以焦炭为填料的生物滴滤塔处理含挥发性脂肪酸臭气

在以焦炭为填料的生物滴滤塔对挥发性脂肪酸臭气的处理研究中考察了空床停留时间、臭气浓度、体积负荷以及进气温度等参数对净化效果的影响。结果表明,空床停留时间较长时对臭气降解有利。在停留时间超过97 s时,能实现完全降解;此外,净化率随臭气浓度和体积负荷的不断增加呈先增加后降低的趋势。当臭气浓度为24.29 mg/m³即臭气的体积负荷为3 g/（m³·h）时,去除率约为96%;当臭气浓度增至1 345.74 mg/m³即体积负荷增至18 g/（m³·h）,去除率达100%;然而,当臭气浓度增至4 934.38 mg/m³即体积负荷增至66 g/（m³·h）时,去除率降至73.1%。另外,进气温度对净化率也有一定程度影响。当进气温度较低时,净化效率相对较高。     

盐析分相微萃取—高效液相色谱法测定水中含氯除草剂

采用盐析分相微萃取—高效液相色谱法同时测定水中3种含氯除草剂,建立并优化了反相离子对液相色谱条件,考察了萃取剂种类、盐析剂的种类和加入量及试样pH对萃取效果的影响。对氯苯氧乙酸、2,4-二氯苯氧乙酸和2,4-滴丁酯的质量浓度在0.1~100.0mg/L内与色谱峰面积呈良好的线性关系,相关系数不低于0.9992。平均回收率分别为96.29%、79.16%和70.21%,相对标准偏差小于5.3%。该方法操作简便、绿色环保,适合于水中含氯除草剂的测定。     

The life cycle assessment of an e-waste treatment enterprise in China

Electrical and electronic waste (e-waste) has become one of the fastest growing waste streams in the world, and many countries have established e-waste treatment enterprises to solve their e-waste problems. In this study, a life cycle assessment (LCA) was undertaken to quantitatively investigate the environmental impacts of an e-waste treatment enterprise in China. The LCA is constructed by SimaPro software version 7.2 and expressed with the Eco-indicator 99 life cycle impact assessment method. For a sensitivity analysis of the overall LCA results, the so-called CML method is used in order to estimate the influence of the choice of the assessment method on the result. According to the survey data, discarded TV sets accounted for the highest proportion of e-waste treated in the enterprise in 2010. The e-waste treatment had little environmental impact, and at the same time large environmental benefits can be achieved mainly due to the recycled resources and reuse of some components. Based on the research results, it can be seen that recycled metal, especially copper, would be of more importance for environmental benefits. Relevant results and data from this study could provide decision support to enterprise managers and government sectors.     

Chemical oxidation of sulfadiazine by the Fenton process: Kinetics,pathways, toxicity evaluation

This paper investigated sulfadiazine oxidation by the Fenton process under various reaction conditions. The reaction conditions tested in the experiments included the initial pH value of reaction solutions, and the dosages of ferrous ions and hydrogen peroxide. Under the reaction conditions with pH 3, 0.25 mM of ferrous ion and 2 mM of hydrogen peroxide, a removal efficiency of nearly 100% was achieved for sulfadiazine. A series of intermediate products including 4-OH-sulfadiazine/or 5-OH-sulfadiazine, 2-aminopyrimidine, sulfanilamide, formic acid, and oxalic acid were identified. Based on these products, the possible oxidation pathway of sulfadiazine by Fenton's reagent was proposed. The toxicity evaluation of reaction solutions showed increased antimicrobial effects following the Fenton oxidation process. The results from this study suggest that the Fenton oxidation process could remove sulfadiazine, but also increase solution toxicity due to the presence of more toxic products.     

