Impact of Land Use on Soluble Organic Nitrogen in Soil

Although it has been hypothesized that soluble organic nitrogen (SON) plays a central role in regulating productivity in some terrestrial ecosystems, the factors controlling the size of the SON pool in soil remain poorly understood. Therefore our principal aim in this work was to assess the impact of seven different land use systems (rough and managed grassland, deciduous and coniferous woodland, heathland, wetland and tilled land) on the size of the SON and inorganic N (NO ₃ ^– , NH ₄ ⁺ ) pools in the surface soil layer (0–15 cm). After extraction with deionised water, we found that in most cases the size of the water extractable organic N (WEON) pool was similar in size to the inorganic N pool. In contrast, the KCl extractable organic N (KClEON) pool constituted the dominant form of soluble N in soils under all land uses, perhaps indicating that significant amounts were held on the soil exchange phase. In contrast to inorganic N, which varied significantly with land use, the size of the KClEON and WEON pool was similar for all land uses with the exception of KClEON in tilled land, where significantly lower amounts were observed. We conclude that SON constitutes an important soil N pool in a broad range of land uses, and that its role in microbial N assimilation, plant nutrition and ecosystem responses to atmospheric N deposition warrants further attention. SAFRD, University of Newcastle, Newcastle-upon-Tyne, NE1 7RU, U.K.     

Measurements of PCB Fluxes into the Atmosphere from a Site Receiving Stabilized Dredged Material

A 50 ha known contaminated site in Bayonne, New Jersey, U.S.A. is permitted to receive up to 3 × 10⁶ m³ of sediment dredged from navigation channels in the New York/New Jersey Harbor. Much of the sediment is expected to contain low to moderate concentrations of industrial and agricultural chemicals, including Polychlorinated Biphenyls (PCBs). The dredged material brought to the site is stabilized with cement and then placed as a capping and grading layer. The flux of PCBs from drying stabilized dredged material has been estimated from measurements of PCB air concentrations at two heights above the ground along with micrometeorological observations. A statistically significant gradient in PCB concentrations has been consistently measured in the first 3 m above the ground. Observed PCB fluxes were highest over freshly placed stabilized dredged sediment and decreased as it cured. The highest flux observed in this study was 7214 ng/m²/h, but during subsequent sampling intervals at the same site, the flux estimates decreased by an order of magnitude over a 5-day interval.     

Change in vegetation cover in East Timor, 1989–1999

Forest resources play a key role and provide many basic needs to communities in developing economies. To assess the patterns of vegetation cover change, as a corollary of resource utilization, satellite imagery, ground truth data, and image processing techniques can be useful. This article is concerned with identifying change in major vegetation types in East Timor between 1989 and 1999, using Landsat Thematic Mapper data. The results highlight a significant level of deforestation and decline in foliage cover. All major vegetation cover types declined from 1989 to 1999, and there was a sizeable increase in degraded woodlands. This decline has had considerable impact on the livelihoods of rural and urban communities. Causes for these changes include: economic exploitation of abundant resources; and implications of transmigration policies implemented during Indonesian rule, resulting in increased competition for land and woodland resources. As the new nation of Timor‐Leste establishes itself, it must consider its current stock and distribution of natural capital to ensure that development efforts are geared towards sustainable outcomes. Without the knowledge of historical patterns of resource consumption, development efforts may, unwittingly, lead to continuing decline in forest resources.     

MODELING THE IMPACT OF MULTICOMPONENT VOCs ON GROUND WATER USING THE STEFAN‐MAXWELL EQUATION1

ABSTRACT: Computer programs that model the fate and transport of organic contaminants through porous media typically use Fick's first law to calculate vapor phase diffusion. Fick's first law, however, is limited to the case of a single, dilute species diffusing into a stagnant, high concentration, bulk vapor phase. When dealing with more than one diffusing species and at higher concentrations, the multicomponent coupling effects on vapor phase diffusion and advection of the various constituents become significant. VLEACH, a one‐dimensional finite difference model developed for the U.S. Environmental Protection Agency (USEPA), is typical of the models using Fick's first law to model vapor‐phase diffusion. The VLEACH model was modified to accommodate up to 10 components and to calculate the binary diffusion coefficients for each of the components based on molecular weight, molecular volume, temperature and pressure, and to address the coupling effects on multiple component vapor phase diffusion and its impact on ground water. The resulting model was renamed MC‐CHEMSOIL. At low vapor phase concentrations, MC‐CHEMSOIL predicts identical ground water impacts (dissolved phase loading) to those from VLEACH 2.2a. At higher vapor phase concentrations, however, the relative difference between the models exceeded 20 percent.     

