我厂安全管理的几点经验

神州煤电焦化股份公司焦化厂调整思路，探索出一套“以人为本，重在落实”的基层车间管理办法，通过实践，证明该方法是行之有效的，使该厂形成了互相监督、互相制约的良好安全氛围。     

Simultaneous determination of estrogenic odorant alkylphenols,chlorophenols, and their derivatives in water using online headspace solid phase microextraction coupled with gas chromatography-mass spectrometry

A simple online headspace solid-phase microextraction (HS-SPME) coupled with the gas chromatography-mass spectrometry (GC-MS) method was developed for simultaneous determination of trace amounts of nine estrogenic odorant alkylphenols and chlorophenols and their derivatives in water samples. The extraction conditions of HS-SPME were optimized including fiber selection, extraction temperature, extraction time, and salt concentration. Results showed that divinylbenzene/Carboxen/polydimethylsiloxane (DVB/CAR/PDMS) fiber was the most appropriate one among the three selected commercial fibers, and the optimal extraction temperature, time, and salt concentration were 70 °C, 30 min, and 0.25 g/mL, respectively. The developed method was validated and showed good linearity (R ²?>?0.989), low limit of detection (LOD, 0.002–0.5 μg/L), and excellent recoveries (76–126 %) with low relative standard deviation (RSD, 0.7–12.9 %). The developed method was finally applied to two surface water samples and some of these target compounds were detected. All these detected compounds were below their odor thresholds, except for 2,4,6-TCAS and 2,4,6-TBAS wherein their concentrations were near their odor thresholds. However, in the two surface water samples, these detected compounds contributed to a certain amount of estrogenicity, which seemed to suggest that more attention should be paid to the issue of estrogenicity rather than to the odor problem.     

预处理-水解酸化-厌氧-好氧工艺对玉米淀粉废水有机污染物的降解

采用气相色谱/质谱(GC/MS)、三维荧光光谱(EEM)等检测手段分析预处理/水解酸化/厌氧/好氧组合工艺对玉米淀粉废水有机污染物的降解情况。结果表明,竖流沉淀预处理阶段对TOC平均去除率36.7%,废水中主要为芳烃、烷烯烃以及杂环类物质,EEM产生的5个荧光峰均为芳香蛋白类有机物;水解酸化阶段大部分杂环以及芳烃类有机物水解成有机酸和醇类物质,TOC平均去除率22.7%;厌氧阶段TOC平均去除率最高,达到97.8%,废水中以芳烃和烷烯烃为主,荧光峰减少至2个且强度减弱;好氧阶段TOC平均去除率为61.3%,有机物主要为难降解的长链烷烃物质,芳香蛋白类有机物荧光峰全部消失,新生成了与微生物代谢相关的腐殖酸类物质。     

化学氧化技术在地下水修复中的应用

近年来,化学氧化技术在地下水修复中得到了很大的关注。本研究对比了Fenton试剂、过硫酸钠、高锰酸钾及次氯酸钠4种常见的氧化剂对农药厂地下水中污染物的去除效果、地下水的pH和氧化还原电位(ORP)的变化的影响。结果表明,Fenton试剂和活化的过硫酸钠对此农药厂地下水各种污染物的去除率最高,两者对其中污染物都能达到80%以上的去除率,但在一定程度上会使地下水的pH降低;高锰酸钾和次氯酸钠对污染物的去除率都能达60%以上。其中高锰酸钾对地下水的pH影响不大;次氯酸钠对氯甲苯没有去除效果,对溴苯的去除率也较低,而且会使地下水的碱性过强。在地下水样中加入4种氧化剂后,会使水样的ORP立即升高。     

中国工业水污染及其成因的de Bruyn模型分析

选取废水、挥发酚、氰化物、COD、石油类和氨氮为中国工业水污染指标,利用分解分析方法将2004—2010年间的污染变化分解为规模效应、结构效应、污染治理效应、清洁技术效应和广义技术效应。结果显示,这5类效应的平均作用强度分别为2.08%、3.04%、15.61%、17.37%和32.88%,其中规模效应和广义技术效应是影响工业水污染的主导效应。各类效应对不同污染物的作用方向并不完全一致,规模效应促进污染物排放量的增加;结构效应以加重污染为主,污染治理效应和清洁技术效应以减轻污染为主;广义技术效应的平均作用强度和负向作用概率均最大,是现阶段中国工业水污染控制最为有效的手段。     

