Further studies using X-ray fluorescence to sample lead contaminated carpeted surfaces

The sampling of carpeted surfaces to test for lead contamination primarily focuses upon vacuum techniques. Vacuum sampling techniques, however, require time-consuming, expensive laboratory analysis of the dusts obtained and are unable to determine total lead load on the carpet. X-ray fluorescence (XRF) analysis is an on-site, inexpensive, non-destructive, quick technique for predicting metals levels in a variety of media, such as water, soil, filter paper and painted surfaces. A 1992 study of the feasibility of XRF to analyze for lead and soil loadings on carpeted surfaces indicated that XRF can detect lead at a low enough level to warrant further study. This paper expands this earlier study and developes lead and soil loading calibration curves for three different carpet types based upon XRF lead L-beta peak areas and XRF iron and barium K-alpha peak and background areas. Results indicate that variation in the data can be reduced through modifications of the XRF analysis technique, thus reducing the statistically determined detection level, and that carpet type does affect the calibration. Detection levels of approximately 70 mg/m² for lead and 5 g/m² for soil were obtained. Overall, good agreement was found between results of this study and the earlier one. XRF shows excellent potential for quantitative analysis of lead on carpeted surfaces.     

Factor analysis of trace-element data from tree-bark samples in The Netherlands

Monte Carlo-assisted factor analysis has been applied to a data set of 20 trace-element concentrations in tree-bark samples obtained from 123 locations in The Netherlands, with the aim to investigate the suitability of bark as a biomonitor for air pollution. A Monte Carlo approach was used to give more insight to the uncertainties and significance levels of the factor analysis results. Notwith-standing a rather strong influence of soil material on the concentration levels, factor analysis enabled the identification of five significant pollution source types, all of which corresponded with source types found in an earlier biomonitoring study in The Netherlands using epiphytic lichens. A more detailed comparison with the lichen results showed a remarkable difference in lead concentrations between bark and lichen. It was concluded that bark can be successfully employed as a biomonitor for air pollution. The power of factor analysis to adequately determine the soil contribution may render extensive sample washing procedures superfluous.     

Characterizing soils for hazardous waste site assessments

This paper provides a review and justification of the minimum data needed to characterize soils for hazardous waste site assessments and to comply with the Comprehensive Environmental Response, Compensation and Liability Act (CERCLA). Scientists and managers within the regulatory agency and the liable party need to know what are the important soil characteristics needed to make decisions about risk assessment, what areas need remediation and what remediation options are available. If all parties involved in characterizing a hazardous waste site can agree on the required soils data set prior to starting a site investigation, data can be collected in a more efficient and less costly manner. Having the proper data will aid in reaching decisions on how to address concerns at, and close-out, hazardous waste sites.This paper was prepared to address two specific concerns related to soil characterization for CERCLA remedial response. The first concern is the applicability of traditional soil classification methods to CERCLA soil characterization. The second is the identification of soil characterization data type required for CERCLA risk assessment and analysis of remedial alternatives. These concerns are related, in that the Data Quality Objective (DQO) process addresses both. The DQO process was developed in part to assist CERCLA decision-makers in identifying the data types, data quality, and data quantity required to support decisions that must be made during the remedial investigation/feasibility study (RI/FS) process. Data Quality Objectives for Remedial Response Activities: Development Process (US EPA, 1987a) is a guidebook on developing DQOs. This process as it relates to CERCLA soil characterization is discussed in the Data Quality Objective Section of this paper.     

Use of cluster and principal component analyses to profile areas in California where ground water has been contaminated by pesticides

An empirical approach to profiling areas of ground water contamination by pesticides was devised that did not rely upon determining the level of vulnerability between land areas and that did not assume any particular pathway for ground water contamination. Climatic and soil data were obtained for 1-square mile sections of land in California where pesticide residues had been found in well water samples and the detection was attributed to legal agricultural applications. These sections were designated as known contaminated (KC) sections. Climate and soil data were also obtained for sections which lacked either well sampling data or a positive pesticide detection. These sections were designated as candidate sections. Statistical procedures were used to cluster groups of KC sections first with respect to climate characteristics and then with respect to soil characteristics. Principal components analysis (PCA) was used to construct a statistical profile of soil variables for each cluster of KC sections. A method based on the PCA was developed to compare the similarity of soil profiles derived for each KC section cluster to individual candidate sections. Since the profiling scheme was based only on data from KC sections, candidate sections that did not match any KC cluster profile could only be considered dissimilar to contaminated sections, receiving a status of not-classified. This profiling method is flexible and it can be revised to incorporate updated well sampling information.     

