对羟基苯甘氨酸生产废水的处理工艺研究

对羟基苯甘氨酸废水属于高浓度难处理有机废水,针对生产工艺的特点,采取了废水分类处理的新路线.试验结果表明,高浓度废水经过物化处理后,苯酚的回收率达到95%,每日回收硫酸铵约6t;低浓度废水采取水解酸化-接触氧化-沉淀-活性炭吸附工艺是可行的,COD、BOD5、NH3-N及挥发酚的总去除率分别为95.6%、94.6%、93.7%和99%.     

水葫芦厌氧发酵工程化应用研究

在实验室进行了接种率、破碎程度和温度等对水葫芦厌氧发酵产气率的影响研究.结果表明:水葫芦在中温35℃下,水葫芦和接种污泥的最佳接种率为1:1(总固体物质比),经简单切分后产气率最高,原料产气率为0.540 m3/d(以每千克固体含量计,下同);高温消化与中温消化相比,产气率无明显优势.在实验室研究基础上,对中国农村地区原有的沼气发酵工艺进行适当的改进,设计构建了5 m3 15 m3(酸化池 产气池)两级反应池,该反应池在夏季常温条件下运行良好,80 d的平均原料产气率达0.305 m3/d.     

葫芦岛市钢屯地区地下水钼污染状况调查

葫芦岛市是中国最重要的钼矿基地。而钼矿主要集中在葫芦岛市连山区钢屯镇。随着钼的大量开采和冶炼,导致大量生产废水外排和偷排,造成附近地区地下水污染,为了弄清该地区污染,为环境管理提供决策依据,我们对该地区的地下水中的钼进行了监测。     

蒽醌化合物的光解动力学及定量结构-性质关系

以高压汞灯为光源, 测定了15 种蒽醌化合物(ATQs)的光解速率常数(k), 讨论了取代基位置、数目及种类对ATQs 光解速率的影响.另外,选取9 种氨基蒽醌, 应用偏最小二乘(PLS)算法, 建立了关于k的定量结构-性质关系(QSPR)模型. 根据该模型, 决定k值大小的主要因素包括:分子生成热、H 原子所带最大正电荷、C 原子所带最大负电荷,以及分子最低未占据轨道与最高占据轨道能量差.     

Investigation of PM2.5 pollution during COVID-19 pandemic in Guangzhou, China

The COVID-19 pandemic has raised awareness about various environmental issues,including PM_2.5 pollution.Here,PM_2.5 pollution during the COVID-19 lockdown was traced and analyzed to clarify the sources and factors influencing PM_2.5 in Guangzhou,with an emphasis on heavy pollution.The lockdown led to large reductions in industrial and traffic emissions,which significantly reduced PM_2.5 concentrations in Guangzhou.Interestingly,the trend of PM_2.5     

Large-scale utilization of desulfurization ash and fly ash for unfired production of high-strength road-base stones

Journal of Material Cycles and Waste Management - This paper utilizes desulfurization ash (DA), fly ash (FA) and ordinary Portland cement (OPC) to prepare unfired high-strength road-base stones by...     

均相Fenton氧化-混凝法强化处理印染废水

采用均相Fenton氧化—混凝法对印染废水进行了强化处理。结果表明,该法特别适用于处理同时含有亲水性和疏水性染料的印染废水,处理过程充分发挥了均相Fenton氧化和混凝的协同作用,对废水中的水溶性有机物、胶粒和疏水性污染物均有较好的去除效果。在印染废水初始pH4.0左右,H2O2、FeSO4·7H2O和絮凝剂聚硅酸氯化铝(PASC)的加入量分别为3.6,1.8,8mL时,处理后废水的色度降到35,COD降到103mg/L,去除率分别高达95%和94.3%,脱色效果显著。     

混凝—催化氧化法处理丁苯橡胶生产废水

以聚合氯化铝（PAC）、阴离子聚丙烯酰胺（PAM）为混凝剂,以H2O2-O3为氧化剂,采用混凝-催化氧化法处理对丁苯橡胶生产废水。考察了混凝剂种类及其加入量、废水pH对混凝处理效果的影响,氧化剂及其加入量、反应时间和废水pH对COD去除率的影响。实验得出的最佳工艺条件：混凝实验,废水pH为7、PAC和PAM加入量为400mg／L和4mg／L;催化氧化实验,废水pH为7～8、H2O2加入量为200mg／L、H2O2与O3的质量比为0．5。处理后,废水COD从860mg／L降至145mg／L,COD去除率达83．1％,出水水质达到国家二级排放标准。     

Experimental research on emission and removal of dioxins in flue gas from a co-combustion of MSW and coal incinerator

This paper describes the experimental study of dioxins removal from flue gas from a co-combustion municipal solid waste and coal incinerator by means of a fluidized absorption tower and a fabric filter. A test rig has been set up. The flow rate of flue gas of the test rig is 150-2000 m3/h. The system was composed of a humidification and cooling system, an absorption tower, a demister, a slurry make-up tank, a desilter, a fabric filter and a measurement system. The total height of the absorption tower was 6.5m, and the diameter of the reactor pool was 1.2 m. When the absorbent was 1% limestone slurry, the recirculation ratio was 3, the jet rate was 5-15 m/s and the submerged depth of the bubbling pipe under the slurry was 0.14 m, the removal efficiency for dioxins was 99.35%. The concentration of dioxins in the treated flue gas was 0.1573 x 10(-13)kg/Nm3 and the concentration of oxygen was 11%. This concentration is comparable to the emission standards of other developed countries.     

Thermal conversion of rice husks and sawdust to liquid fuel

The paper focuses on studying the conversion of rice husks and sawdust into liquid fuel. Rice husks, sawdust and their mixture are pyrolyzed at temperatures between 420 and 540 degrees C, and the main product of liquid fuel is obtained. The experimental result shows that the yield of liquid fuel depends on various factors such as feedstock and temperature. The maximum yields for rice husks, sawdust and their mixture are 56%, 61% and 60% at 465, 490 and 475 degrees C, respectively. Analyses with GC-MS and other apparatus show that the liquid fuel is a complicated compound with low caloric value and can be directly used as a fuel oil for combustion in a boiler or a furnace without any upgrading. Alternatively, the fuel can be refined to be used by vehicles.