Appraisal of kinetin spraying strategy to alleviate the harmful effects of UVC stress on tomato plants

Environmental Science and Pollution Research - Increasing ultraviolet (UV) radiation is causing oxidative stress that accounts for growth and yield losses in the present era of climate change....     

Heavy metal pollution and forest health in the Ukrainian Carpathians

The Ukrainian Carpathians are characterized by high air pollution caused by emissions from numerous industries. We have been monitoring the state of forests in this region since 1989. The highest levels of tree defoliation (>30%) are found close to industrial emission sources and in the upper mountain forests of the Ivano-Frankivsk and Chernivtsi regions. This is caused by a combination of strong anthropogenic influences (pollution, illegal uses, recreation) as well as poor site and climatic conditions. In the Ivano-Frankivsk region, Cd and Mo accumulate in forest soils; Cr, Mo and Zn soil concentrations are higher than their limit levels; and Pb concentrations exceed toxic levels close to industrial areas (10% of the region territory). Local background levels of heavy metals are greatly exceeded in snow close to industrial regions. Analysis of correlation matrices shows that the chemical elements Ba, Cd, Co, Cr, Cu, Mo, Ni, Pb, V and Zn occur at pollution levels in natural ecosystems in the Ukrainian Carpathians. Maximum concentrations of toxic elements occur in the oak forest zone; the most industrially developed area of the region. Toxic heavy metals in the Ukrainian Carpathians forests enter with precipitation and dustfall, then become fixed in soil and accumulate in leaves, needles of vascular plants and mosses. Concentrations of these metals decrease with altitude: highest in the oak forests, less in beech, and lowest in the spruce forest zones. However, some chemical elements have the highest concentrations in spruce forests; V in needles, As in snow, and Ba and Al in soils.     

Role of alpha-tocopherol and beta-carotene in ameliorating the fenvalerate-induced changes in oxidative stress, hemato-biochemical parameters, and semen quality of male rats

Role of alpha-tocopherol (vitamin E), beta-carotene and/or their combination as antioxidants against the toxicity of fenvalerate on blood hematology, free radicals, biochemical parameters, and semen quality were studied in male rats. Fenvalerate (20 mg/kg BW), vitamin E (100 mg/kg BW), beta-carotene (10 mg/kg BW), and vitamin E plus beta-carotene (100 + 10 mg/kg BW, respectively) were given alone or in combination with fenvalerate. The tested doses were given to rats every other day for 30 days. Results obtained showed that fenvalerate significantly (P < 0.05) induced free radicals in plasma and brain and insignificantly in liver and testes. While, vitamin E, beta-carotene alone and/or in combination decreased the levels of free radicals in plasma, liver, testes, and brain. The activities of glutathione S-transferase (liver), alkaline phosphatase (plasma and liver), aspartate aminotransferase (plasma, liver, and testes) and alanine aminotransferase (plasma and liver) were significantly (P < 0.05) increased due to fenvalerate administration. The activity of acetylcholinesterase was significantly (P < 0.05) decreased in brain and plasma, while plasma glucose, urea, creatinine, and bilirubin concentrations were significantly (P < 0.05) increased in rats treated with fenvalerate. Also, results showed a significant (P < 0.05) alterations in plasma proteins, hematological parameters, body weight, and relative weights of organs. Sperm concentration and motility (%) were significantly (P < 0.05) decreased, while dead and abnormal sperm increased in rats exposed to fenvalerate. Vitamin E, beta-carotene alone and/or in combination did not cause any changes in the investigated parameters, but improved semen quality and minimized the toxic effect of fenvalerate. The obtained results demonstrated the beneficial influences of vitamin E, beta-carotene alone and/or in combination in reducing the harmful effects of fenvalerate.     

Preliminary ecotoxicological characterization of a new energetic substance, CL-20

A new energetic substance hexanitrohexaazaisowurtzitane (or CL-20) was tested for its toxicities to various ecological receptors. CL-20 (epsilon-polymorph) was amended to soil or deionized water to construct concentration gradients. Results of Microtox (15-min contact) and 96-h algae growth inhibition tests indicate that CL-20 showed no adverse effects on the bioluminescence of marine bacteria Vibrio fischeri and the cell density of freshwater green algae Selenastrum capricornutum respectively, up to its water solubility (ca. 3.6 mg l(-1)). CL-20 and its possible biotransformation products did not inhibit seed germination and early seedling (16-19 d) growth of alfalfa (Medicago sativa) and perennial ryegrass (Lolium perenne) up to 10,000 mg kg(-1) in a Sassafras sandy loam soil (SSL). Indigenous soil microorganisms in SSL and a garden soil were exposed to CL-20 for one or two weeks before dehydrogenase activity (DHA) or potential nitrification activity (PNA) were assayed. Results indicate that up to 10,000 mg kg(-1) soil of CL-20 had no statistically significant effects on microbial communities measured as DHA or on the ammonium oxidizing bacteria determined as PNA in both soils. Data indicates that CL-20 was not acutely toxic to the species or microbial communities tested and that further studies are required to address the potential long-term environmental impact of CL-20 and its possible degradation products.     

Characterisation of the dilute HCl extraction method for the identification of metal contamination in Antarctic marine sediments

A regional survey of potential contaminants in marine or estuarine sediments is often one of the first steps in a post-disturbance environmental impact assessment. Of the many different chemical extraction or digestion procedures that have been proposed to quantify metal contamination, partial acid extractions are probably the best overall compromise between selectivity, sensitivity, precision, cost and expediency. The extent to which measured metal concentrations relate to the anthropogenic fraction that is bioavailable is contentious, but is one of the desired outcomes of an assessment or prediction of biological impact. As part of a regional survey of metal contamination associated with Australia's past waste management activities in Antarctica, we wanted to identify an acid type and extraction protocol that would allow a reasonable definition of the anthropogenic bioavailable fraction for a large number of samples. From a kinetic study of the 1 M HCl extraction of two Certified Reference Materials (MESS-2 and PACS-2) and two Antarctic marine sediments, we concluded that a 4 h extraction time allows the equilibrium dissolution of relatively labile metal contaminants, but does not favour the extraction of natural geogenic metals. In a regional survey of 88 marine samples from the Casey Station area of East Antarctica, the 4 h extraction procedure correlated best with biological data, and most clearly identified those sediments thought to be contaminated by runoff from abandoned waste disposal sites. Most importantly the 4 h extraction provided better definition of the low to moderately contaminated locations by picking up small differences in anthropogenic metal concentrations. For the purposes of inter-regional comparison, we recommend a 4 h 1 M HCl acid extraction as a standard method for assessing metal contamination in Antarctica.     

Effect of depithing on the safety and environmental aspects of bagasse stockpiling

Large scale sugarcane bagasse storage in uncovered stockpiles has the potential to result in adverse impacts on the environment and surrounding communities through hazards associated with nuisance dust, groundwater seepage, spontaneous combustion and generation of contaminated leachates. Managing these hazards will assist in improved health and safety outcomes for factory staff and reduced potential environmental impacts on surrounding communities. Removal of the smaller fibres (pith) from bagasse prior to stockpiling reduced the dust number of bagasse by 50% and modelling suggests peak ground level PM₁₀ dust emissions would reduce by 70%. Depithed bagasse has much lower water holding capacity (～43%) than whole bagasse.This experimental and modelling study investigated the physical properties of depithed and whole bagasse. Dust dispersion modelling was undertaken to determine the likely effects associated with storage of whole and depithed sugarcane bagasse.