Utilization of a fumigated sediment by two benthic deposit-feeders:Abra alba (Mollusca: Bivalvia) andEupolymnia nebulosa (Annelida: Polychaeta)

The present study tested the utilization of dead microbial biomass by two benthic deposit-feeders:Abra alba (Wood) (Mollusca: Bivalvia) andEupolymnia nebulosa (Montagu) (Annelida: Polychaeta). Clams were collected in the Canet lagoon during spring 1989. Worms were collected in the Port-Vendres harbour during spring 1989. The¹⁴C-labelled (glutamic acid, 24 h) sediment used during the study was sterilized with 1% chloroform, washed with sterile seawater, and dried (60°C; 48 h). This sterilisation procedure, called fumigation is the least harmful to the sediment (Novitsky 1986). Both clams and worms were incubated in the presence of the fumigated sediment for 5, 10, 20, and 50 h. At the end of each experiment we recorded the radioactivity in four compartments: (1) sediment, (2) dissolved organic matter (DOM), (3) CO₂, and (4) animals. The radioactivity of the sediment was subdivided into five fractions: (i) soluble in 2N HCl, (ii) soluble in hot 5% trichloroacetic acid (TCA), (iii) soluble in 1N NaOH, (iv) soluble in hot 6N HCl, (v) residual (after combustion in a Leco carbon analyser). In the first set of experiments, after 20 h of incubation, 5.4 and 4.7% of the total radioactivity was taken up by clams and worms, respectively. However, a model revealed that this uptake could have been correlated with the release of radiolabelled DOM (33% of total radioactivity during the first 5 h). In order to test this assumption, we used the same protocol with three additional washes of the fumigated sediment. This resulted in a significantly lower uptake by the clams (1.9% of the total radioactivity byt = 50 h), whereas the worms exhibited an uptake similar to that in the initial experiment (5.1% of total radioactivity byt = 50 h). These results underline the importance of considering interactions with DOM when applying radiotracer techniques to the study of benthic food chains. The average ingestion rates of fumigated sediment byA. alba andE. nebulosa were 5.2 10^–2 mg sediment dry wt mg^–1 clam h^–1 and 3.5 10^–2 mg sediment dry wt mg^–1 worm h^–1, respectively, which is comparable to previous data reported for other deposit-feeding bivalves and polychaetes feeding on natural sediment or detritus. The low radioactivity recorded for CO₂ together with the similarity of the changes in the partitioning of the radioactivity within the sediment between control experiments and experiments carried out in the presence of clams or worms suggest low assimilation efficiencies. Therefore, the present study supports the fact that dead microbial biomass does not constitute an important food source for benthic deposit-feeders.     

Reduction of heavy metal content in Hiroshima Bay oysters (Crassostrea gigas) by purification

Cultured oysters from Hiroshima Bay were analysed to determine the content of nine trace elements, cadmium (Cd), lead (Pb), chromium (Cr), arsenic (As), manganese (Mn), nickel (Ni), copper (Cu), zinc (Zn), and iron (Fe) and compared with oysters treated for 48 h in both artificial sea water and a solution of 0.5% ethylenediaminetetraacetic acid (EDTA) in artificial sea water. It was found that the values of As and Fe in both groups of treated oysters were significantly lower than in the untreated oysters and that the Pb and Mn levels tended to be lower. It was also found that oysters treated in 0.5% EDTA solution in artificial sea water had lower levels of Cd and Cu than the oysters treated only in artificial sea water.     

Effects of elevated CO2 concentration on the polyamine levels of field-grown soybean at three O3 regimes

Effects of increased ozone (O3) and carbon dioxide (CO2) on polyamine levels were determined in soybean (Glycine max L. Merr. cv. Clark) grown in open-top field chambers. The chamber treatments consisted of three O3 regimes equal to charcoal filtered (CF), non-filtered (NF), and non-filtered plus 40 nl litre(-1) O3 and CO2 treatments equal to 350, 400 and 500 microl litre(-1) for a total of nine treatments. Leaf samples were taken at three different times during the growing season. Examination of growth and physiological characteristics, such as photosynthesis, stomatal resistance, and shoot weight, revealed that increasing CO2 ameliorated the deleterious effects of increased O3. Results from the initial harvest, at the pre-flowering growth stage (23 days of treatment), showed that increasing O3 at ambient CO2 caused increases in putrescine (Put) and spermidine (Spd) of up to six-fold. These effects were lessened with increased CO2. Elevated CO2 increased polyamines in plants treated with CF air, but had no effect in the presence of ambient or enhanced O3 levels. Leaves harvested during peak flowering (37 days of treatment) showed O3-induced increases in Put and Spd at ambient CO2 concentrations. However, increased CO2 levels inhibited this response by blocking the O3-induced polyamine increase. Leaves harvested during the pod fill stage (57 days of treatment) showed no significant O3 or CO2 effects on polyamine levels. Our results demonstrate that current ambient O3 levels induce the accumulation of Put and Spd early in the growing season and that further increases in O3 could result in even greater polyamine increases. These results are consistent with a possible antiozonant function for polyamines. The ability of increased CO2 to protect soybeans from O3 damage, however, does not appear to involve polyamine accumulation.     

