Combined steam-dry reforming of toluene in syngas over CaNiRu/Al2O3 catalysts

Cracking, steam reforming, dry reforming, and combined steam and dry reforming of toluene in model syngas were performed using catalysts to simulate tar removal produced during biomass gasification. The catalysts were prepared by adding Ru, Ca, and Mn to Ni-based catalysts, and their properties were measured using BET, pulse CO chemisorption, XRD and TG. In steam and dry reforming of toluene, a high toluene conversion was observed with increasing Ca content in the catalyst and catalysts containing Ca showed a higher activity than those containing Mn. In combined steam-dry reforming with syngas, 1%CaNiRu/Al₂O₃ indicated a conversion of 93.9% at 800°C.     

Mercury leaching characteristics of waste treatment residues generated from various sources in Korea

In this study, mercury (Hg) leaching characteristics of the waste treatment residues (fly ash, bottom ash, sludge, and phosphor powder) generated from various sources (municipal, industrial, medical waste incinerators, sewage sludge incinerator, oil refinery, coal-fired power plant, steel manufacturing plant, fluorescent lamp recycler, and cement kiln) in Korea were investigated. First, both Hg content analysis and toxicity characteristic leaching procedure (TCLP) testing was conducted for 31 collected residue samples. The Hg content analysis showed that fly ash from waste incinerators contained more Hg than the other residue samples. However, the TCLP values of fly ash samples with similar Hg content varied widely based on the residue type. Fly ash samples with low and high Hg leaching ratios (R_L) were further analyzed to identify the major factors that influence the Hg leaching potential. Buffering capacity of the low-R_L fly ash was higher than that of the high-R_L fly ash. The Hg speciation results suggest that the low-R_L fly ashes consisted primarily of low-solubility Hg compounds (Hg₂Cl₂, Hg⁰ or HgS), whereas the high-R_L fly ashes contain more than 20% high-solubility Hg compounds (HgCl₂ or HgSO₄).     

Assessment of Young Dong tributary and Imgok Creek impacted by Young Dong coal mine,South Korea

An initial reclamation of the Young Dong coal mine site, located in northeastern South Korea, was completed in 1995. Despite the filling of the adit with limestone, acid rock drainage (ARD) enters Young Dong tributary and is then discharged to Imgok Creek. This ARD carries an average of 500 mg CaCO₃/l of mineral acidity, primarily as Fe(II) and Al. Before spring runoff, the flow of Imgok Creek is 3.3–4 times greater than that of the tributary and has an alkalinity of 100 mg CaCO₃/l, which is sufficient to eliminate the mineral acidity and raise the pH to about 6.5. From April through September 2008, there were at least two periods of high surface flow that affects the flow of ARD from the adit. Flow of ARD reaches 2.8 m³/min during spring runoff. This raised the concentrations of Fe and Al in the confluence with Imgok Creek. However, by 2 km downstream the pH of the Imgok Creek is 6.5 and only dissolved Fe is above the Korean drinking water criteria (0.30 mg/l). This suggests only a minor impact of Young Dong Creek water on Imgok Creek. Acid digestion of the sediments in Imgok Creek and Young Dong Tributary reveals considerable abundances of heavy metals, which could have a long-term impact on water quality. However, several water-based leaching tests, which better simulate the bioavailable metals pool, released only Al, Fe, Mn, and Zn at concentrations exceeding the criteria for drinking water or aquatic life.

