芹菜素对丙烯腈引起大鼠精子脂质过氧化和DNA损伤的影响

分析芹菜素(apigenin,AP)对丙烯腈(acrylonitrile,ACN)引起的大鼠精子脂质过氧化和DNA损伤的影响,并探讨其可能的机制。将50只SPF级SD成年雄性大鼠随机分为阴性对照组(玉米油)、ACN组(50 mg·kg~(-1)ACN)、低AP组(50 mg·kg~(-1)ACN+234 mg·kg~(-1)AP)、高AP组(50 mg·kg~(-1)ACN+468 mg·kg~(-1)AP)、N-乙酰半胱氨酸(N-acetylcysteine,NAC)组(50 mg·kg~(-1)ACN+300mg·kg~(-1)NAC),以5 m L·(kg bw)~(-1)灌胃染毒,1次·d~(-1),6 d·周~(-1),连续13周。检测大鼠精子活性氧(ROS)、丙二醛(MDA)含量、超氧化物歧化酶(SOD)活性以及精子DNA损伤情况。结果发现,ACN组、低AP组、高AP组、NAC组精子ROS、MDA含量显著升高,SOD活力显著降低,精子尾部DNA含量百分比、尾长、尾距、Olive尾距均显著增高于对照组(均P0.05);而低AP组、高AP组、NAC组精子ROS、MDA含量、SOD活性和精子DNA损伤情况与ACN组相比差异均无统计学意义(P0.05)。提示ACN可引起大鼠精子脂质过氧化和DNA损伤,而AP、NAC对其无干预作用。     

磺化石墨烯对小麦幼苗生长及生理生化指标的影响

随着石墨烯生产量和使用量的不断增大,其对生态环境的风险逐渐引起了环境学家的关注。采用水培试验,探究了磺化石墨烯(SGO)对小麦幼苗的生长、抗氧化酶活性及脂质过氧化的影响。结果表明:在培养10 d后,低浓度磺化石墨烯对小麦根系的生长有显著促进作用(P0.05),200 mg·L-1浓度处理与对照处理相比提高了84.3%,随着浓度增加促进作用逐渐减弱,1 000 mg·L-1时与对照相比提高了19.9%。但对小麦地上部的生长没有影响。磺化石墨烯处理的小麦幼苗根系和叶片组织中超氧化物歧化酶(SOD)、过氧化氢酶(CAT)、过氧化物酶(POD)及丙二醛(MDA)都呈现先下降后上升的趋势。当磺化石墨烯浓度低于200 mg·L-1时,处理组小麦抗氧化酶的活性及MDA含量相对于对照处理大都有所降低,说明低浓度时磺化石墨烯没有对小麦的生长产生氧化胁迫,这与磺化石墨烯可能具有一定的抗氧化能力有关,而高浓度时由于产生氧化胁迫使各项生理生化指标逐渐上升。本实验结果为石墨烯材料对植物的毒理学研究提供了基础数据。     

硫代硫酸钠溶液修复重金属污染土壤的两种回收技术对比

研究了Na2S2O3溶液对污染土壤中Cu,Cd和Pb的去除能力,以及Na2S2O3萃取这三种金属分离技术的对比.结果表明,Na2S2O3溶液能有效地从土壤中萃取这三种金属,其萃取效率依次为:Cu>Cd>Pb.Na2S 沉淀分离法和阳离子交换树脂交换法均能分离出Na2S2O3萃取液中的Cu和Cd,去除率均达99%.但用Na2S2O3溶液萃取碱性土壤中的重金属时,阳离子交换树脂交换法分离重金属的效果较好,萃取酸性土壤中的重金属则用Na2S 沉淀分离法效果较好.     

氧化铜尾矿对水溶液中磷的吸附

研究不同pH条件下氧化铜尾矿颗粒对水溶液中磷的吸附特性.结果表明:Langmuir方程能很好地描述氧化铜尾矿对磷素的等温吸附特征;影响氧化铜尾矿对磷素吸附的因素主要有尾矿的比表面积、钙及铁氧化物含量、水溶液中磷素的初始浓度、体系pH值等;其吸附量随着钙及铁氧化物含量的增加、磷素初始浓度的提高以及体系pH值的降低而增大;其吸附机制主要为物理吸附和化学吸附.     

农田土壤呼吸对大气CO2浓度升高的响应

大气CO2浓度急剧升高引起的全球气候变暖是人们关注的环境问题之一.随着气候变化对全球生态环境的影响日益增大,全球碳循环研究已经成为各国科学家研究的热点之一.模拟大气CO2浓度升高试验技术先后经历了人工气候室、开顶式气室、FACE技术(Free Air carbon dioxjde eariclament)阶段,FACE技术因其无限接近自然条件而成为研究大气CO2浓度增加对整个生态系统影响的最理想试验平台.土壤呼吸是陆地生态系统碳循环的重要环节,农田生态系统是陆地生态系统的重要组成.研究农田生态系统的土壤呼吸对大气CO2浓度增加的响应是预测和评价农田系统乃至整个陆地生态系统土壤碳周转和碳收支的重要前提与基础.文章根据现有研究成果.阐述了模拟大气CO2浓度升高的试验技术,比较了农田土壤呼吸的测定方法,总结了以FACE研究成果为主的高CO2浓度条件下农田土壤呼吸、不同地下来源贡献及环境因子影响,提出了进一步研究的方向,以期为全球气候变化背景下的农田土壤呼吸和碳固定及全球碳循环研究提供帮助.     

