Methane production potential of leachate generated from Korean food waste recycling facilities: a lab-scale study

This paper examines the applicability of food waste leachate (FWL) in bioreactor landfills or anaerobic digesters to produce methane as a sustainable solution to the persisting leachate management problem in Korea. Taking into account the climatic conditions in Korea and FWL characteristics, the effect of key parameters, viz., temperature, alkalinity and salinity on methane yield was investigated. The monthly average moisture content and the ratio of volatile solids to total solids of the FWL were found to be 84% and 91%, respectively. The biochemical methane potential experiment under standard digestion conditions showed the methane yield of FWL to be 358 and 478 ml/g VS after 10 and 28 days of digestion, respectively, with an average methane content of 70%. Elemental analysis showed the chemical composition of FWL to be C(13.02)H(23.01)O(5.93)N(1). The highest methane yield of 403 ml/g VS was obtained at 35 degrees C due to the adaptation of seed microorganisms to mesophilic atmosphere, while methane yields at 25, 45 and 55 degrees C were 370, 351 and 275 ml/g VS, respectively, at the end of 20 days. Addition of alkalinity had a favorable effect on the methane yield. Dilution of FWL with salinity of 2g/l NaCl resulted in 561 ml CH(4)/g VS at the end of 30 days. Considering its high biodegradability (82.6%) and methane production potential, anaerobic digestion of FWL in bioreactor landfills or anaerobic digesters with a preferred control of alkalinity and salinity can be considered as a sustainable solution to the present emergent problem.     

Production of gaseous fuel from refuse plastic fuel via co-pyrolysis using low-quality coal and catalytic steam gasification

In this study, refuse plastic fuel (RPF) was copyrolyzed with low-quality coal and was gasified in the presence of a metal catalyst and steam. Some metal catalysts, such as Ni, NiO, and Mg, and mixtures of these with base promoters such as Al₂O₃ and Fe₂O₃ were employed in the pyrolysis and gasification processes to convert the synthesis gas into more valuable fuel gas. The operating temperatures for the pyrolysis and gasification were between 700° and 1000°C. The experimental parameters were the operating temperature, catalyst type, basic promoter type, and steam injection amount. Solid fuel samples (5 g) were fed into a semibatch-type quartz tube reactor when the reactor reached the designated temperature. The synthesis gas was analyzed by gas chromatography. The use of low-quality coal as fuel in co-pyrolysis with RPF was explored. For the co-pyrolysis of RPF and low-quality coal, the effectiveness of the catalysts for fuel gas production followed the order Mg > NiO > Ni. In catalytic gasification of RPF, the addition of Al₂O₃ seemed to reduce the activity of the corresponding catalysts Ni and Mg. The maximum fuel gas yield (92.6%) was attained when Mg/Fe₂O₃ was used in steam gasification at 1000°C.     

Assessing the aerodynamic effects of tail elongations in the house martin (Delichon urbica): implications for the initial selection pressures in hirundines

Of the three species of hirundine that breed sympatrically across the U.K., one, the barn swallow, has outer tail feathers elongated into streamers, whereas the other two species, the house martin and the sand martin, do not. The tail streamer of the barn swallow is regarded as a classic example of a sexually selected trait. Recent evidence, however, has suggested that streamers may have evolved largely through natural selection for enhanced flight performance and increased maneuverability. We tested the hypotheses that small streamers (1) increase performance in turning flight, but (2) decrease performance in flight variables related to velocity. We manipulated the lengths of house martin outer tail feathers and measured changes in their free-flight performance, using stereo-video to reconstruct the birds" three-dimensional flight paths. Five flight variables were found to best describe individual variation in flight performance. Of these five, the three variables determining maneuverability predicted that flight performance would be optimized by a 6- to 10-mm increase in the length of the outer tail feathers. In contrast, for mean velocity and mean acceleration, extension of the outer tail feathers appears to have a detrimental effect on flight performance. We suggest that the initial selection pressure for streamers in ancestral short-tailed "barn swallows" was via natural selection for increased maneuverability. In addition, we propose that the benefits of increased maneuverability have differed between hirundines in the past, such that the cost of increasing the length of the outer tail feather has, to date, outweighed the benefits of doing so in streamerless hirundines. Received: 14 February 2000 / Revised: 2 July 2000 / Accepted 18 July 2000     

