The field experiments and model of the natural dust deposition effects on photovoltaic module efficiency

Environmental Science and Pollution Research - The maximisation of the efficiency of the photovoltaic system is crucial in order to increase the competitiveness of this technology. Unfortunately,...     

Physiological–biochemical properties of blue mussel Mytilus edulis adaptation to oil contamination

Bivalves have a known ability to accumulate different contaminants from ambient water and can therefore serve as bioindicators. The paper analyses certain biochemical and physiological parameters of blue mussels in response to varying oil product concentrations. The heart rate (HR) of blue mussels from the sublittoral zone exposed to different levels of oil products was investigated in a long-term experiment using non-invasive monitoring. A sharp rise in HR was observed at oil concentrations of 8.0 and 38.0 mg/l. A decreasing in mussel HR under the effect of lower concentrations (0.4 and 1.9 mg/l) was significant on the fourth day. Strong fluctuations of the cardiac activity were noted under all concentrations. After 6 days of oil treatment, tissues of the mussels were sampled to determine the total lipid composition. Low concentrations of oil products produced no reliable changes in the lipid composition whereas high concentrations induced significant changes in the ratio of lipid components (cholesterol and phospholipids).     

A pilot study on the determination of perfluorooctanesulfonate and other perfluorinated compounds in blood of Canadians

A pilot study was conducted to provide preliminary data on the concentrations of perfluorooctanesulfonate (PFOS), perfluorooctanoic acid (PFOA) and perfluorooctanesulfonamide (PFOSA) in the blood of Canadians. A set of 56 human serum samples was collected from non-occupationally exposed Canadians and analyzed by microbore HPLC-negative ion electrospray tandem mass spectrometry. PFOS was the main component of perfluorinated organic compounds (PFCs) and was detected in all 56 blood specimens at an average concentration of 28.8 ng mL(-1) and a range from 3.7 to 65.1 ng mL(-1). The concentration of PFOA was an order of magnitude lower than that of PFOS and was found only in 16 samples (29%) at concentrations above the limit of quantification (LOQ). PFOSA was not detected at levels above the method detection limit (MDL) in any of the samples. The levels of PFCs observed in the sample group of non-occupationally exposed humans in Canada were similar to the levels reported in a previous US study with a similar sample pool size. Two distinct PFOS isomers in human serum were identified by accurate mass determination.     

Arsenic, chromium and mercury removal using mussel shell ash or a sludge/ashes waste mixture

Different batches of valued mussel shell and waste mussel shell ash are characterised. Shell ash has pH?>?12 and high electrical conductivities (between 16.01 and 27.27 dS?m^?1), while calcined shell shows pH values up to 10.7 and electrical conductivities between 1.19 and 3.55 dS?m^?1. X-ray fluorescence, nitric acid digestion and water extractions show higher concentrations in shell ash for most parameters. Calcite is the dominant crystalline compound in this ash (95.6 %), followed by aragonite. Adsorption/desorption trials were performed for mussel shell ash and for a waste mixture including shell ash, sewage sludge and wood ash, showing the following percentage adsorptions: Hg(II) >94 %, As(V) >96 % and Cr(VI) between 11 and 30 % for shell ash; Hg(II) >98 %, As(V) >88 % and Cr(VI) between 30 and 88 % for the waste mixture. Hg and As desorption was <5 % for both shell ash and the waste mixture, while Cr desorption was between 92 and 45 % for shell ash, and between 19 and 0 % for the mixture. In view of that, mussel shell ash and the mixture including shell ash, sewage sludge and wood ash could be useful for Hg(II) and As(V) removal.     

As(V) retention on soils and forest by-products and other waste materials

As(V) retention capacity is determined by means of adsorption/desorption trials performed for coarse and fine ground mussel shell, forest and vineyard soils with or without fine shell, pine wood ash, oak wood ash, pine sawdust and slate-processing fines. Pine ash shows the highest arsenic retention potential (with >97 % adsorption and ≤1 % desorption), followed by shell-amended forest soil (adsorption between 96 and 92 %), by un-amended forest soil (adsorption between 98 and 86 %) and by the amended vineyard soil (adsorption between 92 and 75 %). Sawdust is the material with the lowest arsenic retention capacity in most cases, with un-amended vineyard soil also showing poor results. In the case of oak ash, As(V) percentage adsorption becomes higher with increasing added arsenic concentrations, while this increase in added arsenic causes lower percentage adsorption in the case of slate fines. Regarding adsorption ability, As(V) adsorption data were fitted to Freundlich and Langmuir models, showing good fitting, with pine ash and shell-amended forest soil having the highest K _F values. In view of that, mussel shell amendment would be useful to increase arsenic retention on forest and vineyard soils, while pine ash could be used to retain arsenic even from wastewaters.     

