Origin and transport of U and Ra in riverine,estuarine and marine sediments of the Krka River,Croatia

Spatial distribution of ²³⁸U and ²²⁶Ra activities in sediment columns along the Krka River and estuary, were studied using gamma spectrometry. Markedly different ²³⁸U and ²²⁶Ra activities between riverine, estuarine and marine sediments were observed. Distribution of these radionuclides, as well as their anthropogenic and natural origin, was evaluated by activity measurements, taking into account sedimentation rates estimated by ¹³⁷Cs distribution in sediment columns.     

Biochemical biomarkers in environmental studies—lessons learnt from enzymes catalase,glutathione <Emphasis Type="Italic">S</Emphasis>-transferase and cholinesterase in two crustacean species

Background, aim and scope  

For reliable environmental risk assessment of pollutants, knowledge on the effects at different levels of biological organisation is needed. During the early days of biomarker research in environmental studies approximately two decades ago, biochemical biomarkers were considered as the most promising tool for such purposes. Among these, three enzymes have often been studied: catalase (CAT), glutathione S-transferase (GST) and cholinesterase (ChE). However, despite their intensive research, their measurements in invertebrates have not been commonly applied in environmental risk assessment (ERA) or for regulatory purposes.     

Assessment of low-level metal contamination using the Mediterranean mussel gills as the indicator tissue

Purpose  

The aim of this study was to compare the level of metal contamination in two bays in the middle part of the Eastern Adriatic coastal zone in Croatia using the gills of mussels Mytilus galloprovincialis as indicator tissue. Despite the existing sources of contamination, previous studies with caged mussels only indicated moderate metal contamination of the Kaštela Bay, contrary to the Trogir Bay in which marina and shipyard present a probable source of Cu- and Zn-contamination.     

Altered toxicity of organic pollutants in water originated from simultaneous exposure to UV photolysis and CdSe/ZnS quantum dots

The paper reports unforeseen results of increased toxicity of water, subsequent to interactions between CdSe/ZnS quantum dots (QDs), phenol and toluene under UV irradiation. The consistent pattern of changes in measured toxicity (TU) was observed and correlated with degradation of phenol and/or toluene. Spearman rank coefficients (SRCs) for data pairs sum-parameters vs. TU were calculated. The highest correlation between toxicity and degradation by-products was observed for hydroquinone (0.86) and catechol (0.89). The presence of QDs in tested concentration range in the absence of UV has shown low toxicity and no interactions with phenol and/or toluene. The leak of constituent core and shell metal ions was observed. The minor differences in physical characteristics of tested QDs of the same chemical composition led to rather different degradation patterns of phenol and toluene, and the amount of leak of the metal ions as well.     

The impact of implementation of the requirements of Standard No. OHSAS 18001:2007 to reduce the number of injuries at work and financial costs in the Republic of Croatia

This article contains the results of research into the impact of implementation of the requirements mentioned in Standard No. OHSAS 18001:2007 to reduce the number of injuries at work and the financial costs incurred in this way. The study was conducted on a determined sample by a written questionnaire survey method in the Republic of Croatia. The objective of the empirical research is to determine the impact of implementation of the requirements of Standard No. OHSAS 18001:2007 to reduce the number of injuries at work and financial costs in Croatia in business organizations that implement these requirements. To provide a broader picture, the research included the collection and analysis of data on the impact of the Standard No. OHSAS 18001:2007 on accidents and fatalities at work. Research findings are based on the analysis of performed statistical data where correlation and regression analysis has been applied.     

