Precision and Accuracy in the Determination of Sulfur Oxides,Fluoride, and Spherical Aluminosilicate Fly Ash Particles in Project MOHAVE

The precision and accuracy of the determination of particu-late sulfate and fluoride, and gas phase SO₂ and HF are estimated from the results obtained from collocated replicate samples and from collocated comparison samples for high-and low-volume filter pack and annular diffusion denuder samplers. The results of replicate analysis of collocated samples and replicate analyses of a given sample for the determination of spherical aluminosilicate fly ash particles have also been compared. Each of these species is being used in the chemical mass balance source apportionment of sulfur oxides in the Grand Canyon region as part of Project MOHAVE, and the precision and accuracy analyses given in this paper provide input to that analysis. The precision of the various measurements reported here is ±1.8 nmol/m³ and ±2.5 nmol/m³ for the determination of SO₂ and sulfate, respectively, with an annular denuder. The precision is ±0.5 nmol/m³ and ±2.0 nmol/m³ for the determination of the same species with a high-volume or low-volume filter pack. The precision for the determination of the sum of HF(g) and fine particulate fluoride is ±0.3 nmol/m³. The precision for the determination of aluminosilicate fly ash particles is ±100 particles/m³. At high concentrations of the various species, reproducibility of the various measurements is ±10% to ±14% of the measured concentration. The concentrations of sulfate determined using filter pack samplers are frequently higher than those determined using diffusion denuder sampling systems. The magnitude of the difference (e.g., 2-10 nmol sulfate/m³) is small, but important relative to the precision of the data and the concentrations of particulate sul-fate present (typically 5-20 nmol sulfate/m³). The concentrations of SO₂(g) determined using a high-volume cascade impactor filter pack sampler are correspondingly lower than those obtained with diffusion denuder samplers. The concentrations of SO_x (SO₂(g) plus particulate sulfate) determined using the two samplers during Project MOHAVE at the Spirit Mountain, NV, and Hopi Point, AZ, sampling sites were in agreement. However, for samples collected at Painted Desert, AZ, and Meadview, AZ, the concentrations of SO_x and SO₂(g) determined with a high-volume cascade impactor filter pack sampler were frequently lower than those determined using a diffusion denuder sampling system. These two sites had very low ambient relative humidity, an average of 25%. Possible causes of observed differences in the SO₂(g) and sulfate results obtained from different types of samplers are given.     

World poverty,another look

The World Bank used the Consumer Price Index (CPI) to calculate changes in the world poverty level (measured in U.S. dollars) prior to 1982. In 1983, the U.S. Bureau of Labor Statistics (BLS) replaced the CPI with several indices including CPI-W which was then adopted by the World Bank. This caused the inflated rate of the U.S. dollars and the percentage of the world population in poverty to be dramatically underestimated. This new incorrect procedure gives 25% (1.5 million) below the poverty line in 2005, while the more appropriate procedure (described herein) gives 52% (3.3 million in 2005). The rapid rise of the poverty line (using the preferable CPI) starting in 1987 occurred at nearly the same time as the peak in per capita annual cereal production.     

Pesticide use among smallholder rice farmers in Tanzania

In an interview study conducted among smallholder rice farmers in Rufiji, Tanzania coastal mainland, and in Cheju, Zanzibar, farmer??s pesticide use and risk awareness were assessed. The farmers generally lacked knowledge or possibilities to manage the pesticides as prescribed by the manufacturers. Few farmers knew what kind of pesticides they were using and had never seen the original packages, as pesticides were usually sold per weight or already diluted without labeling. Protective equipment was rarely used since they were not aware of risks associated with pesticides or did not know where to purchase protective gear. Only half of the farmers were aware of pesticides?? health hazards and few associated pesticides with environmental problems. The pesticide use was relatively low, but based on farmers?? pesticide handling and application practices, health risks were a major concern. Most farmers did not believe in successful rice cultivation without using pesticides to control pests. However, estimated yields did not differ between pesticide users or farmers using conventional methods or neem tree extract. To avoid negative effects on human health and the environment, the farmers need basic education and better assistance in their farming practices and pesticide management.     

Mercury distribution in seawater discharged from a coal-fired power plant equipped with a seawater flue gas desulfurization system

Background and purpose  

More and more coal-fired power plants equipped with seawater flue gas desulfurization systems have been built in coastal areas. They release large amount of mercury (Hg)-containing waste seawater into the adjacent seas. However, very limited impact studies have been carried out. Our research targeted the distribution of Hg in the seawater, sediment, biota, and atmosphere, and its environmental transportation.     

Hexachlorocyclohexane (HCH) as new Stockholm Convention POPs��a global perspective on the management of Lindane and its waste isomers

Purpose

Hexachlorocyclohexane (HCH) isomers (??-, ??- and ??- (Lindane)) were recently included as new persistent organic pollutants (POPs) in the Stockholm Convention, and therefore, the legacy of HCH and Lindane production became a contemporary topic of global relevance. This article wants to briefly summarise the outcomes of the Stockholm Convention process and make an estimation of the amount of HCH waste generated and dumped in the former Lindane/HCH-producing countries.

