Evaluation of interference to conventional and real-time PCR for detection and quantification of fungi in dust

Advances in polymerase chain reaction (PCR) have permitted accurate, rapid and quantitative identification of microorganisms in pure cultures regardless of viability or culturability. In this study, a simple sample processing method was investigated for rapid identification and quantification of fungal spores from dust samples using both conventional and real-time PCR. The proposed method was evaluated for susceptibility to interference from environmental dust samples. Stachybotrys chartarum and Aspergillus fumigatus were used as test organisms. The sensitivity of detection in pure culture was 0.1 spore DNA equivalents per PCR reaction corresponding to 20 spores ml(-1) in the sample. However, 1 spore DNA equivalent per PCR reaction corresponding to 200 spores ml(-1) in the sample was the lowest amount of spores tested without interference in dust samples spiked with spores of either fungal species. The extent of inhibition was calculated using conventional and real-time PCR reactions containing fungal spores, specific primers, specific probes (for real-time PCR) and various amounts of dust. The results indicate that the extent of inhibition by dust on PCR varies with the type and amount of dust, and number of spores. No interference in the analysis of spiked samples was detected from 0.2 mg ml(-1) of four real-life dust samples at p-value >0.05 using 2 x 10(4) spores for conventional PCR and 2 x 10(5) spores for real-time PCR. However, samples containing >0.2 mg ml(-1) real-life dust compromised the PCR assay. These results suggest the potential usefulness of a simple sample processing method in conjunction with PCR for monitoring the fungal content of aerosols collected from indoor environments.     

Spatial contaminant heterogeneity: quantification with scale of measurement at contrasting sites

Material within the terrestrial environment is rarely homogeneously distributed, either spatially or temporally. One consequence of heterogeneity is that uncertainty is usually generated in measurements that are taken with the aim of characterising the environment. For example, a measurement of analyte concentration within soil taken from one sampling location on contaminated land can vary substantially when compared against another sample taken at effectively the same nominal location. The measurement uncertainty arising from the heterogeneity can substantially limit the reliability of the interpretations made upon environmental investigations. The sampling uncertainty usually outweighs the analytical uncertainty from the laboratory, often by a factor of 20 or more. One approach to reducing the uncertainty is to design a more suitable sampling strategy. This might be achieved by predicting the degree of heterogeneity prior to the investigation, but this is often difficult to achieve accurately. Another approach, which was investigated here, is to actually characterise the heterogeneity prior to the main investigation using rapid and inexpensive technology, such as in situ measurement techniques. In situ portable X-ray fluorescence (PXRF) and X-ray microprobe (XMP) techniques were employed to test the feasibility of this approach. Two contrasting contaminated land sites were chosen to characterise the two-dimensional spatial heterogeneity of heavy metal contamination in topsoil at a range of scales (50 m to 0.001 m). The spatial heterogeneity of contaminants, expressed as relative standard deviations, was found to differ between the two sites by a factor of two, largely due to the mode of deposition of pollution. The study also indicated that the heterogeneity did not change systematically with the scale of measurement between sampling locations at either site.     

Land User Participation in Developing a Computerised Decision Support System for Combating Desertification

Combating desertification in natural rangelands has recently become a priority in large parts of southern Africa. Rangeland managers, farmers, scientists, conservationists and land users have been applying a variety of restoration technologies to address this problem. Bush encroachment, as part of the desertification process, involves the natural replacement of the herbaceous plant cover by undesirable problem woody species. The active and passive restoration technologies that are applied, are mainly based on indigenous knowledge and include the chemical, mechanical or manual reclamation of unproductive rangelands, as well as the combating of woody and alien species encroachment. Indigenous practices and knowledge play a major role in the effectiveness and success rate of these technologies. This project faces the challenge of bringing together both local and scientific knowledge in a single user-friendly, computerised Decision Support System (DSS) which is directly accessible by land users to support them in the process of decision making, concerning the combating of desertification. Case studies from central and northern Namibia were used to combine qualitative and quantitative data to develop this Decision Support System. The DSS currently consists of two databases and an expert system, which evaluates the results of land users’ management practices, and provides easily accessible information and advice for participants in the system, based on the incorporated data. The DSS is also linked to national and international web sites and databases to offer a wider range of information on technologies concerning agricultural and conservation practices.     

