Trace elements in particulate matter of ambient air at petroleum filling stations

Size segregated suspended particulate matter (PM_2.5 and PM_10-2.5) in air at four major petroleum-filling stations in Ile-Ife, Nigeria, were monitored using double staged “Gent” stacked samplers to assess variations in mass loads and elemental concentrations of 25 elements. Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Cr, Mn, Fe, Ni, Cu, Zn, Br, Rb, Sr, Zr, Cs, Ta, W, and Pb were determined in both fractions by external ion beam proton-induced X-ray emission technique. Enrichment factors and pollution indices were calculated and results revealed that most elements were anthropogenic in both fractions with concentrations exceeding the World Health Organization guideline standards.     

Methane and nitrous oxide emissions from a subtropical coastal embayment (Moreton Bay, Australia)

Surface water methane (CH₄) and nitrous oxide (N₂O) concentrations and fluxes were investigated in two subtropical coastal embayments (Bramble Bay and Deception Bay, which are part of the greater Moreton Bay, Australia). Measurements were done at 23 stations in seven campaigns covering different seasons during 2010-2012. Water-air fluxes were estimated using the Thin Boundary Layer approach with a combination of wind and currents-based models for the estimation of the gas transfer velocities. The two bays were strong sources of both CH₄ and N₂O with no significant differences in the degree of saturation of both gases between them during all measurement campaigns. Both CH₄ and N₂O concentrations had strong temporal but minimal spatial variability in both bays. During the seven seasons, CH₄ varied between 500% and 4000% saturation while N₂O varied between 128 and 255% in the two bays. Average seasonal CH₄ fluxes for the two bays varied between 0.5 ± 0.2 and 6.0 ± 1.5 mg CH₄/(m²·day) while N₂O varied between 0.4 ± 0.1 and 1.6 ± 0.6 mg N₂O/(m²·day). Weighted emissions (t CO₂-e) were 63%-90% N₂O dominated implying that a reduction in N₂O inputs and/or nitrogen availability in the bays may significantly reduce the bays' greenhouse gas (GHG) budget. Emissions data for tropical and subtropical systems is still scarce. This work found subtropical bays to be significant aquatic sources of both CH₄ and N₂O and puts the estimated fluxes into the global context with measurements done from other climatic regions.     

Identifying fecal sources in a selected catchment reach using multiple source-tracking tools

Given known limitations of current microbial source-tracking (MST) tools, emphasis on small, simple study areas may enhance interpretations of fecal contamination sources in streams. In this study, three MST tools-Escherichia coli repetitive element polymerase chain reaction (rep-PCR), coliphage typing, and Bacteroidales 16S rDNA host-associated markers-were evaluated in a selected reach of Plum Creek in south-central Nebraska. Water-quality samples were collected from six sites. One reach was selected for MST evaluation based on observed patterns of E. coli contamination. Despite high E. coli concentrations, coliphages were detected only once among water samples, precluding their use as a MST tool in this setting. Rep-PCR classification of E. coli isolates from both water and sediment samples supported the hypothesis that cattle and wildlife were dominant sources of fecal contamination, with minor contributions by horses and humans. Conversely, neither ruminant nor human sources were detected by Bacteroidales markers in most water samples. In bed sediment, ruminant- and human-associated Bacteroidales markers were detected throughout the interval from 0 to 0.3 m, with detections independent of E. coli concentrations in the sediment. Although results by E. coli-based and Bacteroidales-based MST methods led to similar interpretations, detection of Bacteroidales markers in sediment more commonly than in water indicates that different tools to track fecal contamination (in this case, tools based on Bacteroidales DNA and E. coli isolates) may have varying relevance to the more specific goal of tracking the sources of E. coli in watersheds. This is the first report of simultaneous, toolbox approach application of a library-based and marker-based MST analyses to flowing surface water.     