Air Pollution in Singapore: Its Multielemental Aspect as Measured by Nuclear Analytical Techniques

Aerosol samples were collected in 1994 in Singapore on two occasions: once in June during the normal meteorological conditions and later in October during a long haze period caused by the heavy forest fire in Indonesia. Filtration and impaction collection methods were used simultaneously so that detailed elemental analysis of bulk as well as of different size fractions could be performed. Accelerator based nuclear analytical techniques such as Particle Induced X-Ray Emission (PIXE), Rutherford Backscattering (RBS) and Nuclear Microscopy (NM) were used for analysis. These techniques are fast, truly multielemental and perfectly suited for routine analysis of a large number of aerosol samples. Typically all samples were analysed for the following 24 elements: Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Mn, Cr, Fe, Co, Ni, Cu, Zn, Ga, As, Br, Rb, Sr and Pb. Detection limits for bulk analysis were generally below ng/m3 and for single particle analysis absolute detectable mass was approximately 10-17 g. Additionally, trace elements such as Cd, Sn, Sb and Ba whose characteristic X-ray lines were normally "obscured" by the lines of other more abundant elements, were detected when analysing by nuclear microscope in single particle mode.Judging by the average concentrations of lead and sulphur which are good indicators of industrial component of air pollution the situation in Singapore is satisfactory. Pb was typically found in concentrations of 5 to 50 ng/m3 and sulphur in concentrations of 1 to 2 µg/m3. These concentrations are well below limits set by the World Health Organisation (1500 ng/m3 and 40 µg/m3, respectively). On the other hand during the haze period the average concentrations of elements like S, K, Ti, V, Mn, Ni, As and Pb were found to be 3 to 6 times higher than usual. Results are presented and discussed.     

Development of monitoring technology for airborne particulate matter

Particulate matter suspended in the air has adverse effects onhuman health. Its level of concentration is an important parameter in evaluating the degree of hazard it poses to the atmosphere. Conventional methods used in measuring particulatematter are often filter-based, which indicates some disadvantagesbecause such a base requires labor and time. In this study, to achieve real-time measurements, a new electrical method was developed for measuring PM10 and PM2.5 concentrations. The basicprinciple is to electrically charge particles passing through thePM inlet using a corona charger and measure the currents createdby charged particles to obtain the number concentration of particulate matter. A new type inlet based on the particle cupimpactor configuration was designed and its performance was evaluated. A unipolar diffusion charger was developed and thecharger's efficiency was determined experimentally in terms ofPn, which represents the penetration through the charger,P, times the average charge number acquired by a particle,n, for different particle sizes. The correlation was constructed between the PM10 (or the PM2.5) mass concentrationsand the electrical currents due to particles, which were chargedby the diffusion charger.     

State estimation in wastewater engineering: Application to an anaerobic process

The use of an extended Kalman filter for state estimation in biological wastewater treatment processes is discussed. The application of the technique requires an adequate mechanistic dynamic model and the identification and modelling of the major sources of stochastic disturbances in the process. The filter allows the on-line tracking of process variables which are not directly measurable. The use of an extended Kalman filter is illustrated through a simulated application to a high rate anaerobic wastewater treatment process.     

Analysing the sensitivity behaviour of two hydrology models

Recently, the New Morris Method has been presented as an effective sensitivity analysis tool for mathematical models. The New Morris Method estimates the sensitivity of an output parameter to a given set of input parameters (first-order effects) and the extent these parameters interact with each other (second-order effects). This method requires the specification of two parameters (runs and resolution) that control the sampling of the output parameter to determine its sensitivity to various inputs. The criteria for these parameters have been set on the analysis of a well-behaved analytical function (see Cropp and Braddock, Reliab. Eng. Syst. Saf. 78:77–83, 2002), which may not be applicable to other physical models that describe complex processes. This paper will investigate the appropriateness of the criteria from (Cropp and Braddock, 2002) and hence the effectiveness of the New Morris Method to determine the sensitivity behaviour of two hydrologic models: the Soil Erosion and Deposition System and Griffith University Representation of Urban Hydrology. In the first case, this paper will separately analyse the sensitivity of an output parameter on a set of input parameters (first- and second-order effects) for each model and discuss the physical meaning of these sensitivities. This will be followed by an investigation into the sampling criteria by exploring the convergence of the sensitivity behaviour for each model as the sampling of the parameter space is increased. By comparing these trends to the convergence behaviour from Cropp and Braddock (2002), we will determine how well the New Morris Method estimates the sensitivity for each model and whether the sampling criteria are appropriate for these models. It will be shown that the New Morris Method can provide additional insight into the functioning of these models, and that, under a different metric, the sensitivity behaviour of these models does converge confirming the sampling criteria set by Cropp and Braddock.     