Size removal on polyester fabrics by plasma source ion implantation device

Plasma treatment was evaluated as an alternative clean desizing technology in this work. As indicated by weight loss, O2 plasma treatment efficiently removed sizing agents such as polyvintyl alcohol (PVA), polyacrylic acid esters and their mixture (MIX) on polyethylene terephthalate (PET) fabrics. SEM pictures of the plasma treated samples directly proved the disappearance of the sizing agents. XPS analysis showed apparent changes in chemical composition and functional groups of the PET surface after O2 plasma treatment. Carbon content decreased due to the removal of sizing agents while oxygen content increased. O2 plasma treatment also increased hydrophilic functional groups of sizing agents, which is confirmed by C1s and O1s deconvolution analyses. After O2 plasma treatment, the PET fabric was subjected to conventional desizing process at different temperatures. Except for the PET fabric sized with PVA, plasma-treated fabrics showed more efficient desizing results when compared with untreated fabrics. Furthermore, the desizing effluent from the treated fabric gave lower TOC, COD and BOD values.     

Nanoparticle and ultrafine particle events at the Fresno supersite

Continuous measurements of particle size distributions of 3-407 nm were collected from August 2002 to July 2004 at the Fresno Supersite to understand their number concentrations, size distributions, and formation processes. Measurements for fine particulate matter (PM2.5) mass, sulfate (SO4(2-)), nitrate (NO3-), black carbon (BC), particle-bound polycyclic aromatic hydrocarbons (PAHs), nitrogen oxides (NOx), carbon monoxide (CO), ozone (O3), and meteorological data (wind speed, wind direction, temperature [T], relative humidity [RH], and solar radiation) were used to determine the causes of nanoparticle (3-10 nm) and ultrafine (10-100 nm) particle events. These events were found to be divided into four types: (1) 3- to 10-nm morning nucleation; (2) 10- to 30-nm morning traffic; (3) 10- to 30-nm afternoon photochemical; and (4) 50- to 84-nm evening home heating, including residential wood combustion. Intense examples of the first type (>10(4) number [#]/cm3) were observed on 29 days, nearly always during the summer. The second type of event was observed on more than 73 days and occurred throughout the year. The third type was observed on 36 days, from spring through summer. The fourth type was found on 109 days, all of them during the winter. Although sulfur dioxide (SO2) emissions in Central California are low, the small residual amounts in gasoline and diesel fuel are apparently sufficient to initiate nucleation events. These were measured in the morning, soon after the shallow surface inversion coupled with layers aloft where nucleation probably was initiated. PM2.5 concentrations were poorly correlated with nanoparticle number.     

Comparison of continuous and filter-based carbon measurements at the Fresno supersite

Results from six continuous and semicontinuous black carbon (BC) and elemental carbon (EC) measurement methods are compared for ambient samples collected from December 2003 through November 2004 at the Fresno Supersite in California. Instruments included a multi-angle absorption photometer (MAAP; lambda = 670 nm); a dual-wavelength (lambda = 370 and 880 nm) aethalometer; seven-color (lambda = 370, 470, 520, 590, 660, 880, and 950 nm) aethalometers; the Sunset Laboratory carbon aerosol analysis field instrument; a photoacoustic light absorption analyzer (lambda = 1047 nm); and the R&P 5400 ambient carbon particulate monitor. All of these acquired BC or EC measurements over periods of 1 min to 1 hr. Twenty-four-hour integrated filter samples were also acquired and analyzed by the Interagency Monitoring of Protected Visual Environments (IMPROVE) thermal/optical reflectance carbon analysis protocol. Site-specific mass absorption efficiencies estimated by comparing light absorption with IMPROVE EC concentrations were 5.5 m2/g for the MAAP, 10 m2/g for the aethalometer at a wavelength of 880 nm, and 2.3 m2/g for the photoacoustic analyzer; these differed from the default efficiencies of 6.5, 16.6, and 5 m2/g, respectively. Scaling absorption by inverse wavelength did not provide equivalent light absorption coefficients among the instruments for the Fresno aerosol measurements. Ratios of light absorption at 370 nm to those at 880 nm from the aethalometer were nearly twice as high in winter as in summer. This is consistent with wintertime contributions from vehicle exhaust and from residential wood combustion, which is believed to absorb more shorter-wavelength light. To reconcile BC and EC measurements obtained by different methods, a better understanding is needed of the wavelength dependence of light-absorption and mass-absorption efficiencies and how they vary with different aerosol composition.     

