低中放废物处置场核素经地下水迁移对环境影响预测

研究了我国某民用低中放固体废物处置场核素迁移的途径，对核素在地下水中的迁移进行了详细分析与计算，假定正常释放或一次降水量达到６００ｍｍ，处置场底浸泡一个月，存在６ｍ的包气带时，对该处置场处置的７种核素进行预测，结果表明，包气带是延迟核素迁移的主要屏障，在５００年内，可以使＾６０Ｃｏ＾１３７Ｃｓ＾９０Ｓｒ、＾６３Ｎｉ等核素延迟，其中＾２３９Ｐｕ降低６个月数量级，但不能延迟＾３Ｈ和＾１４Ｃ的迁移，穿过     

海滩旅游资源质量评比体系

论文回顾了当前国内外海滩旅游资源质量评价体系的发展现状 ,并依据我国具体状况 ,提出了适合我国国情的新的评价体系。新体系选择80个评价因子 ,分为旅游资源条件和可利用条件两个大类 ,前者包括地貌、水体、气候气象、生物、人文等5个亚类 ;后者包括基础设施及管理、安全、卫生等3个亚类。论文建立的新的海滩质量评比展示模式将有利于国内外海滩的质量对比 ,可促使我国海滩旅游业与国际接轨、能够向人们提供较多的海滩质量信息并利于海滩的经营管理     

Approaches to developing risk management objectives: an analysis of international strategies

Risk assessment/management frameworks employed around the world to guide environmental decision-making were analyzed for their approaches to developing risk management objectives and the decision criteria necessary for environmental policy implementation. Frameworks from the Netherlands, the UK, Sweden, Australia/New Zealand, Canada, and the USA were considered. Progress in refining the scientific basis for risk assessment/management has been made, but there has been little parallel development in defining the mechanisms by which available scientific information may be used to define risk management goals or identify and select between management options using a priori decision criteria. The lack of detailed guidance on the setting and achievement of risk management goals that appropriately balance technical information and public input remains an important challenge to the use and practice of all risk assessment/management frameworks.     

分体式膜-生物反应器在废水处理中的工艺条件

对分体式膜-生物反应器(RMBR)处理废水进行了研究.进水COD_Cr:312～584mg/L,RMBR的出水CODCr在运行4d后＜15 mg/L并稳定.向生物反应器添加0.5g/L(混合液)的粉末活性炭(PAC)后出水COD_Cr＜4.22mg/L.膜侧污水流速在0.9～1.9m/s范围内,临界膜通量随膜侧污水流速的增大而增大.添加PAC,组合添加PAC和Al₂(SO₄)₃·18 H₂O均可有效提高临界膜通量.在膜侧流速1.9m/s的条件下,临界膜通量从72L/(m²·h)分别增至76L/(m²·h)和81 L/(m²·h)在22℃～30℃范围内,每升高1℃可提高膜通量1.9%.在连续运行100d中,RMBR可在无任何物理,化学清洗的条件下运行14d而透膜压力无增大,膜通量不降低.对于已污染的膜,水清洗、水碱共间清洗、水碱酸共同清洗可分别恢复至新膜膜通量的47%、83%、94%.     

Development of aquatic life criteria in China: viewpoint on the challenge

While more developed countries have a well-established systems to develop water quality criteria (WQC), little research has been done on the adequacy of the current WQC to protect endemic species of China. In order to maintain the health of aquatic ecosystems in China, a series of projects to establish national WQC based on regional characteristics has recently been initiated. However, the establishment of a completely novel methodology would be costly and time consuming. Also, due to the similarities in physiologies and natural histories of classes of aquatic organisms, there is no reason to believe that WQC would not be sufficient to protect unique species in China. This review was undertaken to identify key outstanding issues regarding establishment of aquatic life criteria (ALC) to be applied in China, including prioritization of chemicals, test species, mode of action, field/semi-field data, and methods of aggregating the information and calculating the ALC. This was used to identify the principle issues that need to be addressed in order to better understand the methods for development of criteria for the protection of aquatic life and provide a reference to China and other developing countries committed to the establishment of their own WQC system.     

Identification and source apportionment of polycyclic aromatic hydrocarbons in ambient air particulate matter of Riyadh, Saudi Arabia

In an effort to assess the occurrence and sources of polycyclic aromatic hydrocarbons (PAHs) in the ambient air of Riyadh, Saudi Arabia, PM₁₀ samples were collected during December 2010. Diagnostic PAH concentration ratios were used as a tool to identify and characterize the PAH sources. The results reflect high PM₁₀ and PAH concentrations (particulate matter (PM)?=?270–1,270 μg/m³). The corresponding average PAH concentrations were in the range of 18?±?8 to 1,003?±?597 ng/m³ and the total concentrations (total PAHs (TPAHs) of 17 compounds) varied from 1,383 to 13,470 ng/m³ with an average of 5,871?±?2,830 ng/m³. The detection and quantification limits were 1–3 and 1–10 ng/ml, respectively, with a recovery range of 42–80 %. The ratio of the sum of the concentrations of the nine major non-alkylated compounds to the total (CPAHs/TPAHs) was 0.87?±?0.10, and other ratios were determined to apportion the PM sources. The PAHs found are characteristic for emissions from traffic with diesel being a predominant source.     

