淀粉-g-丙烯酸/凹凸棒土复合物制备及其吸附废水中NH_4~＋-N性能

采用反相乳液聚合法以凹凸棒土为原料,合成了新型NH4＋-N吸附剂淀粉-g-丙烯酸/凹凸棒土,并进行了氨氮吸附对比实验。结果表明：凹凸棒土氨氮单位吸附量为4.243 mg/g;淀粉-g-丙烯酸/凹凸棒土氨氮单位吸附量为5.301 mg/g,吸附能力比未改性的凹凸棒土提高了25%。淀粉-g-丙烯酸/凹凸棒土的氨氮吸附过程比凹凸棒土更符合Freundlich等温吸附模型。随着pH、温度的升高,凹凸棒土和淀粉-g-丙烯酸/凹凸棒土对NH4＋-N吸附量逐渐增大。     

不同营养水平下悬浮细菌数量对生物粘泥性质的影响

循环水系统中的微生物有悬浮态和附着态,悬浮细菌的存在对附着态生物粘泥的生长及特性有明显影响。通过向模拟循环冷却水系统中投加不同数量初始悬浮细菌,考察在营养水平不同的情况下,悬浮细菌数量对生物粘泥化学组成和脱氢酶活性的影响。结果表明,营养水平不同,初始悬浮细菌数量对生物粘泥的化学组成和脱氢酶活性的影响程度不同;在不同营养水平下,应分别控制初始悬浮细菌数量。贫营养下,初始悬浮细菌数量应控制在6×105个/mL左右;中营养下,初始悬浮细菌数量应控制在1×105～2.6×105个/mL之间;富营养下,初始悬浮细菌数量应控制在0.11×105～2.6×105个/mL之间最不利于生物粘泥的生长。     

生物预处理/常规与常规工艺处理西江原水的对比

采用生物预处理／常规与常规工艺处理西江微污染原水,对主要污染物的去除效果工艺进行了比较。结果表明,生物预处理／常规工艺对COD_Mn、氨氮的平均去除率达48.9%、62.3%,比常规工艺提高了18.9%、28.4%。2种工艺对浊度的去除率相当,皆为95％左右。生物预处理采用高速给水曝气生物滤池工艺,反冲洗采用气水联合方式,48 h过滤水头损失＜2 kPa,冲洗前后过滤水头损失变化量均值＜0.4 kPa。     

给水曝气生物滤池内置粉末活性炭复合净水效果的研究

在给水曝气生物滤池内置粉末活性炭,对比分析其对各工艺单元水质净化效果的影响,确定给水曝气生物滤池内置粉末活性炭的作用与最佳投加量,研究表明,给水曝气生物滤池将活性炭截留在滤池内,大幅度提高了粉末活性炭利用率,部分未饱和粉末活性炭通过反冲洗排入后续常规处理系统,作为生物载体仍能够进一步发挥生物强化作用。当粉末活性炭的投加量为8 mg/L时,砂滤出水氨氮、CODMn、浊度和色度均值分别为：0.02 mg/L,1.82 mg/L0,.46 NTU和6度,去除率分别达到99.6%、71.2%、99.1%和80.6%,出水指标达到《生活饮用水卫生标准（》GB5749-2006）和《饮用净水水质标准（》CJ94-2005）规定的标准。与常规工艺相比,投加量降低了20%～60%。     

Determination of the nitrous oxide emission potential of deammonification under anoxic conditions

Various studies have been performed to determine nitrous oxide (N2O) emissions from conventional biological nitrogen removal processes in wastewater treatment like nitrification and denitrification in the main stream. However, with respect to the overall emissions of a wastewater treatment plant, part-stream treatment for high-strength wastewater (e.g., sludge liquor) is also expected to hold a significant emission potential because of high concentrations and extreme boundary conditions. This paper presents results from a laboratory-scale study on nitrous oxide production by biomass from a deammonification process (nitritation + anammox) under anoxic conditions. It was discovered that N2O formation results from incomplete endogenous denitrification rather than anammox and is dependent on substrate availability. Based on direct measurements of the dissolved N2O concentrations in a sequencing batch reactor, the dynamic behavior of N2O production is characterized in more detail. The results show that, during anoxic conditions, the N2O emission potential of deammonification is significantly lower than from conventional denitrification.     