LIDAR Measurements of the Vertical Aerosol Profile and Optical Depth during the ACE-Asia 2001 IOP, at Gosan, Jeju Island, Korea

In order to investigate the characteristic of optical properties of Asian dust particles, the atmospheric aerosol vertical profile was measured with the multi-wavelength LIDAR system, at the Gosan super site (33 degrees 17'N, 126 degrees 10'E) in Jeju Island, Korea, during the ACE-Asia intensive observation period, 11 March-4 May 2001. An air mass backward trajectory analysis, using Hysplit-4, was carried out to track the aerosol plume, with high mass loading, from the Chinese desert regions during the period of Asian dust storm events. Vertical atmospheric aerosol profiles on three major Asian dust storm event days, 22 March and 13 and 26 April 2001, have been analyzed. The LIDAR-derived aerosol optical depth values were compared with those measured by a collocated sunphotometer.     

Numerical Analyses of Soft Bottom Macroinvertebrates to Diagnose the Pollution in Tropical Coastal Waters

Soft bottom benthic organisms especially polychaetes are known to adapt as r or k selected strategies to different gradients of pollution. This will result in changes of benthic community structure from that of normal structure. There are a number of techniques to assess the impact of pollution on benthic community structure. Hence, to test this hypotheses some of the univariate and multivariate techniques were applied to soft bottom macro-invertebrates data of coastal waters of Mangalore, central west coast of India, a hot-spot area. Univariate techniques such as Pearson Rosenberg Model (PRM), abundance biomass comparison curve (ABC), geometrical class distribution, dominance-diversity curve, benthic community structure indices and multivariate techniques such as cluster classification, multidimensional scaling (MDS) and principal component analysis (PCA) were used to discriminate and diagnose the disturbance among the sites. Effectiveness and applicability of some of the above techniques are highlighted and discussed with the present set of data for environmental impact assessment studies.     

Pool of Dust Particles over the Asian Continent: Balloon-borne Optical Particle Counter and Ground-based Lidar Measurements at Dunhuang, China

Measurements of aerosols were made in 2001 and 2002 at Dunhuang (40 degrees 00'N, 94 degrees 30'E), China to understand the nature of atmospheric particles over the desert areas in the Asian continent. Balloon-borne measurements with an optical particle counter suggested that particle size and concentration had noticeable peaks in super micron size range not only in the boundary mixing layer but also in the free troposphere. Super-micron particle concentration largely decreased in the mid tropopause (from 5 to 10 km; above sea level, a.s.l.). Lidar measurements made during August 2002 at Dunhuang suggested the possibility that mixing of dust particles occurred from near the ground to about 6 km even under calm weather conditions, and a large depolarization ratio of particulate matter was found in the aerosol layer. The top of the aerosol layer was found at heights of nearly 6 km (a.s.l.). It is strongly suggested that nonspherical dust particles (Kosa particles) frequently diffused in the free atmosphere over the Taklamakan desert through small-scale turbulences and are possible sources of dust particles of weak Kosa events that have been identified in the free troposphere not only in spring but also in summer over Japanese archipelago. Electron microscopic experiments of the particles collected in the free troposphere confirmed that coarse and nonspherical particles observed by the mineral particle were major components of coarse mode (diameter larger than 1 microm) below about 5 km over Dunhuang, China.     

Sediment quality in the Douro river estuary based on trace metal contents, macrobenthic community and elutriate sediment toxicity test (ESTT)

The aim of this study was to evaluate the sediment quality in the mesotidal Douro River estuarine environment, in order to identify areas where sediment contamination could cause ecosystem degradation. Samples were obtained in five locations and sediment characterised for grain size, total organic matter, total-recoverable metals (Al, Fe, Cu, Pb, Cr, Ni, Cd, Zn and Mn), as well as acid volatile sulfide (AVS) and simultaneously extracted metals (SEM). In situ effects were evaluated by examining the macrobenthic community structure. An elutriate sediment toxicity test (ESTT) was used to estimate the amount of metals and nutrients that could be exchanged with the water column through resuspension, and its positive or negative effects on the growth of the micro-alga Emiliania huxleyi in a 10 day test. Anthropogenic metal contamination was identified at the north bank of the Douro estuary, with deleterious effects on the macrobenthic community, namely decrease in number of species and diversity. This contamination could possibly also be toxic for water column organisms, in case of resuspension, as shown by the ESTT. Sediments from the salt marsh at the south bank showed an impoverished macrobenthic community and elutriate toxicity, which appeared to be due to anaerobic conditions. This study clearly shows the usefulness of the ESST approach to assess the biological effect of resuspension of estuarine sediments.     

