Melt Flow Behavior and Processability of Polylactic Acid/Polystyrene (PLA/PS) Polymer Blends

The present investigation dealt with the flow behavior and processability of polylactic acid/polystyrene (PLA/PS) polymer blends using a capillary rheometer. For this purpose, PLA/PS blends with different ratios of the concentrations were prepared using a single screw extruder. The shear viscosity, shear stress, shear rate, power-law index, viscous activation energy at a constant shear stress, and elongational stress were determined. PLA/PS blends exhibited a typical shear-thinning behavior over the entire range of shear rates tested, and the viscosity values of the blends would tend to decrease with increasing amount of PLA. In addition, the polymer blend of 70 % PLA and 30 % PS was found to be relatively less sensitive to the processing temperature, implying that the extrusion process was more desirable for fabrication of PLA/PS polymer blend than the injection process.     

Pyrolysis of waste animal fats in a fixed-bed reactor: Production and characterization of bio-oil and bio-char

Several animal (lamb, poultry and swine) fatty wastes were pyrolyzed under nitrogen, in a laboratory scale fixed-bed reactor and the main products (liquid bio-oil, solid bio-char and syngas) were obtained. The purpose of this study is to produce and characterize bio-oil and bio-char obtained from pyrolysis of animal fatty wastes. The maximum production of bio-oil was achieved at a pyrolysis temperature of 500 °C and a heating rate of 5 °C/min. The chemical (GC–MS analyses) and spectroscopic analyses (FTIR analyses) of bio-oil showed that it is a complex mixture consisting of different classes of organic compounds, i.e., hydrocarbons (alkanes, alkenes, cyclic compounds…etc.), carboxylic acids, aldehydes, ketones, esters,…etc. According to fuel properties, produced bio-oils showed good properties, suitable for its use as an engine fuel or as a potential source for synthetic fuels and chemical feedstock. Obtained bio-chars had low carbon content and high ash content which make them unattractive for as renewable source energy.     

Conservative heavy metal total discharge schemes

Currently, according to Taiwan’s Water Pollution Control Act, the environmental control of waterbodies and water quality depends on the effluent standards and the standard of water quality in the rivers. The Act demands that each stationary pollution source comply with the effluent standard before being discharged into the rivers, and that the overall water quality in the river shall not exceed the declared standard of water quality. To improve the condition of the waterbodies and water quality of the rivers, the Environmental Protection Administration (EPA) in Taiwan has made stricter regulations concerning the discharge standard. Such regulations will help to reduce the weight of individual pollutants discharged; the discharged wastewater, however, will still gradually worsen the water quality of the rivers even after complying with the effluent standard since some of the pollutant dischargers may decrease the concentration of pollutants by diluting the water before discharging; thus, the total weight of metals discharged in the rivers will not be reduced, and the water quality in the areas where the pollutant sources are concentrated will not thereby be significantly improved. To protect the irrigation water and farmlands from being polluted by discharged heavy metals in industrial wastewater, the EPA started controlling the sources in accordance with the total quantity control (TQC) as defined in the Water Pollution Control Act, in the hope of perfecting the environmental protection of waterbodies and water quality, as well as ensuring clean water sources without any pollution for the rivers, land, and people.     

The role of sustainability environment in export marketing strategy and performance: a literature review

Increasing environmental issues, economic and cultural differences, the regulatory framework and the great attention to social responsibility, have forced companies to face the challenge of sustainability. Thus, the adaption of a proper marketing strategy in order to achieve a sustainable competitive advantage in the market (specially export markets) has become an important principle in accepting companies. In this regard, this study is a systematic literature review, which investigated 102 published articles in international journals between 1964 and 2015. In the literature review, the main focus was on key issues such as sustainability, marketing strategies, financial and market export performance. In this article, at first, the concept of sustainability from different aspects was collected and described. Then, external factors, such as competitive intensity, public concern, regulations, technology, cultural/social, and economic, as well as internal factors, such as managers, employees, stakeholders, affecting sustainability, were studied. Finally, adaption of export marketing strategies in order to achieve sustainability export performance is discussed.     

International and European Law on Protected Areas and Climate Change: Need for Adaptation or Implementation?