Analysis of pollutant levels in central Hong Kong applying neural network method with particle swarm optimization

Air pollution has emerged as an imminent issue in modernsociety. Prediction of pollutant levels is an importantresearch topic in atmospheric environment today. For fulfillingsuch prediction, the use of neural network (NN), and inparticular the multi-layer perceptrons, has presented to be acost-effective technique superior to traditional statisticalmethods. But their training, usually with back-propagation (BP)algorithm or other gradient algorithms, is often with certaindrawbacks, such as: 1) very slow convergence, and 2) easilygetting stuck in a local minimum. In this paper, a newlydeveloped method, particle swarm optimization (PSO) model, isadopted to train perceptrons, to predict pollutant levels, andas a result, a PSO-based neural network approach is presented. The approach is demonstrated to be feasible and effective bypredicting some real air-quality problems.     

Application of cryofocusing hydride generation and atomic fluorescence detection for dissolved mercury species determination in natural water samples

The concentration levels of mercury (Hg) species in natural water samples are usually low. Consequently, accurate analysis with low detection limits is still a major problem. In this work, a method was applied for the simultaneous direct determination of dissolved mercury species in water samples by on-line hydride generation (HG), cryogenic trapping (CT), gas chromatography (GC) and detection by atomic fluorescence spectrometry (AFS). The suitability of the method for real samples with different organic matter and chloride contents was evaluated by recovery experiments in synthetic and natural spiked water samples. The HG method was compared with other current available methods for mercury analysis with respect to the different fraction of mercury analysed, i.e. 'reactive', 'reducible' or total. HG derivatization and SnCl2 reduction (with and without previous oxidation with BrCl) were applied to synthetic and natural (spiked and non-spiked) water samples. The influence of chloride and dissolved organic matter concentrations was studied. The results suggest that the HG procedure is suitable for the simultaneous determination of Hg2+ and MeHg+ in surface water samples. Inorganic mercury analysed by HG (i.e. reducible) is close to the total inorganic mercury.     

Arsenic speciation in human hair: a new perspective for epidemiological assessment in chronic arsenicism

The analysis for arsenic in hair is commonly used in epidemiological studies to assess exposure to this toxic element. However, poor correlation between total arsenic concentration in hair and water sources have been found in previous studies. Exclusive determination of endogenous arsenic in the hair, excluding external contamination has become an analytical challenge. Arsenic speciation in hair appears as a new possibility for analytical assessing in As-exposure studies. This study applied a relative simple method for arsenic speciation in human hair based on water extraction and HPLC-HG-ICP-MS. The concentration of arsenic species in human hair was assessed in chronically As(V)-exposed populations from two villages (Esqui?a and Illapata) of the Atacama Desert, Chile. The arsenic concentrations in drinking water are 0.075 and 1.25 mg L(-1), respectively, where As(V) represented between 92 and 99.5% of the total arsenic of the consumed waters. On average, the total arsenic concentrations in hair from individuals of Esqui?a and Illapata were 0.7 and 6.1 microg g(-1), respectively. Four arsenic species, As(III), DMA(V), MMA(V) and As(V), were detected and quantified in the hair extracts. Assuming the found species in extracts represent the species in hair, more than 98% of the total arsenic in hair corresponded to inorganic As. On average, As(III) concentrations in hair were 0.25 and 3.75 microg g(-1) in Esqui?a and Illapata, respectively; while, the As(V) average concentrations were 0.15 and 0.45 microg g(-1) in Esqui?a and Illapata, respectively. Methylated species represent less than 2% of the extracted As (DMA(V)+ MMA(V)) in both populations. As(III) in hair shows the best correlation with chronic exposure to As(V) in comparison to other species and total arsenic. In fact, concentrations of As(total), As(III) and As(V) in hair samples are correlated with the age of the exposed individuals from Illapata (R= 0.65, 0.69, 0.57, respectively) and with the time of residence in this village (R= 0.54, 0.71 and 0.58, respectively).