Polychlorinated biphenyls (PCBs) and Polybrominated Diphenyl ethers (PBDEs) in three fish species from an estuary in the southeastern coast of Brazil

Polychlorinated biphenyls (PCBs) and Polybrominated Diphenyls Ethers (PBDEs) are two highly lipophilic classes of persistent organic pollutants able to resist degradation and with the ability to bioaccumulate through the food chain. In Brazil, there are still few studies on PCBs and PBDEs in aquatic organisms. In this study, we determined the levels of PBDEs and PCBs in three different fish species from the Ilha Grande Bay, located in the southern state of Rio de Janeiro, Brazil. PBDEs levels were very low, with values below the limit of quantification. PCBs concentrations ranged from 2.29 to 27.60 ng g^?1 ww in muscle and from 3.41 to 34.22 ng g^?1 ww in liver of the three investigated fish species. Significant positive correlations were established between PCBs concentration and fish biometric variables in mullet (length and lipid content) and a statistically significant change between seasons in croaker was observed.     

Volatile carbonylic compounds in downtown Santiago, Chile

Formaldehyde, acetaldehyde, acetone, propanal, butanal, 2-butenal, 3-methylbutanal, hexanal, benzaldehyde, 2-methylbenzaldehyde, and 2,5-dimethylbenzaldehyde were measured during six spring days at downtown Santiago de Chile. Measurements were performed 24h/day and averaged over three hour periods. The averages of the maxima (ppbv) were, formaldehyde: 3.9+/-1.4; butanal: 3.3+/-3.4; acetaldehyde: 3.0+/-0.9; acetone: 2.4+/-1.0; 2-butenal: 0.56+/-0.52; propanal: 0.46+/-0.21; benzaldehyde: 0.34+/-0.3; 3-butanal: 0.11+/-0.05; hexanal: 0.11+/-0.08; 2-methylbenzaldehyde: 0.08+/-0.05; 2,5-dimethylbenzaldehyde: 0.05+/-0.03. Aliphatic aldehydes (C1-C3) are strongly correlated among them and weakly with primary (toluene) and secondary (ozone plus nitrogen dioxide or PAN) pollutants. In particular, the correlation between acetaldehyde and propanal values remains even if diurnal and nocturnal data are considered separately, indicating similar sources. All these aldehydes present maxima values in the morning (9-12h) and minima at night (0-3h). The best correlation is observed when butanal and 2-butenal data are considered (r=0.99, butanal/2-butenal=6.2). These compounds present maxima values during the 3-6h period, with minima values in the 0-3h period. These data imply a strong pre-dawn emission. Other aldehydes show different daily profiles, suggesting unrelated origins. Formaldehyde is the aldehyde whose concentration values best correlate with the levels of oxidants. The contribution of primary emissions and photochemical processes to formaldehyde concentrations were estimated by using a multiple regression. This treatment indicates that (32+/-16)% of measured values arise from direct emissions, while (79+/-23)% is attributable to secondary formation.     

Evaluating mortality rates with a novel integrated framework for nonmonogamous species

The conservation of wildlife requires management based on quantitative evidence, and especially for large carnivores, unraveling cause‐specific mortalities and understanding their impact on population dynamics is crucial. Acquiring this knowledge is challenging because it is difficult to obtain robust long‐term data sets on endangered populations and, usually, data are collected through diverse sampling strategies. Integrated population models (IPMs) offer a way to integrate data generated through different processes. However, IPMs are female‐based models that cannot account for mate availability, and this feature limits their applicability to monogamous species only. We extended classical IPMs to a two‐sex framework that allows investigation of population dynamics and quantification of cause‐specific mortality rates in nonmonogamous species. We illustrated our approach by simultaneously modeling different types of data from a reintroduced, unhunted brown bear (Ursus arctos) population living in an area with a dense human population. In a population mainly driven by adult survival, we estimated that on average 11% of cubs and 61% of adults died from human‐related causes. Although the population is currently not at risk, adult survival and thus population dynamics are driven by anthropogenic mortality. Given the recent increase of human‐bear conflicts in the area, removal of individuals for management purposes and through poaching may increase, reversing the positive population growth rate. Our approach can be generalized to other species affected by cause‐specific mortality and will be useful to inform conservation decisions for other nonmonogamous species, such as most large carnivores, for which data are scarce and diverse and thus data integration is highly desirable.     

Constructing herbicide metribuzin sustained-release formulations based on the natural polymer poly-3-hydroxybutyrate as a degradable matrix

Polymer poly(3-hydroxybutyrate) [P(3HB)] has been used as a matrix in slow-release formulations of the herbicide metribuzin (MET). Physical P(3HB)/MET mixtures in the form of solutions, powders, and emulsions were used to construct different metribuzin formulations (films, granules, pellets, and microparticles). SEM, X-Ray, and DSC proved the stability of these formulations incubated in sterile water in vitro for long periods of time (up to 49 days). Metribuzin release from the polymer matrix has been also studied. By varying the shape of formulations (microparticles, granules, films, and pellets), we were able to control the release time of metribuzin, increasing or decreasing it.