The protection and management of protected areas must be adapted to the effects of climate change. An important question is if the law on protected areas is capable of dealing with the required changes. In general, both international nature conventions and European Union nature conservation law do not contain any specific provisions on climate change and protected areas. Attention has been paid to this link in non-binding decisions and policy documents. In order to adapt the law to increased dynamics from climate change, more flexibility is needed. This flexibility should not be understood as “legal” flexibility, in the sense of the weakening nature conservation provisions. Scientific uncertainties on the effects of climate change might conflict with the need for legal certainties. In order to adapt to the effects of climate change, the two crucial elements are the strengthening of core protected areas and connectivity between the core areas. At the international level, both elements can be found in non-binding documents. International law enables the required adaptation; however, it often lacks concrete obligations. A stronger legal framework can be found at the level of the European Union. The Birds and Habitats Directives contain sufficient tools to deal with the effects of climate change. The Directives have been insufficiently implemented so far. Especially the central goals of reaching a favorable conservation status and connectivity measures need to be addressed much more in the future.     

Implications of Macroalgal Isolation by Distance for Networks of Marine Protected Areas

The global extent of macroalgal forests is declining, greatly affecting marine biodiversity at broad scales through the effects macroalgae have on ecosystem processes, habitat provision, and food web support. Networks of marine protected areas comprise one potential tool that may safeguard gene flow among macroalgal populations in the face of increasing population fragmentation caused by pollution, habitat modification, climate change, algal harvesting, trophic cascades, and other anthropogenic stressors. Optimal design of protected area networks requires knowledge of effective dispersal distances for a range of macroalgae. We conducted a global meta‐analysis based on data in the published literature to determine the generality of relation between genetic differentiation and geographic distance among macroalgal populations. We also examined whether spatial genetic variation differed significantly with respect to higher taxon, life history, and habitat characteristics. We found clear evidence of population isolation by distance across a multitude of macroalgal species. Genetic and geographic distance were positively correlated across 49 studies; a modal distance of 50–100 km maintained F_ST < 0.2. This relation was consistent for all algal divisions, life cycles, habitats, and molecular marker classes investigated. Incorporating knowledge of the spatial scales of gene flow into the design of marine protected area networks will help moderate anthropogenic increases in population isolation and inbreeding and contribute to the resilience of macroalgal forests. Implicaciones del Aislamiento por Distancia de Macroalgas para Redes de Áreas Marinas Protegidas     

Synthesis of branched,nano channeled,ultrafine and nano carbon tubes from PET wastes using the arc discharge method

Upcycling polymer wastes into useful, and valuable carbon based materials, is a challenging process. We report a novel catalyst-free and solvent-free technique for the formation of nano channeled ultrafine carbon tubes (NCUFCTs) and multiwalled carbon nanotubes (MWCNTs) from polyethylene terephthalate (PET) wastes, using rotating cathode arc discharge technique. The soot obtain from the anode contains ultrafine and nano-sized solid carbon spheres (SCS) with a mean diameter of 221 nm and 100 nm, respectively, formed at the lower temperature region of the anode where the temperature is approximately 1700 °C. The carbon spheres are converted into long “Y” type branched and non-branched NCUFCTs and MWCNTs at higher temperature regions where the temperature is approximately 2600 °C, with mean diameters of 364 nm and 95 nm, respectively. Soot deposited on the cathode is composed of MWCNTs with a mean diameter of 20 nm and other nanoparticles. The tubular structures present in the anode are longer, bent and often coiled with lesser graphitization compared to the nanotubes in the soot on the cathode.     