Criteria for the evaluation of alternative environmental monitoring variables: Theory and an application using winter flounder (Pleuronectes americanus) and Dover sole (Microstomus pacificus)

The design of environmental monitoring programs is frequently hampered by a lack of objective, quantitative criteria for evaluating alternative monitoring variables. In this paper we describe two such criteria, which we call samples required — the number of samples required to detect a given change in value — and information imparted — the amount of environmental information revealed by the monitoring variable. We then use these criteria to evaluate fin erosion in winter flounder (Pleuronectes americanus) and Dover sole (Microstomus pacificus) as marine environmental monitoring variables. Two methods for determining the samples required use contaminated and reference areas to estimate the sample statistics of a hypothetical impacted population. The first method is based on the overall difference in the proportions of diseased fish in the reference and hypothetical populations. The second treats the proportion of diseased fish in individual trawls as the variate and determines the samples required based on the mean and variance of the reference and contaminated populations. We use both methods to predict the number of trawls needed to detect an increase of 200% in fin erosion in the reference population. The first method had greater statistical power but assumes spatially homogeneous populations. The second method accounts for environmental patchiness. For Dover sole it predicted 1661 trawls would be needed to detect the 200% increase. An estuarine winter flounder population would require 74 trawls, and an oceanic winter flounder population would require 142.5 trawls. It appears that fin erosion in winter flounder may be a useful indicator of environmental contamination, but several stipulations apply. Migration may inflate the number of diseased fish observed in the reference population, and a more detailed etiology of the disease is required, including an understanding of what contaminants are responsible for manifestation of the disease.     

Monitoring of the three organophosphate esters TBP,TCEP and TBEP in river water and ground water (Oder,Germany)

The behaviour of the three organophosphate esters tributyl phosphate (TBP), tris(2-chloroethyl)phosphate (TCEP) and tris(2-butoxyethyl)phosphate (TBEP) during infiltration of river water to ground water has been investigated. The monitoring site is the Oder River and the adjacent Oderbruch aquifer. From March 2000 to July 2001, 76 ground water samples from monitoring wells located close to the Oder River and nine river water samples were collected. Additionally, influent and effluent samples from local waste water treatment plants, one sample of rain water and samples of roof runoff were collected. All samples were analysed by solid-phase-extraction followed by gas chromatography/mass spectrometry. TBP, TCEP and TBEP were detected at mean values of 622 ng l(-1), 352 ng l(-1), and 2955 ng l(-1), respectively in municipal waste water effluents. This points to a major input of these compounds into the Oder River by municipal waste water discharge. The concentrations of TBP and TBEP decreased downstream the Oder River possibly due to aerobic degradation. TBP, TCEP and TBEP were detected in ground water influenced predominantly by bank-filtered water. This demonstrates a transport of organic compounds by river water infiltration to ground water. TBP, TCEP and TBEP were also detected in rain water precipitation, roof runoff and ground water predominantly influenced by rain water infiltration. This hints to an input of these compounds to ground water by dry and wet deposition after atmospheric transport. Organophosphate esters were also detected in parts of the aquifer at 21 m depth. This demonstrates low anaerobic degradation rates of TBP, TCEP and TBEP.     

Distribution of polychlorinated biphenyls (PCBs) and organochlorine pesticides in soils from the East Antarctic coast

Concentrations of hexachlorobenzene (HCB), alpha-, beta- and gamma-hexachlorocyclohexane (HCH) isomers, 6 o,p'-and p,p'-isomers of DDT and 28 PCB congeners have been measured in eleven soil samples and one lichen collected on the Eastern coast of Antarctica from 5 Russian stations. For samples with low concentrations of PCBs (range 0.20-0.41 ng g(-1) dry weight) and pesticides (0.86-4.69 ng g(-1) and 0.11-1.22 ng g(-1) dry weight for HCHs and DDTs, respectively), atmospheric long-range transport from Africa, South America or Australia was suggested as the sole source of contamination. The profile of PCB congeners was dominated by the more volatile tri-, tetra- and penta-PCBs congeners, thus supporting long-range transport hypothesis. Four samples contained moderate levels of PCBs (range 1.98-6.94 ng g(-1) dry weight) and variable concentrations of pesticides (gamma-HCH, p,p'-DDT and o,p'-DDT being the main contaminants). For samples with high concentrations of PCBs (range 90.26-157.45 ng g(-1)) and high concentrations of pesticides, the presence of high molecular weight PCB congeners such as: 153, 180, 187, 170 etc, strongly suggest a local source (biotic) of PCBs rather than atmospheric transport. It is likely that on a local scale, biotic focussing of pollutants, due to bird activities (nesting and excrement) can cause high contamination levels and become more significant than contaminant input via abiotic pathways.     

