A comparison of X-ray fluorescence and wet chemical analysis of air filter samples from a scrap lead smelting operation

Personal and area air samples were taken at a scrap lead smelter operation in a bullet manufacturing facility. Samples were taken using the 37-mm styrene-acrylonitrile closed-face filter cassette (CFC, the current US standard device for lead sampling), the 37-mm GSP or "cone" sampler, the 25-mm Institute of Occupational Medicine (IOM) inhalable sampler, and the 25-mm Button sampler (developed at the University of Cincinnati). Polyvinylchloride filters were used for sampling. The filters were pre- and post-weighed, and analyzed for lead content using a field-portable X-ray fluorescence (XRF) analyzer. The filters were then extracted with dilute nitric acid in an ultrasonic extraction bath and the solutions were analyzed by inductively coupled plasma optical emission spectroscopy. The 25-mm filters were analyzed using a single XRF reading, while three readings on different parts of the filter were taken from the 37-mm filters. The single reading from the 25-mm filters was adjusted for the nominal area of the filter to obtain the mass loading, while the three readings from the 37-mm filters were inserted into two different algorithms for calculating the mass loadings, and the algorithms were compared. The IOM sampler was designed for material collected in the body of the sampler to be part of the collected sample as well as that on the filter. Therefore, the IOM sampler cassettes were rinsed separately to determine if wall-loss corrections were necessary. All four samplers gave very good correlations between the two analytical methods above the limit of detection of the XRF procedure. The limit of detection for the 25-mm filters (5 microg) was lower than for the 37-mm filters (10 microg). The percentage of XRF results that were within 25% of the corresponding ICP results was evaluated. In addition, the bias from linear regression was estimated. Linear regression for the Button sampler and the IOM sampler using single readings and the GSP using all tested techniques for total filter loading gave acceptable XRF readings at loadings equivalent to sampling at the OSHA 8-hour Action Level and Permissible Exposure Limit. However, the CFC only had acceptable results when the center reading corrected for filter area was used, which was surprising, and may be a result of a limited data set. In addition to linear regression, simple estimation of bias indicated reasonable agreements between XRF and ICP results for single XRF readings on the Button sampler filters, (82% of the individual results within criterion), and on the IOM sampler filters (77% or 61%--see text), and on the GSP sampler filters using the OSHA algorithm (78%). As a result of this pilot project, all three samplers were considered suitable for inclusion in further field research studies.     

Can health feasibly be considered as part of the planning process in Scotland?

The planning system is significant because of its capacity to determine the quality of the built environment as well as the health, well-being and quality of life of the individuals and communities therein. Development planning is especially important because of the long-term impact of the decisions. This paper was developed in response to increasing recognition amongst HIA practitioners in Scotland of the importance of planning for health. It focuses on the relationship between the planning system in Scotland, specifically the Development Planning element of it, and population health and considers how the health impact assessment (HIA) approach can facilitate and support joint working with planners. In particular, consideration is given to the potential impact of the introduction of Strategic Environmental Assessment (SEA) on the linkages between health, HIA and planning.     

SI-traceable certification of Cu, Cr, Cd and Pb in sediment and fly ash candidate reference materials

Many fields in environmental analytical chemistry deal with very low limits and thresholds as set by governmental legislations or transnational regulations. The need for the accuracy, comparability and traceability of analytical measurements in environmental analytical chemistry has significantly increased and total uncertainties are even asked for by accreditation bodies of environmental laboratories. This paper addresses achieving these goals to guarantee accuracy, quality control, quality assurance or validation of a method by means of certified reference materials. The assessment of analytical results in certified reference materials must be as accurate as possible and every single step has to be fully evaluated. This paper presents the SI-traceable certification of Cu, Cr, Cd and Pb contents in geological and environmentally relevant matrices (three sediments and one fly ash sample). Certification was achieved using isotope dilution (ID) ICPMS as a primary method of measurement. In order to reduce significantly the number of analytical steps and intermediate samples a multiple spiking approach was developed. The full methodology is documented and total uncertainty budgets are calculated for all certified values. A non-element specific sample digestion process was optimised. All wet chemical digestion methods examined resulted in a more or less pronounced amount of precipitate. It is demonstrated that these precipitates originate mainly from secondary formation of fluorides (essentially CaF2) and that their formation takes place after isotopic equilibration. The contribution to the total uncertainty of the final values resulting from the formation of such precipitates was in general < 0.1% for all investigated elements. Other sources of uncertainty scrutinised included the moisture content determination, procedural blank determination, cross-contamination from the different spike materials, correction for spectral interferences, instrumental background and deadtime effects, as well as the use of either certified values or IUPAC data in the IDMS equation. The average elemental content in the sediment samples was 30-130 micrograms g-1 for Pb, 0.5-3 micrograms g-1 for Cd and 50-70 micrograms g-1 for Cu. Cr was measured in one sample and was about 60 micrograms g-1. The concentrations in the fly ash sample were up to 2 orders of magnitude higher. Expanded uncertainty for the investigated elements was about 3% (coverae factor k = 2) except for Cr, (measured by high resolution ICPMS), for which the expanded uncertainty was about 7% (k = 2).     

