Vacuum-ultraviolet (VUV) photolysis of water: Mineralization of atrazine

The versatility and efficiency of the VUV photolysis of water as an “Advanced Oxidation Procedure” for the light-induced oxidative degradation of atrazine as a pollutant of surface and ground waters is evaluated. The oxidation of atrazine using TiO₂ as a photocatalyst has been reported to produce almost stoichiometric amounts of cyanuric acid. Mineralization to CO₂, water and inorganic nitrogen containing ions occurred to a very low extent implying that cyanuric acid is resistant to further degradation under the chosen experimental conditions. Our present results show that in oxygen saturated solutions 50% of the initial atrazine is converted to cyanuric acid, whereas only 10% of the initial atrazine is isolated as cyanuric acid in argon saturated solutions. The results indicate that mineralization is more efficient in not strictly oxidative reaction media.     

Protection from steam at high pressures: development of a test device and protocol.

Extensive use of pressurized steam in the oil and gas sectors has led to incidents where workers were seriously injured. In this study a test device and procedure to measure heat transfer through fabrics during steam exposure were developed and evaluated. Several factors were considered while designing the test device to simulate work site conditions. Fabrics were exposed to steam at 2 distances (50 and 100 mm) and 2 pressures (207 and 69 kPa). Theoretical considerations included heat and mass transfer, and fabric structure and performance properties. The test device and procedure differentiated well among both fabrics and exposure conditions. For all fabrics, maximum heat transfer was observed at highest steam pressure and shortest distance. Laminated and coated fabrics performed better than a fabric without such treatments.     

AN ANTIDEGRADATION POLICY FOR PRESERVING SURFACE WATER QUALITY IN FLORIDA1

ABSTRACT: As part of its overall system for protecting aquatic systems from unnecessary degradation, the State of Florida provides special protection for water bodies of unusual importance. Such water bodies are designated as “Outstanding Florida Waters” (OFW5). New discharges to OFWs are possible only if certain stringent criteria are met. A new point source direct discharge to an OFW is usually not allowed if it would cause any lowering of ambient water quality. A new indirect discharge (upstream from an OFW boundary) may be allowed only if it would not significantly degrade the OFW. To date, the advantages of the OFW system have clearly outweighed the disadvantages, and OFW designations are helping to protect Florida's most valuable waters from additional degradation. Florida's system could be a useful model for other jurisdictions wanting to provide special protection to special water bodies.     

Mechanical properties and microstructure of cement mortars incorporating Cd-zeolitized fly ash

Journal of Material Cycles and Waste Management - A solid enriched with NaA zeolite was synthesized from a coal fly ash, and the so-obtained zeolitized material was used as ion exchanger for...     

Emission and Performance Characteristics of a 2 Litre Toyota Diesel Van Operating on Esterified Waste Cooking Oil and Mineral Diesel Fuel

Exhaust emission and performance characteristics were evaluated in a Toyota van, powered by a 21 indirect injection (IDI) naturally aspirated diesel engine, operating on vegetable based waste cooking oil methyl ester (WCOME).Tests were performed on a chassis dynamometer and the data were compared with previous results conducted on the same vehicle using mineral diesel fuel. The data obtained includes smoke opacity, carbon monoxide (CO), carbon dioxide (CO₂), oxygen (O₂), nitrogen dioxide (NO₂), nitric oxide (NO), sulfur dioxide (SO₂) and brake power. Engine lubricating oil samples were also taken. Results from this study indicated a difference of approximately 9% in brake power between the two fuels. WCOME developed a significant lower smoke opacity level and reduced CO, CO₂, SO₂ emissions. However, O₂, NO₂ and NO levels were higher with the vegetable oil based fuel. Power values were comparable for both fuels. Lubricating oil analysis gave little change of viscosity and wear metal concentrations after 2887km were: Silicon 35ppm, Chromium 3.3ppm, Iron 33.8ppm, Copper 14.1ppm and lead 78.6ppm.     

Trace metals assessment in water, sediment, mussel and seagrass species--validation of the use of Posidonia oceanica as a metal biomonitor

The accumulation of trace metals (Cd, Co, Cr, Hg, Ni and Pb) was measured in water, sediment, the mussel Mytilus galloprovincialis and the seagrass Posidonia oceanica. Samples were collected in three locations of the north-western Mediterranean (Canari, Livorno and Porto-Torres) which present different levels and sources of human impact. Analyses in the different compartments (water, sediment, M. galloprovincialis and P. oceanica) have allowed to identify Canari as the most Cd, Co, Cr and Ni contaminated site; Livorno as the most Hg contaminated and Porto-Torres as the most Pb contaminated. Furthermore, for the first time, metal concentrations found in P. oceanica have been compared with those found in the water column, in the sediment and in the recognized metal bio-indicator species M. galloprovincialis and the results obtained have led to the same conclusions. Thus, this study allows to validate the use of P. oceanica as metal biomonitor of coastal waters.     

Early atmospheric detection of carbon dioxide from carbon capture and storage sites

The early atmospheric detection of carbon dioxide (CO₂) leaks from carbon capture and storage (CCS) sites is important both to inform remediation efforts and to build and maintain public support for CCS in mitigating greenhouse gas emissions. A gas analysis system was developed to assess the origin of plumes of air enriched in CO₂, as to whether CO₂ is from a CCS site or from the oxidation of carbon compounds. The system measured CO₂ and O₂ concentrations for different plume samples relative to background air and calculated the gas differential concentration ratio (GDCR = ?ΔO₂/ΔCO₂). The experimental results were in good agreement with theoretical calculations that placed GDCR values for a CO₂ leak at 0.21, compared with GDCR values of 1–1.8 for the combustion of carbon compounds. Although some combustion plume samples deviated in GDCR from theoretical, the very low GDCR values associated with plumes from CO₂ leaks provided confidence that this technology holds promise in providing a tool for the early detection of CO₂ leaks from CCS sites. Implications: This work contributes to the development of a cost-effective technology for the early detection of leaks from sites where CO₂ has been injected into the subsurface to enhance oil recovery or to permanently store the gas as a strategy for mitigating climate change. Such technology will be important in building public confidence regarding the safety and security of carbon capture and storage sites.     

Respiratory irritation due to carpet shampoo: Two outbreaks

Dried detergent residue left in carpets after they were shampooed with underdiluted carpet shampoo caused respiratory irritation among most employees in an office building and among all staff members and most children in a day-care center. Symptoms included cough, dry throat, difficulty in breathing, nasal congestion, and headache. Eye irritation was also noted by day-care center staff members. Symptoms persisted for many weeks until the carpets were wet extracted. The major ingredient of the three shampoo products implicated in these two outbreaks and in a third similar report in sodium dodecyl sulfate, a respiratory irritant in mice. Unpublished occupational investigations suggest that soap dust exposure may be associated pulmonary function abnormalities in some exposed workers. Detergent dust is a newly recognized example of indoor air pollution and should be considered when patients or employees complain of building-specific respiratory or eye irritation.