Influence of Spartina alterniflora on the mobility of heavy metals in salt marsh sediments of the Yangtze River Estuary, China

Using bio-disturbed sulphide to trace the mobility and transformation of Cu, Pb, Ni and Zn in the sediments of the Spartina alterniflora-dominated salt marsh in the Yangtze River Estuary, measurements were made of the seasonal variations of acid-volatile sulphide (AVS) and of the simultaneously extracted metals (SEM) in the rhizosphere sediments. Microcosm incubation experiments recreating flooding conditions were conducted to evaluate the effect of AVS and other metal binding phases upon the dynamics of Cu, Pb, Ni and Zn in the salt marsh sediments. The results demonstrate that the ratio values of SEM/AVS have a significant seasonal variation in the rhizosphere sediments and that the anoxic conditions in the sediments were likely enhanced by S. alterniflora during the summer and autumn compared with the anoxic conditions resulting from the native species Phragmites australis and Scirpus mariqueter. The incubation experiments suggest that Fe(III) and Mn(IV/III) (hydr)oxides provide important binding sites for heavy metals under oxic conditions, and sulphide provides important binding sites for the Cu and Pb under anoxic conditions. Our observations indicate that the mobility of heavy metals in the salt marsh sediments is strongly influenced by biogeochemical redox processes and that the invasive S. alterniflora may increase the seasonal fluctuation in heavy metal bioavailability in the salt marsh ecosystem.     

Joint action and lethal levels of toluene, ethylbenzene, and xylene on midge (Chironomus plumosus) larvae

Aquatic ecosystems are vulnerable to the exposure with petrochemicals such as toluene, ethylbenzene, and xylene (o-, m-, and p-xylene) (TEX) and their adverse effects. Considering the widespread use, occurrence, and high toxicity of TEX, the aim of this work was to investigate the differential toxicity of TEX against midge (Chironomus plumosus) larvae and reveal the joint action of binary and ternary mixtures of TEX using the predictive concentration addition model. More importantly, this research can afford the basic toxicity data and scientific reference for the establishment of water quality criteria or benchmark, water pollution control, and aquatic risk assessment. Single and joint toxic effects of TEX on C. plumosus larvae were investigated using a semi-static bioassay, and the type of joint effects of TEX was ascertained. In the single toxicant experiments, the toxicity of the three pollutants could be sequenced as ethylbenzene > xylene > toluene. Specifically, LC_50s of T, E, and X after a 48-h exposure were 64.9, 37.8, and 42.0 mg/L, respectively. In the binary mixture experiments, the interaction between toluene and ethylbenzene, ethylbenzene and xylene, and toluene and xylene was largely in conformity with partial additive or additive effect as determined by isobologram representation and toxic unit models. In the ternary mixture experiments, the interaction was basically dependent on the use of additive index and mixture toxicity index methods. However, the antagonistic and synergistic actions were not significant. Thus, the tertiary mixture interaction could be regarded as additive action. The concentration addition model could successfully predict the joint action of TEX mixtures on C. plumosus larvae. Particularly, the additive action of TEX on C. plumosus larvae can be further recommended to evaluate water quality criteria of TEX.     

Pollution characteristics of ambient volatile organic compounds (VOCs) in the southeast coastal cities of China

With the rapid urbanization, the southeast coastal cities of China are facing increasing air pollution in the past decades. Large emissions of VOCs from vehicles and petrochemical factories have contributed greatly to the local air quality deterioration. Investigating the pollution characteristics of VOCs is of great significance to the environmental risk assessment and air quality improvement. Ambient VOC samples were collected simultaneously from nine coastal cities of southeast China using the Tedlar bags, and were subsequently preprocessed and analyzed using a cryogenic preconcentrator and a gas chromatography–mass spectrometry system, respectively. VOC compositions, spatial distributions, seasonal variations and ozone formation potentials (OPFs) were discussed. Results showed that methylene chloride, toluene, isopropyl alcohol and n-hexane were most abundant species, and oxygenated compounds, aromatics and halogenated hydrocarbons were most abundant chemical classes (62.5–95.6 % of TVOCs). Both industrial and vehicular exhausts might contribute greatly to the VOC emissions. The VOC levels in the southeast coastal cities of China were sufficiently high (e.g., 6.5 μg?m^?3 for benzene) to pose a health risk to local people. A more serious pollution state was found in the southern cities of the study region, while higher VOC levels were usually observed in winter. The B/T ratio (0.26?±?0.09) was lower than the typical ratio (ca. 0.6) for roadside samples, while the B/E (1.6–7.6) and T/E (7.2–26.8) ratios were higher than other cities around the world, which indicated a unique emission profile in the study region. Besides, analysis on ozone formation potentials (OFPs) indicated that toluene was the most important species in ozone production with the accountabilities for total OFPs of 22.6 to 59.6 %.     

