This paper studied the biofilm properties and corrosion behavior of sulfate reducing bacteria (SRB) on stainless steel 316L (SS316L) surface in circulating cooling water system with and without additives including hydroxy ethyl fork phosphonic acid (HEDP), dodecyl dimethyl benzyl ammonium chlotide (1227) and NaClO. Biochemical technique, electrochemical technology, X-ray photoelectron spectroscopy (XPS) and scanning electron microscope (SEM) were used. The results show that the extracellular polymeric substance (EPS) in biofilm attached on the SS316L surface mainly contain proteins and polysaccharides, the contents are 98 ug·cm-2 and 635ug·cm-2, respectively. The polysaccharides were cut by 1227 about 80%, while 55% by NaClO. The proteins were reduced by NaClO about 53%, while only 30% by 1227. The potentiodynamic polarization shows that the corrosion potential of SS316L was enhanced from -0.495 V to -0.390 V by the chemical additives, delaying the occurrence of the corrosion. And the corrosion rate was also reduced from 5.19 × 10-3 mm·a-1 to 2.42 × 10-3 mm·a-1. But NaClO still caused pitting corrosion after sterilizing the bacteria, while 1227 can form a protective film on the surface of SS316L. Though HEDP contribute to the bacteria activity, it can enhance the breakdown potential. XPS results confirmed that 1227 can change the value of C:O in the biofilm attached on metal surface, and NaClO can eliminate the existence of amidogen. This study would provide some recommendations for the selection of chemical additives in the thermal power plant.
Negatively charged carboxymethylated polyethersulfone (CMPES) and positively charged quaternized polyethersulfone (QAPES) ultrafiltration (UF) membranes were prepared by bulk chemical modification and non-solvent induced phase separation method. The effects of PES membrane interfacial electrokinetic property on the bovine serum albumin (BSA) membrane fouling behavior were studied with the aid of the membrane-modified colloidal atomic force microscopy (AFM) probe. Electrokinetic test results indicated that the streaming potential (ΔE) of QAPES membrane was not consistent with its expected IEC value, however, within the pH range of 3–10, the ζ potentials of two charged-modified PES membranes were more stable than the unmodified membrane. When pH value was 3, 4.7 or 9, the interaction behavior between charged PES membrane and BSA showed that there was significant linear correlation between the jump distance r0 of membrane-BSA adhesion force (F/R) and the ζ potential absolute value. Charged modification significantly reduced the adhesion of PES membrane-BSA, and the adhesion data was good linear correlated with the flux decline rate in BSA filtration process, especially reflected in the CMPES membrane. The above experimental facts proved that the charged membrane interfacial electric double layer structure and its electrokinetic property had strong ties with the protein membrane fouling behavior.
Environmental Science and Pollution Research - Composite adsorbents usually outperform single component adsorbents as they could combine the properties and advantages of each component. In this... 相似文献
The initial degradation mechanisms of OH and 4-chloro-2-methylphenoxyacetic acid (MCPA) including molecular form and anionic form are studied at the MPWB1K/6-311+G(3df, 2p)//MPWB1K/6-31+G(d, p) level. Possible reaction pathways of H-atom abstraction and OH addition are considered in detail. By result comparison analysis, it is found that the reaction mechanisms for OH and two forms of MCPA are different, and most reactions for anionic MCPA are easier than those for molecular MCPA. For H-atom abstraction reactions, the calculated energies show that OH abstracting H-atom from -CH3 group of molecular MCPA is the most kinetically favorable process; the potential energy surface for anionic MCPA indicates that H-atom in -CH2 group is slightly easier to be abstracted than that in -CH3 group. For OH addition reactions, the addition of OH to the C1 site is the initial step for molecular MCPA and the predominant product is 4-chloro-2-methylphenol (denoted P3), while the C4 site is the most reactive site for anionic MCPA and the primary product results from the hydroxylation of the aromatic ring, which is in good agreement with the experimental observation. In additional, results from PCM calculations show that most reactions in water phase are more kinetically favorable than those in gas phase, though the mechanisms discussed above will not be changed. 相似文献
