The relative influence of nutrients and habitat on stream metabolism in agricultural streams

Stream metabolism was measured in 33 streams across a gradient of nutrient concentrations in four agricultural areas of the USA to determine the relative influence of nutrient concentrations and habitat on primary production (GPP) and respiration (CR-24). In conjunction with the stream metabolism estimates, water quality and algal biomass samples were collected, as was an assessment of habitat in the sampling reach. When data for all study areas were combined, there were no statistically significant relations between gross primary production or community respiration and any of the independent variables. However, significant regression models were developed for three study areas for GPP (r ² = 0.79–0.91) and CR-24 (r ² = 0.76–0.77). Various forms of nutrients (total phosphorus and area-weighted total nitrogen loading) were significant for predicting GPP in two study areas, with habitat variables important in seven significant models. Important physical variables included light availability, precipitation, basin area, and in-stream habitat cover. Both benthic and seston chlorophyll were not found to be important explanatory variables in any of the models; however, benthic ash-free dry weight was important in two models for GPP.     

Multiscale satellite and spatial information and analysis framework in support of a large-area forest monitoring and inventory update

Many countries undertake a national forest inventory to enable statistically valid monitoring in support of national and international reporting of forest conditions and change. Canada’s National Forest Inventory (NFI) program is designed to operate on a 10-year remeasurement cycle, with an interim report produced at the 5-year mid-point. The NFI is a sample-based inventory, with approximately 18,850 2 ×2-km photo plots across the country, distributed on a 20×20-km grid of sample points; these photo plots are the primary data source for the NFI. Capacity to provide annual monitoring information is required to keep policy and decision makers apprised of current forest conditions. In this study, we implemented a multistage monitoring framework and used a Moderate Resolution Imaging Spectroradiometer (MODIS) change product to successfully identify 78% of the changes in forest cover area that were captured with a Landsat change detection approach. Of the NFI photo plots that were identified by both the Landsat and MODIS approaches as having changes in forest cover, the proportion of change area within the plots was similar (R ²?=?0.78). Approximately 70% of the Landsat-derived change events occupied less than 40% of a single MODIS pixel, and more than 90% of the change events of this size were successfully detected with the MODIS product. Finally, MODIS estimates of the proportion of forest cover change at the NFI photo plot level were comparable to change estimates for the ecoregions as a whole (R ²?=?0.95). High-temporal, low-spatial resolution imagery such as MODIS, in combination with other remotely sensed data sources, can provide information on disturbance events within a national forest inventory remeasurement cycle, thereby satisfying the interim information needs of policy and decision makers as well as the requirements of national and international reporting commitments.     

A comparison of storm-based and annual-based indices of hydrologic variability: a case study in Fort Benning, Georgia

The magnitude, frequency, duration, timing, and rate of change of hydrologic conditions regulate ecological processes in aquatic ecosystems. Conditions are typically characterized using annual-based hydrologic indices derived from daily and/or monthly stream flow data. In this study, we present an alternative approach to identify hydrologic indices based on storm hydrographs. Hydrologic indices derived from long-term daily flow data were compared to those from storm events for two headwater watersheds in Fort Benning, Georgia. Five hydrologic indices derived from daily flow data and storm events shared common features. Storm-based magnitude of mean peak discharge and mean response factor, frequency of bankfull discharge, rate of change in mean slopes of rising, and falling limb of the hydrograph were consistent with the results from long-term daily flow data. The annual flow increases and decreases were well matched by stormflow rising and falling. Both indicators showed one watershed having three times the response rates as compared to the other. Results suggested that select storm-based indices may be used as surrogates to the indices derived from long-term data.     