大气细菌,霉菌数量与风速相关性初探

通过对大气细菌数量、霉菌数量与风速相关性的研究,得出齐市地区冬季气候寒冷,无相关性;春季气候干燥,风沙大,有相关性;雨后大气细菌数量与风速无相关性,大气霉菌数量与风速相关。     

Enhanced triallyl isocyanurate (TAIC) degradation through application of an O3/UV process: Performance optimization and degradation pathways

• UV/O₃ process had higher TAIC mineralization rate than O₃ process. • Four possible degradation pathways were proposed during TAIC degradation. • pH impacted oxidation processes with pH of 9 achieving maximum efficiency. • CO₃^2– negatively impacted TAIC degradation while HCO₃^– not. • Cl^– can be radicals scavenger only at high concentration (over 500 mg/L Cl^–). Triallyl isocyanurate (TAIC, C₁₂H₁₅N₃O₃) has featured in wastewater treatment as a refractory organic compound due to the significant production capability and negative environmental impact. TAIC degradation was enhanced when an ozone(O₃)/ultraviolet(UV) process was applied compared with the application of an independent O₃ process. Although 99% of TAIC could be degraded in 5 min during both processes, the O₃/UV process had a 70%mineralization rate that was much higher than that of the independent O₃ process (9%) in 30 min. Four possible degradation pathways were proposed based on the organic compounds of intermediate products identified during TAIC degradation through the application of independent O₃ and O₃/UV processes. pH impacted both the direct and indirect oxidation processes. Acidic and alkaline conditions preferred direct and indirect reactions respectively, with a pH of 9 achieving maximum Total Organic Carbon (TOC) removal. Both CO₃^2– and HCO₃^– decreased TOC removal, however only CO₃^2– negatively impacted TAIC degradation. Effects of Cl^– as a radical scavenger became more marked only at high concentrations (over 500 mg/L Cl^–). Particulate and suspended matter could hinder the transmission of ultraviolet light and reduce the production of HO· accordingly.     

Catalytic oxidation of CO over Pt/Fe3O4 catalysts: Tuning O2 activation and CO adsorption

• Strong metal-support interaction exists on Pt/Fe₃O₄ catalysts. • Pt metal particles facilitate the formation of oxygen vacancies on Fe₃O₄. • Fe₃O₄ supports enhance the strength of CO adsorption on Pt metal particles. The self-inhibition behavior due to CO poisoning on Pt metal particles strongly impairs the performance of CO oxidation. It is an effective method to use reducible metal oxides for supporting Pt metal particles to avoid self-inhibition and to improve catalytic performance. In this work, we used in situ reductions of chloroplatinic acid on commercial Fe₃O₄ powder to prepare heterogeneous-structured Pt/Fe₃O₄ catalysts in the solution of ethylene glycol. The heterogeneous Pt/Fe₃O₄ catalysts achieved a better catalytic performance of CO oxidation compared with the Fe₃O₄ powder. The temperatures of 50% and 90% CO conversion were achieved above 260°C and 290°C at Pt/Fe₃O₄, respectively. However, they are accomplished on Fe₃O₄ at temperatures higher than 310°C. XRD, XPS, and H₂-TPR results confirmed that the metallic Pt atoms have a strong synergistic interaction with the Fe₃O₄ supports. TGA results and transient DRIFTS results proved that the Pt metal particles facilitate the release of lattice oxygen and the formation of oxygen vacancies on Fe₃O₄. The combined results of O₂-TPD and DRIFTS indicated that the activation step of oxygen molecules at surface oxygen vacancies could potentially be the rate-determining step of the catalytic CO oxidation at Pt/Fe₃O₄ catalysts. The reaction pathway involves a Pt-assisted Mars-van Krevelen (MvK) mechanism.     

Bioreduction of nitrate in groundwater using a pilot-scale hydrogen-based membrane biofilm reactor

A long-term pilot-scale H₂-based membrane biofilm reactor (MBfR) was tested for removal of nitrate from actual groundwater. A key feature of this second-generation pilot MBfR is that it employed lower cost polyester hollow fibers and still achieved high loading rate. The steady-state maximum nitrate surface loading at which the effluent nitrate and nitrite concentrations were below the Maximum Contaminant Level (MCL) was at least 5.9 g·N·(m²·d)^?1, which corresponds to a maximum volumetric loading of at least 7.7 kg·N·(m³·d) ^?1. The steady-state maximum nitrate surface area loading was higher than the highest nitrate surface loading reported in the first-generation MBfRs using composite fibers (2.6 g·N·(m²·d)^?1). This work also evaluated the H₂-utilization efficiency in MBfR. The measured H₂ supply rate was only slightly higher than the stoichiometric H₂-utilization rate. Thus, H₂ utilization was controlled by diffusion and was close to 100% efficiency, as long as biofilm accumulated on the polyester-fiber surface and the fibers had no leaks.