Rapidly eroding piñon-juniper woodlands in New Mexico: response to slash treatment

The pi?on (Pinus edulis Engelm.)-juniper [Juniperus monosperma (Engelm.) Sarg.] woodlands of Bandelier National Monument are experiencing accelerated erosion. Earlier studies suggest that causes of these rapidly eroding woodlands are related to an unprecedented rapid transition of ponderosa pine (Pinus ponderosa C. Lawson) savanna to pi?on-juniper woodlands as a result of cumulative historical effects of overgrazing, fire suppression, and severe drought. To study the effectiveness of slash treatment in reducing accelerated erosion, we used sediment check dams to quantify sediment yield from twelve paired microwatersheds (300-1100 m2) within an existing paired water-shed study. Six of the twelve microwatersheds were located in a 41-ha (treatment) watershed with scattered slash treatment, whereas six microwatersheds were located in an adjacent 35-ha untreated (control) watershed. The primary purpose of our research was to quantify the rates of sediment yield between the treated and control microwatersheds. Sediment yield was measured from 15 individual storms during the months of June-September (2000 and 2001). In response to slash treatment, mean seasonal sediment yield for 2000 equaled 2.99 Mg/ha in the control vs. 0.03 Mg/ha in the treatment and 2.07 Mg/ha in the control vs. 0.07 Mg/ha in the treatment in 2001. The practice of slash treatment demonstrates efficacy in reducing erosion in degraded pi?on-juniper woodlands by encouraging herbaceous recovery. Our data show that slash treatment increases total ground cover (slash and herbaceous growth) beyond a potential erosion threshold. Restored pi?on-juniper woodlands, as the result of slash treatment, provide a forest structure similar to pre-grazing and pre-fire suppression conditions and decrease catastrophic fire hazard.     

Chromate reduction by chromium-resistant bacteria isolated from soils contaminated with dichromate

Extensive use of hexavalent chromium [Cr(VI)] in various industrial applications has caused substantial environmental contamination. Chromium-resistant bacteria isolated from soils can be used to remove toxic Cr(VI) from contaminated environments. This study was conducted to isolate chromium-resistant bacteria from soils contaminated with dichromate and describes the effects of some environmental factors such as pH, temperature, and time on Cr(VI) reduction and resistance. We found that chromium-resistant bacteria can tolerate 2500 mg L(-1) Cr(VI), but most of the isolates tolerated and reduced Cr(VI) at concentrations lower than 1500 mg L(-1). Chromate reduction activity of whole cells was detected in five isolates. Most of these isolates belong to the genus Bacillus as identified by the 16S rRNA gene sequencing. Maximal Cr(VI) reduction was observed at the optimum pH (7.0-9.0) and temperature (30 degrees C) of growth. One bacterial isolate (Bacillus sp. ES 29) was able to aerobically reduce 90% of Cr(VI) in six hours. The Cr(VI) reduction activity of the whole cells of five isolates had a K(M) of 0.271 (2.61 mM) to 1.51 mg L(-1) (14.50 mM) and a V(max) of 88.4 (14.17 nmol min(-1)) to 489 mg L9-1) h(-1) (78.36 nmol min(-1)). Our consortia and monocultures of these isolates can be useful for Cr(VI) detoxification at low and high concentrations in Cr(VI)-contaminated environments and under a wide range of environmental conditions.     

Chemical extraction methods to assess bioavailable arsenic in soil and solid media

Soil ingestion by children is an important pathway in assessing public health risks associated with exposure to arsenic-contaminated soils. Soil chemical methods are available to extract various pools of soil arsenic, but their ability to measure bioavailable arsenic from soil ingestion is unknown. Arsenic extracted by five commonly used soil extractants was compared with bioavailable arsenic measured in vivo by immature swine (Sus scrofa) dosing trials. Fifteen contaminated soils that contained 233 to 17 500 mg kg(-1) arsenic were studied. Soil extractants were selected to dissolve surficially adsorbed and/or readily soluble arsenic (water, 1 M sodium acetate, 0.1 M Na2HPO4/0.1 M NaH2PO4) and arsenic in Fe and Mn oxide minerals (hydroxylamine hydrochloride, ammonium oxalate). The mean percent of total arsenic extracted was: ammonium oxalate (53.6%) > or = hydroxylamine hydrochloride (51.7%) > phosphate (10.5%), acetate (7.16%) > water (0.15%). The strongest relationship between arsenic determined by soil chemical extraction and in vivo bioavailable arsenic was found for hydroxylamine hydrochloride extractant (r = 0.88, significant at the 0.01 probability level). Comparison of the amount of arsenic extracted by soil methods with bioavailable arsenic showed the following trend: ammonium oxalate, hydroxylamine hydrochloride > in vivo > phosphate, acetate > water. The amount of arsenic dissolved in the stomach (potentially bioavailable) is between surficially adsorbed (extracted by phosphate or acetate) and surficially adsorbed + nonsurficial forms in Fe and Mn oxides (extracted by hydroxylamine hydrochloride or ammonium oxalate). Soil extraction methods that dissolve some of the amorphous Fe, such as hydroxylamine hydrochloride, can be designed to provide closer estimates of bioavailable arsenic.     