     

Analysis of the association between air pollution and allergic diseases exposure from nearby sources of ambient air pollution within elementary school zones in four Korean cities

The objectives of this study were to survey elementary school students regarding the environmental conditions of their elementary schools and to assess the relationship between air pollution and allergic disease using the International Study of Asthma and Allergies in Childhood (ISAAC) questionnaire. Therefore, this study was designed as a cross-sectional study. In this study, seven elementary schools were selected and they were classified into three categories. The selection included one school with no traffic-related or other pollutants, three with traffic-related pollutants, and three with traffic-related and other pollutants from industrial and filling station sources. The ISAAC questionnaire survey was given to all of the students except to those in the 1st grade who were presumed to be less likely to be exposed to the school environment than the remainder of the students attending those seven schools. The assessment of allergic disease was conducted on a total of 4,545 students. Three school zones with critical exposure were selected within each school and they were evaluated based on the levels of black carbon (BC), PM₁₀, SO₂, NO₂, and O₃. There was a significant increase in the risks based on the odds ratios of treatment experiences (within 1 year) for allergy-related diseases such as asthma and allergic rhinitis (a) in the school group with traffic-related pollutants and the school group with complex pollutants were 2.12 (1.41–3.19) and 1.59 (1.06–2.37), respectively, in comparison to the school groups with no exposure to pollutants. This was determined based on the odds ratio of symptoms and treatment experiences for allergy-related diseases by group based on the home town zone as a reference. Also, in the case of atopic dermatitis, the odds ratio of treatment experiences (within 1 year) was 1.42 (1.02–1.97), which indicated elevated risks compared to the students in the S1 school. A regression analysis was used to assess the relationship between the substances and the symptomatic experiences within the last year. There were significant increases in the odds ratio of the symptoms associated with allergic rhinitis and the BC and SO₂ in the complex pollution areas. The results of the assessment of the relationship between atopic dermatitis-associated symptoms and O3 showed that the odds ratio increased with statistical significance.     

Estimating bulk optical properties of aerosols over the western North Pacific by using MODIS and CERES measurements

Over the western North Pacific, a large amount of land aerosols from Asian-Pacific countries is transported by the prevailing westerlies. This transport makes the radiative characteristics of these aerosols diverse, particularly when one compares those characteristics over the coastal sea with those over the open sea. In this paper we discuss a method that uses satellite data to obtain the single-scattering albedo (ω) and asymmetry factor (g) of atmospheric aerosols for two large-scale subdivisions—the coastal sea (within 250 km from the coast) and the open sea (the remaining area)—over the western North Pacific (110°E–180°, 20°N–50°N). Our estimation method uses satellite measurements, obtained over a six-year period (2000–2005), of aerosol optical depth (AOD) and shortwave fluxes at both the surface and the top of the atmosphere (TOA); the measurements are obtained using the Moderate Resolution Imaging Spectroradiometer (MODIS) and the Clouds and the Earth's Radiant Energy System (CERES). For the two subdivisions, the estimated annual means of (ω,g) at 630 nm are significantly different: (0.94, 0.65) over the coastal sea and (0.97, 0.70) over the open sea. From a quantitative viewpoint, this result indicates that in comparison with aerosols over the open sea, those over the coastal sea show greater absorption and lesser forward scattering of solar radiation. The estimated optical properties are responsible for the aerosol surface cooling observed by MODIS and CERES, which is approximately 138 and 108 W m⁻² per AOD over the coastal sea and open sea, respectively.     

Comparison of two estimation methods for surface area concentration using number concentration and mass concentration of combustion-related ultrafine particles

Recent research has suggested that the adverse health effects caused by nanoparticles are associated with their surface area (SA) concentrations. In this study, SA was estimated in two ways using number and mass concentrations and compared with SA (SA_meas) measured using a diffusion charger (DC). Aerosol measurements were made twice: once starting in October 2002 and again starting in December 2002 in Mysore, India in residences that used kerosene or liquefied petroleum gas (LPG) for cooking. Mass, number, and SA concentrations and size distributions by number were measured in each residence. The first estimation method (SA_PSD) used the size distribution by number to estimate SA. The second method (SA_INV) used a simple inversion scheme that incorporated number and mass concentrations while assuming a lognormal size distribution with a known geometrical standard deviation. SA_PSD was, on average, 2.4 times greater (range = 1.6–3.4) than SA_meas while SA_INV was, on average, 6.0 times greater (range = 4.6–7.7) than SA_meas. The logarithms of SA_PSD and SA_INV were found to be statistically significant predictors of the logarithm of SA_meas. The study showed that particle number and mass concentration measurements can be used to estimate SA with a correction factor that ranges between 2 and 6.     