CuO/γ-Al2O3类Fenton试剂降解丁基黄药

CuO/γ-Al2O3类Fenton试剂是降解丁基黄药的优良试剂。该试剂与传统的Fenton试剂相比,提高了反应的pH值,可在较高pH(4~5)条件下反应,而传统的Fenton试剂的适宜pH值一般在3以下。采用单因素实验和正交实验相结合的方法研究了pH、催化剂投加量、过氧化氢投加量以及反应时间对丁基黄药降解效果的影响,并对催化剂的使用寿命进行了探讨。研究结果表明,反应的最佳条件为:pH为4~5,催化剂投加量为6 g/L,过氧化氢用量为30 mg/L,反应30min。在此反应条件下,丁基黄药的降解率达98%以上;影响丁基黄药降解效果的因素大小顺序为:pH>反应时间>H2O2用量>催化剂投加量,其中pH对CuO/γ-Al2O3类Fenton试剂降解丁基黄药的影响最为显著。     

大型蚤标志酶用于城市二级出水毒性的评价

大型蚤是一种国际公认的标准实验生物,广泛应用于污水、地表水等水质毒性检测。毒性水平较低的城市二级出水,对大型蚤往往无急性毒性效应,而具有慢性毒性效应,但慢性毒性检测周期过长,因此探索一种更灵敏的指标,实现快速检测,对于控制二级出水的水质风险具有重要意义。本研究考察了大型蚤在短期暴露于城市二级出水条件下,其体内乙酰胆碱酯酶、超氧化物歧化酶、过氧化氢酶、ATP酶、羧酸酯酶和碱性磷酸酯酶的酶活变化特征,从中筛选出对二级出水毒性响应灵敏的标志酶指标。实验结果表明,碱性磷酸酯酶、过氧化氢酶对二级出水毒性响应相对较灵敏,具有成为标志酶的潜力,研究结果为城市二级出水生物毒性评价方法优化提供新的思路。     

玉米秸秆活性炭的制备及其吸附动力学研究

以玉米秸秆为原材料,采用ZnCl2活化法制备玉米秸秆活性炭,吸附次甲基蓝染料废水,进行动力学分析。本实验用Langmuir和Freundlich模型对吸附等温线进行拟合,结果表明,玉米秸秆活性炭对次甲基蓝的吸附与Langmuir方程拟合良好,R2=0.9857。采用Lagergren准一级速率模型、Lagergren准二级速率模型、Bangham动力学方程和Elovich动力学方程分别对秸秆活性炭吸附次甲基蓝溶液进行吸附动力学拟合,通过分析得出吸附过程与Lagergren准二级速率模型拟合最好,R2=0.9979。秸秆活性炭对次甲基蓝的最大吸附量达到909.09 mg/g,具有很高的吸附能力。     

Comparison of the purification performance and microbial community functional diversity in flow-directional-switching and unidirectional-flow biotrickling filters

Because of the characteristics of low operating cost and convenient operation, the biotrickling filter is extensively researched and used to treat low concentration waste gas contaminated by volatile organic compounds (VOCs) and other odors. In this paper, two laboratory-scale biotrickling filters were constructed and toluene was selected as the sole carbon source, and the effects of different waste-gas flow configuration patterns on the purification capacity and the microbial community functional diversity of biotrickling filters were evaluated. The results indicated that the flow-directional-switching (FDS) biotrickling filter had better purification performance, and the maximum elimination capacity reached 480 g·m^?3·hr^?1, which was 17.1% higher than conventional unidirectional-flow (UF) biotrickling filter. Comparing the purification capacities of different sections in two biotrickling filters, the maximum toluene elimination capacity of section III in FDS system could reach 542 g·m^?3·hr^?1, which was 2.8 times as great as that in UF system, which resulted from the difference of elimination capacity in two systems. By analyzing the metabolic activity of two systems by community-level physiological profiling (CLPP) with Biolog (Biolog Inc., Hayward, CA) ECO-plate technique, metabolic activity in three sections of FDS system was higher than that of UF system. The metabolic activity was the highest in section III of FDS system and 46.8% higher than that of UF system. Shannon index and McIntosh index of section III in FDS system were 6.2% and 31.5% higher, respectively, than those of UF system.

Implications: The flow-directional-switching (FDS) biotrickling filter had a better purification performance than unidirectional-flow (UF) biotrickling filter at high inlet loadings, because FDS produced a more uniform distribution of biomass and microbial metabolic capacity along the length of the packed bed without diminishing activity and removal capacity in the inlet section.     

芳香酯类富勒烯衍生物的制备及光电性能研究

以PCBM为初始原料,经过水解、酯化反应,生成3类富勒烯衍生物,采用红外光谱(FT-IR)、核磁共振(1H NMR和13C NMR)、元素分析仪、质谱(MS)对产物结构进行了表征;并通过紫外可见光谱、循环伏安法等手段研究了目标物的光学与电化学性能,结果表明,目标物PCBTE、PCBBE、PCB(4-MOB)M的LUMO能级分别为-3.91 V、-3.88 V、-3.94 V。