Effect of ventilation rate on air cleanliness and energy consumption in operation rooms at rest

The interrelationships between ventilation rate, indoor air quality, and energy consumption in operation rooms at rest are yet to be understood. We investigate the effect of ventilation rate on indoor air quality indices and energy consumption in ORs at rest. The study investigates the air temperature, relative humidity, concentrations of carbon dioxide, particulate matter (PM), and airborne bacteria at different ventilation rates in operation rooms at rest of a medical center. The energy consumption and cost analysis of the heating, ventilating, and air conditioning (HVAC) system in the operation rooms at rest were also evaluated for all ventilation rates. No air-conditioned operation rooms had very highest PM and airborne bacterial concentrations in the operation areas. The bacterial concentration in the operation areas with 6–30 air changes per hour (ACH) was below the suggested level set by the United Kingdom (UK) for an empty operation room. A 70% of reduction in annual energy cost by reducing the ventilation rate from 30 to 6 ACH was found in the operation rooms at rest. Maintenance of operation rooms at ventilation rate of 6 ACH could save considerable amounts of energy and achieve the goal of air cleanliness.     

Rapid detection of toxic metals in non-crushed oyster shells by portable X-ray fluorescence spectrometry

The aim of this study was the multi-elemental detection of toxic metals such as lead (Pb) in non-crushed oyster shells by using a portable X-ray fluorescence (XRF) spectrometer. A rapid, simultaneous multi-element analytical methodology for non-crushed oyster shells has been developed using a portable XRF which provides a quick, quantitative, non-destructive, and cost-effective mean for assessment of oyster shell contamination from Pb. Pb contamination in oyster shells was further confirmed by scanning electron microscopy with energy dispersive spectroscopy (SEM-EDS). The results indicated that Pb is distributed in-homogeneously in contaminated shells. Oyster shells have a lamellar structure that could contribute to the high accumulation of Pb on oyster shells.     

Aquatic biomonitoring of Giardia cysts and Cryptosporidium oocysts in peninsular Malaysia

An aquatic biomonitoring of Giardia cysts and Cryptosporidium oocysts in river water corresponding to five villages situated in three states in peninsular Malaysia was determined. There were 51.3 % (20/39) and 23.1 % (9/39) samples positive for Giardia and Cryptosporidium (oo)cysts, respectively. Overall mean concentration between villages for Giardia cysts ranged from 0.10 to 25.80 cysts/l whilst Cryptosporidium oocysts ranged from 0.10 to 0.90 oocysts/l. Detailed results of the river samples from five villages indicated that Kuala Pangsun 100 % (9/9), Kemensah 77.8 % (7/9), Pos Piah 33.3 % (3/9) and Paya Lebar 33.3 % (1/3) were contaminated with Giardia cysts whilst Cryptosporidium (oo)cysts were only detected in Kemensah (100 %; 9/9) and Kuala Pangsun (66.6 %; 6/9). However, the water samples from Bentong were all negative for these waterborne parasites. Samples were collected from lower point, midpoint and upper point. Midpoint refers to the section of the river where the studied communities are highly populated. Meanwhile, the position of the lower point is at least 2 km southward of the midpoint and upper point is at least 2 km northward of the midpoint. The highest mean concentration for (oo)cysts was found at the lower points [3.15?±?6.09 (oo)cysts/l], followed by midpoints [0.66?±?1.10 (oo)cysts/l] and upper points [0.66?±?0.92 (oo)cysts/l]. The mean concentration of Giardia cysts was highest at Kuala Pangsun (i.e. 5.97?±?7.0 cysts/l), followed by Kemensah (0.83?±?0.81 cysts/l), Pos Piah (0.20?±?0.35 cysts/l) and Paya Lebar (0.10?±?0.19 cysts/l). On the other hand, the mean concentration of Cryptosporidium oocysts was higher at Kemensah (0.31?±?0.19 cysts/l) compared to Kuala Pangsun (0.03?±?0.03cysts/l). All the physical and chemical parameters did not show significant correlation with both protozoa. In future, viability status and molecular characterisation of Giardia and Cryptosporidium should be applied to identify species and genotypes/subgenotypes for better understanding of the epidemiology of these waterborne parasites.     