Simultaneous adsorption and degradation of Zn2+ and Cu2+ from wastewaters using nanoscale zero-valent iron impregnated with clays

Clays such as kaolin, bentonite and zeolite were evaluated as support material for nanoscale zero-valent iron (nZVI) to simultaneously remove Cu²⁺ and Zn²⁺ from aqueous solution. Of the three supported nZVIs, bentonite-supported nZVI (B-nZVI) was most effective in the simultaneous removal of Cu²⁺ and Zn²⁺ from a aqueous solution containing a 100 mg/l of Cu²⁺ and Zn²⁺, where 92.9 % Cu²⁺ and 58.3 % Zn²⁺ were removed. Scanning electronic microscope (SEM) revealed that the aggregation of nZVI decreased as the proportion of bentonite increased due to the good dispersion of nZVI, while energy dispersive spectroscopy (EDS) demonstrated the deposition of copper and zinc on B-nZVI after B-nZVI reacted with Cu²⁺ and Zn²⁺. A kinetics study indicated that removing Cu²⁺ and Zn²⁺ with B-nZVI accorded with the pseudo first-order model. These suggest that simultaneous adsorption of Cu²⁺and Zn²⁺ on bentonite and the degradation of Cu²⁺and Zn²⁺ by nZVI on the bentonite. However, Cu²⁺ removal by B-nZVI was reduced rather than adsorption, while Zn²⁺ removal was main adsorption. Finally, Cu²⁺, Zn²⁺, Ni²⁺, Pb²⁺ and total Cr from various wastewaters were removed by B-nZVI, and reusability of B-nZVI with different treatment was tested, which demonstrates that B-nZVI is a potential material for the removal of heavy metals from wastewaters.     

Sedimentary record of polycyclic aromatic hydrocarbons and DDTs in Dianchi Lake, an urban lake in Southwest China

Unique time trends of polycyclic aromatic hydrocarbons (PAHs) and dichlorodiphenyltrichloroethanes (DDTs) were found in a dated sediment core from Dianchi Lake (DC), an urban lake in Southwest China. The temporal trend of PAHs in DC was not only different from those in China's coastline and remote lakes of China, but also different from those in more developed countries. Identification of sources suggested that PAHs in DC originated primarily from domestic combustion of coal and biomass. However, a change of source from low- and moderate-temperature combustion to high-temperature combustion processes was observed. Different from those in China's coastline and some developed countries, the temporal trend of DDTs in DC mirrored the historical usage of DDTs in China, with erosion of soils and surface runoff from its drainage area the most likely routes of DDT introduction to the lake. Rapid urbanization and industrialization in its catchment, effective interception of point-source pollution, and changes in sources of energy during the last few decades have significantly influenced the vertical profiles of PAHs in DC.     

Distribution and temporal trend of polybrominated diphenyl ethers in one Shanghai municipal landfill, China

The scarcity of information on polybrominated diphenyl ethers’ (PBDEs) flow in landfill restricts the life cycle analysis of PBDEs. In this study, eight PBDE congeners (BDEs 28, 47, 99, 100, 153, 154, 183, and 209) in topsoil, vegetation leaves, leachate, and municipal aged refuse collected from Shanghai Laogang Municipal Landfill (SLML) were investigated. The present study revealed elevated PBDE concentrations in topsoil and proved PBDE leakage from SLML and vegetation uptake. BDE-209 was the predominant congener, and this could be due to massive usage of deca-BDE mixture in Shanghai. ΣPBDE concentrations in leachates treated by reed wetland and A²/O process fell in the low end of the worldwide range. ΣPBDE concentrations in aged refuse samples rose from under 50 ng/g dw in 1989 to the range of 5,150–5,718 ng/g dw in 2002. PBDE concentrations increase in aged refuse samples throughout the 1990s into the 2000s paralleled municipal solid waste output from 1991 to 2002 in Shanghai. Exponential increase in BDE-209 concentration in aged refuse suggested the increasing market demands for deca-BDE mixture after 1990 in China. Notably, the inventory of PBDEs in SLML was 28.7 MT, and the doubling time of BDE-209 in aged refuse was calculated to be 1.6 year. SLML can be considered as a source of PBDE and one main recipient of PBDE as well, receiving inputs predominantly from the PBDE-containing waste. Priority should be given to formulate regulation on PBDEs and sorting work before landfill disposal.