Characterization of Municipal Solid Waste Incineration Residues From Facilities with Different Air Pollution Control Systems

Abstract

Municipal Solid Waste incinerator residues produced in two types of facilities were exhaustively characterized: granulometry, mineralogy, chemical composition, leaching behavior, and elemental distribution as a function of particle size. Air Pollution Control (APC) residues coming from a semi-dry scrubber have shown higher solubility than fly ashes originating in an Electrostatic Precipitator (ESP), as well as higher contents in volatile metals (Cd, Hg). Different metal speciation and distribution as a function of particle size have been found in fly ashes (ESP residues) and APC residues. In APC residues, heavy metals (with the exception of Hg) show a parabolic distribution with maxima in the smallest and largest particles, following the same profile as soluble salts. Metal distribution for APC residues exhibits that metals generally are not associated with silicate aluminate matrix. Results show the effect of adding lime to APC residues in metal speciation and distribution.     

A Comparative Analysis of Emissions Deterioration for In-Use Alternative Fuel Vehicles

Abstract

Although there have been several studies examining emissions from in–use alternative fuel vehicles (AFVs), little is known about the deterioration of these emissions over vehicle lifetimes and how this deterioration compares with deterioration from conventional vehicles (CVs). This paper analyzes emissions data from 70 AFVs and 70 CVs operating in the federal government fleet to determine whether AFV emissions deterioration differs significantly from CV emissions deterioration. An analysis is conducted on three alternative fuel types (natural gas, methanol, and ethanol) and on four pollutants (carbon monoxide, total hydrocarbons, non-methane hydrocarbons, and nitrogen oxides). The results indicate that for most cases studied, deterioration differences are not statistically significant; however, several exceptions (most notably with natural gas vehicles) suggest that air quality planners and regulators must further analyze AFV emissions deterioration to properly include these technologies in broader air quality management schemes.     

Estimation of Trends in Atmospheric Concentrations of Sulfate in the Northeastern United States

Abstract

Daily atmospheric concentrations of sulfate collected at six locations in the northeastern United States are regressed against meteorological factors, ozone, seasonal cycles, and time in order to determine if a significant trend in sulfate can be detected. The data used in this analysis were collected during the Sulfate Regional Experiment (SURE, 1977-1978) and the Eulerian Model Evaluation Field Study (EMEFS, 1988-1989). Ozone, specific humidity, and seasonal terms (reflecting the potential of the atmosphere for oxidation of sulfur dioxide) emerged as important explanatory variables. After accounting for the variability explained by environmental factors, the median estimated change in sulfate concentration from the six locations over the 11-year period is -22% (or -28% if ozone is not used as an explanatory variable). Although there are wide variations among locations, these changes are commensurate with an estimated 25% decline in sulfur emissions in the northeastern U.S. during the same period. These analyses provide insight into methods for detecting reductions in sulfate that may be expected to occur as a result of the Clean Air Act Amendments of 1990. Uncertainties in the estimates, with consideration of serial correlation in the data, imply a minimum detectable reduction of 10% using this modeling procedure with similar data availability.     

Comparison of Computer Simulations of Total Lung Deposition to Human Subject Data in Healthy Test Subjects

ABSTRACT

A mathematical model was used to predict the deposition fractions (DF) of PM within human lungs. Simulations using this computer model were previously validated with human subject data and were used as a control case. Human intersubject variation was accounted for by scaling the base lung morphology dimensions based on measured functional residual capacity (FRC) values. Simulations were performed for both controlled breathing (tidal volumes [V_T] of 500 and 1000 mL, respiratory times [T] from 2 to 8 sec) and spontaneous breathing conditions. Particle sizes ranged from 1 to 5 um. The deposition predicted from the computer model compared favorably with the experimental data. For example, when V_T = 1000 mL and T = 2 sec, the error was 1.5%. The errors were slightly higher for smaller tidal volumes. Because the computer model is deterministic (i.e., derived from first principles of physics), the model can be used to predict deposition fractions for a range of situations (i.e., for different ventilatory parameters and particle sizes) for which data are not available. Now that the model has been validated, it may be applied to risk assessment efforts to estimate the inhalation hazards of airborne pollutants.     

