Air Pollution in Singapore: Its Multielemental Aspect as Measured by Nuclear Analytical Techniques

Aerosol samples were collected in 1994 in Singapore on two occasions: once in June during the normal meteorological conditions and later in October during a long haze period caused by the heavy forest fire in Indonesia. Filtration and impaction collection methods were used simultaneously so that detailed elemental analysis of bulk as well as of different size fractions could be performed. Accelerator based nuclear analytical techniques such as Particle Induced X-Ray Emission (PIXE), Rutherford Backscattering (RBS) and Nuclear Microscopy (NM) were used for analysis. These techniques are fast, truly multielemental and perfectly suited for routine analysis of a large number of aerosol samples. Typically all samples were analysed for the following 24 elements: Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Mn, Cr, Fe, Co, Ni, Cu, Zn, Ga, As, Br, Rb, Sr and Pb. Detection limits for bulk analysis were generally below ng/m3 and for single particle analysis absolute detectable mass was approximately 10-17 g. Additionally, trace elements such as Cd, Sn, Sb and Ba whose characteristic X-ray lines were normally "obscured" by the lines of other more abundant elements, were detected when analysing by nuclear microscope in single particle mode.Judging by the average concentrations of lead and sulphur which are good indicators of industrial component of air pollution the situation in Singapore is satisfactory. Pb was typically found in concentrations of 5 to 50 ng/m3 and sulphur in concentrations of 1 to 2 µg/m3. These concentrations are well below limits set by the World Health Organisation (1500 ng/m3 and 40 µg/m3, respectively). On the other hand during the haze period the average concentrations of elements like S, K, Ti, V, Mn, Ni, As and Pb were found to be 3 to 6 times higher than usual. Results are presented and discussed.     

State estimation in wastewater engineering: Application to an anaerobic process

The use of an extended Kalman filter for state estimation in biological wastewater treatment processes is discussed. The application of the technique requires an adequate mechanistic dynamic model and the identification and modelling of the major sources of stochastic disturbances in the process. The filter allows the on-line tracking of process variables which are not directly measurable. The use of an extended Kalman filter is illustrated through a simulated application to a high rate anaerobic wastewater treatment process.     

Analysing the sensitivity behaviour of two hydrology models

Recently, the New Morris Method has been presented as an effective sensitivity analysis tool for mathematical models. The New Morris Method estimates the sensitivity of an output parameter to a given set of input parameters (first-order effects) and the extent these parameters interact with each other (second-order effects). This method requires the specification of two parameters (runs and resolution) that control the sampling of the output parameter to determine its sensitivity to various inputs. The criteria for these parameters have been set on the analysis of a well-behaved analytical function (see Cropp and Braddock, Reliab. Eng. Syst. Saf. 78:77–83, 2002), which may not be applicable to other physical models that describe complex processes. This paper will investigate the appropriateness of the criteria from (Cropp and Braddock, 2002) and hence the effectiveness of the New Morris Method to determine the sensitivity behaviour of two hydrologic models: the Soil Erosion and Deposition System and Griffith University Representation of Urban Hydrology. In the first case, this paper will separately analyse the sensitivity of an output parameter on a set of input parameters (first- and second-order effects) for each model and discuss the physical meaning of these sensitivities. This will be followed by an investigation into the sampling criteria by exploring the convergence of the sensitivity behaviour for each model as the sampling of the parameter space is increased. By comparing these trends to the convergence behaviour from Cropp and Braddock (2002), we will determine how well the New Morris Method estimates the sensitivity for each model and whether the sampling criteria are appropriate for these models. It will be shown that the New Morris Method can provide additional insight into the functioning of these models, and that, under a different metric, the sensitivity behaviour of these models does converge confirming the sampling criteria set by Cropp and Braddock.     

Application of cryofocusing hydride generation and atomic fluorescence detection for dissolved mercury species determination in natural water samples

The concentration levels of mercury (Hg) species in natural water samples are usually low. Consequently, accurate analysis with low detection limits is still a major problem. In this work, a method was applied for the simultaneous direct determination of dissolved mercury species in water samples by on-line hydride generation (HG), cryogenic trapping (CT), gas chromatography (GC) and detection by atomic fluorescence spectrometry (AFS). The suitability of the method for real samples with different organic matter and chloride contents was evaluated by recovery experiments in synthetic and natural spiked water samples. The HG method was compared with other current available methods for mercury analysis with respect to the different fraction of mercury analysed, i.e. 'reactive', 'reducible' or total. HG derivatization and SnCl2 reduction (with and without previous oxidation with BrCl) were applied to synthetic and natural (spiked and non-spiked) water samples. The influence of chloride and dissolved organic matter concentrations was studied. The results suggest that the HG procedure is suitable for the simultaneous determination of Hg2+ and MeHg+ in surface water samples. Inorganic mercury analysed by HG (i.e. reducible) is close to the total inorganic mercury.     

