Petroleum hydrocarbon concentrations in eight mollusc species along Tamilnadu coast, Bay of Bengal, India

Eight mollusc species and sediment samples collected from three different stations along Tamilnadu coast, Bay of Bengal, India were analysed for the levels of petroleum hydrocarbons to elucidate the status of the petroleum residues in mollusc meant for human consumption. The concentrations of petroleum hydrocarbons in sediments along Tamilnadu coast varied from 5.04–25.5 g/g dw (dry weight). High concentration of petroleum hydrocarbons in the sediment of Uppanar estuary (25.5 1.45 g/g dw) was perhaps land and marine based anthropogenic sources of this region. The petroleum hydrocarbon residues in eight mollusc species collected from Uppanar, Vellar and Coleroon estuaries varied between 2.44–6.04 g/g ww (wet weight). Although the concentration of petroleum hydrocarbons in sediment of the Uppanar region was markedly higher than the background, the petroleum hydrocarbon residues in mollusc collected from Uppanar estuary did not suggest bioaccumulation. The results signified that industrial growth has affected the aquatic environments and regular monitoring will help to adopt stringent pollution control measures for better management of the aquatic region.     

Consumption of rice and fish in an electronic waste recycling area contributes significantly to total daily intake of mercury

<正>Mercury is a global pollutant due to its widespread use,emission,and long-range transport(Blum,2013;Pacyna et al.,2010).It is considered a priority pollutant due to its neurological toxicity,persistence,and bioaccumulation(Pacyna et al.,2010;Sharma et al.,2015).Mercury pollution can occur when products that contain mercury are improperly disposed of and mercury is released into the air,water,and soil(Zhang and Wong,2007).An estimated 22%of the annual world usage of mercury is in electrical equipment such as batteries,thermometers,and discharge lamps,and electronic devices such as monitors and     

微生物强化处理与堆制强化处理含油污泥对比试验

为探索含油污泥的高效处理方法,对含油量为12.68%的污泥进行微生物菌剂强化处理和堆制强化处理现场试验.在第1、15、30d分别向微生物强化处理单元投加微生物菌剂和营养液;同时向堆制强化单元投加10kg畜禽粪便来提供共降解物质,强化堆制处理过程.结果表明,微生物强化处理单元含油量持续下降,56d后下降至6.42%,去除率达到47%;强化堆制单元处理效果较好,56d后含油量下降至6.98%,去除率达到31%;对照单元含油量则变化很小,56d后含油量为10.15%.对照单元的pH基本保持不变,最高为8.28,最低为7.93,微生物强化处理单元pH最低达到7.33,一般稳定在7.8左右,菌剂的添加对pH影响明显.堆制强化处理单元温度随着农家肥的添加而剧烈升高,最高达到54℃.试验进行过程中监测了样品中微生物总数的变化情况.通过气谱-质谱分析,可以明显地看出2种方法处理后,含油污泥中石油成分的差异,对碳原子数小于21的烃类有着良好的去除效果.     

北京市大气PM2.5中矿物成分的污染特征

为了解北京市大气细粒子中矿物成分的浓度水平和污染特征,在清华园和车公庄进行了连续1a的PM_2.5累积周采样和全样品分析.Al、Si、Ca、Mg和Fe等地壳元素的周变化相似,最大周均浓度均出现在春季有强沙尘天气的一周;其季节变化显著,显示季节性的源排放以及气象条件对矿物成分的含量影响显著.土壤尘的季节平均浓度从夏季逐步上升,至次年春季达到最高(21.1 μg·m^-3),表明春季频繁发生的沙尘天气对土壤尘细粒子有重要贡献.大量的建筑活动可能大大增加了北京细粒子中Ca的负荷,应加强其排放控制.     

Erratum to: Accumulation of Cr,Cd, Pb,Cu, and Zn by plants in tanning sludge storage sites: opportunities for contamination bioindication and phytoremediation

Environmental Science and Pollution Research -     

Increased bioavailability of metals in two contrasting agricultural soils treated with waste wood-derived biochar and ash

Recycled waste wood is being increasingly used for energy production; however, organic and metal contaminants in by-products produced from the combustion/pyrolysis residue may pose a significant environmental risk if they are disposed of to land. Here we conducted a study to evaluate if highly polluted biochar (from pyrolysis) and ash (from incineration) derived from Cu-based preservative-treated wood led to different metal (e.g., Cu, As, Ni, Cd, Pb, and Zn) bioavailability and accumulation in sunflower (Helianthus annuus L.). In a pot experiment, biochar at a common rate of 2 % w/w, corresponding to ～50 t ha^?1, and an equivalent pre-combustion dose of wood ash (0.2 % w/w) were added to a Eutric Cambisol (pH 6.02) and a Haplic Podzol (pH 4.95), respectively. Both amendments initially raised soil pH, although this effect was relatively short-term, with pH returning close to the unamended control within about 7 weeks. The addition of both amendments resulted in an exceedance of soil Cu statutory limit, together with a significant increase of Cu and plant nutrient (e.g., K) bioavailability. The metal-sorbing capacity of the biochar, and the temporary increase in soil pH caused by adding the ash and biochar were insufficient to offset the amount of free metal released into solution. Sunflower plants were negatively affected by the addition of metal-treated wood-derived biochar and led to elevated concentration of metals in plant tissue, and reduced above- and below-ground biomass, while sunflower did not grow at all in the Haplic Podzol. Biochar and ash derived from wood treated with Cu-based preservatives can lead to extremely high Cu concentrations in soil and negatively affect plant growth. Identifying sources of contaminated wood in waste stream feedstocks is crucial before large-scale application of biochar or wood ash to soil is considered.     

Analysis of ecotoxic influence of waste from the biomass gasification process

Environmental Science and Pollution Research - The purpose of this research was evaluation of the effect of soil contamination with waste coming from biomass gasification on chosen indicators of...     

Using long-term data for a reintroduced population to empirically estimate future consequences of inbreeding

Inbreeding depression is an important long-term threat to reintroduced populations. However, the strength of inbreeding depression is difficult to estimate in wild populations because pedigree data are inevitably incomplete and because good data are needed on survival and reproduction. Predicting future population consequences is especially difficult because this also requires projecting future inbreeding levels and their impacts on long-term population dynamics, which are subject to many uncertainties. We illustrate how such projections can be derived through Bayesian state-space modeling methods based on a 26-year data set for North Island Robins (Petroica longipes) reintroduced to Tiritiri Matangi Island in 1992. We used pedigree data to model increases in the average inbreeding level (F ) over time based on kinship of possible breeding pairs and to estimate empirically N_e/N (effective/census population size). We used multiple imputation to model the unknown components of inbreeding coefficients, which allowed us to estimate effects of inbreeding on survival for all 1458 birds in the data set while modeling density dependence and environmental stochasticity. This modeling indicated that inbreeding reduced juvenile survival (1.83 lethal equivalents [SE 0.81]) and may have reduced subsequent adult survival (0.44 lethal equivalents [0.81]) but had no apparent effect on numbers of fledglings produced. Average inbreeding level increased to 0.10 (SE 0.001) as the population grew from 33 (0.3) to 160 (6) individuals over the 25 years, giving a ratio of 0.56 (0.01). Based on a model that also incorporated habitat regeneration, the population was projected to reach a maximum of 331–1144 birds (median 726) in 2130, then to begin a slow decline. Without inbreeding, the population would be expected stabilize at 887–1465 birds (median 1131). Such analysis, therefore, makes it possible to empirically derive the information needed for rational decisions about inbreeding management while accounting for multiple sources of uncertainty.