Flexible and high-efficiency Sb2S3/solid carrier solar cell at low light intensity

Environmental Chemistry Letters - Producing green and efficient energy sources is a major challenge. As a consequence, the use of photovoltaic devices for conversion of light into electricity is...     

On ground truth in cross-border ozone transport

Cross-border transport of ozone is one of the most contentious issues of air pollution management in the U.S. Yet, both the modeling and observational studies are lacking. Models are normally validated by comparing predicted and observed ozone concentrations. However, proper validation of cross-border transport model requires a comparison of predictions against observation-based benchmarks of cross-border ozone transport. Such benchmarks are unavailable, as published observation-based studies always deal only with a combination of local production and cross-border transport, not a cross-border transport itself. We show how to extract necessary benchmarks from observations of rural monitoring sites near state borders. On example of the western border of New York, we find that in about two-thirds of the most polluted days all the ozone came in a steady cross-border inflow after previously passing over one or more large urban areas to the west. In all the enumerated days with direct cross-border inflow, daily maximum 8-hr concentrations of ozone just upwind of the border were over 60 ppb, with an average value of 68 ppb, just short of the 70 ppb ozone regulatory threshold, information also useful to state air pollution authorities.

Implications: The purpose of the cross-border ozone pollution models is to predict cross-border transport of ozone, so the ability of the model to accurately represent observed ozone concentrations is necessary but not sufficient for model validation. The accuracy of predicted ozone concentrations is not necessarily the same as the accuracy of the predictions of ozone transport. Proper model validation requires comparisons against observation-based benchmarks of cross-border transport. Such observations, so far absent, can be obtained from rural monitoring sites near state borders, as illustrated by the example of western New York.     

Evaluation of preservation methods for nutrient species collected by automatic samplers

Automatic samplers are a common method of data collection for numerous monitoring projects in the South Florida region and elsewhere. Although total phosphorus (TP) is the primary parameter of interest within this region, nitrogen species such as ammonia nitrogen (NH₄-N), nitrate+nitrite nitrogen (NO_x-N), and total kjeldahl nitrogen (TKN) are also collected and analyzed. Federal and state quality assurance guidelines require nutrient samples to be preserved by acidification with H₂SO₄ to a pH < 2 and stored immediately at 4 °C. However, the remoteness of manysampling locations in South Florida makes it difficult to supplyelectricity for the refrigeration of samples collected by autosamplers. In addition, the use of propane-powered refrigerated autosamplers is a costly and ineffective solution in the South Florida climate. Consequently, while samples collected at these remote locations are routinely pre-preservedwith acid, they are not cooled to 4 °C for a period fromone to seven days. This study evaluated if a statistically significant difference ( = 0.05) existed between concentrations of nitrogen species from a common source samplethat was either: processed immediately; refrigerated to 4 °C for seven days; or not refrigerated for seven days.In all cases, the collected sample was pre-preserved by adding 1 mL of 50% H₂SO₄ to each 1 L discrete sample container before each 7 day testing period. Differences in concentrations of the calculated parameter total nitrogen (TN)were also investigated.Analyses using the Wilcoxon Signed-Rank Test showed no significant differences among the three treatment groups for NO_x-N, TKN, TN and TP. Significant differences were observedwhen the NH₄-N samples that were processed immediately werepaired with NH₄-N samples that were left unrefrigerated or refrigerated for seven days. Information from this study can be used by researchers and managers in evaluating the usefulness of nutrient water quality data that is collected when sample refrigeration is not available.     

Developing a Questionnaire for Measuring Safety Climate in the Workplace in Serbia

This study was conducted because a real method for measuring safety climate had never been developed and assessed in Serbian industry. The aim of this paper was to start the process of developing a safety climate questionnaire that could be used in Serbia. As a starting point a 21-item questionnaire was adopted after an extensive literature review. The questionnaire was distributed at several Serbian factories; 1098 workers responded. After a statistical analysis of the data obtained with the questionnaire and a critical comparison with the available reference results, a final questionnaire with 21 questions, divided into 7 groups, was developed. The 7 groups of questions (factors) were safety awareness and competence, safety communication, organizational environment, management support, risk judgment and management reaction, safety precautions and accident prevention, and safety training.     

Water ultrasound-assisted oxidation of 2-oxo-1,2,3,4-tetrahydropyrimidines and benzylic acid salts

Environmental Chemistry Letters - Nitrogen six-membered heterocyclic compounds, such as pyrimidines, are of synthetic interest because they constitute an important class of natural and synthetic...     