Biowaste effects on soil and native plants in a semiarid ecosystem

Many soils of the Mediterranean region with a semiarid climate are subjected to progressive degradation as a result of water erosion. Biosolids and municipal solid wastes (MSW) were surface-applied once at three rates (40, 80, and 120 Mg ha(-1)) to different plots in a degraded semiarid ecosystem. The study was conducted to determine the effects of such applications on soil chemical properties and native vegetation over a three-year period. Soil N, P, and K initially increased with increasing biowaste application rates, but then decreased over time. Levels of Zn and Cu were higher in MSW than biosolid-treated plots, and increased in both years after application. Concentrations of soil Cd, Pb, Ni, and Cr did not change as a result of biowaste amendment in the study period. The growth of native plants was enhanced by the addition of biowastes. Total plant canopy and plant biomass increased significantly and remained higher in all treatments than in the control plot over the three-year period. The species richness of native plants decreased with increasing biowaste rates. Differences in the development of native plant communities between treatments were observed, and were more remarkable three years after biowaste application. Tissue N, P, K, Zn, and Cu levels increased with the biowaste application rate, but concentrations of tissue Pb, Cd, Ni, and Cr did not increase significantly. Biowastes applied at the rate of 80 Mg ha(-1) gave rise to the most favorable soil and native vegetation results while avoiding environmental risks.     

The Truth about Public Health Protection and Community Sewerage and Water Supply Sanitation in Developing Countries

Since the establishment, following World War II, of the World System, by which the affluent industrialized countries established various international assistance agencies (including the multilateral development banks, UN affiliates, and Bilaterals), these assistance agencies have invested very large sums in helping finance planning and construction of community sewerage and water supply facilities in the developing countries. However, much of this large investment has been ineffective and wasted, primarily because of the lack of understanding by the staff of the assistance agencies that the design criteria for the facilities must be modified to suit the socio-economic status of the developing country. The developing countries are relatively very poor in terms of available finances, hence cannot afford to emulate Western environmental standards and design practices, especially as related to operation and maintenance, hence much simpler approaches must be used. Experiences in several Asian countries are discussed, and a recommendation is made on how to go about resolving this problem.     

Importance of Sediment–Water Interactions in Coeur d’Alene Lake,Idaho, USA: Management Implications

A field study at Coeur dAlene Lake, Idaho, USA, was conducted between October 1998 and August 2001 to examine the potential importance of sediment–water interactions on contaminant transport and to provide the first direct measurements of the benthic flux of dissolved solutes of environmental concern in this lake. Because of potential ecological effects, dissolved zinc and orthophosphate were the solutes of primary interest. Results from deployments of an in situ flux chamber indicated that benthic fluxes of dissolved Zn and orthophosphate were comparable in magnitude to riverine inputs. Tracer analyses and benthic-community metrics provided evidence that solute benthic flux were diffusion-controlled at the flux-chamber deployment sites. That is, effects of biomixing (or bioturbation) and ground-water interactions did not strongly influence benthic flux. Remediation efforts in the river might not produce desired water-quality effects in the lake because imposed shifts in concentration gradients near the sediment–water interface would generate a benthic feedback response. Therefore, development of water-quality models to justify remediation strategies requires consideration of contaminant flux between the water column and underlying sediment in basins that have been affected by long-term (decadal) anthropogenic activities.     