Uranyl–water-containing complexes: solid-state UV-MALDI mass spectrometric and IR spectroscopic approach for selective quantitation

Since primary environmental concept for long storage of nuclear waste involved assessment of water in uranium complexes depending on migration processes, the paper emphasized solid-state matrix-assisted laser desorption/ionization (MALDI) mass spectrometric (MS) and IR spectroscopic determination of UO₂(NO₃)₂·6H₂O; UO₂(NO₃)₂·3H₂O, α-, β-, and γ-UO₃ modifications; UO₃·xH₂O (x?=?1 or 2); UO₃·H₂O, described chemically as UO₂(OH)₂, β- and γ-UO₂(OH)₂ modifications; and UO₄·2H₂O, respectively. Advantages and limitation of vibrational spectroscopic approach are discussed, comparing optical spectroscopic data and crystallographic ones. Structural similarities occurred in α–γ modifications of UO₃, and UO₂(OH)₂ compositions are analyzed. Selective speciation achieved by solid-state mass spectrometry is discussed both in terms of its analytical contribution for environmental quality assurance and assessment of radionuclides, and fundamental methodological interest related the mechanistic complex water exchange of UO₃·H₂O forms in the gas phase. In addition to high selectivity and precision, UV-MALDI-MS, employing an Orbitrap analyzer, was a method that provided fast steps that limited sample pretreatment techniques for direct analysis including imaging. Therefore, random and systematic errors altering metrology and originating from the sample pretreatment stages in the widely implemented analytical protocols for environmental sampling determination of actinides are significantly reduced involving the UV-MALDI-Orbitrap-MS method. The method of quantum chemistry is utilized as well to predict reliably the thermodynamics and nature of U–O bonds in uranium species in gas and condensed phases.     

The integrated biomarker response revisited: optimization to avoid misuse

The growing need to evaluate the quality of aquatic ecosystems led to the development of numerous monitoring tools. Among them, the development of biomarker-based procedures, that combine precocity and relevance, is recommended. However, multi-biomarker approaches are often hard to interpret, and produce results that are not easy to integrate in the environmental policies framework. Integrative index have been developed, and one of the most used is the integrated biomarker response (IBR). However, an analysis of available literature demonstrated that the IBR suffers from a frequent misuse and a bias in its calculation. Then, we propose here a new calculation method based on both a more simple formula and a permutation procedure. Together, these improvements should rightly avoid the misuse and bias that were recorded. Additionally, a case study illustrates how the new procedure enabled to perform a reliable classification of site along a pollution gradient based on biomarker responses used in the IBR calculations.     

Increased bioavailability of metals in two contrasting agricultural soils treated with waste wood-derived biochar and ash

Recycled waste wood is being increasingly used for energy production; however, organic and metal contaminants in by-products produced from the combustion/pyrolysis residue may pose a significant environmental risk if they are disposed of to land. Here we conducted a study to evaluate if highly polluted biochar (from pyrolysis) and ash (from incineration) derived from Cu-based preservative-treated wood led to different metal (e.g., Cu, As, Ni, Cd, Pb, and Zn) bioavailability and accumulation in sunflower (Helianthus annuus L.). In a pot experiment, biochar at a common rate of 2 % w/w, corresponding to ～50 t ha^?1, and an equivalent pre-combustion dose of wood ash (0.2 % w/w) were added to a Eutric Cambisol (pH 6.02) and a Haplic Podzol (pH 4.95), respectively. Both amendments initially raised soil pH, although this effect was relatively short-term, with pH returning close to the unamended control within about 7 weeks. The addition of both amendments resulted in an exceedance of soil Cu statutory limit, together with a significant increase of Cu and plant nutrient (e.g., K) bioavailability. The metal-sorbing capacity of the biochar, and the temporary increase in soil pH caused by adding the ash and biochar were insufficient to offset the amount of free metal released into solution. Sunflower plants were negatively affected by the addition of metal-treated wood-derived biochar and led to elevated concentration of metals in plant tissue, and reduced above- and below-ground biomass, while sunflower did not grow at all in the Haplic Podzol. Biochar and ash derived from wood treated with Cu-based preservatives can lead to extremely high Cu concentrations in soil and negatively affect plant growth. Identifying sources of contaminated wood in waste stream feedstocks is crucial before large-scale application of biochar or wood ash to soil is considered.