Elimination of Methanol and Ethanol by Biofiltration: An Experimental Study

This study presents the experimental results obtained during long-term operation of two biofilters treating two alcohols: methanol and ethanol. The biofilters used for this purpose were previously packed with a compost material made from tobacco processing residues. The alcohols concentrations tested lay between 0.40 and 3.20 g/m³ for methanol, and 0.55 and 5.05 g/m³ for ethanol. The empty bed residence time in each biofilter was 60 s. Biofilter inlet loads of less than 190 and 300 g/m³/h for the methanol and ethanol additions respectively, were thereafter evaluated. In addition, the concentrations of nutrient nitrogen were also varied, from 0.1 to 2.0 g-N/l and from 0.3 to 11.3 g-N/l for the ethanol and the methanol, respectively. The results thus obtained have made it possible to select the optimal nitrogen concentrations which, for the cases examined, turn out to be 0.3 g-N/l and between 2 and 3.8 g-N/l for the ethanol and methanol substrates, respectively. The maximum elimination capacities obtained in this study were 82 and 150 g/m³/h, respectively for the methanol and ethanol cases. It was therefore concluded that, for a readily biodegradable compound such as ethanol, the nitrogen requirement is substantially lower than that needed for the methanol degradation, the latter appearing to be more difficult to degrade biologically under similar operating conditions. The production rate of the co-product carbon dioxide during methanol and ethanol biofiltration was also investigated. Also, a good correlation was found to exist between the temperature and the conversion achieved in the biofilter.     

Performance of a low cost MBT prior to landfilling: study of the biological treatment of size reduced MSW without mechanical sorting

In France, the interest in Mechanical Biological Treatment (MBT) prior to landfilling is actually growing. In the absence of acceptance criteria for the waste to be landfilled, an alternative to the intensive, high-technology MBT can only find its place in the French context if it shows substantial benefits from an environmental, economic or operational point of view. This paper presents an experiment of low-cost MBT of size reduced MSW without material splitting. The performance of an experimental, pilot-scale mechanical and biological treatment process has been studied on 37.5 Mg of raw municipal solid waste. The mechanical process has been kept simple with only coarse shredding and no material recovery. The biological treatment, which was a low-cost forced aeration process, was monitored for 25 weeks. The biogas production potential of the waste was reduced by 90% to 19 NL kgDM(-1). The initial AT4 index of 82.9 mg O2 gDM(-1) decreased to 16.0 mg O2 gDM(-1). After 25 weeks of aerobic treatment, the dry mass loss reached 37%, while the mass of waste going to landfill was reduced by 28%. The average performances of the process were explained by the biological process itself, which was not optimal, and also by the characteristics of the input waste. The high particle size of the treated waste and the high content of slowly biodegradable matter (such as paper and cardboard) may both be significant drawbacks for the biological stabilisation of waste.     

Treatment and use of air pollution control residues from MSW incineration: an overview

This work reviews strategies for the management of municipal solid waste incineration (MSWI) residues, particularly solid particles collected from flue gases. These tiny particles may be retained by different equipment, with or without additives (lime, activated carbon, etc.), and depending on the different possible combinations, their properties may vary. In industrial plants, the most commonly used equipment for heat recovery and the cleaning of gas emissions are: heat recovery devices (boiler, superheater and economiser); dry, semidry or wet scrubbers; electrostatic precipitators; bag filters; fabric filters, and cyclones. In accordance with the stringent regulations in force in developed countries, these residues are considered hazardous, and therefore must be treated before being disposed of in landfills. Nowadays, research is being conducted into specific applications for these residues in order to prevent landfill practices. There are basically two possible ways of handling these residues: landfill after adequate treatment or recycling as a secondary material. The different types of treatment may be grouped into three categories: separation processes, solidification/stabilization, and thermal methods. These residues generally have limited applications, mainly due to the fact that they tend to contain large quantities of soluble salts (NaCl, KCl, calcium compounds), significant amounts of toxic heavy metals (Pb, Zn, Cr, Cu, Ni, Cd) in forms that may easily leach out, and trace quantities of very toxic organic compounds (dioxin, furans). The most promising materials for recycling this residue are ceramics and glass-ceramic materials. The main purpose of the present paper is to review the published literature in this field. A range of studies have been summarized in a series of tables focusing upon management strategies used in various countries, waste composition, treatment processes and possible applications.     