Quantification and analysis of airborne bacterial characteristics in a nursing care institution

Indoor air quality has become a critical issue because people spend most of their time in the indoor environment. The factors that influence indoor air quality are very important to environmental sanitation and air quality improvement. This study focuses on monitoring air quality, colony counts, and bacteria species of the indoor air of a nursing care institution. The regular colony counts in two different wards range from 55 to 600 cfu m(-3) Regression analysis results indicate that the bacterial colony counts have close correlation with relative humidity or carbon dioxide (CO2) but not with carbon monoxide (CO) or ozone (O3). Real-time PCR was used to quantify the bacterial pathogens of nosocomial infection, including Acinetobacter baumannii, Citrobacter freundii, Escherichia coli, Klebsiella pneumoniae, and methicillin-sensitive Staphylococcus aureus. The most abundant bacteria species in the air of the nursing care institution is E. coli.     

膜生物反应器(MBR)-反渗透(RO)工艺深度处理印染废水的实验研究

采用膜生物反应器（MBR）-反渗透（RO）工艺对印染废水进行了深度处理实验。原水经MBR系统处理后,COD去除率、ss去除率和色度去除率分别达89．9％、100％和87．5％。MBR系统处理出水进入反渗透（RO）系统进行处理,硬度去除率和除盐率分别达99．62％和99．64％,同时可进一步除去剩余的COD、色度。系统出水水质满足生产回用的要求。     

垂直流人工湿地水力学特性研究

通过示踪剂实验从停留时间分布（RTD）曲线及其统计特征值等方面对垂直流人工湿地的水力学特性进行了定性和定量的分析。研究表明水流在垂直流人工湿地中的流动是一种非理想的不均匀流动,存在一定的死区和水流的扩散;垂直流人工湿地较大的死区率与其表面布水的不均匀性有关,这也可能是其死区率大于表流人工湿地的最主要的原因。实验还表明,进水流量对垂直流人工湿地停留时间分布影响较大,随着进水流量的增加,平均停留时间减小,但标准平均停留时间增大,死区率减小;当进水流量为15L／h（水力负荷为620mm／d）时,水流在湿地中的散度最大,水流更接近全混流,不利于污染物的降解。     

甲基氯硅烷生产废液制备氯化氢和有机硅树脂

研究了将高、低沸点甲基氯硅烷生产废液分别通过醇解和水解反应制备HCl和有机硅树脂的工艺方法,考察了醇解时间、醇解温度和m(废液)∶m(甲醇)等因素对产物收率的影响.实验得到最佳反应条件为:m(废液)∶m(甲醇)=1∶0.5,醇解温度65℃,醇解时间2h.在该条件下由高、低沸点废液制得的有机硅树脂收率分别为43.2％和40.6％.将制得的有机硅树脂经500℃干燥处理后,可作为填料,制备有机硅树脂-聚氯乙烯复合材料.该材料的力学性能与SiO2 -聚氯乙烯复合材料接近.     

Biodegradable Water Soluble Copolymer for Antimicrobial Applications

Synthesis and characterization of novel biodegradable, water soluble and optically active DL-malic acid (DMA) and citric acid (CA) copolymers were studied for possible use as antibacterial agents. The copolymers were synthesized by direct bulk melt condensation in the absence of a catalyst above 150 °C. Characterization of obtained copolymers was carried out with the help of infrared absorption spectra, differential scanning calorimetry and thermo gravimetric analysis. The antibacterial activity of copolymers against bacteria was investigated. The results obtained shows the above copolymers possess a broad wound dressing activity against different types of bacteria and may be useful as antibacterial agents.