Gloves against mineral oils and mechanical hazards: composites of carboxylated acrylonitrile–butadiene rubber latex

Resistance to permeation of noxious chemical substances should be accompanied by resistance to mechanical factors because the glove material may be torn, cut or punctured in the workplace. This study reports on glove materials, protecting against mineral oils and mechanical hazards, made of carboxylated acrylonitrile–butadiene rubber (XNBR) latex. The obtained materials were characterized by a very high resistance of the produced materials to oil permeation (breakthrough time?>?480?min). The mechanical properties, and especially tear resistance, of the studied materials were improved after the addition of modified bentonite (nanofiller) to the XNBR latex mixture. The nanocomposite meets the requirements in terms of parameters characterizing tear, abrasion, cut and puncture resistance. Therefore, the developed material may be used for the production of multifunctional protective gloves.     

Impact of environmental factors on the sampling rate of β-blockers and sulfonamides from water by a carbon nanotube-passive sampler

Passive techniques are a constantly evolving approach to the long-term monitoring of micropollutants, including pharmaceuticals, in the aquatic environment. This paper presents, for the first time, the calibration results of a new CNTs-PSDs (carbon nanotubes used as a sorbent in passive sampling devices) with an examination of the effect of donor phase salinity, water pH and the concentration of dissolved humic acids (DHAs), using both ultrapure and environmental waters. Sampling rates (R_s) were determined for the developed kinetic samplers. It has been observed that the impact of the examined environmental factors on the R_s values strictly depends on the type of the analytes. In the case of β-blockers, the only environmental parameter affecting their uptake rate was the salinity of water. A certain relationship was noted, namely the higher the salt concentration in water, the lower the R_s values of β-blockers. In the case of sulfonamides, water salinity, water pH 7–9 and DHAs concentration decreased the uptake rate of these compounds by CNTs-PSDs. The determined R_s values differed in particular when the values obtained from the experiments carried out using ultrapure water and environmental waters were compared. The general conclusion is that the calibration of novel CNTs-PSDs should be carried out under physicochemical conditions of the aquatic phase that are similar to the environmental matrix.     

Polycyclic aromatic hydrocarbons in pine and spruce shoots-temporal trends and spatial distribution

In the framework of the German environmental specimen bank one-year old spruce shoots (Picea abies) and pine shoots (Pinus sylvestris) serve as bioindicators for the atmospheric pollution. Sampling is performed in two urbanized areas in western and eastern Germany (Warndt and Duebener Heide, respectively), and in seven different rural locations. Prior to archiving conifer shoots are continuously analyzed for a set of 17 individual polycyclic aromatic hydrocarbons (PAHs). The results from the two urbanized areas show that the atmospheric contamination with PAH has declined by about 75% between 1985 and 2004 at Warndt and by about 85% between 1991 and 2004 at Duebener Heide. However, summation operatorPAH concentrations stayed virtually constant at both locations since the end of the 1990s at levels of about 100 ng g(-1) wet weight (ww). In spruce shoots from rural areas current concentrations of PAHs are significantly lower and vary between 8 and 61 ng g(-1) ww. In all shoot samples the four low molecular aromatics phenanthrene, fluoranthene, pyrene, and chrysene dominate the pattern by contributing 60 to 90% to summation operatorPAH. The group of high molecular weight aromatics is dominated by benzo[b,j,k]fluoranthene, especially in spruce shoots originating from greater altitudes remarkable amounts of six and seven ringed PAHs could be detected. Despite the strong decrease of PAH concentrations in urban areas patterns of aromatics remained nearly unchanged in the observation period 1985 to 2004.     