Spatial contaminant heterogeneity: quantification with scale of measurement at contrasting sites

Material within the terrestrial environment is rarely homogeneously distributed, either spatially or temporally. One consequence of heterogeneity is that uncertainty is usually generated in measurements that are taken with the aim of characterising the environment. For example, a measurement of analyte concentration within soil taken from one sampling location on contaminated land can vary substantially when compared against another sample taken at effectively the same nominal location. The measurement uncertainty arising from the heterogeneity can substantially limit the reliability of the interpretations made upon environmental investigations. The sampling uncertainty usually outweighs the analytical uncertainty from the laboratory, often by a factor of 20 or more. One approach to reducing the uncertainty is to design a more suitable sampling strategy. This might be achieved by predicting the degree of heterogeneity prior to the investigation, but this is often difficult to achieve accurately. Another approach, which was investigated here, is to actually characterise the heterogeneity prior to the main investigation using rapid and inexpensive technology, such as in situ measurement techniques. In situ portable X-ray fluorescence (PXRF) and X-ray microprobe (XMP) techniques were employed to test the feasibility of this approach. Two contrasting contaminated land sites were chosen to characterise the two-dimensional spatial heterogeneity of heavy metal contamination in topsoil at a range of scales (50 m to 0.001 m). The spatial heterogeneity of contaminants, expressed as relative standard deviations, was found to differ between the two sites by a factor of two, largely due to the mode of deposition of pollution. The study also indicated that the heterogeneity did not change systematically with the scale of measurement between sampling locations at either site.     

Climate change in mountain regions: a marginal issue?

Summary Mountain regions comprise one-fifth of the world's land surface. They are home to a tenth and important in the lives of half of humankind. Yet mountains are often regarded as physically, politically and economically marginal; their importance has only recently been globally recognized. The potential impacts of climate change in mountain regions will vary considerably between different types of regions. These are briefly described, as an introduction to an evaluation of the potential impacts with regard to agriculture, forestry, water resources, tourism, energy, transport and health. It is concluded that climate change cannot be considered a marginal issue and that the ability of mountain and downstream people to adapt and respond in the long term will require attention to the maintenance and use of local knowledge and cooperative social networks, as well as considerable scientific research.Dr Martin Price obtained his Ph.D from the University of Colorado at Boulder, following a first degree at the University of Sheffield and an MSc from the University of Calgary, Canada. He is currently the Programme Leader for the Mountain Regions Programme at the Environmental Change Unit at the University of Oxford. This paper was presented at the Global Forum '94 Academic Conference and it represents a revision of an article by the author in Beniston (1994).     

坦桑尼亚霞水母章鱼(Octopus cyanea Gray)的个体渔业

2000年4月期间坦桑尼亚霞水母章鱼(1849)个体渔业的初步结果到2001年6月才被提供.对在坦噶、马菲亚岛和姆特瓦拉三地的2546个单个渔获物和15 473个样品进行了分析.     

Conservation of Bio synthetic pheromone pathways in honeybees Apis

Social insects use complex chemical communication systems to govern many aspects of their life. We studied chemical changes in Dufours gland secretions associated with ovary development in several genotypes of honeybees. We found that C28–C38 esters were associated only with cavity nesting honeybee queens, while the alcohol eicosenol was associated only with their non-laying workers. In contrast, both egg-laying anarchistic workers and all parasitic Cape workers from queenright colonies showed the typical queen pattern (i.e. esters present and eicosenol absent), while egg-laying wild-type and anarchistic workers in queenless colonies showed an intermediate pattern, producing both esters and eicosenol but at intermediate levels. Furthermore, neither esters nor eicosenol were found in aerial nesting honeybee species. Both esters and eicosenol are biosynthetically similar compounds since both are recognizable products of fatty acid biosynthesis. Therefore, we propose that in honeybees the biosynthesis of esters and eicosenol in the Dufours gland is caste-regulated and this pathway has been conserved over evolutionary time.     

Spectral heterogeneity of honeybee ommatidia

The honeybee compound eye is equipped with ultraviolet, blue, and green receptors, which form the physiological basis of a trichromatic color vision system. We studied the distribution of the spectral receptors by localizing the three mRNAs encoding the opsins of the ultraviolet-, blue- and green-absorbing visual pigments. The expression patterns of the three opsin mRNAs demonstrated that three distinct types ommatidia exist, refuting the common assumption that the ommatidia composing the bee compound eye contain identical sets of spectral receptors. We found that type I ommatidia contain one ultraviolet and one blue receptor, type II ommatidia contain two ultraviolet receptors, and type III ommatidia have two blue receptors. All the three ommatidial types contain six green receptors. The ommatidia appear to be distributed rather randomly over the retina. The ratio of type I, II, and III ommatidia was about 44:46:10. Type III ommatidia appeared to be slightly more frequent (18%) in the anterior part of the ventral region of the eye. Retinal heterogeneity and ommatidial randomness, first clearly demonstrated in butterflies, seems to be a common design principle of the eyes of insects.     

A survey of diagnostic amniocenteses in Oxford from 1974–1981

A survey was conducted of the results of mid-trimester diagnostic amniocenteses in the Oxford Region from 1974 to 1981. The survey used data relating to all 4357 singleton pregnancies in which an amniocentesis was performed during this period. Follow-up information on outcome was obtained in respect of 4284 (98 per cent) pregnancies. A cell culture to determine karyotype and an alpha-fetoprotein determination was carried out in all cases. From 1974 to 1981 amniocenteses became increasingly common, rising from 2 to 32 per 1000 births. The most common indication for amniocentesis was a high risk of a chromosome abnormality–56 per cent of all amniocenteses. Within this group advanced maternal age was responsible for 89 per cent of the cases. The next most common indication was a high risk of a neural tube defect (37 per cent of all amniocenteses)–in 1974 a raised maternal serum alpha-fetoprotein level accounted for only 4 per cent of these; by 1981 this had risen to 67 per cent. There were seven false-positive and 132 true-positive diagnoses of neural tube defect; since 1981, with the introduction of amniotic fluid acetylocholinesterase determination as a secondary diagnostic test for neural tube defects, there have been no further false-positive diagnoses. In 1981 76 per cent of women aged 35 years or more did not have an amniocentesis. It is not known to what extent this was due to not offering women in this age group amniocentesis or to women not accepting such an offer.