SI-traceable certification of Cu, Cr, Cd and Pb in sediment and fly ash candidate reference materials

Many fields in environmental analytical chemistry deal with very low limits and thresholds as set by governmental legislations or transnational regulations. The need for the accuracy, comparability and traceability of analytical measurements in environmental analytical chemistry has significantly increased and total uncertainties are even asked for by accreditation bodies of environmental laboratories. This paper addresses achieving these goals to guarantee accuracy, quality control, quality assurance or validation of a method by means of certified reference materials. The assessment of analytical results in certified reference materials must be as accurate as possible and every single step has to be fully evaluated. This paper presents the SI-traceable certification of Cu, Cr, Cd and Pb contents in geological and environmentally relevant matrices (three sediments and one fly ash sample). Certification was achieved using isotope dilution (ID) ICPMS as a primary method of measurement. In order to reduce significantly the number of analytical steps and intermediate samples a multiple spiking approach was developed. The full methodology is documented and total uncertainty budgets are calculated for all certified values. A non-element specific sample digestion process was optimised. All wet chemical digestion methods examined resulted in a more or less pronounced amount of precipitate. It is demonstrated that these precipitates originate mainly from secondary formation of fluorides (essentially CaF2) and that their formation takes place after isotopic equilibration. The contribution to the total uncertainty of the final values resulting from the formation of such precipitates was in general < 0.1% for all investigated elements. Other sources of uncertainty scrutinised included the moisture content determination, procedural blank determination, cross-contamination from the different spike materials, correction for spectral interferences, instrumental background and deadtime effects, as well as the use of either certified values or IUPAC data in the IDMS equation. The average elemental content in the sediment samples was 30-130 micrograms g-1 for Pb, 0.5-3 micrograms g-1 for Cd and 50-70 micrograms g-1 for Cu. Cr was measured in one sample and was about 60 micrograms g-1. The concentrations in the fly ash sample were up to 2 orders of magnitude higher. Expanded uncertainty for the investigated elements was about 3% (coverae factor k = 2) except for Cr, (measured by high resolution ICPMS), for which the expanded uncertainty was about 7% (k = 2).     

Insecticide Contamination of Jamaican Environment. V. Island-Wide Rapid Survey of Residues in Surface and Ground Water

Residues of organochlorines and organophosphates were determined by gas chromatography in water and sediment from 26 locations in 17 major rivers, 7 natural springs and 13 wells across Jamaica. Samples were collected on only one occasion between May and July, 1994. Residues of endosulfan were detected in all but three rivers; -endosulfan in 15 samples of sediment (0.9–108.1, mean = 28.93, S.E. = 7.198 g kg-1) and 13 of water (0.01–0.35, mean = 0.11, S.E. = 0.035 g L-1), -endosulfan in 5 sediment (15.29–49.35, mean = 30.56, S.E. = 7.132 g kg-1) and 12 water (0.05–0.31, mean = 0.14, S.E. = 0.031 g L-1) samples, and endosulfan sulphate in waters of three rivers (0.003–0.244 g L-1). Chlorpyrifos was present in 9 sediment (0.423-135.2, mean = 18.38, S.E. = 10.699 g kg-1) and two water (0.001–0.022 g L-1) samples, diazinon and ethoprophos in the sediment of one river each. Mean levels (g L-1) of and isomers and sulphate of endosulfan were 0.16 (S.E. = 0.057), 0.12 (S.E. = 0.036) and 0.15 (S.E. = 0.089), respectively, in four of the seven springs and 0.23 (S.E. = 0.052), 0.11 (S.E. = 0.029) and 0.26 (S.E. = 0.088), respectively, in seven of the thirteen wells monitored.     

Sampling Benthic Macroinvertebrates in a Large Flood-Plain River: Considerations of Study Design, Sample Size, and Cost