Assessment of risk to aquatic biota from elevated salinity -- a case study from the Hunter River, Australia

A linear engineering project--i.e. a pipeline--has a potential long- and short-term impact on the environment and on the inhabitants therein. We must find better, less expensive, and less time-consuming ways to obtain information on the environment and on any modifications resulting from anthropic activity. We need scientifically sound, rapid and affordable assessment and monitoring methods. Construction companies, industries and the regulating government organisms lack the resources needed to conduct long-term basic studies of the environment. Thus there is a need to make the necessary adjustments and improvements in the environmental data considered useful for this development project. More effective and less costly methods are generally needed. We characterized the landscape of the study area, situated in the center and north-east of Argentina. Little is known of the ecology of this region and substantial research is required in order to develop sustainable uses and, at the same time, to develop methods for reducing impacts, both primary and secondary, resulting from anthropic activity in this area. Furthermore, we made an assessment of the environmental impact of the planned linear project, applying an ad hoc impact index, and we analyzed the different alternatives for a corridor, each one of these involving different sections of the territory. Among the alternative corridors considered, this study locates the most suitable ones in accordance with a selection criterion based on different environmental and conservation aspects. We selected the corridor that we considered to be the most compatible--i.e. with the least potential environmental impact--for the possible construction and operation of the linear project. This information, along with suitable measures for mitigating possible impacts, should be the basis of an environmental management plan for the design process and location of the project. We pointed out the objectivity and efficiency of this methodological approach, along with the possibility of integrating the information in order to allow for the application thereof in this type of study.     

Levoglucosan and other cellulose and lignin markers in emissions from burning of Miocene lignites

Levoglucosan (L), mannosan (M), galactosan (G) and other cellulose and lignin markers from burn tests of Miocene lignites of Poland were determined by gas chromatography–mass spectrometry (GC–MS) to assess their distributions and concentrations in the smoke. Their distributions were compared to those in the pyrolysis products of the lignites. Levoglucosan and other anhydrosaccharides are products from the thermal degradation of cellulose and hemicellulose and are commonly used as tracers for wood smoke in the atmosphere. Here we report emission factors of levoglucosan in smoke particulate matter from burning of lignite varying from 713 to 2154 mg kg^?1, which are similar to those from burning of extant plant biomass. Solvent extracts of the lignites revealed trace concentrations of native levoglucosan (0.52–3.7 mg kg^?1), while pyrolysis yielded much higher levels (1.6–3.5 × 10⁴ mg kg^?1), indicating that essentially all levoglucosan in particulate matter of lignite smoke is derived from cellulose degradation. The results demonstrate that burning of lignites is an additional input of levoglucosan to the atmosphere in regions where brown coal is utilized as a domestic fuel. Interestingly, galactosan, another tracer from biomass burning, is not emitted in lignite smoke and mannosan is emitted at relatively low concentrations, ranging from 7.8 to 70.5 mg kg^?1. Thus, we propose L/M and L/(M + G) ratios as discriminators between products from combustion of lignites and extant biomass. In addition, other compounds, such as shonanin, belonging to lignans, and some saccharides, e.g., α- and β-glucose and cellobiose, are reported for the first time in extracts of bulk lignites and of smoke particulate matter from burning these lignites.     

Variations of arsenic species content in edible Boletus badius growing at polluted sites over four years

The content of arsenic (As) in mushrooms can vary depending on the concentration level of this metalloid in the soil/substrate. The present study evaluated the content of arsenic in Boletus badius fruiting bodies collected from polluted and non-polluted sites in relation to the content of this element in overgrown substrate. It was found that mushrooms from the arsenic-polluted sites contained mean concentrations from 49 to 450 mg As kg^?1 dry matter (d.m.), with the greatest content found for specimens growing in close proximity of sludge deposits (490±20 mg As kg^?1d.m.). The mean content of total arsenic in mushrooms from clean sites ranged from 0.03 to 0.37 mg kg^?1 It was found that B. badius could tolerate arsenic in soil substrate at concentrations of up to 2500 mg kg^?1, at least. In different years of investigation, shifts in particular arsenic forms, as well as a general increase in the accumulation of organic arsenic content, were observed. The results of this study clearly indicate that B. badius should not be collected for culinary purposes from any sites that may be affected by pollution.     