Landform Classification for Land Use Planning in Developed Areas: An Example in Segovia Province (Central Spain)

Landform-based physiographic maps, also called land systems inventories, have been widely and successfully used in undeveloped/rural areas in several locations, such as Australia, the western United States, Canada, and the British ex-colonies. This paper presents a case study of their application in a developed semi-urban/suburban area (Segovia, Spain) for land use planning purposes. The paper focuses in the information transfer process, showing how land use decision-makers, such as governments, planners, town managers, etc., can use the information developed from these maps to assist them. The paper also addresses several issues important to the development and use of this information, such as the goals of modern physiography, the types of landform-based mapping products, the problem of data management in developed areas, and the distinctions among data, interpretations, and decisions.     

The highly specialised gut of Fritillariidae (Appendicularia: Tunicata)

The morphology and some functions of the gut of Fritillaria pellucida and Fritillaria formica (Fritillaridae) were investigated by light and electron microscopy, and also by means of histochemical and immunohistochemical techniques. Fritillarids, very important for their abundance and ecological impact in marine ecosystems, have a very simplified gut: a straight oesophagus connects the pharynx to the digestive nucleus, composed of globular stomach and rectum, connected dorsally through a very short proximal intestine. The latter is characterised by a few (two to four) extremely specialised cells, completely filled with mitochondria associated tightly with membrane infoldings showing strong ATP-ase activity, and probably involved in the osmoregulation of internal body fluids. The gut is formed of an extremely low number of cells, which, although poorly diversified, are very large in the stomach and rectum. Food transfer along the gut depends on and is regulated by well-developed cardiac and pyloric valves, and signs of general digestive and absorptive activity are recognisable all along the brush border of the main tracts. The macroscopic organisation and cytological characters of the gut in fritillarids are completely different from those of the oikopleurids. In particular, fritillarids lack specialised cells for endocytosis and intracellular digestion, like those described in the genus Oikopleura. The general simplification and specialisation observed in Fritillaria gut may account for their elevated growth rate and abundant diffusion in all oceans.     

Assessment of the leaching of metallic elements in the technology of solidification in aqueous solution

Results are presented of experiments performed to optimize the solidification/stabilization system for metallic elements in aqueous solution. This system involves mixing cement and a solution of metallic elements in a conventional mixer: the paste thus obtained is transferred drop by drop into a recipient filled with an aqueous solution of NaOH at 20% by weight, in which it solidifies immediately. The separate use of chloride solutions of Li+, Cr3+, Pb2+ and Zn2+ makes it possible to obtain granules displaying various levels of compressive strength. Three different inertization matrices were used in the experiments, the first consisting solely of Portland cement, the second of Portland cement and a superplasticizer additive, and the third of Portland cement partially replaced with silica-fume and superplasticizer. The results of the tests performed showed a very low level of leaching into the alkaline solidification solution for Cr3+, the quantity leached being under 2% as against higher levels for the other metallic elements. For all the considered elements, the best results were obtained by using silica-fume in the inertization matrix.     

Waste ecocompatibility in storage and reuse scenarios: global methodology and detailed presentation of the impact study on the recipient environments

In 1995, the ADEME launched a research program called "Waste Ecocompatibility" in order to define a reliable methodology for measuring the impact of waste in storage or reuse scenarios. The French concept of "Ecocompatibility" is defined as the situation where the pollutant flux from waste disposed of or used in specified conditions is compatible with the environmental acceptance of the receiving environments. The chief feature of this definition is to integrate the evaluation of the three following terms: pollutants emission from the waste, transport of the pollutants from the waste to the receptor cells and the environmental acceptance of the receiving environments. The "Waste Ecocompatibility" program consisted of a literature survey and an experimental part. The literature study aimed to determine factors and waste characteristics to be considered for a reliable ecocompatility assessment, to provide an overview of the available tools for measuring those factors and characteristics and to propose a first approach of the methodology. In the framework of the experimental program, this approach was then applied to three theoretical scenarios to validate the laboratory tools (comparative study of laboratory and field results) and to calibrate the global methodology. This paper deals with the results of the experimental program concerning the impact study on receiving environments: impact on plants and microorganisms living in soil, impacts on soil fauna and aquatic fauna. In other papers we intend to present the operational methodology for the assessment of waste ecocompatibility. It includes bio-assays at laboratory scale (microcosms), pilot scale (mesocosms) and in situ experiments (experimental prairie). To limit the use of in situ experiments other research works are necessary to validate bio-assays at laboratory or pilot scale.