钙基膨润土辅助对堆肥及土壤Cu、Zn形态转化和白菜吸收的影响

通过好氧堆肥和盆栽试验,探究不同比例（0%、2.5%、5%、7.5%和10%）钙基膨润土（CB）辅助猪粪堆肥过程及盆栽土壤中Cu、Zn形态的变化,并分析CB对白菜生物量及吸收Cu、Zn的影响.结果表明,在所有处理的堆肥过程中,可交换态Cu、Zn的分布比例逐渐下降,而可氧化态和残渣态逐渐升高,与0% CB相比,2.5%~10% CB可使堆肥结束时生物可利用态（可交换态和可还原态）Cu、Zn的分布比例分别降低19.84%~48.90%和4.94%~16.39%,并以10% CB的效果最为显著.进而开展的盆栽试验显示,施用堆肥后,土壤有机质和EC显著升高,而pH有所下降;CB辅助堆肥能够促使土壤EC的降低及pH的升高,稳定土壤有机质.与纯土处理相比,施用堆肥可显著提升白菜的生物量,且10% CB处理中的生物量最大（6.51 g·盆^-1±0.34 g·盆^-1）.施用CB辅助堆肥后,种后土壤中生物可利用态Cu含量增加;但各处理中可交换态Zn含量分别降低38.91%、43.69%、46.02%、45.12%和54.65%.白菜在施用堆肥后Cu、Zn的吸收量显著降低,并且随着CB辅助比例的增加Zn的吸收量随之减少,而Cu的吸收量呈增加趋势.本研究表明,钙基膨润土能够降低堆肥过程中Cu、Zn活性,在堆肥施入土壤后仍对Zn有持续的固定作用,同时CB辅助堆肥可以提高白菜的生物量,减少重金属Zn在白菜中的累积,并以10% CB的效果最为显著.     

Pretreatment of cyanided tailings by catalytic ozonation with Mn/O

The increasing amount of cyanided tailings produced as a by-product has gained significant attention in recent years because of the rapid development of the gold industry and extensive exploitation of gold mineral resources. The effective use of these secondary resources is becoming an important and urgent problem for all environmental protection staff. Manganese-catalyzed ozonation for the pre-oxidation of cyanided tailings was studied and the effects of Mn^2 + dosage, initial sulfuric acid concentration, ozone volume flow, temperature and agitation speed on pretreatment were examined. The optimum reaction conditions were observed to be: ore pulp density 2.5%, agitation speed 700 r/min, temperature 60°C, Mn^2 + dosage 40 g/L, ozone volume flow 80 L/hr, initial sulfuric acid concentration 1 mol/L, and reaction time 6 hr. Under these conditions, the leaching rate of Fe and weight loss could reach 94.85% and 48.89% respectively. The leaching process of cyanided tailings by Mn^2 +/O³ was analyzed, and it was found that the leaching of pyrite depends on synergetic oxidation by high-valent manganese and O³, in which the former played an important part.     

Pretreatment of cyanided tailings by catalytic ozonation with Mn2+/O3

The increasing amount of cyanided tailings produced as a by-product has gained significant attention in recent years because of the rapid development of the gold industry and extensive exploitation of gold mineral resources. The effective use of these secondary resources is becoming an important and urgent problem for all environmental protection staff. Manganese-catalyzed ozonation for the pre-oxidation of cyanided tailings was studied and the effects of Mn2+dosage, initial sulfuric acid concentration, ozone volume flow, temperature and agitation speed on pretreatment were examined. The optimum reaction conditions were observed to be: ore pulp density 2.5%, agitation speed 700 r/min,temperature 60°C, Mn2+dosage 40 g/L, ozone volume flow 80 L/hr, initial sulfuric acid concentration 1 mol/L, and reaction time 6 hr. Under these conditions, the leaching rate of Fe and weight loss could reach 94.85% and 48.89% respectively. The leaching process of cyanided tailings by Mn2+/O3 was analyzed, and it was found that the leaching of pyrite depends on synergetic oxidation by high-valent manganese and O3, in which the former played an important part.     