Health effects of PM2.5 constituents and source contributions in major metropolitan cities,South Korea

Ambient PM_2.5 is one of the major risk factors for human health, and is not fully explained solely by mass concentration. We examined the short-term associations of cause-specific mortality (i.e., all-cause, cardiovascular, and respiratory mortality) with the 15 chemical constituents and sources of PM_2.5 in four metropolitan cities of South Korea during 2014–2018. We found transition metals consistently showed significant associations with all-cause mortality, while the effects of other constituents varied across the cities and for cause of death. Carbonaceous components strongly affected the all-cause, cardiovascular, and respiratory mortality in Daejeon. Secondary inorganic aerosols, SO₄^2? and NH₄⁺, showed significant associations with respiratory mortality in Gwangju. We also found the sources from which species closely linked to mortality generally increased the relative mortality risks. Heavy metal markers from soil or industrial sources were significantly associated with mortality in all cities. However, several sources influenced mortality despite their marker species not being significantly associated with it. Secondary nitrate and secondary sulfate sources were linked to mortality in DJ. This could be attributed to the deep inland location, which might have facilitated formation of secondary inorganic aerosols. In addition, primary sources including mobile and coal combustion seemed to have acute impacts on respiratory mortality in Gwangju. Our findings suggest the necessity of positive matrix factorization (PMF)-based approaches for evaluating health effects of PM_2.5 while considering the spatial heterogeneity in the compositions and source contributions of PM_2.5.

     

Sorption of the fumigant 1,3-dichloropropene on soil

The fumigant 1,3-dichloropropene (1,3-D) is considered a major replacement to methyl bromide, which is to be phased out of use in the United States by 2005. The main purpose of this study was to evaluate soil-water partitioning of 1,3-D in two California agricultural soils (Salinas clay loam and Arlington sandy loam). The partition coefficients (Kd and Kf) were determined by directly measuring the concentration of 1,3-D in the solid phase (Cs) and aqueous phase (Cw) after batch equilibration. In the Salinas clay loam, the Kf of cis-1,3-D in adsorption and desorption isotherms was 0.47 and 0.54, respectively, with respective values of 0.39 and 0.49 for trans-1,3-D. This slight hysteric effect suggests that a different range of forces are involved in the adsorption and desorption process. Since n was near unity in the Freundlich equation, the Freundlich isotherms can also be approximated using the liner isotherm. At 25 degrees C, the Kd of the 1,3-D isomers in both soils ranged from 0.46 to 0.56, and the Koc (organic matter partition coefficient) ranged from 58 to 70. The relatively low Kd values and a Koc that falls within the range of 50-150, suggests that 1,3-D is weakly sorbed and highly mobile in these soils. Understanding the sorption behavior of 1,3-D in soil is important when developing fumigation practices to reduce the movement of 1,3-D to the air and groundwater.     

Studies on hexavalent chromium biosorption by chemically-treated biomass of Ecklonia sp

The biomass of the brown seaweed, Ecklonia sp., is capable of reducing Cr(VI) to Cr(III). However, very little is known about the mechanism of Cr(VI) reduction by the biomass. The aims of the present investigation were to enhance the Cr(VI)-reducing capacity of the biomass using various chemical treatments and to elucidate the mechanisms governing Cr(VI) reduction. Among the various chemical treatments, acid-treatment showed the best performance with regards the improvement of Cr(VI) removal from the aqueous phase, while organic solvent-treatment significantly improved the removal efficiency of total Cr in the equilibrium state. Based on FTIR study, the biomass was subjected to chemical modification of its amino and carboxyl groups, to examine their roles in the Cr(VI) removal from the aqueous phase. Methylation of the amino group significantly decreased the Cr(VI) removal rate, but amination of the carboxyl group significantly increased the Cr(VI) removal rate. Meanwhile, esterification of the carboxyl group and carboxylation of the amino group decreased the Cr(VI) removal rate, but the former showed a more negative effect than the latter. These findings indicated that the amino and carboxyl groups take part in the Cr(VI) removal from the aqueous phase. In conclusion, mechanisms for direct and indirect Cr(VI) removal are proposed, and some aspects for the application of this biomass to Cr(VI) detoxification are discussed.