Hazard property classification of waste according to the recent propositions of the EC using different methods

Hazard classification of waste is a necessity, but the hazard properties (named “H” and soon “HP”) are still not all defined in a practical and operational manner at EU level. Following discussion of subsequent draft proposals from the Commission there is still no final decision. Methods to implement the proposals have recently been proposed: tests methods for physical risks, test batteries for aquatic and terrestrial ecotoxicity, an analytical package for exhaustive determination of organic substances and mineral elements, surrogate methods for the speciation of mineral elements in mineral substances in waste, and calculation methods for human toxicity and ecotoxicity with M factors.In this paper the different proposed methods have been applied to a large assortment of solid and liquid wastes (>1 0 0).Data for 45 wastes – documented with extensive chemical analysis and flammability test – were assessed in terms of the different HP criteria and results were compared to LoW for lack of an independent classification. For most waste streams the classification matches with the designation provided in the LoW. This indicates that the criteria used by LoW are similar to the HP limit values.This data set showed HP 14 ‘Ecotoxic chronic’ is the most discriminating HP. All wastes classified as acute ecotoxic are also chronic ecotoxic and the assessment of acute ecotoxicity separately is therefore not needed. The high number of HP 14 classified wastes is due to the very low limit values when stringent M factors are applied to total concentrations (worst case method). With M factor set to 1 the classification method is not sufficiently discriminating between hazardous and non-hazardous materials. The second most frequent hazard is HP 7 ‘Carcinogenic’. The third most frequent hazard is HP 10 ‘Toxic for reproduction’ and the fourth most frequent hazard is HP 4 “Irritant – skin irritation and eye damage”. In a stepwise approach, it seems relevant to assess HP 14 first, then, if the waste is not classified as hazardous, to assess subsequently HP 7, HP 10 and HP 4, and then if still not classified as hazardous, to assess the remaining properties.The elements triggering the HP 14 classification in order of importance are Zn, Cu, Pb, Cr, Cd and Hg. Progress in the speciation of Zn and Cu is essential for HP 14. Organics were quantified by the proposed method (AFNOR XP X30-489) and need no speciation. Organics can contribute significantly to intrinsic toxicity in many waste materials, but they are only of minor importance for the assessment of HP 14 as the metal concentrations are the main HP 14 classifiers. Organic compounds are however responsible for other toxicological characteristics (hormone disturbance, genotoxicity, reprotoxicity…) and shall be taken into account when the waste is not HP 14 classified.     

Recent patterns of production for the main cereal grains: implications for food security in China

China’s large population and deteriorating environment have created great concern related to the sustainability of food production, especially since details related to this topic remain poorly studied. Thus, an integrated analysis of both crop yield and cultivated area is essential for gaining a better understanding of cereal grain production in China and for making corresponding policies designed to achieve food security. In this study, we adopt trend analysis of both provincial yield and cultivated area to assess the subsequent provincial-level cereal production sustainability between 1980 and 2011 with the goal of providing a better understanding of regional agricultural development. The results indicate that while maize shows the most promise for yield improvement, rice and wheat production is experiencing substantial yield stagnation among most provinces across mainland China. In addition, the trends in spatial patterns are prominently different from those of yields. The sizes of the main rice- and wheat-growing areas in China have declined greatly, suggesting that the related production of these cereals should attract more attention from land management planners and farmers. Specifically, the south-eastern coastal provinces have largely failed to sustain both crop yield and area, while the north-eastern provinces have witnessed thriving agricultural production during the last three decades. Moreover, we find that cereal production in China is significantly affected by governmental policies related to the agricultural sector. Thus, this analysis of food production in China will help policymakers to better understand how the potential implications of food security in China may be applicable to countries worldwide.     

Defining the Impact of Non‐Native Species

Non‐native species cause changes in the ecosystems to which they are introduced. These changes, or some of them, are usually termed impacts; they can be manifold and potentially damaging to ecosystems and biodiversity. However, the impacts of most non‐native species are poorly understood, and a synthesis of available information is being hindered because authors often do not clearly define impact. We argue that explicitly defining the impact of non‐native species will promote progress toward a better understanding of the implications of changes to biodiversity and ecosystems caused by non‐native species; help disentangle which aspects of scientific debates about non‐native species are due to disparate definitions and which represent true scientific discord; and improve communication between scientists from different research disciplines and between scientists, managers, and policy makers. For these reasons and based on examples from the literature, we devised seven key questions that fall into 4 categories: directionality, classification and measurement, ecological or socio‐economic changes, and scale. These questions should help in formulating clear and practical definitions of impact to suit specific scientific, stakeholder, or legislative contexts. Definiendo el Impacto de las Especies No‐Nativas