Exposure of Chronic Obstructive Pulmonary Disease Patients to Particulate Matter: Relationships between Personal and Ambient Air Concentrations

ABSTRACT

Most time-series studies of particulate air pollution and acute health outcomes assess exposure of the study population using fixed-site outdoor measurements. To address the issue of exposure misclassification, we evaluate the relationship between ambient particle concentrations and personal exposures of a population expected to be at risk of particle health effects.

Sampling was conducted within the Vancouver metropolitan area during April-September 1998. Sixteen subjects (non-smoking, ages 54-86) with physician-diagnosed chronic obstructive pulmonary disease (COPD) wore personal PM_{2 5} monitors for seven 24-hr periods, randomly spaced approximately 1.5 weeks apart. Time-activity logs and dwelling characteristics data were also obtained for each subject. Daily 24-hr ambient PM₁₀ and PM_2.5 concentrations were measured at five fixed sites spaced throughout the study region. SO₄ ^2-, which is found almost exclusively in the fine particle fraction and which does not have major indoor sources, was measured in all PM_{2 5} samples as an indicator of accumulation mode particu-late matter of ambient origin.     

Development of a Sample Equilibration System for the TEOM Continuous PM Monitor

ABSTRACT

In recent years, scientific discussion has included the influence of thermodynamic conditions (e.g., temperature, relative humidity, and filter face velocity) on PM retention efficiency of filter-based samplers and monitors. Method-associated thermodynamic conditions can, in some instances, dramatically influence the presence of particle-bound water and other light-molecular-weight chemical components such as particulate nitrates and certain organic compounds. The measurement of fine particle mass presents a new challenge for all PM measurement methods, since a relatively greater fraction of the mass is semi-volatile.

The tapered element oscillating microbalance (TEOM) continuous PM monitor is a U.S. Environmental Protection Agency (EPA) PM₁₀ equivalent method (EQPM-1090-079). Several hundred of these monitors are deployed throughout the United States. The TEOM monitor has the unique characteristic of providing direct PM mass measurement without the calibration uncertainty inherent in mass surrogate methods. In addition, it provides high-precision, near-real-time continuous data automatically. Much attention has been given to semi-volatile species retention of the TEOM method.

While using this monitor, it is desirable to maintain as low an operating temperature as practical and to remove unwanted particle-bound water. A new sample equilibration system (SES) has been developed to allow conditioning of the PM sample stream to a lower humidity and temperature level. The SES incorporates a special low-particle-loss Nafion dryer. This paper discusses the configuration and theory of the SES. Performance results include high time-resolved PM_2.5 data comparison between a 30 °C sample stream TEOM monitor with SES and a standard 50 °C TEOM monitor. In addition, 24-hr integrated data are compared with data collected using an EPA PM_2.5 Federal Reference Method (FRM)-type sampler. The SES is a significant development because it can be applied easily to existing TEOM monitors.     

An Environmental Decision-Making Tool for Evaluating Ground-Level Ozone-Related Health Effects