CO2 adsorption using TiO2 composite polymeric membranes: A kinetic study

CO₂ is the main greenhouse gas which causes global climatic changes on larger scale. Many techniques have been utilised to capture CO₂. Membrane gas separation is a fast growing CO₂ capture technique, particularly gas separation by composite membranes. The separation of CO₂ by a membrane is not just a process to physically sieve out of CO₂ through the controlled membrane pore size. It mainly depends upon diffusion and solubility of gases, particularly for composite dense membranes. The blended components in composite membranes have a high capability to adsorb CO₂. The adsorption kinetics of the gases may directly affect diffusion and solubility. In this study, we have investigated the adsorption behaviour of CO₂ in pure and composite membranes to explore the complete understanding of diffusion and solubility of CO₂ through membranes. Pure cellulose acetate (CA) and cellulose acetate-titania nanoparticle (CA-TiO₂) composite membranes were fabricated and characterised using SEM and FTIR analysis. The results indicated that the blended CA-TiO₂ membrane adsorbed more quantity of CO₂ gas as compared to pure CA membrane. The high CO₂ adsorption capacity may enhance the diffusion and solubility of CO₂ in the CA-TiO₂ composite membrane, which results in a better CO₂ separation. The experimental data was modelled by Pseudo first-order, pseudo second order and intra particle diffusion models. According to correlation factor R², the Pseudo second order model was fitted well with experimental data. The intra particle diffusion model revealed that adsorption in dense membranes was not solely consisting of intra particle diffusion.     

Succinate-bonded pullulan: An efficient and reusable super-sorbent for cadmium-uptake from spiked high-hardness groundwater

Chemically modified pullulan was evaluated for its sorption efficiency and selectivity to remove cadmium(Cd) from spiked high-hardness groundwater(GW). Pullulan esterified with succinic anhydride using dimethylaminopyridine showed a fairly high degree of substitution value as confirmed by1 H NMR spectroscopy. Pullulan succinate(Pull-Suc) was converted into the sodium salt(Pull-Suc-Na). The effect of contact time(5–200 min) and p H(2–8) on Cd-uptake by the sorbent(Pull-Suc-Na) was investigated. The sorbent showed more than 90% Cd-removal in first 15 min from distilled water(DW) and GW solution,respectively. Comparison of Pull-Suc-Na with other polysaccharidal sorbents suggested its high efficiency(DW 476.2 mg/g and GW 454.5 mg/g) and selectivity for the removal of Cd by an ion exchange mechanism, which is further supported by the negative Gibbs free energy values calculated from Langmuir isotherms. A Langmuir isotherm kinetic model provided the best fit for the sorption of Cd using Pull-Suc-Na. The sorbent showed a negligible decrease in Cd-uptake over three regeneration cycles. The thermal stability testing of the sorbents indicated that Pull-Suc-Na(sorbent) is more stable than Pull-Suc.     

Assessment of cobalt in wheat grains as affected by diverse fertilizers: implications for public health

Environmental Science and Pollution Research - Present study was conducted to check the heavy metal content in wheat treated with municipal solid waste, Although municipal solid waste was enriched...     

Heavy metal tolerant endophytic fungi Aspergillus welwitschiae improves growth,ceasing metal uptake and strengthening antioxidant system in Glycine max L.

Environmental Science and Pollution Research - In modern agricultural practice, heavy metal (HM) contamination is one of the main abiotic stress threatening sustainable agriculture, crop...     

Development of zerovalent iron and titania (Fe0/TiO2) composite for oxidative degradation of dichlorophene in aqueous solution: synergistic role of peroxymonosulfate (HSO5−)

Environmental Science and Pollution Research - Binary composite of zerovalent iron and titanium dioxide (Fe0/TiO2) was synthesized for the catalytic removal of dichlorophene (DCP) in the presence...     

Screening of various Brassica species for phytoremediation of heavy metals-contaminated soil of Lakki Marwat,Pakistan

Environmental Science and Pollution Research - Natural resources, especially agrarian soils, have been much contaminated with various pollutants including heavy metals since industrial revolution,...     

The dynamic nexus between air transport,technological innovation,FDI, and economic growth: evidence from BRICS-MT countries

Environmental Science and Pollution Research - This study examines the endogenous growth theory for technological innovation and economic growth with the role of foreign direct investment (FDI) and...