Planar detonation structure for chain-branching kinetics with large activation energy and small initiation rate

The structure of the steady planar detonation wave is analyzed for three-step chain-branching kinetics consistent with hydrogen–air chemistry. The initiation and chain-branching steps are described by an Arrhenius rate. Both are thermally neutral, so that heat release is due to termination. The initiation rate is typically very low and very stiff. As a result, a small fraction of the reactant is consumed in the initiation region, which is very long but ends in an exponential chain-branching explosion. Next, the reactant is rapidly converted into chain-branching radicals, within a very thin zone, which ends when the concentration of the chain-branching radical reaches a peak, because of reactant depletion. Finally, the termination step consumes the chain-branching radicals and releases heat within a region thicker than the peak zone, but much thinner than the initiation region. The analysis is based upon two assumptions: that the chain-branching activation energy is high and that initiation is slow. The structure of the initiation and chain-branching zones is different for post-shock states within or outside the explosion region in the chain-branching diagram. In the former situation, chain-branching is already stronger than termination at the von Neumann point, and vice versa. In the no-explosion case, the initiation zone becomes very long, while the little chain-branching specie produced by initiation is directly converted into product by the termination step. Temperature increases slowly until reaching the explosion curve, when chain-branching becomes stronger than termination. The subsequent structure is similar to the explosion case.     

消防射水对导线火烧熔痕金相组织的影响

模拟火灾现场,制作不同线径铜导线的火烧熔珠,然后在不同温度下对熔珠进行冷却.利用金相显微镜对火烧熔珠的金相组织进行观察,发现铜导线火烧熔痕在不同温度下经消防射水冷却后,会出现类似一次短路和二次短路熔痕的金相组织.     

一种机(针)织物与非织造布网络互穿复合材料的研究

本文主要对机织物与非织造布复合材料的网络互穿结构进行了描述,并从材料选择、单体试制、复合工艺方面进行了实践,研制出了较高透气性能和剥离强度的复合材料。     

基于道化学法的大型合成氨装置安全评价

根据道化学公司火灾、爆炸危险指数的基本原理。用VH6．0开发的安全评价软件DowSE1．0，对某大型合成氨装置进行安全评价，得出其安全措施补偿前后的火灾、爆炸指数F＆EI以及危险暴露面积，危害系数，危险等级，实际可能财产损失程度等指数。结果表明。合成氨装置中实际最大可能财产损失值都没有超过200万美元，气化系统在合成氨装置中实际最大可能财产损失值占损失替换值比例高达53％，超过了10％的相对危险值界限。说明在引进国外技术时应注重其安全防范配套措施消化吸收，并结合实际采取切实可行的安全措施，降低合成氨装置的风险程度。     

紫外辐照-催化湿式过氧化氢氧化技术处理酸性大红GR染料废水

采用自制的负载型CuO-ZnO-CeO2/γ-Al2O3催化剂,常温常压下通过紫外辐照-催化湿式氧化技术处理酸性大红GR模拟染料废水。考察了催化剂加入量、H2O2加入量、废水pH、反应时间、初始酸性大红GR质量浓度等对废水脱色率的影响。实验得到最佳工艺条件为初始酸性大红GR质量浓度200mg/L,催化剂加入量10.0g/L,H2O2加入量2.0mL/L,废水pH4,反应时间2h。最佳工艺条件下废水脱色率达99.33%。     

絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水

用絮凝#x02014;微波辐射#x02014;Fenton试剂氧化法深度处理焦化废水,研究了微波辐射时间、微波功率、FeSO₄加入量、H₂O₂加入量和废水pH对废水处理效果的影响。实验结果表明：在聚合氯化铝加入量为350mg/L、聚丙烯酰胺加入量为12mg/L、废水pH=5、FeSO₄加入量为250mg/L、H₂O₂总加入量为1400mg/L、H₂O₂分3次投加、微波功率为400W、微波辐射时间为60min的条件下,处理后出水的浊度、色度和COD去除率分别为98.59%,97.62%,86.21%。处理后出水澄清透明,COD为50.34mg/L,满足GB50050#x02014;2007《工业循环冷却水处理设计规范》的要求。     

Reutilisation-extended material flows and circular economy in China

Circular economy (CE), with its basic principle of Reduce, Reuse, and Recycle, has been determined as the key strategy for the national development plan by the Chinese government. Given the economy-wide material flow analysis (EW-MFA) that leaves the inner flow of resource reutilisation unidentified, the reutilisation-extended EW-MFA is first introduced to evaluate and analyse the material input, solid waste generation, and reutilisation simultaneously. The total amount of comprehensive reutilisation (CR) is divided into three sub-flows, namely, reutilisation, recycle, and reuse. Thus, this model is used to investigate the resource CR in China from 2000 to 2010. China’s total amount of CR and its sub-flows, as well as the CR rate, remain to have a general upward trend. By the year 2010, about 60% of the overall solid waste generation had already been reutilised, and more than 20% of the total resource requirement was reutilised resource. Moreover, the growth patterns of the CR sub flows show different characteristics.Interpretations of resource reutilisation-related laws and regulations of CE and the corresponding policy suggestions are proposed based on the results.     

浅谈钢筋混凝土结构的可靠性鉴定

系统介绍了混凝土结构检测的主要内容及方法,总结了我国目前可靠性鉴定三种方法的主要理论、优缺点及使用范围,并指出耐久性对可靠性鉴定的重要意义,以及耐久性评估所采用的理论和存在的问题。     

工业企业安全生产管理的规范化研究

根据安全系统工程原理,探讨和提出了一种被当地试点所证明、可行的工业企业安全生产综合、简便的规范化管理方法。把国家有关安全生产法律法规有机地贯穿于基础规范管理工作过程之中;建立了动态性管理模式;为积极引导企业的安全管理工作,由事故管理向预防性管理,从行政管理向依法管理,由传统管理向技术性管理的方向转变,并为促进现代企业形成自主经营,相互制约,依法管理安全生产的运行机制提供了新思路