Atmospheric polycyclic aromatic hydrocarbons (PAHs) in Asia: a review from 1999 to 2004

Polycyclic aromatic hydrocarbons (PAHs) are present in both gaseous and particulate phases. These compounds are considered to be atmospheric contaminants and are human carcinogens. Many studies have monitored atmospheric particulate and gaseous phases of PAH in Asia over the past 5 years. This work compares and discusses different sample collection, pretreatment and analytical methods. The main PAH sources are traffic exhausts (AcPy, FL, Flu, PA, Pyr, CHR, BeP) and industrial emissions (BaP, BaA, PER, BeP, COR, CYC). PAH concentrations are highest in areas of traffic, followed by the urban sites, and lowest in rural sites. Meteorological conditions, such as temperature, wind speed and humidity, strongly affect PAH concentrations at all sampling sites. This work elucidates the characteristics, sources and distribution, and the healthy impacts of atmospheric PAH species in Asia.     

温度及外加碳源对生物脱氮除磷过程的影响

针对污水处理厂普遍面临的进水碳源不足及冬季低温时出水氮磷不能稳定达标的问题,研究了温度(21、15和10℃)和外加碳源(乙酸)对活性污泥缺氧条件下反硝化及释磷过程的影响。结果表明,在缺氧条件下投加乙酸,释磷与反硝化反应可同时进行,且乙酸投量的增加仅延长快速碳源反硝化阶段及缺氧释磷阶段的反应时间;温度降低为15℃和10℃时,快速碳源反硝化阶段反硝化速率及缺氧释磷速率较21℃分别降低了约29.2%、42.2%和26.1%、32.3%。当硝态氮目标去除量与磷酸盐目标释放量之比超过5时,乙酸的最优投量以满足反硝化要求为准,计算得出21、15和10℃时常州某城镇污水处理厂乙酸最优投加量计算值约为30、39和46 mg/L。     

AERMOD在国内环境影响评价中的实例验证与应用

AERMOD是美国环保局推出的新一代空气质量模式系统,它由AERMET(气象数据预处理器)、AERMAP(地形数据预处理器)和AERMOD(大气扩散模型)3部分组成.结合宁波市北仑区域大气环境影响评价,对该模式系统进行模式验证,并应用于实际预测评价.验证结果表明,在采用适当的模型参数时,该系统预测值与实际监测值具有很好的一致性,SO2、NO2日均最高浓度预测准确率分别达到64.3%和85.7%.最后结合实际预测评价工作,提出AERMOD模式系统在国内环境影响评价工作中的优势及不足.     

SBR降解动力学研究

采用SBR工艺处理有机废水,在已有工艺条件下对生物降解动力学进行了研究,得出生物降解反应为一级反应。研究表明,用Monod公式能较好反映出有机物的降解规律,确定了其动力学参数V_max=14.6306 d^-1,K_s=83.2993 mg/L,得出SBR降解动力学模型为V=14.6306X·S/(83.2993+S)。利用以动力学为基础的动态模拟法优化SBR工艺,实验结果表明该方法合理可行,对SBR的设计与运行有一定的指导作用,可作为SBR反应器扩大实验和设计的依据。     

好氧颗粒污泥自生动态膜生物反应器处理碱减量印染废水

自生动态膜生物反应器(SFDMBR)接种颗粒污泥启动,研究溶解氧浓度和水力停留时间对该反应器处理碱减量印染废水的影响。自生动态膜生物反应器形成稳定的动态膜后,出水浊度小于10 NTU,系统对浊度的去除率在90%以上,溶解氧和水力停留时间对反应器出水浊度基本无影响。系统对废水色度的去除率随着溶解氧浓度的提高和水力停留时间的延长而增加,但是系统对色度的去除效率一般不超过40%。溶解氧浓度由0.3 mg/L逐渐增大至2.4 mg/L,COD的去除率由40%提升至80%,而当溶解氧浓度大于1.0 mg/L后,UV254的去除率达到95%。水力停留时间在8~48 h时,COD去除效率由65%逐渐上升至85%左右;水力停留时间在8~32 h,UV254去除效率为68%~93%,超过32 h后水力停留时间对UV254去除效率的影响已不明显。     

水产养殖废水处理技术及应用

主要综述了国内外水产养殖废水的物理化学处理和生物处理 2方面的技术 ,并总结了水产养殖废水循环使用的水处理工艺流程和生物工程在水产养殖废水处理中的应用 ,表明了水产养殖废水的综合利用和无害化排放技术为今后发展方向。     

