Use of biosurfactants from urban wastes compost in textile dyeing and soil remediation

A compost isolated humic acid-like (cHAL) material was pointed out in previous work for its potential as auxiliary in chemical technology. Its potential is based on its relatively low 0.4gL(-1) critical micellar concentration (cmc) in water, which enables cHAL to enhance the water solubility of hydrophobic substances, like phenanthrene, when used at higher concentrations than 0.4gL(-1). This material could be obtained from a 1:1 v/v mixture of municipal solid and lignocellulosic wastes composted for 15 days. The compost, containing 69.3% volatile solids, 39.6% total organic C and 21C/N ratio, was extracted for 24h at 65 degrees C under N2 with aqueous 0.1molL(-1) NaOH and 0.1molL(-1) Na4P2O7, and the solution was acidified to separate the precipitated cHAL in 12% yield from soluble carbohydrates and other humic and non-humic substances. In this work two typical applications of surfactants, i.e., textile dyeing (TD) and soil remediation by washing (SW), were chosen as grounds for testing the performance of the cHAL biosurfactant against the one of sodium dodecylsulfate (SDS), which is a well established commercial synthetic surfactant. The TD trials were carried out with nylon 6 microfiber and a water insoluble dye, while the SW tests were performed with two soils contaminated by polycyclic aromatic hydrocarbons (PAH) for several decades. Performances were rated in the TD experiments based on the fabric colour intensity (DeltaE) and uniformity (sigmaDeltaE), and in the SW experiments based on the total hydrocarbons concentration (CWPAH) and on the residual surfactant (Cre) concentrations in the washing solution equilibrated with the contaminated soils. The results show that both cHAL and SDS exhibit enhanced performance when applied above their cmc values. However, while in the TD case a significant performance effect was observed at the surfactants cmc value, in the SW case the required surfactants concentration values were equivalent to 25-125xcmc for cHAL and to 4-22xcmc for SDS. The vis-a-vis comparison of the two surfactants gave the following results: in the TD case the cHAL biosurfactant at 0.4gL(-1) yields good colour intensity and equal colour uniformity as SDS at 5gL(-1), in the SW case cHAL was found to enhance CWPAH by a factor of 2-4 relative to SDS with one soil, whereas with the other soil the two surfactants behaved similarly. The Cre data, however, showed that both soils absorbed by far more SDS (68-95%) than cHAL (12-54%). The results point out intriguing technological and environmental perspectives deriving from the use of compost isolated biosurfactants in the place of synthetic surfactants.     

Acoustic analysis of blast waves produced by rapid phase transition of LNG released on water

Massive offshore and onshore storage of fuel have led the international community to raise questions about the hazards on the surrounding installations and people. Among the possible accidental scenarios when cryogenic gas as liquefied natural gas (LNG) is spilled on water at a very fast rate, the phenomenon of rapid phase transition (RPT) may occur: large amounts of energy are released during phase transition which can generate explosions. The related consequences should be added to the possible consequences of fire in terms of flash fire, fireball, pool fire, and vapour cloud explosion for confined and congested geometry surrounding the release point.In this paper, the analysis of RPT of LNG has been studied from the point of view of blast wave production, through ab initio acoustic analysis for monopole source. Maximum overpressures, as calculated at the source point and along the blast pathway are compared with results of large scale experiments. Safety distances are given for the sake of comparison with threshold distances reported in the open literature.     

Impact of sublethal doses of 2,4-D, simulating drift, on tomato yield

Tomato is considered one of the most sensitive crops regarding 2,4-D drift. In many cases, such susceptibility has led to important restrictions in the use of 2,4-D based products. Field experiments were carried out for two consecutive years in tomato, by applying sublethal doses of 2,4-D (ranging from 0.42 to 13.44 g a.i. ha(-1)) directly to plants, at different stages of growth, as a simulation of eventual drifts to the crop. The range of rates was based on the assumption of a 0.0625-2.0% drift level of a 1 L ha(-1) of the most common formulated herbicides. For this crop, the range of rates between 0.42 and 13.44 g a.i ha(-1) applied at the beginning of flowering caused a linear crop reduction. On the other hand, rates < or = 13.44 g a.i. ha(-1) applied after full development of fourth truss stage or latter had no effect on crop yield or development. For tomato, tolerance to 2,4-D strongly increases with plant age.     