Results

In a preliminary assessment, the countries and the respective amount of HCH residues stored and deposited from Lindane production are estimated. Between 4 and 7 million tonnes of wastes of toxic, persistent and bioaccumulative residues (largely consisting of alpha- (approx. 80%) and beta-HCH) are estimated to have been produced and discarded around the globe during 60 years of Lindane production. For approximately 1.9 million tonnes, information is available regarding deposition. Countries are: Austria, Brazil, China, Czech Republic, France, Germany, Hungary, India, Italy, Japan, Macedonia, Nigeria, Poland, Romania, Slovakia, South Africa, Spain, Switzerland, Turkey, The Netherlands, UK, USA, and former USSR. The paper highlights the environmental relevance of deposited HCH wastes and the related POPs?? contaminated sites and provides suggestions for further steps to address the challenge of the legacy of HCH/Lindane production.

Conclusion

It can be expected that most locations where HCH waste was discarded/stockpiled are not secured and that critical environmental impacts are resulting from leaching and volatilisation. As parties to the Stockholm Convention are legally required to take action to stop further POPs pollution, identification and evaluation of such sites are necessary.     

Material and energy recovery in integrated waste management systems. An evaluation based on life cycle assessment

This paper reports the environmental results, integrated with those arising from mass and energy balances, of a research project on the comparative analysis of strategies for material and energy recovery from waste, funded by the Italian Ministry of Education, University and Research. The project, involving the cooperation of five University research groups, was devoted to the optimisation of material and energy recovery activities within integrated municipal solid waste (MSW) management systems. Four scenarios of separate collection (overall value of 35%, 50% without the collection of food waste, 50% including the collection of food waste, 65%) were defined for the implementation of energetic, environmental and economic balances. Two sizes of integrated MSW management system (IWMS) were considered: a metropolitan area, with a gross MSW production of 750,000 t/year and an average province, with a gross MSW production of 150,000 t/year. The environmental analysis was conducted using Life Cycle Assessment methodology (LCA), for both material and energy recovery activities. In order to avoid allocation we have used the technique of the expansion of the system boundaries. This means taking into consideration the impact on the environment related to the waste management activities in comparison with the avoided impacts related to the saving of raw materials and primary energy. Under the hypotheses of the study, both for the large and for the small IWMS, the energetic and environmental benefits are higher than the energetic and environmental impacts for all the scenarios analysed in terms of all the indicators considered: the scenario with 50% separate collection in a drop-off scheme excluding food waste shows the most promising perspectives, mainly arising from the highest collection (and recycling) of all the packaging materials, which is the activity giving the biggest energetic and environmental benefits. Main conclusions of the study in the general field of the assessment of the environmental performance of any integrated waste management scheme address the importance of properly defining, beyond the design value assumed for the separate collection as a whole, also the yields of each material recovered; particular significance is finally related to the amount of residues deriving from material recovery activities, resulting on average in the order of 20% of the collected materials.     

The Effect of CTBN Concentrations on the Kinetic Parameters of Decomposition of Blends of Epoxy Resins Modified with Carboxyl-Terminated Liquid Copolymer

Diglycidyl ether of bisphenol—A (DGEBA)—based epoxy resin was blended in the ratio of 3:1 (weight basis) with cycloaliphatic epoxy (CAE) resin. The prepared blend sample was further blended with different weight percentages of carboxyl-terminated butadiene acrylonitrile copolymer (CTBN) ranging between 0 and 25 wt% with an interval of 5 wt% and cured with stiochiometric amounts of 4, 4’- diamino diphenyl sulphone (DDS) cure agent. Structural changes during blending were studied by Fourier-transform infra-red (FTIR) spectroscopic analysis. The kinetic parameters, viz., order of decomposition reaction (n), activation energy (E), pre-exponential factor (Z) and rate decomposition constant (k), for the decomposition of the samples were calculated by applying Coats-Redfern equation over thermogravimetric (TG) data. The degradation of each sample followed second-order degradation kinetics, which was calculated by Coats-Redfern equation using best-fit analysis. This was further confirmed by linear regression analysis. The validity of data was checked by t-test statistical analysis. Further, the blend sample had higher initial degradation temperature and activation energy than its respective pure epoxy resin indicating that the CTBN acted as thermal stabilizer for epoxy resin which improved the thermal stability.     

Potential of microalgae as biopesticides to contribute to sustainable agriculture and environmental development

The loss of yields from agricultural production due to the presence of pests has been treated over the years with synthetic pesticides, but the use of these substances negatively affects the environment and presents health risks for consumers and animals. The development of agroecological systems using biopesticides represents a safe alternative that contributes to the reduction of agrochemical use and sustainable agriculture. Microalgae are able to biosynthesize a number of metabolites with potential biopesticidal action and can be considered potential biological agents for the control of harmful organisms to soils and plants. The present work aims to provide a critical perspective on the consequences of using synthetic pesticides, offering as an alternative the biopesticides obtained from microalgal biomass, which can be used together with the implementation of environmentally friendly agricultural systems.