Comparison of leaching tests to determine and quantify the release of inorganic contaminants in demolition waste

The changes in waste management policy caused by the massive generation of waste materials (e.g. construction and demolition waste material, municipal waste incineration products) has led to an increase in the reuse and recycling of waste materials. For environmental risk assessment, test procedures are necessary to examine waste materials before they can be reused. In this article, results of column and lysimeter leaching tests having been applied to inorganic compounds in a reference demolition waste material are presented. The results show a good agreement between the leaching behaviour determined with the lysimeter unit and the column units used in the laboratory. In view of less time and system requirements compared to lysimeter systems, laboratory column units can be considered as a practicable instrument to assess the time-dependent release of inorganic compounds under conditions similar to those encountered in a natural environment. The high concentrations of elements in the seepage water at the initial stage of elution are reflected by the laboratory column leaching tests. In particular, authorities or laboratories might benefit and have an easy-to-use, but nevertheless reliable, method to serve as a basis for decision-making.     

Road soil retention of Pb leached from MSWI bottom ash

Municipal solid waste incinerator (MSWI) bottom ash may be used as a road construction material; it potentially contains however a sizable quantity of heavy metals, which under the effect of rainfall infiltration through the road structure can be leached out from the material and infiltrate into the underlying soil. An eco-compatibility assessment of MSWI bottom ash reuse in road construction applications necessitates examining the solubility and retention of heavy metals in road soils. This study is dedicated to Pb transfer, sorption and desorption (NEN 7341 standard test) within various soils. These experiments yield results relative to the interaction between road soils and an MSWI bottom ash leachate representative of a "fresh" product, with a high leaching potential. For the soils investigated, the sorption of lead varies between 90% and 99%. For an extraction at pH 7, Pb release is very low (<2%) for all soils, while at pH 4 leaching varies between 4% and 47%. This work shows that Pb may be fixed by some types of road soil in mostly stable forms.     

A comparison of two techniques for studying sediment desorption kinetics of hydrophobic pollutants

A comparison of two techniques (gaseous purge and vial desorption) for studying the kinetics of desorption of hydrophobic pollutants from natural sediments was conducted using identical, pre-equilibrated pollutant-sediment suspensions. Desorption profiles for the two techniques [for Lindane, Aldrin, 2,2'-dichlorobiphenyl (2,2'-DCB), 4,4'-dichlorobiphenyl (4,4'-DCB), and 2,2',6,6'-tetrachlorobiphenyl (TCB)] were then compared, based on the distribution of pollutant mass between the labile (fast) and non-labile (slow) desorption phases and the release rate constants for each phase of release. The vial desorption technique shows many practical advantages over the gaseous purge technique, including its more realistic mixing conditions, the use of an independent sample for each data point (as opposed to a calculation of a cumulative mass purged at each time point), the fact that the vials constitute a closed system and are therefore less subject to ambient contamination, and the relatively low demands of time and money for the vial technique. No consistent trends in labile rate constants or in pollutant distribution between the labile and non-labile phase were observed between the two techniques. A comparison of kinetic parameters shows much faster non-labile rate constants for the gaseous purge technique, attributed to the violent, continuous agitation employed, which likely disrupted sediment aggregates and oxidized the natural organic matter associated with the sediment. Non-labile rate constants have implications for the long-term fate of compounds adsorbed to repetitively disturbed sediments. This study suggests that the traditionally less popular vial desorption technique may yield more realistic non-labile desorption rate constants.     

Modified Fenton reaction for trichlorophenol dechlorination by enzymatically generated H2O2 and gluconic acid chelate

Glucose oxidase is a well-known enzyme that catalyzes the oxidation of β-d-glucose to produce gluconic acid and hydrogen peroxide. Fenton reaction is a powerful oxidation technology used for the oxidation of groundwater pollutants. For the application of Fenton reaction in groundwater remediation, successful operation of Fenton reaction near neutral pH, and on-site generation of both H₂O₂ and chelate will be beneficial. The focus of this experimental study was to couple the glucose oxidation reaction with chelate-based Fenton reaction. The idea was to use the hydrogen peroxide and chelate gluconic acid generated during glucose oxidation for the dechlorination of 2,4,6-trichlorophenol (TCP) by Fenton reaction. The oxidation of glucose was achieved using the enzyme in free and immobilized forms. The rate of production of hydrogen peroxide was determined for each system, and was used to estimate the time required for complete consumption of glucose during the process, thus avoiding any traces of glucose in the Fenton reaction. In the case of free enzyme reaction, separation of the enzyme was achieved using an ultrafiltration membrane before initiating the Fenton reaction. The oxidation of TCP by Fenton reaction was performed at varying ratios of gluconic acid/Fe, and its effect on the decomposition of TCP and H₂O₂ was studied. TCP degradation was studied both in terms of parent compound degradation and free chloride generation.     