Abstract

A computer model called the Ozone Risk Assessment Model (ORAM) was developed to evaluate the health effects caused by ground-level ozone (O₃) exposure. ORAM was coupled with the U.S. Environmental Protection Agency’s (EPA) Third-Generation Community Multiscale Air Quality model (Models-3/CMAQ), the state-of-the-art air quality model that predicts O₃ concentration and allows the examination of various scenarios in which emission rates of O₃ precursors (basically, oxides of nitrogen [NO_x] and volatile organic compounds) are varied. The principal analyses in ORAM are exposure model performance evaluation, health-effects calculations (expected number of respiratory hospital admissions), economic valuation, and sensitivity and uncertainty analysis through a Monte Carlo simulation. As a demonstration of the system, ORAM was applied to the eastern Tennessee region, and the entire O₃ season was simulated for a base case (typical emissions) and three different emission scenarios. The results indicated that a synergism occurs when reductions in NO_x emissions from mobile and point sources were applied simultaneously. A 12.9% reduction in asthma hospital admissions is expected when both mobile and point source NO_x emissions are reduced (50 and 70%, respectively) versus a 5.8% reduction caused by mobile source and a 3.5% reduction caused by point sources when these emission sources are reduced individually.     

Weekday/Weekend Ozone Differences: What Can We Learn from Them?

Abstract

A national analysis of weekday/weekend ozone (O₃) differences demonstrates significant variation across the country. Weekend 1-hr or 8-hr maximum O₃ varies from 15% lower than weekday levels to 30% higher. The weekend O₃ increases are primarily found in and around large coastal cities in California and large cities in the Midwest and Northeast Corridor. Both the average and the 95th percentile of the daily 1-hr and 8-hr maxima exhibit the same general pattern. Many sites that have elevated O₃ also have higher O₃ on weekends even though traffic and O₃ precursor levels are substantially reduced on weekends. Detailed studies of this phenomenon indicate that the primary cause of the higher O₃ on weekends is the reduction in oxides of nitrogen (NO_x) emissions on weekends in a volatile organic compound (VOC)-limited chemical regime. In contrast, the lower O₃ on weekends in other locations is probably a result of NO_x reductions in a NO_x-limited regime. The NO_x reduction explanation is supported by a wide range of ambient analyses and several photochemical modeling studies. Changes in the timing and location of emissions and meteorological factors play smaller roles in weekend O₃ behavior. Weekday/weekend temperature differences do not explain the weekend effect but may modify it.     

Microwave Process for Volatile Organic Compound Abatement

ABSTRACT

The CHA Corporation has completed the U.S. Air Force Phase II Small Business Innovation Research program to investigate the feasibility of using a novel microwave-based process for the removal and destruction of volatile organic compounds (VOCs) in effluents from noncombustion sources, such as paint booth ventilation streams. Removal of solvents by adsorption, followed by the regeneration of saturated granular activated carbon (GAC) by microwave energy, was achieved in a single fixed-bed reactor. Microwave regeneration of the fixed-bed-saturated carbon restored the original GAC adsorption capacity. After 20 adsorption/regeneration cycles, the adsorption capacity dropped from 13.5 g methyl ethyl ketone (MEK)/100 g GAC to 12.5 g MEK/100 g GAC. During microwave regeneration of the GAC fixed bed, the concentrated desorbed paint solvent was oxidized by passing the solvent mixture through a fixed bed of an oxidation catalyst mixed with silicon carbide in a microwave reactor. A 98% oxidation efficiency was consistently achieved from the oxidation of VOCs in the microwave catalytic reactor.     

Combined PCDD/F Destruction and Particulate Control in a Baghouse: Experience with a Catalytic Filter System at a Medical Waste Incineration Plant

ABSTRACT

Phoenix Services, Inc., owns and operates the Baltimore Regional Medical Waste Incinerator in Baltimore, MD. New regulations for dioxins and furans imposed a limit that was considerably below historical emission levels. To determine a method to comply with the new dioxin/furan regulations, Phoenix Services performed trials with powdered activated carbon (PAC). Although the results with carbon were acceptable, Phoenix Services decided to replace their woven fiberglass filter bags with catalytic filters that simultaneously destroy dioxins and furans and collect particulate matter (PM). The catalytic filter system offered several advantages to Phoenix Services, including destruction of dioxins and furans instead of adsorption on carbon. The catalytic filters also offered a passive solution that did not require new carbon injection equipment. In January 2000, a campaign to measure dioxins/furans and PM was undertaken.