Environmental impact minimization of a total wastewater treatment network system from a life cycle perspective

Synthesis of distributed wastewater treatment plants (WTPs) has focused on cost reduction, but never on the reduction of environmental impacts. A mathematical optimization model was developed in this study to synthesize existing distributed and terminal WTPs into an environmentally friendly total wastewater treatment network system (TWTNS) from a life cycle perspective. Life cycle assessment (LCA) was performed to evaluate the environmental impacts of principal contributors in a TWTNS. The LCA results were integrated into the objective function of the model. The mass balances were formulated from the superstructure model, and the constraints were formulated to reflect real wastewater treatment situations in industrial plants. A case study validated the model and demonstrated the effect of the objective function on the configuration and environmental performance of a TWTNS. This model can be used to minimize environmental impacts of a TWTNS in retrofitting existing WTPs in line with cleaner production and sustainable development.     

Measurement of real time black carbon for investigating spot loading effects of Aethalometer data

Measurements of real-time continuous PM_2.5 black carbon (BC) concentrations were made using a single-wavelength Aethalometer (@880 nm) in three different environments, i.e., an indoor office, a residential indoor living room and an urban site, to evaluate the difference in temporal behaviors of BC particles and investigate the optical shadowing effect in the Aethalometer BC data. An empirical method was used for correcting the optical saturation effect on the original BC data obtained from the measurements at the three sites. Also, the elemental carbon (EC) concentrations from 24-h filter-based measurements of PM_2.5 particles were determined using a thermal optical transmittance (TOT) method at the same urban site for comparison with the Aethalometer BC results. Transient events of BC were often observed for period of a few hours at all sites, reaching a maximum level of 27.3 μg m^?3 at the urban site. The diurnal cycles of the BC concentrations observed at the two indoor environments were found to be considerably affected by the air exchange rate, occupants' behavior patterns and nearby traffic emissions. The time-series plots of the Aethalometer data showed obvious discontinuities at the filter spot change, and a rise in the apparent BC concentrations after filter tape advances. Also, the relationship between the attenuation and BC concentration was found to be non-linear at all sites. The empirical approach presented here demonstrated a definite improvement in the continuity of the BC data across the time gaps of each tape advance. The compensated BC concentration was 1.10–1.23 times greater than the raw BC data, depending on the observation sites, with the highest difference observed between the raw and compensated BC data at an indoor office near a small traffic road. The 24-h integrated EC concentration was approximately 12% higher than the original 24-h average BC concentration and 6% lower than the loading compensated BC concentration, showing that the loading compensation process accounted for the saturation effect of the filter tape.     

Determinants of exposure to fine particulate matter (PM2.5) for waiting passengers at bus stops

This research evaluates commuter exposure to particulate matter during pre-journey commute segments for passengers waiting at bus stops by investigating 840 min of simultaneous exposure levels, both inside and outside seven bus shelters in Buffalo, New York. A multivariate regression model is used to estimate the relation between exposure to particulate matter (PM_2.5 measured in μg m^?3) and three vectors of determinants: time and location, physical setting and placement, and environmental factors. Four determinants have a statistically significant effect on particulate matter: time of day, passengers’ waiting location, land use near the bus shelter, and the presence of cigarette smoking at the bus shelter. Model results suggest that exposure to PM_2.5 inside a bus shelter is 2.63 μg m^?3 (or 18 percent) higher than exposure outside a bus shelter, perhaps due in part to the presence of cigarette smoking. Morning exposure levels are 6.51 μg m^?3 (or 52 percent) higher than afternoon levels. Placement of bus stops can affect exposure to particulate matter for those waiting inside and outside of shelters: air samples at bus shelters located in building canyons have higher particulate matter than bus shelters located near open space.