Assessment of Metal Contamination in Doñana National Park (Spain) using Crayfish (Procamburus Clarkii)

Water quality assessment in the Aznalcollar area was attempted using multivariate methods based on heavy metal concentrations in red swamp crayfish (Procamburus clarkii). Trace levels of four heavy metals, copper (Cu), zinc (Zn), cadmium (Cd) and lead (Pb), were detected in crayfish from eleven different stations. Principal component analysis (PCA) highlighted a gradient of contamination between the sampling stations. Cluster analysis (CA) distinguished three groups of stations. Discriminant analysis also differentiated three groups. The group centroids of the first discriminant function were used to devise an index that varies according to the source of the crayfish. These standardized values are proposed for use as a water quality index. The ability of this index to successfully predict environmental quality was proved with random samples.     

Monochlorobenzene Marine Risk Assessment with Special Reference to the Osparcom Region: North Sea

This risk assessment on monochlorobenzene was carried out for the marine environment, following methodology given in the EU risk assessment Regulation (1488/94) and Guidance Document of the EU New and Existing Substances Regulation (TGD, 1996). Data from analytical monitoring programmes in large rivers and estuaries in the North Sea area were collected and evaluated for effects and environmental concentrations. Risk is indicated by the ratio of predicted environmental concentration (PEC) to predicted no-effect concentration (PNEC) for the marine aquatic environment. In total, 27 data for fish, 24 data for invertebrates and 13 data for algae were evaluated. Acute and chronic toxicity studies were taken into account and appropriate assessment factors used to define a final PNEC value of 32 micro/l. Recent monitoring data indicate that monochlorobenzene levels in surface waters are below determination limits of 0.1, 0.2, 0.5 microg/l used in monitoring programs. Assuming that half of the lowest determination (0.1 microg/l) is typical, a PEC of 0.05 microg/l was derived. A worst case of 0.5 microg/l is assumed. PEC/PNEC ratios give safety factors of 60 to over 500, taking no account of dilution in the sea. Monochlorobenzene is not a 'toxic, persistent and liable to bioaccumulate' substance sensu the Oslo and Paris Conventions for the Prevention of Marine Pollution (OSPAR-DYNAMEC) criteria. Environmental fate and effects data indicate that current use of monochlorobenzene poses no unacceptable risk to the aquatic environment.     

Total versus inhalable sampler comparison study for the determination of asphalt fume exposures within the road paving industry

Exposure to asphalt fumes has a threshold limit value (TLV of 0.5 mg m(-3) (benzene extractable inhalable particulate) as recommended by the American Conference of Governmental Industrial Hygienists (ACGIH). This reflects a recent change (2000) whereby two variables are different from the previous recommendation. First is a 10-fold reduction in quantity from 5 mg m(-3) to 0.5 mg m(-3). Secondly, the new TLV specifies the "inhalable" fraction as compared to what is presumed to be total particulate. To assess the impact of these changes, this study compares the differences between measurements of paving asphalt fume exposure in the field using an "inhalable" instrument versus the historically used 'total' sampler. Particle size is also examined to assist in the understanding of the aerodynamic collection differences as related to asphalt fumes and confounders. Results show that when exposures are limited to asphalt fumes, a 1:1 relationship exists between samplers, showing no statistically significant differences in benzene soluble matter (BSM). This means that for the asphalt fume ACGIH TLV, the 'total' 37-mm sampler is an equivalent method to the "inhalable" method, referred to as IOM (Institute of Occupational Medicine), and should be acceptable for use against the TLV. However, the study found that when confounders (dust or old asphalt millings) are present in the workplace, there can be significant differences between the two samplers' reported exposure. The ratio of IOM/Total was 1.37 for milling asphalt sites, 1.41 for asphalt paving over granular base, and 1.02 for asphalt over asphalt pavements.