Atmospheric bulk deposition of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in the vicinity of an iron and steel making plant

An IRA-743 resin bulk sampler was validated to monitor long-term bulk deposition of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). Six consecutive sampling campaigns (2008-2009) were conducted at four sites around steel complexes in Pohang, South Korea to investigate spatial and seasonal variations of PCDD/F bulk deposition. The bulk deposition within the steel complex showed the highest ∑_4-8PCDD/F (Tetra-Octa) fluxes, ranging from 204 to 608 (mean: 352) pg m⁻² d⁻¹, indicating steel complexes were major sources of PCDD/Fs. The homologue profiles were dominated with lower chlorinated PCDFs. Furthermore, the prevailing winds were confirmed to influence the spatial distribution of PCDD/F deposition. There were apparent seasonal variations of the bulk deposition at each site, and seasonal homologue patterns of PCDD/Fs were clearly observed. According to the passive air sampling, however, no significant seasonal change of ambient air concentrations of PCDD/Fs was observed. Therefore, it was concluded that the seasonal variations of deposition fluxes of PCDD/Fs probably resulted from temperature-dependent gas/particle partitioning.     

改性无纺布膜生物反应器处理聚酯工艺废水研究

采用自制壳聚糖改性聚丙烯无纺布膜为膜组件的A/O-MBR(厌氧/好氧-膜生物反应器)工艺对聚酯工艺废水的处理进行了研究,并与PVDF商品膜性能进行了比较研究。在近70 d的运行中,当进水COD在200~500 mg/L之间,总氮在30~45 mg/L之间波动时,2种平板膜出水水质稳定。出水COD40 mg/L,NH4+-N0.5 mg/L,TN5 mg/L,浊度0.2 NTU,均满足回用水水质要求和最新的辽宁省废水排放标准。实验中考察分析了污泥浓度和COD/TN对总氮去除率的影响。对比2种膜的运行结果,改性聚丙烯无纺布膜的出水水质略好于PVDF商品膜,但过膜压力稍大、膜通量稍小。     

硬质聚氨酯泡沫和组合聚醚中消耗臭氧层物质的便携式GC-MS测定方法

建立了便携式顶空/气相色谱-质谱法测定硬质聚氨酯泡沫和组合聚醚中一氟三氯甲烷（CFC-11）、二氟二氯甲烷（CFC-12）、二氟一氯甲烷（HCFC-22）及一氟二氯乙烷（HCFC-141b）的定性分析方法,系统考察了色谱柱、顶空体系、顶空温度和顶空时间对测定结果的影响。结果表明,DB-WAX色谱柱对目标物质的分离效果最好,顶空温度为50℃、顶空时间为10 min条件下,目标物质的检测灵敏度最高。在优化条件下,硬质聚氨酯泡沫取样体积为1 cm³时,4种目标物的方法检出限为0.6~0.8 μg;组合聚醚取样量为10 mg时,4种目标物的方法检出限为0.5~0.6 μg。该方法具有较高的灵敏度,定性准确,适用于实际样品的现场快速定性分析。     

南京市城郊蔬菜生产基地有机氯农药残留特征

以网格法在南京市无公害蔬菜生产基地八卦洲采集70个土壤样品,用加速溶剂萃取、固相萃取柱净化后GC-μECD测定土壤中有机氯农药(α-HCH,β-HCH,γ-HCH和δ-HCH以及o,p'-DDT,p,p'-DDT,o,p'-DDE,p,p'-DDE 和p,p'-DDD)残留量.结果表明,土壤中有机氯农药残留总量在6.18～84.72 μg·kg-1之间,平均18.63 μg·kg-1.DDT残留量高于HCH,为3.36～74.19 μg·kg-1,平均12.61 μg·kg-1.土壤中HCH残留量为2.48～17.80 μg·kg-1,平均6.02 μg·kg-1.DDT同系物中以p,p'-DDE和p,p'-DDT为主,而HCH中δ-HCH含量较低,其他3种异构体含量水平相当.所有土样中DDT和HCH残留量均远远低于GB/T 18407 无公害蔬菜产地土壤标准限定值500 μg·kg-1,但大多数土样中DDT和HCH残留量远远高于荷兰无污染土壤标准.