Evaluation of the aggressive potential of marine chloride and sulfate salts on mortars applied as renders in the Metropolitan Region of Salvador--Bahia, Brazil

In recent years, growing interest has focused on determining the performance of materials and evaluating the service life of structures exposed to various environmental forces. In this context, the determination of the aggressive potential of marine salts on mortars used as external renders is critical. The present study aimed to evaluate the spatial distribution of marine salts relative to distance from the sea. This was done by monitoring the deposition rate of chlorides and sulfates in wet candle sensors, located at nine stations scattered around the Metropolitan Region of Salvador, state of Bahia, Brazil. The study also determined the effectiveness of water-soluble salts at penetrating three different types of mortars of varying cement content via deposition and diffusion. The methodology employed enabled an evaluation of the efficiency of the monitoring sensors' measurement of the aggressiveness potential of local marine aerosol, and determination of the comparative performance of the three mortars tested, from the standpoint of resistance to salt penetration. The type and amount of salts captured both in solution and in powder samples extracted from the mortars were determined by ion chromatography. The analysis of the various types of mortars tested indicated which types are more resistant to the aggressive potential of the region's marine aerosol and the distance from the shore where local buildings are liable to be most strongly affected.     

Investigative monitoring within the European Water Framework Directive: a coastal blast furnace slag disposal, as an example

The European Water Framework Directive (WFD) establishes a framework for the protection of estuarine and coastal waters, with the most important objective being to achieve 'good ecological status' for all waters, by 2015. Hence, Member States are establishing programmes for the monitoring of water quality status, through the assessment of ecological and chemical elements. These monitoring programmes can be of three types: surveillance monitoring; operational monitoring (both undertaken on a routine basis); and investigative monitoring (carried out where the reason of any exceedance for ecological and chemical status is unknown). Until now, nothing has been developed in relation to investigative monitoring and no clear guidance exists for this type of monitoring, as it must be tackled on a 'case-by-case' basis. Consequently, the present study uses slag disposal from a blast furnace, into a coastal area, as a case-study in the implementation of investigative monitoring, according to the WFD.In order to investigate the potential threat of such slags, this contribution includes: a geophysical study, to determine the extent of the disposal area; sediment analysis; a chemical metal analysis; and an ecotoxicological study (including a Microtox test and an amphipod bioassay). The results show that metal concentrations are several times above the background concentration. However, only one of the stations showed toxicity after acute toxicological tests, with the benthic communities being in a good status. The approaches used here show that contaminants are not bioavailable and that no management actions are required with the slags.     

Benthic communities of streams related to different land uses in a hydrographic basin in southern Brazil

Different land uses affect the characteristics of a hydrographic basin, reflected in the river water quality, and consequently affecting the aquatic biota. The benthic community closely reflects the alterations caused by different human activities. In this study, the effects of different land uses were evaluated by analysis of the benthic community structure in streams with urban, agricultural and pasturage influences, as well as areas in better-conserved regions. The abiotic parameters showed distinct seasonal variability, which did not occur with the benthic organisms. A degradation gradient was observed among the study sites, in the headwaters-agriculture-pasture-urban direction. By the CCA its possible to observe that the density of organisms tended to increase along this gradient, whereas richness, diversity, evenness, and EPT families decreased. The most intense effects of land use on the benthic community composition, richness, and diversity were observed in urban areas (F (1,4) = 16.0, p = 0.01; F (1,4) = 8.97, p = 0.04; respectively). In conclusion a trend in the benthic community is observed in to predict alterations caused for the different land uses, mainly, when the source point pollution, as the case of urban area.     

Development of the concept of spatial–temporal mask for testing effects of discharge from well-drilling activities on biological communities

This paper describes the use of Bayesian spatial models to develop the concept of a spatial–temporal mask for the purpose of identifying regions in which before and after drilling effects are most clearly defined and from which the consequences of exposure of macrofauna and meiofauna to the release of drilling discharges can be evaluated over time. To determine the effects of drilling fluids and drill-cuttings on the marine benthic community, it is essential to know not only where discharged materials ended up within the possible impact area, but also the chemical concentrations to which biota were exposed during and after drilling. Barium and light hydrocarbons were used as chemical tracers for water-based and non-aqueous-based fluids in a shallow water site in the Campos Basin, off the coast of Brazil. Since the site showed evidence of exposure to waste material from earlier drilling, the analysis needed to take into account the background concentrations of these compounds. Using the Bayesian models, concentrations at unsampled sites were predicted and regions altered and previously contaminated were identified.     

Chromium(VI) resistance and removal by actinomycete strains isolated from sediments

Forty-one isolated actinomycetes were used to study qualitative and semi-quantitative screening of chromium(VI) resistance. Chromate-removing activity was estimated using the Cr(VI) specific colorimetric reagent 1,5-diphenylcarbazide. Twenty percent of the isolates from El Cadillal (EC) and 14% of isolates from a copper filter plant (CFP) were able to grow at 13 mM of Cr(VI). All isolates from sugar cane (SCP) could grow up to Cr(VI) concentration of 17 mM. EC, CFP and SCP strains were able to remove 24%, 30% and more than 40% of Cr(VI), respectively. The highest and lowest Cr(VI) specific removal values were 75.5 mg g(-1) cell by M3 (CFP), and 1.5 mg g(-1) cell by C35 (EC) strains. Eleven Cr(VI) resistant strains were characterized and identified as species of the genera Streptomyces (10) and Amycolatopsis (1). Differences on actinomycete community composition between contaminated and non-contaminated soil were found. This study showed the potential capacity of actinomycetes as tools for Cr(VI) bioremediation.     