Toward a robust analytical method for separating trace levels of nano-materials in natural waters: cloud point extraction of nano-copper(II) oxide

Cloud point extraction (CPE) factors, namely Triton X-114 (TX-114) concentration, pH, ionic strength, incubation time, and temperature, were optimized for the separation of nano-sized copper(II) oxide (nCuO) in aqueous matrices. The kinetics of phase transfer was studied using UV–visible spectroscopy. From the highest separation rate, the most favorable conditions were observed with 0.2 %?w/v of TX-114, pH?=?9.0, ionic strength of 10 mM NaCl, and incubation at 40 °C for 60 min, yielding an extraction efficiency of 89.2?±?3.9 % and a preconcentration factor of 86. The aggregate size distribution confirmed the formation of very large nCuO–micelle assemblies (11.9 μm) under these conditions. The surface charge of nCuO was also diminished effectively. An extraction efficiency of 91 % was achieved with a mixture of TX-100 and TX-114 containing 30 wt.% of TX-100. Natural organic and particulate matters, represented by humic acid (30 mg/L) and micron-sized silica particles (50 mg/L), respectively, did not significantly reduce the CPE efficiency (<10 %). The recovery of copper(II) ions (20 mg/L) in the presence of humic acid was low (3–10 %). The spiked natural water samples were analyzed either directly or after CPE by inductively coupled plasma mass spectrometry following acid digestion/microwave irradiation. The results indicated the influence of matrix effects and their reduction by CPE. A delay between spiking nCuO and CPE may also influence the recovery of nCuO due to aggregation and dissolution. A detection limit of 0.04 μg Cu/L was achieved for nCuO.     

Recharge and Flow in the Medicine Lake Volcano–Fall River Springs Groundwater Basin,California

Isotopic measurements of the 34 m³/s discharge from the Fall River Springs of northern California indicate recharge from 50 km upgradient in high elevation regions of Medicine Lake Volcano. Age determinations suggest less than 20-year travel time. Data demonstrate Klamath Basin further north cannot be a recharge source. Mass balance calculations support that annual precipitation on the volcano supplies observed spring discharge, requiring 50%–75% recharge rates. Radiocarbon and δ¹³C of dissolved inorganic carbon indicate 30%–40% is derived from magmatic CO₂. Measured excess ³He is also consistent with the presence of magmatic gas derived from the Quaternary Age Medicine Lake Volcano.     

Distribution features of biological hazardous pollutants in residential environments in Korea

This research has been conducted continuously since 2009 as part of a cohort of studies examining relationships between asthma and genetic factors, dietary habits, and environmental factors. Based on data from environmental research on house dust mites and endotoxins, which are widely known as pollutants in bedding that cause asthma in pregnant women and children, this work was conducted to obtain basic data that can be used in future cohort studies that analyze links between distribution of biological hazards and physical features of residential environments. The detection rates of house dust mite allergens, Der p1 and Der f1, were 52.7 and 86.5 %, respectively, indicating that Der f1 is a dominant species in domestic indoor environments. According to comparisons between concentrations of house dust mites and endotoxins in bedding of pregnant women and children, Der p1 and endotoxins showed significantly lower concentrations in bedding of pregnant women compared with those in bedding of children, whereas Der f1 showed no significant difference in concentration according to bedding.     

A Collaborative Effort to Model Plant Response to Acidic Rain

Radish plants were exposed three times per week to simulated acidic rain at pH values of 2.6 to 5.4 over the course of four weeks in trials performed at Argonne, Illinois; Ithaca and Upton, New York; Corvallis, Oregon; Oak Ridge, Tennessee; and Toronto, Canada. Uniform genotype, soil media and planting techniques, treatment procedures, biological measurements, and experimental design were employed. Growth of plants differed among trials as a result of variation in greenhouse environmental conditions according to location and facilities. Larger plants underwent greater absolute but lower relative reductions in biomass after exposure to the higher levels of acidity. A generalized Mitscherlich function was used to model the effects of acidity of simulated rain or dry mass of hypocotyls using data from three laboratories that performed duplicate trials. The remaining data, from three other laboratories that performed only one trial each, were used to test the model. When the laboratory by trial effect was removed (influence of different growth. conditions), lack of fit to the Mitscherlich function was insignificant. Thus, a single mathematical model satisfactorily characterized the relationship between acidity and mean plant response. The pH value associated with a 10 percent reduction in mass was 3.3 ± 0.3 for hypocotyls. No value was estimated for shoots because effects oh shoots were not significant. The results of this study demonstrate that a generalized exposure-response model can be developed in the presence of large variations in environmental conditions when plant culture and exposure to simulated rain are standardized among laboratories.     

A Model for Pulse Jet Fabric Filters

ABSTRACT

A new model for pulse jet fabric filtration is proposed. In contrast to the earlier model of Ravin and Humphries,¹ which was formulated on the steady state assumption, the present study is aimed at developing a predictive capability for both transient and steady state operations, taking into account the compression effect of filter cakes. The model's relative simplicity allows frequent updating of the model parameter values, thus improving the accuracy of predictions. As a result, the model is particularly useful in developing control algorithms and designing controllers of pulse jet fabric filtration systems.