Derivation of Nutrient Guidelines for Streams in Victoria, Australia

Human induced increases to nutrientconcentrations in streams have led to many agenciesdeveloping strategies and criteria for nutrientreduction. National or statewide guidelines aregenerally inappropriate, due to the natural variabilityin stream ecosystems within political boundaries. Thisstudy used an extant aquatic macroinvertebrate-basedregionalisation for the state of Victoria, Australia, asthe basis for defining regions of relatively homogeneousenvironmental character. This enabled the selection ofecologically-based regional reference sites andsubsequent characterisation of the nutrient status ofthese sites. Using an extensive biological and nutrientdata base for streams across the State, we calculated50th and 75th percentile concentrations forreference sites within each region. Using thesepercentiles in conjunction with impact and recoverystudies, we defined nutrient guidelines for each region. Although the nutrient data largely supported thebiological regionalisation, patterns in the nutrient datadid require some minor modifications for the nutrientregions. Relatively unimpacted regions with referencesites in very good-to excellent-condition were assignedguidelines largely based on the 75th percentiles. The more impacted regions, where best availablereference sites were of poorer quality, were assignedguidelines based largely on the 50th percentiles. Professional judgement and known extents of impactsacross each region provided important contributions tothe decision-making process. The derived guidelineconcentrations are comparable to several cited in theliterature and are proposed for use in monitoring,assessment and restoration targets.     

Persistent chlorinated pesticides in fish and cattle fat and their implications for human serum concentrations from the Sene-Gambian region

The concentrations of organochlorine pesticides (OCPs) in fish, shrimps, cattle fat and human serum samples from the Sene-Gambian region were measured using validated analytical methodologies. The results obtained were compared with those of other existing African studies and with data from other developing countries. In fish samples, p,p'-dichlorodiphenyldichloroethylene (p,p'-DDE) and HCB were detected with a frequency of 100%, whereas p,p'-dichlorodiphenyltrichloroethane (p,p'-DDT) was detected in eight, heptachlorepoxide in six and endosulfansulfate in five of the nine fish samples. Relatively low concentrations of OCPs were found in cattle and shrimp fat samples. p,p'-DDE and alpha-hexachlorocyclohexane (alpha-HCH) were the most frequently identified. The sum of HCHs ranged from undetected to 13.3 ng g-1 fat, the sum of DDTs from 11.1 to 199.2 ng g-1 fat and the sum of endosulfans from not detected to 49.7 ng g-1 fat in fish and shrimps. In serum samples, alpha-HCH, p,p'-DDE, o,p'-DDT and p,p'-DDT were detected in all 16 pooled serum samples, whereas endosulfansulfate, methoxychlor, mirex, heptachlorepoxide and endrin were detected in 15 samples with most of the concentrations below 10 ng mL-1. The concentrations of OCPs in human serum were given on a serum lipid and whole serum volume basis. The implications for the human diet of these OCP concentrations in serum were investigated by means of biomagnification factors related to the log Kow values of the targeted compounds. The current use of HCH mixtures was suggested to explain the unusually high alpha-HCH concentration. The distribution pattern of these OCPs in humans was also discussed and compared with that in other studies.     

CO and NO2 pollution in a long two-way traffic road tunnel: investigation of NO2/NOx ratio and modelling of NO2 concentration

The CO, NO and NO2 concentrations, visibility and air flow velocity were measured using continuous analysers in a long Norwegian road tunnel (7.5 km) with traffic in both directions in April 1994 and 1995. The traffic density was monitored at the same time. The NO2 concentration exceeded Norwegian air quality limits for road tunnels 17% of the time in 1994. The traffic through the tunnel decreased from 1994 to 1995, and the mean NO2 concentration was reduced from 0.73 to 0.22 ppm. The ventilation fan control, based on the CO concentration only, was unsatisfactory and the air flow was sometimes low for hours. Models for NO2 concentration based on CO concentration and absolute air flow velocity were developed and tested. The NO2/NOx ratio showed an increase for NOx levels above 2 ppm; a likely explanation for this phenomenon is NO oxidation by O2. Exposure to high NO2 concentrations may represent a health risk for people with respiratory and cardiac diseases. In long road tunnels with two-way traffic, this study indicates that ventilation fan control based on CO concentration should be adjusted for changes in vehicle CO emission and should be supplemented by air flow monitoring to limit the NO2 concentration.