Global Biomass Energy Potential

The intensive use of renewable energy is one of the options to stabilize CO₂atmospheric concentration at levels of 350 to 550ppm. A recent evaluation of the global potential of primary renewable energy carried out by Intergovernmental Panel on Climate Change (IPCC) sets a value of at least 2800EJ/yr, which is more than the most energy-intensive SRES scenario forecast for the world energy requirement up to the year 2100. Nevertheless, what is really important to quantify is the amount of final energy since the use of renewable sources may involve conversion efficiencies, from primary to final energy, different from the ones of conventional energy sources. In reality, IPCC does not provide a complete account of the final energy from renewables, but the text claims that using several available options to mitigate climate change, and renewables is only one of them, it is possible to stabilize atmospheric carbon dioxide (CO₂) concentration at a low level. In this paper, we evaluate in detail biomass primary and final energy using sugarcane crop as a proxy, since it is one of the highest energy density forms of biomass, and through afforestation/reforestation using a model presented in IPCC Second Assessment Report (SAR). The conclusion is that the primary-energy potential for biomass has been under-evaluated by many authors and by IPCC, and this under-evaluation is even larger for final energy since sugarcane allows co-production of electricity and liquid fuel. Regarding forests we reproduce IPCC results for primary energy and calculate final energy. Sugarcane is a tropical crop and cannot be grown in all the land area forecasted for biomass energy plantation in the IPCC/TAR evaluation (i.e. 1280Mha). Nevertheless, there are large expanses of unexploited land, mainly in Latin America and Africa that are subject to warm weather and convenient rainfall. With the use of 143Mha of these lands it is possible to produce 164EJ/yr (1147GJ/hayr or 3.6W/m²on average) of primary energy and 90EJ/yr of final energy in the form of liquid fuel (alcohol) and electricity, using agricultural productivities near the best ones already achievable and biomass gasification technology. More remarkable is that these results can be obtained with the operation of 4,000 production units with unitary capacity similar to the largest currently in operation. These units should be spread over the tropical land area yielding a plantation density similar to the one presently observed in the state of São Paulo, Brazil, where alcohol and electricity have been commercialized in a cost-effective way for several years. Such an amount of final energy would be sufficiently large to fulfill all the expected global increase in oil demand, as well as in electricity consumption by 2030, assuming the energy demand of such sources continues to grow at the same pace observed over the last two decades. When sugarcane crops are combined with afforestation/reforestation it is possible to show that carbon emissions decline for some IPCC SRES scenarios by 2030, 2040 and 2050. Such energy alternatives significantly reduce CO₂emissions by displacing fossil fuels and promote sustainable development through the creation of millions of direct and indirect jobs. Also, it opens an opportunity for negative CO₂emissions when coupled with carbon dioxide capture and storage.     

Extraction of anthropogenic heavy metals from reduced sediments: Indeterminations due to authigenic sulphides and clay minerals

A mineralogical and micro‐chemical study was performed by X‐ray diffraction and SEM/EDS techniques in a reduced sediment sample from the Venice Lagoon to investigate selectivity and significance of two widely used acid extractions (cold IN HCl and hot 8N HNO₃) for the evaluation of anthropogenic metal concentrations. Hydrochloric acid determines an incomplete and variable solubilization of authigenic iron sulphides, yielding a partial extraction of the associated metals (Hg, Mn, Zn and less Ni and Cu). Nitric acid is effective in solubilizing all sulphides, however, it leads to an overestimate of the anthropogenic metal content since it partially dissolves the lattice of some clay‐minerals, particularly chlorites. When these acid extractions are used to asses metal pollution in aquatic ecosystems, the possible over or under‐estimate of the anthropogenic concentration must be taken into account, considering the mineralogical composition of the sediment.     

Benthic-pelagic coupling in frontal system areas of the Northern Adriatic Sea: Analysis of the carbon budgets

Sediment samples were collected between 1996 and 1998 during 4 cruises in the northern sector of the Adriatic Sea, facing the Po River outflow. In each sampling period, after identification of the front line, a grid of 6 sampling stations was selected in order to cover: the coastal area (largely affected by river waters), the inner and outer front areas, and the offshore waters. The biochemical composition of sedimentary organic matter (OM, lipids, proteins, carbohydrates and photosynthetic pigments) and enzymatic activity rates were studied to provide information on the potential organic matter turnover. Tentative estimates of the organic carbon budgets (input/production versus requirement by benthic consumers) are presented. Benthic carbon requirements, estimated from bacterial plus meiofaunal secondary production, was high (897 r mg r C r m m 2 r d m 1 ). OM concentrations in the Northern and Middle Adriatic Sea displayed high values, proteins being dominant, thus suggesting inputs of freshly produced material to the sea floor. OM turnover was generally rapid (11-30 r d m 1 ) and higher during summer. The uncoupled enzymatic rates ( i.e. faster protein than carbohydrate mobilisation in February, 1997) determined a decrease of the OM quality that plays an important role in biogeochemical cycles and OM diagenesis, limiting bacterial secondary production and sedimentary organic carbon utilisation. These data suggest that the efficiency of the system in the transfer of energy through the food web is generally higher in summer, especially during mucilage production.     

Pollution threats in the Mediterranean Sea: An overview

This overview summarises the present knowledge on major sources of pollution, which are of concern for the Mediterranean Sea. Eutrophication, red tides, organic loads, hydrocarbon spills, heavy metal contamination and their biological effects are described on the light of the ecological characteristics of the Mediterranean. In particular special attention is paid to the "new pollution" processes; i.e. , the introduction of novel substances with biological activity that might have synergetic effects with "classical pollutants". Different compartments and marine ecosystems are considered and compared. The degree of anthropogenic impact and its apparent trends are discussed. Possible monitoring plans and remedial actions for a sustainable management of coastal zones subjected to increasing pollution are also suggested.     

Vitellogenesis in the deep-sea shark Centroscymnus coelolepis

At present, information on the reproductive physiology of Centroscymnus coelolepis, which is one of most important and widespread deep-sea shark species, is completely lacking. In this study, we investigated vitellogenesis, a key step in the reproduction biology of fishes. Specimens of C. coelolepis were collected at 2850 m depth in the Western Mediterranean Sea. The size of the collected sharks (range: 35.5–65.0 cm TL) was much lower than those typically reported for the Atlantic and Pacific Oceans. The marked distinctiveness of Mediterranean and Atlantic/Pacific populations was reflected by the achievement of sexual maturity at a smaller size in Mediterranean specimens. The examination of cytoplasmatic components of oocytes indicated that vitellogenin uptake in the ovary started when oocytes reached 14 mm in diameter. Only reproductive females displayed a significant relationship between plasmatic vitellogenin and gonadal development, suggesting that vitellogenesis in C. coelolepis is a discontinuous process. Oestradiol levels were tightly coupled with gonadal development, underlining the importance of this hormone in controlling vitellogenesis. All these findings suggest that vitellogenesis in this yolk-sac viviparous shark might occur with similar mechanisms of oviparous vertebrates.