Implication of zinc excess on soil health

This study was undertaken to evaluate zinc's influence on the resistance of organotrophic bacteria, actinomyces, fungi, dehydrogenases, catalase and urease. The experiment was conducted in a greenhouse of the University of Warmia and Mazury (UWM) in Olsztyn, Poland. Plastic pots were filled with 3 kg of sandy loam with pH_KCl – 7.0 each. The experimental variables were: zinc applied to soil at six doses: 100, 300, 600, 1,200, 2,400 and 4,800 mg of Zn²⁺ kg^?1 in the form of ZnCl₂ (zinc chloride), and species of plant: oat (Avena sativa L.) cv. Chwat and white mustard (Sinapis alba) cv. Rota. Soil without the addition of zinc served as the control. During the growing season, soil samples were subjected to microbiological analyses on experimental days 25 and 50 to determine the abundance of organotrophic bacteria, actinomyces and fungi, and the activity of dehydrogenases, catalase and urease, which provided a basis for determining the soil resistance index (RS). The physicochemical properties of soil were determined after harvest. The results of this study indicate that excessive concentrations of zinc have an adverse impact on microbial growth and the activity of soil enzymes. The resistance of organotrophic bacteria, actinomyces, fungi, dehydrogenases, catalase and urease decreased with an increase in the degree of soil contamination with zinc. Dehydrogenases were most sensitive and urease was least sensitive to soil contamination with zinc. Zinc also exerted an adverse influence on the physicochemical properties of soil and plant development. The growth of oat and white mustard plants was almost completely inhibited in response to the highest zinc doses of 2,400 and 4,800 mg Zn²⁺ kg^?1.     

The variations of aluminium species in mountainous forest soils and its implications to soil acidification

Aluminium (Al) speciation is a characteristic that can be used as a tool for describing the soil acidification process. The question that was answered is how tree species (beech vs spruce) and type of soil horizon affect Al speciation. Our hypotesis is that spruce and beech forest vegetation are able to modify the chemical characteristics of organic horizon, hence the content of Al species. Moreover, these characteristics are seasonally dependent. To answer these questions, a detailed chromatographic speciation of Al in forest soils under contrasting tree species was performed. The Jizera Mountains area (Czech Republic) was chosen as a representative mountainous soil ecosystem. A basic forestry survey was performed on the investigated area. Soil and precipitation samples (throughfall, stemflow) were collected under both beech and spruce stands at monthly intervals from April to November during the years 2008–2011. Total aluminium content and Al speciation, pH, and dissolved organic carbon were determined in aqueous soil extracts and in precipitation samples. We found that the most important factors affecting the chemistry of soils, hence content of the Al species, are soil horizons and vegetation cover. pH strongly affects the amount of Al species under both forests. Fermentation (F) and humified (H) organic horizons contain a higher content of water extractable Al and Al³⁺ compared to organo-mineral (A) and mineral horizons (B). With increasing soil profile depth, the amount of water extractable Al, Al³⁺ and moisture decreases. The prevailing water-extractable species of Al in all studied soils and profiles under both spruce and beech forests were organically bound monovalent Al species. Distinct seasonal variations in organic and mineral soil horizons were found under both spruce and beech forests. Maximum concentrations of water-extractable Al and Al³⁺ were determined in the summer, and the lowest in spring.     

Assessment of genotoxic effects of lead in occupationally exposed workers

The genotoxicological effects in 200 lead acid storage battery recycling and manufacturing industry workers in Hyderabad along with matched 200 controls were studied. The genetic damage was determined by comet, micronucleus (MN), and chromosomal aberration (CA) test in peripheral blood lymphocytes (PBL). The MN test was also carried out in buccal epithelial cells (BECs). Pb in ambient air, blood Pb (B-Pb) concentrations, and hematological parameters were measured. The superoxide dismutase (SOD), catalase (CAT), glutathione (GSH), glutathione peroxidase (GPx), and malondialdehyde (MDA) formed were also studied. The results of the present study showed that there was a statistically significant (P?P?GPx, and CAT levels were significantly decreased while GSH and MDA levels increased in exposed group when compared to control group. The present study suggests that environmental health standards should be enforced to control Pb contamination from battery industries to reduce human health risk.