The influence of radical architecture on cadmium bioaccumulation in the black mangrove, Avicennia germinans L

Two groups of Avicennia germinans plants with differences in the radical architecture were exposed under hydroponic conditions to 95ppm of cadmium (Cd) for a period of 24h. Later, Cd concentration in roots, stems and leaves was determined by graphite furnace atomic absorption spectrophotometry. Our results showed that, for both groups of plants, the roots accumulated higher concentration of Cd as compared to stems and leaves, though, the plants of group B displayed enhanced radical architecture, better growth performance, and lower Cd concentration as compared to plants of group A. In contrast, low values of leaves/roots Cd transportation index, and bioaccumulation factor were found in plants of group B. These results suggest that the higher radical architecture developed in plants of group B might better adjust the uptake of Cd as a result of an integrated network of multiple response processes for instances, production of organic acids, antioxidative replay, cell-wall lignification and/or suberization. Further studies will be focused in understanding the role of the radical system in mangrove plants with the rhizosphere activation and root adsorption to soil Cd under natural conditions.     

Municipal waste compost as an alternative to cattle manure for supplying potassium to lowland rice

The importance of the use of potassium in agriculture is increasing in South Asia for making most productive use of the nutrient in terms of economic returns. Nutrient supply traditionally by cattle manure is constrained by its insufficient availability. Municipal waste compost may be an alternative source of nutrient supplements. Field experiments were conducted at the Experimental Farm of Calcutta University, West Bengal, India during the wet seasons of 1997, 1998 and 1999 on flooded lowland rice. Potassium fractions in municipal waste compost and cattle manure were determined by sequential extraction and also the potassium uptake by rice to compare the effectiveness of municipal waste compost with traditional manure. Potassium was significantly bound to the organic matter in municipal waste compost. Potassium uptake by rice grain and straw increased significantly with the combined application of organics and fertilizers and it was higher in grain than in straw. Water-soluble and non-exchangeable potassium contents of municipal waste compost and cattle manure were highly correlated with the uptake of potassium by straw and grain. Exchangeable and residual potassium were also significantly correlated with the uptake of potassium by straw and grain of rice. Much higher uptake of K in rice straw and rain resulted from applying the manures in conjunction with fertilizers than when applied singly.     

Oxidation of trichloroethene over metal oxide catalysts: kinetic studies and correlation with adsorption properties

The performance of bulk chromium oxide is compared with that of a Mn commercial catalyst for the deep oxidation of trichloroethene (1000-2500ppmv, 55h(-1) space velocity) in air, in dry and wet (20000ppm of H(2)O) conditions, in terms of activity, selectivity and stability. Chromium oxide was found to be more active (on a catalyst weight basis), however its activity decreases continuously with time on stream. The presence of water increases its stability, the Mn catalyst showing the opposite behaviour. The effect of water on the Cr catalyst can be explained according to the Deacon equilibrium, as the presence of water tends to decrease the Cl(2) concentration, assumed to be responsible of the catalyst deactivation. Regarding to the selectivity, the Mn catalyst yields C(2)Cl(4), CCl(4) and CHCl(3) as organochlorinated by-products, whereas chromium oxide produces only trace amounts of CCl(4). Simple power-law kinetics expressions (first-order for Mn and zero-order for Cr) provide fairly good fits for the evolution of the conversion with the temperature. Furthermore, the kinetic behaviour of chromium oxide can be represented with a Langmuir-Hinshelwood model taking into account the chlorine inhibitory effect.