Arsenic speciation in human hair: a new perspective for epidemiological assessment in chronic arsenicism

The analysis for arsenic in hair is commonly used in epidemiological studies to assess exposure to this toxic element. However, poor correlation between total arsenic concentration in hair and water sources have been found in previous studies. Exclusive determination of endogenous arsenic in the hair, excluding external contamination has become an analytical challenge. Arsenic speciation in hair appears as a new possibility for analytical assessing in As-exposure studies. This study applied a relative simple method for arsenic speciation in human hair based on water extraction and HPLC-HG-ICP-MS. The concentration of arsenic species in human hair was assessed in chronically As(V)-exposed populations from two villages (Esqui?a and Illapata) of the Atacama Desert, Chile. The arsenic concentrations in drinking water are 0.075 and 1.25 mg L(-1), respectively, where As(V) represented between 92 and 99.5% of the total arsenic of the consumed waters. On average, the total arsenic concentrations in hair from individuals of Esqui?a and Illapata were 0.7 and 6.1 microg g(-1), respectively. Four arsenic species, As(III), DMA(V), MMA(V) and As(V), were detected and quantified in the hair extracts. Assuming the found species in extracts represent the species in hair, more than 98% of the total arsenic in hair corresponded to inorganic As. On average, As(III) concentrations in hair were 0.25 and 3.75 microg g(-1) in Esqui?a and Illapata, respectively; while, the As(V) average concentrations were 0.15 and 0.45 microg g(-1) in Esqui?a and Illapata, respectively. Methylated species represent less than 2% of the extracted As (DMA(V)+ MMA(V)) in both populations. As(III) in hair shows the best correlation with chronic exposure to As(V) in comparison to other species and total arsenic. In fact, concentrations of As(total), As(III) and As(V) in hair samples are correlated with the age of the exposed individuals from Illapata (R= 0.65, 0.69, 0.57, respectively) and with the time of residence in this village (R= 0.54, 0.71 and 0.58, respectively).     

Mobilization of aluminium and deposition on fish gills during sea salt episodes--catchment liming as countermeasure

Episodic events may be critical with respect to aluminium (Al) toxicity in moderately acidified salmon rivers. The present work demonstrates that sea salt episodes enhance the toxicity of Al in acidic rivers. The documented sea salt episode (300 [micro sign]M Cl) mobilized positively charged Al species (0.4 to 1.1 [micro sign]M Al(i)), enhanced the Al accumulation on fish gills (0.9 to 10 [micro sign]mol g(-1) dw) and caused increased stress responses (6 to15 mM blood glucose) in fish. Accumulated Al on gills remained high several days after the episode. The presented results are based on a six-week field study in two tributary rivers on the west coast of Norway. Changes in the river water qualities and Al speciation were followed using in situ fractionation techniques. Al accumulation on gills and stress responses were followed for Atlantic salmon (Salmo salar) kept in tanks continually exposed to the changing water quality. The potential mobilization of Al from the two catchments was studied by extracting soils with diluted seawater (salinity of 3). To counteract Al toxicity, one of the tributary catchments has been limed. The potential mobility of Al by sea salt was lower in limed soils compared to acid soils, and the Al deposition on fish gills (<3.5 [micro sign]mol g(-1) dw) and associated stress responses stayed low during the sea salt episode in the river draining the limed catchment. Thus, for acid river systems in coastal areas, catchment liming should be considered as a useful countermeasure for Al toxicity.     

Analysis of BTEX and other substituted benzenes in water using headspace SPME-GC-FID: method validation

The analysis of BTEX and other substituted benzenes in water samples using solid phase microextraction (SPME) and quantification by gas chromatography with flame ionization detection (GC-FID) was validated. The best analytical conditions were obtained using PDMS/DVB/CAR fibre using headspace extraction (HS-SPME) at 50 [degree]C for 20 min without stirring. The linear range for each compound by HS-SPME with GC/FID was defined. The detection limits for these compounds obtained with PDMS/DVB/CAR fibre and GC/FID were: benzene (15 ng L(-1)), toluene (160 ng L(-1)), monochlorobenzene (54 ng L(-1)), ethylbenzene (32 ng L(-1)), m-xylene (56 ng L(-1)), p-xylene (69 ng L(-1)), styrene (35 ng L(-1)), o-xylene (42 ng L(-1)), m-dichlorobenzene (180 ng L(-1)), p-dichlorobenzene (230 ng L(-1)), o-dichlorobenzene (250 ng L(-1)) and trichlorobenzene (260 ng L(-1)). This headspace SPME-GC-FID method was compared with a previously validated method of analysis using closed-loop-stripping analysis (CLSA). The headspace SPME-GC-FID method is suitable for monitoring the production and distribution of potable water and was used, in field trials, for the analysis of samples from main intakes of water (surface or underground) and from the water supply system of a large area (Lisbon and neighbouring municipalities).     

Competitive Retention of Lead and Cadmium on an Agricultural Soil

Lead and cadmium contamination of an agricultural soil has been studied using batch and column experiments. Thermodynamics of theretention phenomena may be represented by a Langmuir isotherm foran aqueous metal concentration up to 100 mg L^-1. First order kinetics with respect to the solid phase yield good predictabilityfor both batch and column experiments. Kinetics and thermodynamics of lead retention predominate over those ofcadmium. As a consequence, lead is preferentially retainedand can even displace sorbed cadmium. In the event of anspill involving both metals, cadmium would move further inthe soil and its aqueous concentration downstream could beeven higher than that of the influent solution, increasingpotential risks. A two-region model has been used to fit all the experimental results. Satisfactory predictions for column experiments are obtained with parameters which are consistent with those obtained for the batch experiments, for which sorption is described by a Langmuir isotherm including competitive retention.