Simulation of wind-driven dispersion of fire pollutants in a street canyon using FDS

Air quality in urban areas attracts great attention due to increasing pollutant emissions and their negative effects on human health and environment. Numerous studies, such as those by Mouilleau and Champassith (J Loss Prevent Proc 22(3): 316–323, 2009), Xie et al. (J Hydrodyn 21(1): 108–117, 2009), and Yassin (Environ Sci Pollut Res 20(6): 3975–3988, 2013) focus on the air pollutant dispersion with no buoyancy effect or weak buoyancy effect. A few studies, such as those by Hu et al. (J Hazard Mater 166(1): 394–406, 2009; J Hazard Mater 192(3): 940–948, 2011; J Civ Eng Manag (2013)) focus on the fire-induced dispersion of pollutants with heat buoyancy release rate in the range from 0.5 to 20 MW. However, the air pollution source might very often be concentrated and intensive, as a consequence of the hazardous materials fire. Namely, transportation of fuel through urban areas occurs regularly, because it is often impossible to find alternative supply routes. It is accompanied with the risk of fire accident occurrences. Accident prevention strategies require analysis of the worst scenarios in which fire products jeopardize the exposed population and environment. The aim of this article is to analyze the impact of wind flow on air pollution and human vulnerability to fire products in a street canyon. For simulation of the gasoline tanker truck fire as a result of a multivehicle accident, computational fluid dynamics large eddy simulation method has been used. Numerical results show that the fire products flow vertically upward, without touching the walls of the buildings in the absence of wind. However, when the wind velocity reaches the critical value, the products touch the walls of the buildings on both sides of the street canyon. The concentrations of carbon monoxide and soot decrease, whereas carbon dioxide concentration increases with the rise of height above the street canyon ground level. The longitudinal concentration of the pollutants inside the street increases with the rise of the wind velocity at the roof level of the street canyon.     

Economic,ecological, and health aspects of β-diketonate application in the process of water purification

Environmental Science and Pollution Research - Water pollution is a constant challenge for humanity. Sustainable economic development and environmental protection through a green economy structure...     

Whole genome amplification and microsatellite genotyping of herbarium DNA revealed the identity of an ancient grapevine cultivar

Reconstruction of the grapevine cultivation history has advanced tremendously during the last decade. Identification of grapevine cultivars by using microsatellite DNA markers has mostly become a routine. The parentage of several renowned grapevine cultivars, like Cabernet Sauvignon and Chardonnay, has been elucidated. However, the assembly of a complete grapevine genealogy is not yet possible because missing links might no longer be in cultivation or are even extinct. This problem could be overcome by analyzing ancient DNA from grapevine herbarium specimens and other historical remnants of once cultivated varieties. Here, we present the first successful genotyping of a grapevine herbarium specimen and the identification of the corresponding grapevine cultivar. Using a set of nine grapevine microsatellite markers, in combination with a whole genome amplification procedure, we found the 90-year-old Tribidrag herbarium specimen to display the same microsatellite profile as the popular American cultivar Zinfandel. This work, together with information from several historical documents, provides a new clue of Zinfandel cultivation in Croatia as early as the beginning of fifteenth century, under the native name Tribidrag. Moreover, it emphasizes substantial information potential of existing grapevine and other herbarium collections worldwide.     

Natural attenuation of petroleum hydrocarbons—a study of biodegradation effects in groundwater (Vitanovac,Serbia)

The role of natural attenuation processes in groundwater contamination by petroleum hydrocarbons is of intense scientific and practical interest. This study provides insight into the biodegradation effects in groundwater at a site contaminated by kerosene (jet fuel) in 1993 (Vitanovac, Serbia). Total petroleum hydrocarbons (TPH), hydrochemical indicators (O₂, NO₃^?, Mn, Fe, SO₄^2?, HCO₃^?), δ¹³C of dissolved inorganic carbon (DIC), and other parameters were measured to demonstrate biodegradation effects in groundwater at the contaminated site. Due to different biodegradation mechanisms, the zone of the lowest concentrations of electron acceptors and the zone of the highest concentrations of metabolic products of biodegradation overlap. Based on the analysis of redox-sensitive compounds in groundwater samples, redox processes ranged from strictly anoxic (methanogenesis) to oxic (oxygen reduction) within a short distance. The dependence of groundwater redox conditions on the distance from the source of contamination was observed. δ¹³C values of DIC ranged from ??15.83 to ??2.75‰, and the most positive values correspond to the zone under anaerobic and methanogenic conditions. Overall, results obtained provide clear evidence on the effects of natural attenuation processes—the activity of biodegradation mechanisms in field conditions.