Fast firing of tiles containing paper mill sludge, glass cullet and clay

The paper describes results obtained in the development of a previous research. We study here, in fast firing, the sintering behaviour and measure some properties of tiles containing a mixture of 60 wt% of paper mill sludge and 40 wt% of glass cullet. The behaviour of this material is compared to those displayed by materials obtained by the same mixture added with 10, 20 and 30 wt% of a natural red clay. In parallel, the same properties are measured also on a reference blend, which is presently used to produce commercial tiles. We show that powders containing 60 wt% of paper sludge and 40 wt% of glass cullet to which 30 wt% of clay is added give rise to materials that display a stable sintering process and have good hardness and strength and therefore could be used for the industrial production of tiles.     

Anoxic-aerobic treatment of the liquid fraction of cattle manure

Cattle manure from a dairy farm was treated in order to reduce its pollution potential. The manure came from a farm with 120 cows kept in stables in a free stall barn. As pretreatment, the manure is usually filtered on the farm using a screw press separator with a 0.5 mm mesh. Approximately 70% of the total filtered volume passes through the screen, thus constituting the liquid fraction. This fraction, with a composition of around 64,500 mg COD/l, 5770 mg total-N/l and 800 mg total-P/l, was subjected to centrifugation followed by a two-step biological treatment (anoxic-aerobic) to reduce organic matter (COD), nitrogen and phosphorus compounds. Centrifugation led to the following removal efficiencies: 35% total solids, 60% COD, 75% total phosphorus and 20% total nitrogen (mainly organic nitrogen). With the subsequent anoxic-aerobic treatment, average removal efficiencies of 85% for COD, 90% for total phosphorus and 75% for total nitrogen were achieved.     

Monsoon-induced changes in the size-fractionated phytoplankton biomass and production rate in the estuarine and coastal waters of southwest coast of India

Changes in the autotrophic pico- (0.2–2 μm), nano- (2–20 μm), and microplankton (>20 μm) biomass (chlorophyll a) and primary production were measured in the estuarine and coastal waters off Cochin, southwest coast of India during the onset and establishment of a monsoon. During this period, the estuary was dominated by nutrient-rich freshwater, whereas the coastal waters were characterized with higher salinity values (>30 psu) and less nutrients. The average surface chlorophyll a concentrations and primary production rates were higher in the estuary (average 13.7 mg m^???3 and 432 mgC m^???3 day^???1) as compared to the coastal waters (5.3 mg m^???3 and 224 mgC m^???3 day^???1). The nanoplankton community formed the major fraction of chlorophyll a and primary production, both in the estuary (average 85 ± SD 8.3% and 81.2 ± SD 3.2%) and the coastal waters (average 73.2 ± SD 17.2% and 81.9 ± 15.7%). Nanoplankton had the maximum photosynthetic efficiency in the coastal waters (average 4.8 ± SD 3.9 mgC mgChl a m^???3 h^???1), whereas in the estuary, the microplankton had higher photosynthetic efficiency (average 7.4 ± 7 mgC mgChl a m^???3 h^???1). The heavy cloud cover and increased water column turbidity not only limit the growth of large-sized phytoplankton in the Cochin estuary and coastal waters but also support the proliferation of nanoplankton community during the monsoon season, even though large variation in nanoplankton chlorophyll a and production exists between these two areas.     

Comparison of different collection systems for sorted household waste in Sweden

Composition and quantity per person of municipal solid waste (MSW) have been analyzed in six municipalities in southern Sweden with similar socio-economic conditions but with different collection systems. Samples of residual waste have been sorted, classified and weighed in 21 categories during 26 analyses that took place from 1998-2004. Collection data of the total waste flow, including source sorted recycling materials, in the same area have been compiled and compared. Multivariate data analyses have been applied. Weight-based billing reduced delivered amounts of residual household waste by 50%, but it is unknown to what extent improper material paths had developed. With curbside collection more metal, plastic and paper packaging was separated and left to recycling. When separate collection of biodegradables was included in the curbside system, the overall sorting of dry recyclables increased. The large uncertainty associated with waste composition analyses makes it difficult to draw strong conclusions regarding the effects on specific recyclables or the changes in the composition of the residual waste.     

Management of MSW in Spain and recovery of packaging steel scrap

Packaging steel is more advantageously recovered and recycled than other packaging material due to its magnetic properties. The steel used for packaging is of high quality, and post-consumer waste therefore produces high-grade ferrous scrap. Recycling is thus an important issue for reducing raw material consumption, including iron ore, coal and energy. Household refuse management consists of collection/disposal, transport, and processing and treatment - incineration and composting being the most widely used methods in Spain. Total Spanish MSW production exceeds 21 million tons per year, of which 28.1% and 6.2% are treated in compost and incineration plants, respectively. This paper presents a comprehensive study of incineration and compost plants in Spain, including a review of the different processes and technologies employed and the characteristics and quality of the recovered ferrous scrap. Of the total amount of packaging steel scrap recovered from MSW, 38% comes from compost plants and 14% from incineration plants. Ferrous scrap from incineration plants presents a high degree of chemical alteration as a consequence of the thermal process to which the MSW is subjected, particularly the conditions in which the slag is cooled, and accordingly its quality diminishes. Fragmentation and magnetic separation processes produce an enhancement of the scrap quality. Ferrous scrap from compost plants has a high tin content, which negatively affects its recycling. Cleaning and detinning processes are required prior to recycling.     

