Empirical Relationships between Observed Ozone Concentrations and Geographical Areas with Concentrations Likely to Be above 120 ppb

The extent to which existing ozone monitoring data can be used to represent concentrations outside the area immediately surrounding a monitoring station is investigated. The results should be of Interest to those who wish to define areas within which standards are likely to have been exceeded. Relationships are established between the observed second-maximum hour-average ozone concentrations and the area within which It is possible to state with reasonable probability that National Ambient Air Quality Standards (NAAQS) have or have not been exceeded. All pairs of SAROAD stations (Storage and Retrieval of Aerometric Data) separated by 500 km or less which had nearly complete annual data sets were considered for the years 1974 through 1977 to determine the probability that the NAAQS would be exceeded at one station of the pair, given station separation and the observed second-maximum hourly ozone concentration at the other station. The resulting relationship was applied to SAROAD data for 1977, and circles were drawn around each SAROAD monitoring site to show the area within which it is 90% probable that the 120 ppb NAAQS was exceeded during 1977.     

Technique for Measuring the Total Concentration of Gaseous Fixed Nitrogen Species

This paper reports the development of a rapid, continuous technique for analyzing fixed nitrogen species (NH₃, HCN, CH₃NH₂, etc.). The technique uses a platinum catalyst at low pressure in combination with a conventional chemiluminescent NO _x analyzer. Previous workers observed that conventional stainless steel catalysts, and platinum catalysts operated at atmospheric pressure, do not reliably convert NH₃ to NO. The most serious problem was the variation in the efficiency of these catalysts with operating conditions. Changes in temperature, gas composition, or X_NH3 could change the conversion efficiency from 99.9% to <30%. The new conversion technique, however, is quantitative up to several thousand ppm NH₃ in either O₂/He or O₂/CO₂/N₂.     

Biogenic Sulfur Gas Emissions from Soils in Eastern and Southeastern United States

Data are presented for the first systematic measurements of biogenic sulfur gas flux from the major soil orders within the eastern and southeastern United States. Sulfur flux samples were collected and analyzed on-site during the fall of 1977, spring and summer of 1978 and summer of 1979. A total of 27 sampling locales in 17 states were examined. Eight additional sites were visited in 1980.

At some locales, two to four soils were examined, providing an even broader sampling of the soil orders. Three of the locales were revisited two or three times during the course of the study to establish the influence of seasonal climatology upon the measured emission rates and chemical composition of the sulfur flux mixtures.

The sulfur gas enhancement of sulfur-free sweep air passing through dynamic emission flux chambers placed over selected sampling areas was determined by combined cryogenic enrichment sampling and wall-coated, open tubular, capillary column, cryogenic gas chromatography (WCOT/GC) using a sulfur selective, flame photometric detector (FPD).

Sulfur gas mixtures varied with soil order, ambient temperature, insolation, soil moisture, cultivation, and vegetative cover. Statistical analyses indicated strong temperature and soil order relationships for sulfur emissions from soils.

Fluxes ranged from 0.001 g to 1940 g of total sulfur as S/m²/yr. The calculated mean annual sulfur flux, weighted by soil order, was 0.03 g S/m²/yr for the study land area, or 110,872 metric tons (mT). The estimated annual average sulfur flux increased from 65 mT per 6400 km² for the land grids in the northernmost east-west grid tier to an average 1800 mT for the land grids in the southern Florida grid tiers.

This systematic sampling of major soils provides a much broader data base for estimating biogenic sulfur flux than previously reported for isolated intertidal sites, and presents the first sulfur flux estimates for inland soils which make up approximately 93% of the land of the eastern United States.     

experience of the forest products industry in obtaining air quality permits for new and modified sources

A detailed study of the air quality permitting process for 65 different forest products industry projects requiring preconstruction permit approvals from EPA, state, and local air pollution control agencies was conducted. The projects included a wide array of sources including kraft recovery furnaces, lime kilns, fossil fuel and wood residue fired boilers, solid wood products manufacturing facilities, paper coaters, and printing presses. Information concerning the time involved in the permitting process, costs associated with obtaining the permits, use of air quality models and ambient monitoring data, emission control technology determinations, problem areas encountered during the permitting process, perceived benefits and drawbacks of the permitting process, and the effect of permitting requirements on project planning was obtained.

The results indicate that certain permitting requirements such as Best Available Control Technology (BACT) determinations, dispersion modeling results, and use of ambient air quality monitoring data seldom influence the emission limitations ultimately imposed in the final approved permit, with 87% of the final emission limits equivalent to the applicable New Source Performance Standard (NSPS). The 65 permitting case histories also show that obtaining permits for projects subject to Prevention of Significant Deterioration (PSD) requirements takes approximately twice as long and costs twice as much as obtaining permits for projects not subject to PSD requirements.     

