制备的净水材料对色度为7400倍、COD为3040mg／L的染料废水的脱色率为98．9％,略优于杏壳活性炭的脱色率(98．2％);COD去除率为91．3％,与杏壳活性炭的COD去除率91．7％相差无几。净水材料的染料吸附量是添加剂升温烧蚀后产品的近85倍,是酸洗刻蚀后产品的近590倍,是原材料的900多倍,其对染料废水的净化能力整体优于杏壳活性炭。     

聚异丁烯丁二酰亚胺尾气吸收系统的改进

针对聚异丁烯丁二酰亚胺生产工艺中废气排放量大、尾气吸收得到的盐酸含油量高、难以销售等问题,在分析原因的基础上,对尾气吸收系统进行了技术改进。尾气吸收系统改进后,排放的HCl和Cl2的质量浓度分别由65,42mg／m^3降至为零;产品综合收率由89．5％增加至96．0％;产品成本降低了700元/t。     

真菌降解废气中邻-二甲苯试验研究

采用真菌降解废气中的邻-二甲苯,试验装置为真菌生物滤池.将滤池内填料分成3段,考察每一段的负荷能力、去除效率以及pH值、温度、湿度的变化特点等.邻-二甲苯的进气浓度为400～700mg·m-3,气量为0 25m3·h-1,停留时间为100s.试验结果表明,真菌能够有效地去除废气中的邻 二甲苯,总去除率达到90%以上.其中,从上到下各段的去除率分别为36 8%,28 6%和25 5%.生物滤池内产生CO2的浓度与邻 二甲苯的降解有密切关联,通过在线监测进出气中的CO2浓度变化,可以间接反映出生物滤池的运行状况和生物生长量.在本研究中,降解的邻二甲苯中的碳约74%转化成CO2.微生物鉴定结果表明,降解邻 二甲苯的微生物主要是青霉菌和诺卡氏菌.     

曝气生物滤池内的自养反硝化作用

采用多孔介质——火山岩为载体的上向流曝气生物滤池(BAF),研究了限制供氧条件下,无有机碳源时反应器的硝化反硝化特性.结果表明,在 10～30℃范围内,20℃为临界点,低于20℃时,硝化速率缓慢;高于 20℃后,硝化速率加快.温度从 20℃升高到 30℃,硝化速率增长仅为10%,这一特性与悬浮生长反应器内温度对硝化速率的影响完全不同.此外,稳定运行的 BAF 内存在大量氮流失现象,分析认为,限制供氧和无有机碳源时,生物膜内发生了以 Anammox反应为主的自养反硝化作用,大量的氮以 N₂的形式流失.     

Improvements of nano-SiO2 on sludge/fly ash mortar

Sewage sludge ash has been widely applied to cementitious materials. In this study, in order to determine effects of nano-SiO(2) additives on properties of sludge/fly ash mortar, different amounts of nano-SiO(2) were added to sludge/fly ash mortar specimens to investigate their physical properties and micro-structures. A water-binding ratio of 0.7 was assigned to the mix. Substitution amounts of 0%, 10%, 20%, and 30% of sludge/fly ash (1:1 ratio) were proposed. Moreover, 0%, 1%, 2%, and 3% of nano-SiO(2) was added to the mix. Tests, including SEM and compressive strength, were carried out on mortar specimens cured at 3, 7, and 28 days. Results showed that sludge/fly ash can make the crystals of cement hydration product finer. Moreover, crystals increased after nano-SiO(2) was added. Hence, nano-SiO(2) can improve the effects of sludge/fly ash on the hydration of mortar. Further, due to the low pozzolanic reaction active index of sludge ash, early compressive strengths of sludge/fly ash mortar were decreased. Yet, nano-SiO(2) could help produce hydration crystals, which implies that the addition of nano-SiO(2) to mortar can improve the influence of sludge/fly ash on the development of the early strength of the mortar.     

Recycling MSWI bottom and fly ash as raw materials for Portland cement

Municipal solid waste incineration (MSWI) ash is rich in heavy metals and salts. The disposal of MSWI ash without proper treatment may cause serious environmental problems. Recently, the local cement industry in Taiwan has played an important role in the management of solid wastes because it can utilize various kinds of wastes as either fuels or raw materials. The objective of this study is to assess the possibility of MSWI ash reuse as a raw material for cement production. The ash was first washed with water and acid to remove the chlorides, which could cause serious corrosion in the cement kiln. Various amounts of pre-washed ash were added to replace the clay component of the raw materials for cement production. The allowable limits of chloride in the fly ash and bottom ash were found to be 1.75% and 3.50% respectively. The results indicate that cement production can be a feasible alternative for MSWI ash management. It is also evident that the addition of either fly ash or bottom ash did not have any effect on the compressive strength of the clinker. Cement products conformed to the Chinese National Standard (CNS) of Type II Portland cement with one exception, the setting time of the clinker was much longer.     

Variations of metal distribution in sewage sludge composting

In the study, the variations of heavy metal distributions (of Cu, Mn, Pb, and Zn) during the sewage sludge composting process were investigated by sequential extraction procedures. The total content of Cu and Zn in the composted mixture increased after the composting process. Mn and Zn were mainly found in mobile fractions (exchangeable fraction (F1), carbonate fraction (F2), and Fe/Mn oxide fraction (F3)). Cu and Pb were strongly associated with the stable fractions (organic matter/sulfides fraction (F4) and residual fraction (F5)). These five metal fractions were used to calculate the metal mobility (bioavailability) in the sewage sludge and composted mixture. The mobility (bioavailability) of Mn, Pb, and Zn (but not Cu) increased during the composting process. The metal mobility in the composted mixture ranked in the following order: Mn>Zn>Pb>Cu.     

游憩践踏对芜湖赭山城市公园影响研究

城市生态型公园是户外游憩活动影响最集中的一个区域,特别是践踏的影响表现最为明显。对芜湖市赭山生态型城市公园的19条游憩路径进行了调查,路径总长度达3123m。分析了户外游憩活动践踏造成的影响,得出了不同的旅游路径对践踏所引起的路面变宽、植物根系暴露、多路径和路面损伤是不同的,土质路面游道受到践踏影响的程度最大,石板路面游道次之,水泥路面相对最小。城市生态型公园的道路系统建设应该适应游客的游憩需求,减少践踏对公园生态环境的影响,最大化地满足城市居民的需要。