Geo-accumulation index and contamination factors of heavy metals (Zn and Pb) in urban river sediment

The aim of the present study was to appraise the levels of heavy metal contamination (Zn and Pb) in sediment of the Langat River (Selangor, Malaysia). Samples were collected randomly from 15 sampling stations located along the Langat River. The parameters measured were pH, redox potential, salinity, electrical conductivity, loss of ignition, cation exchanges capacity (Na, Mg, Ca, K), and metal ions (Zn and Pb). The geo-accumulation index (I _geo) and contamination factor (C _f) were applied to determine and classify the magnitude of heavy metal pollution in this urban river sediment. Results revealed that the I _geo of Pb indicated unpolluted to moderately polluted sediment at most of the sampling stations, whereas Zn was considered to be within background concentration. The I _geo results were refined by the C _f values, which showed Pb with very high C _f at 12 stations. Zinc, on the other hand, had low to moderate C _f values. These findings indicated that the sediment of the Langat River is severely polluted with Pb. The Zn concentration at most sampling points was well below most sediment quality guidelines. However, 40% of the sampling points were found to have a Pb concentration higher than the consensus-based probable effect concentration of 128 mg/kg (concentrations above this value are likely to cause harmful effects). This result not only highlights the severity of Pb pollution in the sediment of the Langat River, but also the potential risk it poses to the environment.     

Occupational exposure

Concentrations of polychlorinated biphenyls (PCB), polychlorinated naphthalenes (PCN), polychlorinated dibenzo-p-dioxins (PCDD), polychlorinated dibenzofurans (PCDF), hexachlorobenzene and methylsulphonyl metabolites of PCB were determined in blood plasma from potentially exposed workers and controls. Three of the potentially exposed subjects had worked with cable incineration and two were electricians. Extraction of the organochlorine compounds and lipids were performed using the lipophilic gel Lipidex. Different adsorbents and gel permeation chromatography were applied for further purification of the samples and separation of analytes. Determinations of the chlorinated compounds were made by using gas chromatography with electron-capture detection and gas chromatography-mass spectrometry. Only small differences in the concentrations of organochlorine compounds were found in the plasma from the three subject groups. Thus, specific exposure of the workers could not be confirmed.     

Evaluation of kinetics and mechanism properties of CO2 adsorption onto the palm kernel shell activated carbon

Environmental Science and Pollution Research - The volumetric adsorption kinetics of carbon dioxide (CO2) onto the synthesized palm kernel shell activated carbon via single-stage CO2 activation and...     

Carbon emissions from the peat fire problem—a review

Environmental Science and Pollution Research - Peat fires in tropical peatland release a substantial amount of carbon into the environment and cause significant harm to peatlands and the ecology,...     

Levels of heavy metals (Zn,Cu, Cd,and Pb) in mudskippers (Periophthalmodon schlosseri) and sediments collected from intertidal areas at Morib and Remis,Peninsular Malaysia

The concentrations of Zn, Cu, Cd, and Pb were determined in different tissues of mudskipper fishes Periophthalmodon schlosseri caught at two selected locations (Morib and Remis) of the intertidal mudflat area of Selangor state, West Coast of Peninsular Malaysia and in surface sediment samples. Metal concentrations in the mudskipper tissue and in the sediment samples tended to vary significantly (p < 0.05) between the two locations. Higher metal concentrations (except for Zn) were mostly found in the tissues of mudskippers from Remis. For sediment samples, significantly (p < 0.05) higher metal concentrations of all metals were also found at Remis. Generally, metal distribution between different tissues of mudskipper varied with scales being highly accumulative of Zn, Cd, and Pb, while for Cu, the highest mean concentrations were found in the liver. The lowest mean concentrations of Zn, Cu, and Cd were found in the muscles except for Pb, which was lowest in the liver. This study suggests that mudskippers can be potential biomonitoring organisms for heavy metal bioavailability and contamination of intertidal coastal mudflats. The concentrations of Cd and Pb were slightly above the acceptable limits of Malaysian and European food safety guidelines.     

Critical success factors of sustainable manufacturing practices in Malaysian automotive industry

The purpose of this study is to examine the critical success factors of sustainable manufacturing practices (SMPs) in Malaysian automotive industry. The questionnaires were designed and distributed to the 50 respondents. The pilot study sample consists of 26 respondents from 50 questionnaires, with an average response rate of 52%. The results of reliability analysis show that social responsibility is critical factor influencing the direct SMPs implementation success. By implementing SMPs in Malaysian automotive industry, it can assist company to improve the quality of management. Thus, this study recommends that the future research explore the influence of SMPs on sustainable performance in Malaysian automotive industry.     

Monotonic aspects of the mechanical behaviour of bottom ash from municipal solid waste incineration and its potential use for road construction

Municipal solid waste incineration (MSWI) bottom ash is an atypical granular material because it may include industrial by-products that result from the incineration of domestic waste. The prospects for the beneficial use of this particular material mainly lie in the field of road construction, as a substitute for the traditional natural aggregates. However, its mechanical properties are still little known, particularly in term of stiffness and deformability, characteristics that are essential to the construction of a durable roadway. The purpose of this paper is to describe better the mechanical behaviour of this recycled material. In order to reach this objective, a large experimental campaign is presented. The first part of this paper presents and comments in detail on the results obtained from static monotonic tests. Oedometric and triaxial shear tests were performed on MSWI bottom ash both before and after treatment with a specific hydraulic binder. These tests allow specification of the mechanical characteristics of the MSWI bottom ash, such as the initial Young's modulus, Poisson's ratio, the compressibility index, the friction angle, and the contracting or dilating behaviour of the material. The results reveal a mechanical behaviour similar to that of initially dense standard materials (sands, unbound granular materials) and a dependence on the applied average pressure, characteristic of the mechanical behaviour of granular media. More laboratory data on other samples of MSWI bottom ash are required to ensure that this comparison is statistically valid.     

Enhancement of Tensile Strength and Flexibility of Polycaprolactone/Tapioca Starch Blends by Octadecylamine Modified Clay

Polycaprolactone/tapioca starch/octadecylamine modified clay (OMMT) nanocomposites were successfully prepared by melt blending. X-ray diffraction and transmission electron microscopy (TEM) of the products showed that they are nanocomposites of a mixture intercalated and exfoliated types. In addition, the TEM also revealed that the OMMT layers are homogeneously distributed in the polymer matrix. The presence of 1 php of OMMT improved the compatibility of the polymers in the blends which consequently increased the tensile strength of the blend of more than 60% and elongation at break of more than 1,000%.     

Prediction of total bed material load for rivers in Malaysia: A case study of Langat,Muda and Kurau Rivers

A soft computational technique is applied to predict sediment loads in three Malaysian rivers. The feed forward-back propagated (schemes) artificial neural network (ANNs) architecture is employed without any restriction to an extensive database compiled from measurements in Langat, Muda, Kurau different rivers. The ANN method demonstrated a superior performance compared to other traditional sediment-load methods. The coefficient of determination, 0.958 and the mean square error 0.0698 of the ANN method are higher than those of the traditional method. The performance of the ANN method demonstrates its predictive capability and the possibility of generalization of the modeling to nonlinear problems for river engineering applications.