Sensitivity Studies of the Effects of Model Formulation on the Evaluation of Control Strategies for Photochemical Air Pollution Formation in the United Kingdom

In the OZIPP (ozone isopleth plotting package, developed by United States Environmental Protection Agency) a number of model specific assumptions with respect to chemical and physical processes are made. These assumptions are introduced into an alternative model developed at AERE Harwell, United Kingdom, in which a detailed chemistry and mixture of organic emissions is included. The impact on the AERE Harwell model results of the assumptions made in OZIPP of omitting ground removal of ozone (O₃) and peroxyacetylnitrate (PAN) and of employing an incomplete PAN chemistry and adopting a reaction rate coefficient of the key reaction NO + HO₂ → NO₂ + OH which is a factor 10 lower than the accepted value, are discussed. The composition of the organic emissions is an important model parameter, and it is shown how grouping of nonmethane hydrocarbon (NMHC) emissions into a small group of NMHC thought to be representative, often implies that O₃ and other pollutants are overestimated. The O₃ isopleth diagram for London constructed using the AERE Harwell model gives a somewhat different picture from that obtained with OZIPP. OZIPP in general predicts that NO_x control or combined hydrocarbon(HC) and NO_x control is efficient with respect to O₃ reduction whilst the AERE Harwell model predicts that HC control alone usually is more efficient than combined HC and NO_x control. Furthermore NO_x control alone may often increase the O₃ burden downwind in the AERE Harwell model.     

Change in Pulmonary Function in Children Associated with Air Pollution Episodes

Pulmonary function of approximately 200 school children in Steubenville, OH was measured before and immediately following air pollution alerts in the fall of 1978 and 1979. TSP concentrations exceeded the National Primary Ambient Air Quality 24 h standards in 1978. SO₂ exceeded the standard in 1979. The children were then reexamined in three weekly visits following each alert. Estimated mean Forced Vital Capacity (FVC) was approximately 2% lower following each alert, although the lowest means were observed one to two weeks after the episodes. Forced Expired Volume in 0.75 sec (FEV_0.75) did not change during the 1978 study, but was 4% lower immediately following the 1979 alert. The children were measured again in five weekly examinations in the spring and fall of 1980. Air pollution levels did not exceed the standards on either occasion. In the spring of 1980, estimated mean FVC and FEV_0.75 showed a decline similar to that observed following the alerts in 1978 and 1979. In the fall of 1980, there were no significant differences in the estimated mean FVC or FEV_0.75 between the examinations. A total of 335 children were tested in the four studies, including 194 who participated in more than one study. The evidence for each child from all the studies was combined in a regression analysis of pulmonary function on TSP and SO₂ average concentrations in the previous 24 h. The distribution of the individual regression coefficients was centered significantly below zero, implying a decrease in pulmonary function with increasing TSP and SO₂ concentrations. The magnitude of the median change was less than 1% of the mean FVC and FEV_0.75 over the range of TSP and SO₂ concentrations observed.     

Resource Recovery from Flue Gas Desulfurization Systems

The cost effective benefits of yielding a flue gas desulfurization (FGD) sludge predominantly composed of CaSO₄·2H₂O, have been previously established. The recovery of this material as FGD by-product gypsum has been demonstrated abroad. Recently U.S. wallboard manufacturers have recognized the viability of this recovery practice. Such techno-economic decision making variables as a) by-product specification, b) transportation costs, and c) location of suitable FGD systems enable the recognition of FGD by-product recovery. Recent investigations of resultant solids content and chloride washing reflect the technical possibility of delivering a suitable product. Commercial and economic factors favor recovery based upon rising disposal and transportation costs. Existing and near term proposed systems surface the technical and commercial problems faced by utilities considering recovery.

Generation of an oxidized FGD sludge consisting of 90⁺% CaSO₄·2H₂O and dewatered to 80⁺% solids is technically achievable by air sparging within the FGD system. Although the product is suitable for land disposal, electric power utilities should consider and evaluate by-product recovery. U.S. wallboard manufacturers have established technical criteria for FGD by-product gypsum. Percent CaSO₄·2H₂O, final solids content, particle size, and chloride content are primarily technical parameters. Technology exists within the FGD industry to satisfy these criteria and results are discussed.

Economic factors comparing mining costs, transportation costs, and disposal costs are developed for specific utility projects. Such comparison established generalized financial criteria for a given utility to develop the economic reasonableness of considering FGD byproduct recovery.

End product user perspectives are presented providing electric utilities with a realistic appreciation for by-product recovery potential. Location of existing wallboard plants highlight potential recovery regions. Quality control problems are discussed in terms of generating a by-product rather than a disposable material.     

The Effect of Building Fan Operation on Indoor-Outdoor Dust Relationships

As part of an energy conservation program recently implemented by the Bell System, fans in many telephone equipment buildings now operate only when necessary to bring the temperature within allowable limits, rather than continuously. In the study reported here the effects of fan operation on indoor-outdoor dust relationships were monitored at 2 representative telephone offices. Automatic dichotomous samplers were used to collect fine and coarse aerosol particles inside telephone equipment buildings at Wichita, KS and Lubbock, TX. At both sites, outdoor samples (roof top) were collected at the same time as the indoor samples. During the tests the building fans were repetitively cycled between 2-week intervals of continuous fan operation and 2-week intervals of intermittent fan operation. The indoor dust concentrations typically increased when the fans were off. The results indicate that this increase was due to loss of constant filtration, but not due to loss of building pressurlzation (i.e., filtration of the recirculated air is largely responsible for the lower dust levels when the fans are running continuously). An expression is derived for the relative dust increase when the building fans are switched off. Among other factors, the relative increase is directly proportional to the efficiency of the building filters and to the rate at which air is recirculated through them. The present findings can be extended to similar buildings.