Implications of the spatial variability of landfill emission rates on geospatial analyses

Accurate methods quantifying whole landfill surface flux of methane are important for regulatory and research purposes. This paper presents the results from the analysis of chamber measurements utilizing geospatial techniques [kriging and inverse distance weighting (IDW)] to arrive at an estimation of the whole landfill surface flux from the spatially distributed chamber measurement points. The difficulties in utilizing these methods will be discussed. Methane flux was determined on approximately 20 m grid spacing and variogram analysis was performed in order to model spatial structure, which was used to estimate methane flux at unsampled locations through kriging. Our analysis indicates that while the semi-variogram model showed some spatial structure, IDW was a more accurate interpolation method for this particular site. This was seen in the comparison of the resulting contour maps. IDW, coupled with surface area algorithms to extract the total area of user defined contour intervals, provides a superior estimate of the methane flux as confirmed through the methane balance. It is critical that the results of the emissions estimates be viewed in light of the whole cell methane balance; otherwise, there is no rational check and balance system to validate the results.     

Net value royalties : Practical tool or economist's illusion?

The petroleum industry has traditionally generated substantial revenues for governments. Where governmental power is divided, as in federations like Canada and Australia, a junior level of government normally collects royalties while the senior level levies a variety of imposts (income tax, export duties, excises on production). The combination of recent sharp reductions in prices, more price volatility and an era of freer markets has subjected existing tax and royalty systems to severe strain and has shifted attention to the design of fiscal systems that are more profit- sensitive. For the royalty element, interest focuses on net value royalties (NVRs). This paper deals with the nature and problems of NVRs. It proceeds by looking first at the application of resource rent royalties in Australia. It then focuses on recent megaproject royalty arrangements in Alberta and evaluates the degree to which Alberta's current royalty system is profit- sensitive. Problems associated with NVRs are discussed in the fourth section; concluding remarks are made in the last section.     

Reverse logistics in the Brazilian construction industry

In Brazil most Construction and Demolition Waste (C&D waste) is not recycled. This situation is expected to change significantly, since new federal regulations oblige municipalities to create and implement sustainable C&D waste management plans which assign an important role to recycling activities. The recycling organizational network and its flows and components are fundamental to C&D waste recycling feasibility. Organizational networks, flows and components involve reverse logistics. The aim of this work is to introduce the concepts of reverse logistics and reverse distribution channel networks and to study the Brazilian C&D waste case.     

Landfill leachate treatment methods: A review

Landfilling of municipal waste is still a major issue of the waste management system in Europe. The generated leachate must be appropriately treated before being discharged into the environment. Technologies meant for leachate treatment can be classified as follows (i) biological methods, (ii) chemical and physical methods. Here we review briefly the main processes currently used for the landfill leachates treatments.     

堆肥处理对污泥腐殖物质组成和光谱学特征的影响

采用凝胶(Sephadex G-75)色谱、荧光光谱和红外光谱法研究了污泥堆肥的HA和FA在堆制前后的组成与结构特征变化．凝胶色谱分析表明,污泥经过63d堆腐后,HA中大分子组分含量明显提高;而FA则由不同分子量物质组成,其中小分子量物质占主要部分,在堆腐以后,FA中大分子物质含量下降30％,小分子量物质含量则相对增加．同时,荧光光谱、红外光谱的结果表明：随着污泥堆肥的进行,HA中有机物不饱和结构的多聚化或联合程度增大,芳香结构物质含量增加;但经过堆制的FA具有更多的结构简单的低分子量物质和更低的芳构化水平．     

Nitrogen export from an agriculture watershed in the Taihu Lake area, China

Temporal changes in nitrogen concentrations and stream discharge, as well as sediment and nitrogen losses from erosion plots with different land uses, were studied in an agricultural watershed in the Taihu Lake area in eastern China. The highest overland runoff loads and nitrogen losses were measured under the upland at a convergent footslope. Much higher runoff, sediment and nitrogen losses were observed under upland cropping and vegetable fields than that under chestnut orchard and bamboo forest. Sediment associated nitrogen losses accounted for 8-43.5% of total nitrogen export via overland runoff. N lost in dissolved inorganic nitrogen forms (NO(3-)-N + NH4+-N) accounted for less than 50% of total water associated nitrogen export. Agricultural practices and weather-driven fluctuation in discharge were main reasons for the temporal variations in nutrient losses via stream discharge. Significant correlation between the total nitrogen concentration and stream discharge load was observed. Simple regression models could give satisfactory results for prediction of the total nitrogen concentrations in stream water and can be used for better quantifying nitrogen losses from arable land. Nitrogen losses from the studied watershed via stream discharge during rice season in the year 2002 were estimated to be 10.5 kg N/ha using these simple models.