NITRATE CONCENTRATIONS IN ILLINOIS RIVERS 1967 TO 1974: COMPARISON AMONG REPORTING AGENCIES1

ABSTRACT: Long term data on surface water quality can sometimes be assembled by combining data collected by different agencies at different times and assuming that between agency differences in data quality are insignificant. The objective of this paper was to assess the quality of riverine nitrate (NO₃) concentrations in Illinois measured and reported by four agencies from 1967 to 1974 by comparing median values for similar sampling locations and periods. A total of 17 river reaches were identified for which two agencies reported NO₃ concentrations during similar periods. Nonparametric comparison of median values and analysis of covariance with discharge as a covariant produced similar results. Nitrate concentrations reported by the U.S. Geological Survey (USGS) from 1967 to 1971 were not statistically (P > 0.05) different from values reported by the Illinois State Water Survey (ISWS) for two of three river reaches. Additionally, NO₃ concentrations reported by USGS from 1972 to 1974 were not statistically different than concentrations reported by the Illinois Environmental Protection Agency (IEPA) for four of five river reaches. From 1969 to 1971, NO₃ concentrations reported by the Illinois Department of Public Heath and the Illinois Environmental Protection Agency (IDPH/IEPA) were less than one‐fourth the magnitude of values reported by ISWS. The median NO₃ concentrations measured by the Central Illinois Public Service (CIPS) were significantly greater than those measured by USGS and IDPH/IEPA in the three comparable sampling locations. The use of NO₃ concentrations measured by CIPS and IDPH/IEPA prior to 1972 is not recommended.     

Removal of selenate from water by zerovalent iron

Zerovalent iron (ZVI) has been widely used in the removal of environmental contaminants from water. In this study, ZVI was used to remove selenate [Se(VI)] at a level of 1000 microg L(-1) in the presence of varying concentrations of Cl-, SO(2-)4, NO(-)3, HCO(-)3, and PO(3-)4. Results showed that Se(VI) was rapidly removed during the corrosion of ZVI to iron oxyhydroxides (Fe(OH)). During the 16 h of the experiments, 100 and 56% of the added Se(VI) was removed in 10 mM Cl- and SO(2-)4 solutions under a closed contained system, respectively. Under an open condition, 100 and 93% of the added Se(VI) were removed in the Cl- and SO(2-)4 solutions, respectively. Analysis of Se species in ZVI-Fe(OH) revealed that selenite [Se(IV)] and nonextractable Se increased during the first 2 to 4 h of reaction, with a decrease of Se(VI) in the Cl- experiment and no detection of Se(VI) in the SO(2-)4 experiment. Two mechanisms can be attributed to the rapid removal of Se(VI) from the solutions. One is the reduction of Se(VI) to Se(IV), followed by rapid adsorption of Se(IV) to Fe(OH). The other is the adsorption of Se(VI) directly to Fe(OH), followed by its reduction to Se(IV). The results also show that there was little effect on Se(VI) removal in the presence of Cl- (5, 50, and 100 mM), NO(-)3 (1, 5, and 10 mM), SO(2-)4 (5 mM), HCO(-)3 (1 and 5 mM), or PO(3-)4 (1 mM) and only a slight effect in the presence of SO(2-)4 (50 and 100 mM), HCO(-)3 (10 mM), and PO(3-)4 (5 mM) during a 2-d experiment, whereas 10 mM PO(3-)4 significantly inhibited Se(VI) removal. This work suggests that ZVI may be an effective agent to remove Se from Se-contaminated agricultural drainage water.     