Estimation of benthic macroinvertebrate populations over large spatial scales is difficult due to the high variability in abundance and the cost of sample processing and taxonomic analysis. To determine a cost-effective, statistically powerful sample design, we conducted an exploratory study of the spatial variation of benthic macroinvertebrates in a 37 km reach of the Upper Mississippi River. We sampled benthos at 36 sites within each of two strata, contiguous backwater and channel border. Three standard ponar (525 cm²) grab samples were obtained at each site ('Original Design'). Analysis of variance and sampling cost of strata-wide estimates for abundance of Oligochaeta, Chironomidae, and total invertebrates showed that only one ponar sample per site ('Reduced Design') yielded essentially the same abundance estimates as the Original Design, while reducing the overall cost by 63%. A posteriori statistical power analysis ( = 0.05, = 0.20) on the Reduced Design estimated that at least 18 sites per stratum were needed to detect differences in mean abundance between contiguous backwater and channel border areas for Oligochaeta, Chironomidae, and total invertebrates. Statistical power was nearly identical for the three taxonomic groups. The abundances of several taxa of concern (e.g., Hexagenia mayflies and Musculium fingernail clams) were too spatially variable to estimate power with our method. Resampling simulations indicated that to achieve adequate sampling precision for Oligochaeta, at least 36 sample sites per stratum would be required, whereas a sampling precision of 0.2 would not be attained with any sample size for Hexagenia in channel border areas, or Chironomidae and Musculium in both strata given the variance structure of the original samples. Community-wide diversity indices (Brillouin and 1-Simpsons) increased as sample area per site increased. The backwater area had higher diversity than the channel border area. The number of sampling sites required to sample benthic macroinvertebrates during our sampling period depended on the study objective and ranged from 18 to more than 40 sites per stratum. No single sampling regime would efficiently and adequately sample all components of the macroinvertebrate community.     

Soil properties and crop productivity as influenced by flyash incorporation in soil

Field experiments were carried out during 1996–97at Gulawathi, Muthiani and Salarpur Villages, IARI Farm, NewDelhi and NCPP Campus, Dadri to evaluate changes in soilcharacteristics and growth of wheat (Triticum aestivum L.),mustard (Brassica juncea L.), lentil (Lence esculentaMoench.), rice (Oryza sativa L.) and maize (Zea mays L.) byvarying amounts of flyash addition (up to 50t ha^-1) in soils atsowing/transplanting time of crops. Flyash addition in areasadjoining NCPP Thermal Power Plant, Dadri, Ghaziabad, U.P.ranged from 5–12 t ha^-1 yr^-1 in 1995–96. Shoot and root growthand yield of test crops at different locations after flyashincorporation resulted in beneficial effects of flyashaddition in most cases. The silt dominant texture of flyashimproved loamy sand to sandy loam textures of the surfacesoils at the farmers' fields. The increased growth in yield ofcrops with flyash incorporation was possibly due tomodifications in soil moisture retention and transmissioncharacteristics, bulk density, physico-chemical characterssuch as pH and EC and organic carbon content. The response offlyash addition in the soil on soil health and cropproductivity needs to be evaluated on long-term sustainableaspects.     

The interaction between physical and social-psychological factors in indoor environmental health

Indoor environmental health is now recognized as an important factor in preventing respiratory health problems in the United States. It is also a concern in Canada due to the amount of time that Canadians spend indoors because of cold weather and the potential for increased time indoors during the summer if theclimate warms. The negative health effects are often labeled assick building syndrome, but diagnosing a building or itsoccupants as sick is complicated by the variety of symptoms, thepresence of chronic versus acute symptoms and social andpsychological (socio-psychological) factors that may reduce theeffectiveness of an engineering solution. As a case study, thecontribution of various factors to indoor environmental health,in three buildings at the University of Toronto, was examinedusing five different methods. The results indicate that theinhabitants of the buildings consider features other than airquality in considering building health such as design,maintenance, funding cuts and socio-psychological factors.     

Using Multiple Antibiotic Resistance and land use characteristics to determine sources of fecal coliform bacterial pollution

Multiple Antibiotic Resistance (MAR) analysis and regression modeling techniques were used to identify surface water areas impacted by fecal pollution from human sources, and to determine the effects of land use on fecal pollution in Murrells Inlet, a small, urbanized, high-salinity estuary located between Myrtle Beach and Georgetown, South Carolina. MAR analysis was performed to identify areas in the estuary that are impacted by human-source fecal pollution. Additionally, regression analysis was performed to determine if an association exists between land use and fecal coliform densities over the ten-year period from 1989 to 1998. Land-use variables were derived using Geographic Information System (GIS) techniques and were used in the regression analysis.MAR analyses were conducted by comparing the frequency and patterns of antibiotic resistance found in Escherichia coli isolates derived from surface water samples and from sewage sources in the Murrells Inlet sewage collection system. The MAR results suggest that the majority of the fecal pollution detected in the Murrells Inlet estuary may be from non-human sources, including fecal coliforms isolated from areas in close proximity to high densities of active septic tanks.A MAR Index, which measures the frequency of antibiotic resistance, was calculated for each of twenty-three water samples and nine sewage samples. The antibiotic resistance pattern comparisons were performed using cluster analysis. Although the MAR indices indicated that several surface water sites had potential human-source contamination, the cluster analysis suggests that only one sampling site had MAR patterns that were similar to those found in the sewage samples. This site was in close proximity to several large pleasure boats as well as a sewage collection system lift station, but was not near areas with active septic tanks. The results of the regression analysis also suggest that sewage sources and rainfall runoff from urbanized areas may contribute to fecal pollution in the estuary.     

