Optimization of a multielement sequential extraction method employing an experimental design approach for metal partitioning in soils and sediments

The optimisation of a simple multielement extraction method employing an experimental design approach is described. The method uses centrifugation to pass one extractant solution at varying pH through a contaminated soil sample. The nature and concentration of the acid, rate of centrifugation and time, number of sequential leachates and the ratio of extractant volume: sample weight have been studied in order to obtain the optimum conditions for extraction. A fractional factorial experimental design was performed, and the results were used to identify significance which was then evaluated by carrying out a central composite experimental approach. Once optimum conditions had been obtained, sequential leaches were analysed by ICP-AES and chemometrics were employed to identify the composition of each component. Comparisons have been made with previous studies and tentative assignments, based on well defined separated fractions and percentage compositions for individual elements, used to identify the different physico-chemical components in the sample.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Integrating disciplinary research into an interdisciplinary framework: A case study in sustainability research

The complexity of today’s research problems increasingly demands that scientists move beyond the confines of their own discipline. In this special issue, the basics of a transdisciplinary framework are established and problems analyzed in a specific discipline are successfully integrated in this transdisciplinary network. The intent has been to go beyond only statements about the importance of enabling early stage researchers to work across disciplinary boundaries, and to show that important discoveries are being made at the intersection of disciplines. Embedding various research projects in a more global framework can meet the demands of an interdisciplinary or transdisciplinary approach (especially for early stage researchers) and contribute significantly to sustainable research.     

A study on the orbit of air temperature movement

In this paper, we describe an air temperature movement by mapping its time series to the polar coordinates: the value of the time series is plotted on the radial coordinate and the time on the angular coordinate. In this way, both the yearly and daily air temperature movements from five different locations of China are used to demonstrate that, in an intuitionistic view, air temperature movement is neither random nor chaotic, but has its own orbit. We then propose an elliptic orbit model for the air temperature movement. Our proposed model provides quite good results when it is applied to the evaluation of yearly air temperature movements in eight locations in various parts of the world, and the evaluation of daily air temperature movements in five locations in Hunan Province of China on December 17, 2005. Results show that our approach provides a concise and helpful model for air temperature analysis.     

上海汽车制造业涂装废气VOCs排放特征

于2015年10月对上海市嘉定区4家(A、B、C、D)汽车制造企业涂装废气ρ(VOCs)和组成特征进行了调查分析。结果表明,A、B、C、D厂涂装废气排放口ρ(VOCs)总为0. 743～6. 11 mg/m~3,主要检出物和最高检出值分别为:A厂二甲苯2. 06 mg/m~3、B厂二甲苯0. 578 mg/m~3、C厂甲苯2. 59 mg/m~3、D厂庚烷0. 274 mg/m~3;芳香烃类是A、B、C厂排放比例最高的VOCs组分,烷烃类是D厂排放比例最高的VOCs组分。指出,原、辅料种类影响排放物的主要成分,废气处理工艺类型影响排放物主要成分和浓度。     

环境样品中痕量锰的催化动力学测定法

对环境样品中痕量锰的催化动力学测定方法进行简要评述，引述文献１６篇。     

Assessing land use impacts on flood processes in complex terrain by using GIS and modeling approach

A distributed hydrologic modeling and GIS approach is applied for the assessment of land use impact in the Steinsel sub-basin, Alzette, Grand-Duchy of Luxembourg. The assessment focuses on the runoff contributions from different land use classes and the potential impact of land use changes on runoff generation. The results show that the direct runoff from urban areas is dominant for a flood event compared with runoff from other land use areas in this catchment, and tends to increase for small floods and for the dry season floods, whereas the interflow from forested, pasture and agricultural field areas contributes to the recession flow. Significant variations in flood volume, peak discharge, time to the peak, etc., are found from the model simulation based on the three hypothetical land use change scenarios.     

Application of a checklist for quality assistance in environmental modelling to an energy model

Large, complex energy models present considerable challenges to develop and test. Uncertainty assessments of such models provide only partial guidance on the quality of the results. We have developed a model quality assistance checklist to aid in this purpose. The model checklist provides diagnostic output in the form of a set of pitfalls for the model application. The checklist is applied here to an energy model for the problem of assessing energy use and greenhouse gas emissions. Use of the checklist suggests that results on this issue are contingent on a number of assumptions that are highly value-laden. When these assumptions are held fixed, the model is deemed capable of producing moderately robust results of relevance to climate policy over the longer term. Checklist responses also indicate that a number of details critical to policy choices or outcomes on this issue are not captured in the model, and model results should therefore be supplemented with alternative analyses.     

A study of the distribution of lead, cadmium and copper between water and kaolin, bentonite and a river sediment

Experiments were carried out to monitor the equilibrium distribution of lead, cadmium and copper between an aqueous phase modelling natural water and a solid phase modelling natural sediment, under varying conditions. The aqueous phase was analysed using ETAAS and differential pulse anodic stripping voltammetry (DPASV), whereas XRD and FTIR were used to study the solid phase. Sorption isotherms at constant pH were measured. Conditional distribution constants were calculated as functions of the pH, the time of equilibration and the amount of solid material. The results obtained stress the need for standardization of the approaches to the study of water-sediment interactions in order to be able to evaluate and compare the extensive data from field measurements and to predict these interactions.     

Assessment of Metal Contamination in Doñana National Park (Spain) using Crayfish (Procamburus Clarkii)

Water quality assessment in the Aznalcollar area was attempted using multivariate methods based on heavy metal concentrations in red swamp crayfish (Procamburus clarkii). Trace levels of four heavy metals, copper (Cu), zinc (Zn), cadmium (Cd) and lead (Pb), were detected in crayfish from eleven different stations. Principal component analysis (PCA) highlighted a gradient of contamination between the sampling stations. Cluster analysis (CA) distinguished three groups of stations. Discriminant analysis also differentiated three groups. The group centroids of the first discriminant function were used to devise an index that varies according to the source of the crayfish. These standardized values are proposed for use as a water quality index. The ability of this index to successfully predict environmental quality was proved with random samples.