Fire effects on stable isotopes in a Sierran forested watershed

This study tested the hypothesis that stable C and N isotope values in surface soil and litter would be increased by fire due to volatilization of lighter isotopes. The hypothesis was tested by: (1) performing experimental laboratory burns of organic and mineral soil materials from a watershed at combinations of temperature ranging 100 to 600 degrees C and duration ranging from 1 to 60 min; (2) testing field samples of upland soils before, shortly after, and 1 yr following a wildfire in the same watershed; and (3) testing field soil samples from a down-gradient ash/sediment depositional area in a riparian zone following a runoff event after the wildfire. Muffle furnace results indicated the most effective temperature range for using stable isotopes for tracing fire impacts is 200 to 400 degrees C because lower burn temperatures may not produce strong isotopic shifts, and at temperatures>or=600 degrees C, N and C content of residual material is too low. Analyses of field soil samples were inconclusive: there was a slightly significant effect of the wildfire on delta15N values in upland watershed analyses 1 yr postburn, while riparian zone analyses results indicated that delta13C values significantly decreased approximately 0.71 per thousand over a 9 mo post-fire period (p=0.015), and ash/sediment layer delta13C values were approximately 0.65 per thousand higher than those in the A horizon. The lack of field confirmation may have been due to overall wildfire burn temperatures being <200 degrees C and/or microbial recovery and vegetative growth in the field. Thus, the muffle furnace experiment supported the hypothesis, but it is as yet unconfirmed by actual wildfire field data.     

Removal of Se(IV) from aqueous solution using sulphuric acid-treated peanut shell

A carbonaceous sorbent was prepared from peanut shell via sulphuric acid treatment. Se(IV) removal from aqueous solution on the sorbent was studied varying time, pH, Se(IV) concentration, temperature and sorbent status (wet and dry). Se(IV) removal was faster using the wet sorbent than the dry sorbent following a pseudo-first-order model. Se(IV) removal increases at low pH values, and decreases as pH increases until pH 7. Sorption was found to fit the Langmuir equation and sorption capacity for the wet sorbent was higher than that for the dry one. Both sorbents showed an increased selenium sorption by rising the temperature. Redox processes between Se(IV) and the carbon sorbent are involved. Analysis by scanning electron microscope and X-ray powder diffraction for the sorbent after the reaction with acidified Se(IV) confirmed the availability of elemental selenium as particles on the sorbent surface as a result of Se(IV) reduction. Physicochemical tests showed an increase in sorbent acidity, cation exchange capacity (CEC) and surface functionality after the reaction with acidified Se(IV), indicating the oxidation processes occurring on the sorbent surface. Due to its reduction properties, the sorbent seems efficient for Se(IV) removal from aqueous solution.     

The Rate of Soil Cover Recovery in Anthropogenically Disturbed Areas: An Example of Western Siberian Archaeological Landmarks

The soils formed on fortifications around the sites of ancient settlements 1500 and 2700 years old were studied in the Endyr archaeological landmarks (West Siberia, central taiga). It was shown that podzolic soils with morphological characteristics identical to those of the background soils were formed during these time periods. An attempt was made to estimate the characteristic times for some chemical characters. The greatest values of this parameter were about 8000 years.     

Characterisation of projectiles composed of depleted uranium

Projectiles suspected to be composed of depleted uranium (DU) were found in Kosovo. Their properties were analysed using alpha and gamma ray spectrometry, mass spectrometry and electron microscopy. They were found to be composed of DU with small amounts of other elements such as Ti. 236U was detected in the penetrators, reflecting the use of reprocessed fuel. No transuranium elements were detected. The typical external dose rate meter is not the best option for mapping the location of penetrators from the ground. Monte Carlo calculations were performed in estimating possible skin doses. Penetrators in long-lasting contact with skin may cause a notable equivalent dose to skin.     

Mineralization of integrated gasification combined-cycle power-station wastewater effluent by a photo-fenton process

The aim of this work was to study the mineralization of wastewater effluent from an integrated-gasification combined-cycle (IGCC) power station sited in Spain to meet the requirements of future environmental legislation. This study was done in a pilot plant using a homogeneous photo-Fenton oxidation process with continuous addition of H₂O₂ and air to the system.The mineralization process was found to follow pseudo-first-order kinetics. Experimental kinetic constants were fitted using neural networks (NNs). The NNs model reproduced the experimental data to within a 90% confidence level and allowed the simulation of the process for any values of the parameters within the experimental range studied. At the optimum conditions (H₂O₂ flow rate = 120 mL/h, [Fe(II)] = 7.6 mg/L, pH = 3.75 and air flow rate = 1 m³/h), a 90% mineralization was achieved in 150 min.Determination of the hydrogen peroxide consumed and remaining in the water revealed that 1.2 mol of H₂O₂ was consumed per each mol of total organic carbon removed from solution. This result confirmed that an excess of dissolved H₂O₂ was needed to achieve high mineralization rates, so continuous addition of peroxide is recommended for industrial application of this process.Air flow slightly improved the mineralization rate due to the formation of peroxo-organic radicals which enhanced the oxidation process.