Characterization of microbial communities from coastal waters using microarrays

Molecular methods, including DNA probes, were used to identify and enumerate pathogenic Vibrio species in the Chesapeake Bay; our data indicated that Vibrio vulnificus exhibits seasonal fluctuations in number. Our work included a characterization of total microbial communities from the Bay; development of microarrays that identify and quantify the diversity of those communities; and observation of temporal changes in those communities. To identify members of the microbial community, we amplified the 16S rDNA gene from community DNA isolated from a biofilm sample collected from the Chesapeake Bay in February, 2000. The resultant 75 sequences were 95% or more similar to 7 species including two recently described Shewanella species, baltica and frigidimarina, that have not been previously isolated from the Chesapeake. When the genera of bacteria from biofilm after culturing are compared to those detected by subcloning amplified 16S fragments from community DNA, the cultured sample exhibited a strong bias. In oysters collected in February, the most common bacteria were previously unknown. Based on our 16S findings, we are developing microarrays to detect these and other microbial species in these estuarine communities. The microarrays will detect each species using four distinct loci, with the multiple loci serving as an internal control. The accuracy of the microarray will be measured using sentinel species such as Aeromonas species, Escherichia coli, and Vibrio vulnificus. Using microarrays, it should be possible to determine the annual fluctuations of bacterial species (culturable and non-culturable, pathogenic and non-pathogenic). The data may be applied to understanding patterns of environmental change; assessing the health of the Bay; and evaluating the risk of human illness associated with exposure to and ingestion of water and shellfish.     

Emissions of VOCs at Urban Petrol Retail Distribution Centres in India (Delhi and Mumbai)

Air pollution has assumed gigantic proportion killing almost half a million Asians every year. Urban pollution mainly comprises of emissions from buses, trucks, motorcycle other forms of motorized transport and its supporting activities. As Asia's cities continue to expand the number of vehicles have risen resulting in greater pollution. Fugitive emissions from retail distribution center in urban area constitute a major source. Petrol vapours escape during refueling adding pollutants like benzene, toluene, ethylbenzene and xylene to ambient air. This paper discusses a study on fugitive emissions of Volatile Organic Compounds (VOC) at some refueling station in two metropolitan cities of India, i.e., Mumbai and Delhi. Concentration of VOCs in ambient air at petrol retail distribution center is estimated by using TO-17 method. Concentration of benzene in ambient air in Delhi clearly shows the effect of intervention in use of petroleum and diesel fuel and shift to CNG. Chemical Mass Balance (CMB) model is used to estimate source contributions. At Delhi besides diesel combustion engines, refueling emissions are also major sources. At Mumbai evaporative emissions are found to contribute maximum to Total VOC (TVOC) concentration in ambient air.     

The Impact of Landsat Satellite Monitoring on Conservation Biology

Landsat 7s recent malfunctioning will result in significant gaps in long-term satellite monitoring of Earth, affecting not only the research of the Earth science community but also conservation users of these data. To determine whether or how important Landsat monitoring is for conservation and natural resource management, we reviewed the Landsat programs history with special emphasis on the development of user groups. We also conducted a bibliographic search to determine the extent to which conservation research has been based on Landsat data. Conservation biologists were not an early user group of Landsat data because a) biologists lacked technical capacity – computers and software – to analyze these data; b) Landsats 1980s commercialization rendered images too costly for biologists budgets; and c) the broad-scale disciplines of conservation biology and landscape ecology did not develop until the mid-to-late 1980s. All these conditions had changed by the 1990s and Landsat imagery became an important tool for conservation biology. Satellite monitoring and Landsat continuity are mandated by the Land Remote Sensing Act of 1992. This legislation leaves open commercial options. However, past experiments with commercial operations were neither viable nor economical, and severely reduced the quality of monitoring, archiving and data access for academia and the public. Future satellite monitoring programs are essential for conservation and natural resource management, must provide continuity with Landsat, and should be government operated.