Leachate recirculation effects on waste degradation: study on columns

The purpose of this study is to determine the impact of leachate recirculation on the degradation of municipal solid wastes (bioreactor concept). The study was carried out using columns containing approximately 50 kg of waste, in order to follow waste degradation over a limited time. Three types of waste were studied: fresh waste of standard composition, fresh waste of fermentable composition and some 8-yr-old waste extracted from a site in France. Measurement of the global parameters, such as chemical oxygen demand (COD), volatile acidity, alkalinity, leachate conductivity, methane potential of the wastes and biogas production monitoring (volume of CO2 and CH4 produced), were carried out. The quantity of oxydizable matter and biogas production was increased by the leachate recirculation, and the duration of the first degradation phases was reduced in all cases. Chloride, ammonium and organic pollution accumulation was observed according to the duration of recirculation. After 400 days of degradation, waste stabilization seemed to be reached for all of the recirculated columns (COD<300 mg/L O2, and methane potential reached).     

Diel cycles of arsenic speciation due to photooxidation in acid mine drainage from the Iberian Pyrite Belt (Sw Spain)

Twenty four hours diel cycles of arsenic speciation in Acid Mine Drainage (AMD) due to photooxidation have been reported for the first time. AMD samples were taken during 48 h (31st March and 1st April, 2005) at 6 h intervals from the effluent of a massive abandoned polymetallic sulphide mine of the Iberian Pyrite Belt (Sw Spain). Samples were preserved in situ using cationic exchange prior to analysis by coupled high performance liquid chromatography, hydride generation and atomic fluorescence spectrometry (HPLC-HG-AFS) for arsenic speciation. The results indicated the presence of inorganic arsenic species with daily means of 262mugl(-1) for As(V) and 107 microg l(-1) for As(III). No marked diel trend was observed for As(V). However, a marked diel trend was observed for As(III) in the two studied days, with maximum concentrations during nighttime (141-143 microg l(-1)) and minimum concentrations at daytime (72-77 microg l(-1)). This difference in concentration during daytime and nighttime is ca. 100%. A similar diel cycle was observed for iron. An explanation for the arsenic diel cycles observed is the light induced photooxidation of As(III) and the elimination of As(V) due to its adsorption onto Fe precipitates during the daytime. Furthermore, the diel changes in arsenic speciation emphasize the importance of designing suitable sampling strategies in AMD systems.     

Combustion characteristics of Malaysian municipal solid waste and predictions of air flow in a rotary kiln incinerator

Malaysia is in dire need of alternatives to landfilling for solid waste management. Recently, landfills have faced the problems of overfilling, overflowing of leachates leading to pollution of water resources, and uncontrolled dust emissions adversely affecting the local environment. With the rising cost of urbanization coupled with the high rate of waste generation, one possible method of waste treatment that is receiving particular attention by the government is incineration. Incineration of solid waste is rather new in Malaysia, with limited usage in handling small sources of waste generation such as the municipal solid waste (MSW) of resort islands; however, its potential in ameliorating the problems associated with solid waste treatment may make it an attractive alternative to landfill. This article presents the results of test runs conducted to investigate the performance of a locally designed and manufactured rotary kiln incinerator (RKI). The test runs were conducted using MSW collected from the Shah Alam municipality. The combustion efficiency was analyzed by looking at the temperature profiles and chemical species concentrations. To complement the combustion characteristics measurements, predictions of the air flow in the incinerator during the process were also investigated. The overall performance of the RKI suggests that it is suitable for treating MSW.     

Lysimeter Experiments to Investigate the Fate of Chemicals in Soils – Comparison of Five Different Lysimeter Systems

Several lysimeter scenarios and approaches exist to study the fate of agro-chemicals or contaminants from deposition in soil columns. In many systems just transport and leaching of the parent compound is followed, in some systems the leaching and transport of the metabolites is investigated as well. In more sophisticated lysimeter systems the volatilization and also the mineralization of the applied chemicals can be additionally monitored. Depending on the lysimeter system used and on the fact whether the applied chemicals are ¹⁴C-labeled or not, different results and various interpretations of the results might be achieved. Different lysimeter systems are described in this paper and a real dataset of a specific lysimeter experiment was transferred and evaluated in a virtual approach in the different lysimeter systems in order to show the advantages and disadvantages of the various systems.     

A Systematic Test of an Enterprise Strategy for Community-Based Biodiversity Conservation

Abstract: A commonly held belief is that if people can benefit financially from enterprises that depend on nearby forests, reefs, and other natural habitats, then they will take action to conserve and sustainably use them. The Biodiversity Conservation Network brought together conservation and development organizations and local communities to systematically test this hypothesis across 39 conservation project sites in Asia and the Pacific. Each project implemented one or more community-based enterprises such as setting up an ecotourism lodge, distilling essential oils from wild plant roots, producing jams and jellies from forest fruits, harvesting timber, or collecting marine samples to test for pharmaceutical compounds. Each project team collected the biological, enterprise, and social data necessary to test the network's hypothesis. We present the results of this test. We found that a community-based enterprise strategy can lead to conservation, but only under limited conditions and never on its own. We summarize the specific conditions under which an enterprise strategy will and will not work in a decision chart that can be used by project managers to determine whether this strategy might make sense at their site. We also found that an enterprise strategy can be subsidized and still create a net gain that pays for conservation. Based on our experiences, we recommend developing "learning portfolios" that combine action and research to test other conservation strategies.