Tillage erosion and its effect on soil properties and crop yield in Denmark

Tillage erosion had been identified as a major process of soil redistribution on sloping arable land. The objectives of our study were to investigate the extent of tillage erosion and its effect on soil quality and productivity under Danish conditions. Soil samples were collected to a 0.45-m depth on a regular grid from a 1.9-ha site and analyzed for 137Cs inventories, as a measure of soil redistribution, soil texture, soil organic carbon (SOC) contents, and phosphorus (P) contents. Grain yield was determined at the same sampling points. Substantial soil redistribution had occurred during the past decades, mainly due to tillage. Average tillage erosion rates of 2.7 kg m(-2) yr(-1) occurred on the shoulderslopes, while deposition amounted to 1.2 kg m(-2) yr(-1) on foot- and toeslopes. The pattern of soil redistribution could not be explained by water erosion. Soil organic carbon and P contents in soil profiles increased from the shoulder- toward the toeslopes. Tillage translocation rates were strongly correlated with SOC contents, A-horizon depth, and P contents. Thus, tillage erosion had led to truncated soils on shoulderslopes and deep, colluvial soils on the foot- and toeslopes, substantially affecting within-field variability of soil properties. We concluded that tillage erosion has important implications for SOC dynamics on hummocky land and increases the risk for nutrient losses by overland flow and leaching. Despite the occurrence of deep soils across the study area, evidence suggested that crop productivity was affected by tillage-induced soil redistribution. However, tillage erosion effects on crop yield were confounded by topography-yield relationships.     

Sustainable land application: an overview

Man has land-applied societal nonhazardous wastes for centuries as a means of disposal and to improve the soil via the recycling of nutrients and the addition of organic matter. Nonhazardous wastes include a vast array of materials, including manures, biosolids, composts, wastewater effluents, food-processing wastes, industrial by-products; these are collectively referred to herein as residuals. Because of economic restraints and environmental concerns about land-filling and incineration, interest in land application continues to grow. A major lesson that has been learned, however, is that the traditional definition of land application that emphasizes applying residuals to land in a manner that protects human and animal health, safeguards soil and water resources, and maintains long-term ecosystem quality is incomplete unless the earning of public trust in the practices is included. This overview provides an introduction to a subset of papers and posters presented at the conference, "Sustainable Land Application," held in Orlando, FL, in January 2004. The USEPA, USDA, and multiple national and state organizations with interest in, and/or responsibilities for, ensuring the sustainability of the practice sponsored the conference. The overriding conference objectives were to highlight significant developments in land treatment theory and practice, and to identify future research needs to address critical gaps in the knowledge base that must be addressed to ensure sustainable land application of residuals.     

Equilibrium and kinetic studies on biosorption of Hg(II), Cd(II) and Pb(II) ions onto microalgae Chlamydomonas reinhardtii

The microalgae Chlamydomonas reinhardtii was used for the biosorption of Hg(II), Cd(II) and Pb(II) ions. The maximum adsorption of Hg(II) and Cd(II) ions on Chlamydomonas reinhardtii biomass was observed at pH 6.0 and the corresponding value for Pb(II) ions was 5.0. The biosorption of Hg(II), Cd(II) and Pb(II) ions by microalgae biomass increased as the initial concentration of Hg(II), Cd(II) and Pb(II) ions increased in the biosorption medium. The maximum biosorption capacities of microalgae for Hg(II), Cd(II) and Pb(II) ions were 72.2+/-0.67, 42.6+/-0.54 and 96.3+/-0.86 mg/g dry biomass, respectively. The affinity order for algal biomass was Pb(II)>Hg(II)>Cd(II). FT-IR analysis of algal biomass revealed the presence of amino, carboxyl, hydroxyl and carbonyl groups, which were responsible for biosorption of metal ions. Biosorption equilibrium was established in about 60 min and the equilibrium was well described by the Freundlich biosorption isotherms. Temperature change in the range of 5-35 degrees C did not affect the biosorption capacity. The microalgae could be regenerated using 0.1 M HCl, with up to 98% recovery, which allowed the reuse of the biomass in six biosorption-desorption cycles without any considerable loss of biosorption capacity.