Determination of selenium by GFAAS in slurries of fish feces to estimate the bioavailability of this micronutrient in feed used in pisciculture

This paper presents a simple, fast and sensitive method to determine selenium in samples of feces and of fish feed by graphite furnace atomic absorption spectrometry (GFAAS) through the direct introduction of slurries of the samples into the spectrometer's graphite tube. The limits of detection (LOD) and quantification (LOQ) calculated for 20 readings of the blank of the standard slurries (0.50% m/v of feces or feed devoid of selenium) were 0.31 microg l(-1) and 1.03 microg l(-1), respectively, for the standard feces slurries and 0.35 microg l(-1) and 1.16 microg l(-1), respectively, for the standard feed slurries. The proposed method was applied in studies of bioavailability of selenium in different fish feeds and the results proved consistent with that obtained from samples mineralized by acid digestion using the microwave oven.     

Monitoring PCDD/Fs, PCBs and metals in the ambient air of an industrial area of Catalonia, Spain

In 2005 and 2006, the levels of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs), polychlorinated biphenyls (PCBs) and metals (As, Be, Cd, Co, Cr, Cu, Mn, Ni, Pb, Sn, Tl and V) were measured in air samples collected in an industrial area of Sant Adrià del Besòs (Barcelona, Catalonia, Spain) where a municipal solid waste incinerator (MSWI) is placed, and in a background/control area. In general terms, concentrations of all environmental pollutants were higher at the industrial site. No significant seasonal/temporal variations were observed in any of the areas. No Pearson correlation was found between the PCDD/F concentrations and the environmental conditions of the two sampling periods considered. Principal component analyses (PCA) were performed to get information on the relationship among samples, pollutants, and emission sources. The results indicate that the MSWI of S. Adrià de Besòs is not a significant emission source of the above compounds for the area under its direct influence. Moreover, a notable difference in the PCDD/F congener profiles was found between ambient air and stack gas emissions, indicating that the current levels of PCDD/Fs are more related to other potential emissions sources rather than to those from the MSWI.     

Spatial distribution and concentration of sulfur in relation to vegetation cover and soil properties on a reclaimed sulfur mine site (Southern Poland)

This work aims to assess the spatial distribution and concentration of sulfur in the topsoil layer and to determine the relationships between sulfur concentration, soil pH, soil electrical conductivity, and plant cover at the reforested site of the former sulfur mine (Southern Poland). Soil samples were collected from 0 to 20 cm (topsoil) from a total of 86 sampling points in a regular square grid with sides of 150 m. Plant cover was assayed in circular plots with an area of 100 m², divided into a woody plant layer and herbaceous plant layer. Soil properties such as particle size distribution, pH in KCl and H₂O, soil electrical conductivity (EC), soil organic carbon (SOC), total nitrogen (N_T), and total sulfur (S_T) were determined. The degree of soil contamination with sulfur was assessed based on the guidelines of the Institute of Soil Science and Plant Cultivation (IUNG), Poland. The results indicate that remediation and application of lime were not fully effective in spatial variation, because 33 points with sulfur contamination above 500 mg kg^?1 were observed. These spots occurred irregularly in the topsoil horizons. This high sulfur concentration in the soil did not result in severe acidification (below 4.5) in all cases, most likely due to neutralization from the application of high doses of flotation lime. High vegetative cover occurred at some points with high soil sulfur concentrations, with two points having S concentration above 40,000 mg kg^?1 and tree cover about 60%. Numerous points with high soil EC above 1500 μS cm^?1 as well as limited vegetation and high soil sulfur concentrations, however, indicate that the reclamation to forest is still not completely successful.     

Large and mesoscale meteo-oceanographic patterns in local responses of biogeochemical concentrations

Investigations surrounding the variability of productivity in upwelling regions are necessary for a better understanding the physical-biological coupling in these regions by monitoring systems of environmental impacts according to the needs of the regional coastal management. Using a spatial and temporal database from National Centers for Environmental Prediction (NCEP) and National Center for Atmospheric (NCAR) Research reanalysis, Quick Scatterometer vector wind, and surface stations from the Southeast coast of Brazil, we investigate the meteorological influences due to the large-scale systems in the variability of the nutrient and larvae concentration, and chlorophyll a, describing statistically relationships between them in upwelling regions. In addition, we used multivariate analysis, such as PCA and clustering to verify spatial and temporal variances and describe more clear the structure and composition of the ecosystem. Correlation matrix analyses were applied for different water masses present in the study area to identify the relations between physical and biogeochemical parameters in a region, where frequently upwelling occur. Statistical approaches and seasonal variability show that the period of November to March is more sensitive to nutrients (1.20?mg/m(3) for chlorophyll a, 2.20?μmol/l for total nitrogen and 5.5?ml/l for DO) and larvae concentrations (120 org/m(3) for most of the larvae, except for cirripedia that presented values around 370 org/m(3)) relating to the influence of large and mesoescale meteorological patterns. The spatial and temporal variables analyzed with multivariate approach show meaningful seasonality variance of the physical and biological samples, characterizing the principal components responsible for this variance in spring and summer (upwelling period), emphasizing the monitoring of species as crustaceans and mussels that are present in the local economy. Then, the spring and summer season are characterized by high productivity due to the occurrence of upwelling in this period.