Water reclamation during drinking water treatments using polyamide nanofiltration membranes on a pilot scale

The aim of this study was to investigate the performances of polyamide nanofiltration membranes during water reclamation. The study was conducted using nanofiltration concentrates obtained from two different nanofiltration drinking water treatment plants placed in the northern part of Serbia (Kikinda and Zrenjanin). Used nanofiltration concentrates contained high concentrations of arsenic (45 and 451 μg/L) and natural organic matter (43.1 and 224.40 mgKMnO₄/L). Performances of polyamide nanofiltration membranes during water reclamation were investigated under various fluxes and transmembrane pressures in order to obtain drinking water from nanofiltration concentrates and, therefore, reduce the amount of produced concentrates and minimize the waste that has to be discharged in the environment. Applied polyamide nanofiltration membranes showed better removal efficiency during water reclamation when the concentrate with higher content of arsenic and natural organic matter was used while the obtained permeates were in accordance with European regulations. This study showed that total concentrate yield can be reduced to ~5 % of the optimum flux value, in both experiments. The obtained result for concentrate yield under the optimum flux presents considerable amount of reclaimed drinking water and valuable reduced quantity of produced wastewater.     

Factors associated with driving under the influence of alcohol

Objective: This study examined the risk factors of driving under the influence of alcohol (DUI) among drivers of specific vehicle categories (DSC). On the basis of this research, the variables related to DUI and involvement in traffic crashes were defined. The analysis was conducted for car drivers, bicyclists, motorcyclists, bus drivers, and truck drivers.

Method: The research sample included drivers involved in traffic crashes on the territory of Serbia in 2016 (60,666). Two types of analyses were conducted in this study. Logistic regression established the correlation between DUI and DSC and the The Technique for Order of Preference by Similarity to Ideal Solution (Multi-criteria decision making) method was applied to consider the scoring and explore the potential for the prevalence of DUI on the basis of 2 data sets (DUI and non DUI).

Results: The study results showed that driver error and male drivers were the 2 most significant risk factors for DUI, with the highest scores and potential for prevalence. The nonuse of restraint systems, driver experience, and driver age are the factors with a significant prediction of involvement in an accident and an insignificant prediction of DUI.

Conclusions: Following the development of the logistic prediction models for DUI drivers, testing of the model was conducted for 3 control driver groups: Car, motorcycle, and bicycle. The prediction model with a probability greater than 50% showed that 77% of car drivers were under the influence of alcohol. Similarly, the prediction percentage for motorcyclists and bicyclists amounted to 71 and 67%, respectively. The recommendation of the study is that drivers whose DUI probability is above 50% should be potentially suspected of DUI. The results of this study can help to understand the problem of DUI among specific driver categories and detect DUI drivers, with the aim of creating successful traffic safety policy.     

The Properties of Poly(<Emphasis Type="SmallCaps">l</Emphasis>-Lactide) Prepared by Different Synthesis Procedure

Different synthesis methods were applied to determine optimal conditions for polymerization of (3S)-cis-3,6-dimethyl-1,4-dioxane-2,5-dione (l-lactide), in order to obtain poly(l-lactide) (PLLA). Bulk polymerizations (in vacuum sealed vessel, high pressure reactor and in microwave field) were performed with tin(II) 2-ethylhexanoate as the initiator. Synthesis in the vacuum sealed vessel was carried out at the temperature of 150 °C. To reduce the reaction time second polymerization process was carried out in the high pressure reactor at 100 °C and at the pressure of 138 kPa. The third type of rapid synthesis was done in the microwave reactor at 100 °C, using frequency of 2.45 GHz and power of 150 W at the temperature of 100 °C. The temperature in this method was controlled via infrared system for in-bulk measuring. The solution polymerization (with trifluoromethanesulfonic acid as initiator) was possible even at the temperature of 40 °C, yielding PLLA with narrow molecular weight distribution in a very short period of time (less than 6 h). The obtained polymers had the number-average molecular weights ranging from 43,000 to 178,000 g mol⁻¹ (polydispersity index ranging from 1 to 3) according to the gel permeation chromatography measurements. The polymer structure was characterized by Fourier transform infrared and NMR spectroscopy. Thermal properties of the obtained polymers were investigated using thermogravimetry and differential scanning calorimetry.