On the Relation Between the Indoor and Outdoor Concentrations of Nitrogen Oxides

Simultaneous measurements were made of the concentrations of NO, NO₂, and CO inside and outside of a building. The building is located in the Los Angeles area, which is heavily polluted by photochemical smog, and the experiments were conducted at a time of the year when the pollutants in question tend to be high. The results shows that there is a direct relationship between the inside and outside concentrations, and that the phase lag between the concentrations depends principally on the ratio of the building volume to the ventilation rate. Although the outside concentrations of the pollutants in question did not follow the same pattern every day, peak concentrations seemed to be related to “rush-hour” traffic. By reducing ventilation rates during these periods, it may be possible to reduce the concentration peaks inside of the building. The building involved in the current study was not located in the immediate vicinity of heavy traffic, and the indoor concentrations of NO, NO₂, and CO did not appear to be very severe when compared to those defined by present air quality standards. Finally, the results support the belief that NO and O₃ do not co-exist indoors except in very small quantities.     

Modifications to an H2S Tape Sampler for Increasing Sensitivity and Accuracy in H2S Sampling

The tape samplers using lead acetate impregnated paper tapes for continuous hydrogen sulfide sampling are subject to a number of errors which can throw considerable doubt on the accuracy of H₂S concentrations being measured. Some of the errors have been minimized with a change in the humidification system and a reduction of the lamp intensity in the optical system.     

Stack Dust Sampling: in-Stack Filter or E.P.A. Train

The Environmental Protection Agency has recommended or specified methods for the measurement of participate concentrations in flue gases. The EPA Train for this measurement originally comprised two segments: the front half and the impinger train downstream from the filter proper. This review examines the controversial areas implicit in the use of this EPA Train or the revised EPA train which eliminates the impinger train.     

Automotive Exhaust Emission Levels by Geographic Area and Vehicle Make A Nationwide Survey

Gross average automotive exhaust emissions data collected by the Atlantic Richfield Clean Air Caravan during the summer of 1970 showed only slight geographical variations when the specific makes were ignored. When considering specific makes, significant differences were found on an average emissions basis. Vehicle population—emission distributions showed wide variations in the 50% population levels and in the percent of vehicles with emissions greater than specified values. Hydrocarbon (HC) and carbon monoxide (CO) data are given on a gross basis for the 1970, 1968-69, 1966-67, and pre-1966 model year group vehicles. Average HC and CO emissions and vehicle population-Idle emissions distribution curves are included for specific make vehicles in selected areas.     

Product Guide/1975

Measurements conducted on full-scale hazardous waste incinerators have occasionally shown a relationship between carbon monoxide (CO) emissions and emissions of toxic organic compounds. In this study, four mixtures of chlorinated C₁ and C₂ hydrocarbons were diluted in commercial-grade heptane and burned in a water-cooled turbulent flame reactor (TFR) under two different excess air levels. No correlation between CO and organic emissions could be discerned. Reasons for this lack of observable correlations are discussed in terms of combustion and chemical reaction kinetic theory.     

Methylcyclopentadienyl Manganese Tricarbonyl as an Antiknock: Composition and Fate of Manganese Exhaust Products

Methylcyclopentadienyl manganese tricarbonyl (MMT) has been marketed as a combustion improver for fuel oil and turbine fuel. Use concentrations for this purpose are about 0.025 g manganese/gal in fuel oil and 0.08 to 0.5 g/gal in turbine fuels. In addition, it has been used to a small extent in gasoline.     

Fine Paniculate Removal and S02 Absorption with a Two Stage Wet Scrubber

This paper includes results from pilot plant studies and early field demonstration units and a discussion of the application of the limestone wet scrubbing process to a low sulfur syb-butuminous coal. This latter application required the development of a hybrid two stage scrubber to enable collection of the fine particulate matter as well as removal of a significant amount of the sulfur dioxide.     

Cooling Towers and the Environment

Measurements of natural draft cooling tower plume behavior, as well as meteorological variables, were obtained from aircraft flights near major power plants of the American Electric Power System. Persistence of the visible plume to great distances depends essentially on ambient humidity. Atmospheric stability at plume elevation was also important. Cooling tower-induced fog at ground-level was never observed in any of the tests, and aerodynamic downwash of the visible plume was absent also. The cooling towers did cause modification of natural clouds and they occasionally shadowed some local areas from the sun. Merging of the stack and cooling tower plumes was a common occurrence.     

The Analysis of Airborne Sulfate

This report reviews the current state of analytical methodology for sulfate in airborne particles. Methods for determination of total aerosol sulfate and total soluble sulfate are assessed. A more detailed review of the relatively new techniques for quantitative speciation of airborne sulfate then follows. Size distribution methodology and filter sampling difficulties relating to the collection of airborne sulfate-containing particles are enumerated. Experiments are suggested which use new, improved, and potentially applicable sulfate speciation techniques to obtain a better understanding of the generation, transport, transformation and removal processes that, in turn, determine the identity and concentrations of sulfate species in ambient air.     

Biological Effects of Carbon Monoxide vs. Whole Emissions from Engine with Catalyst

The introduction of oxidizing catalytic converters in the exhaust system of automobiles has been found to be effective in reducing carbon monoxide, total hydrocarbons, and some other components of tailpipe emissions. The utilization of these converters, however, has also caused further oxidation of sulfur compounds producing an increased amount of sulfur trioxide (SO₃) which yields sulfuric acid and sulfates.¹ Studies on the biological effects of these sulfur compounds are in progress in our laboratory and preliminary findings are reported separately. This paper compares the biological effects of exposure to whole emissions from engines with and without converter and exposure to carbon monoxide alone.