极低风速条件下水-气界面甲烷气体传输速率分析

薄边界层理论被广为用来计算水-气界面气体通量,而气体传输速率(k600)则是其中的关键性环境因子.为了研究极低风速下小型浅水湿地水-气界面甲烷气体传输速率,以宜昌饮用水水库梅子垭水库和周邻5个富营养化池塘为研究对象,采用静态通量箱进行了为期一年的水-气界面甲烷气体通量观测,同步监测了水环境因子和气象因子.野外监测时的风速(U10)范围为0~0.75 m·s~(-1),平均值约为0.19 m·s~(-1);水温(Tw)变化范围为6.3~30.9℃,平均值约为19.3℃.结果表明,梅子垭水库和周边5个池塘水-气界面甲烷气体传输速率较小,在0.20~1.99 cm·h~(-1)之间变化,平均值约为0.50 cm·h~(-1).本研究利用表层水温和风速指标两个参数的双二次项模型和二次项加幂函数模型,回归得到了气体传输速率的数学公式,回归结果与原始数据和对k600进行深度平均(bin-averaged)后的数据均存在极显著性关系.     

Fe-MnOx-CeO2/ZrO2低温催化还原NO性能研究

以纳米ZrO2为载体,用浸渍法制备出Fe-MnOx-CeO2/ZrO2催化剂,考察了活性组分配比和助剂负载量对催化剂低温NH3选择性催化还原NO活性的影响,并对催化剂进行了XRD、SEM、EDS和BET表征;探讨了温度、H2O和SO2对Fe-MnOx-CeO2/ZrO2催化剂低温下NH3选择性催化还原NO的影响,结果表明,无SO2和H2O条件下,8%Fe-10%MnOx-CeO2/ZrO2催化剂具有良好的催化活性和稳定性.120℃时,催化剂的脱硝效率为85.23%,当温度升至180℃时,脱硝效率可达到92.0%.SO2和H2O共存条件下,催化剂易失活,采用傅立叶变换红外光谱对各反应阶段的催化剂进行了表征,对其失活机制进行深入研究,结果表明,催化剂失活的主要原因是催化剂表面硫酸铵盐的沉积和催化剂本身活性成分的硫酸盐化.     

基于实时交通信息的道路机动车动态排放清单模拟研究

以上海市为例开展了实际道路车流分布、行驶工况和车辆技术的实地调查,建立了道路车流、VSP分布和车辆技术数据库.在此基础上,基于实时的车流、车速等交通信息,构建了动态化的道路机动车污染物排放清单模拟方法,并开展了城区典型道路的机动车小时排放模拟案例研究.调查结果表明,上海市城区道路车流以轻型客车和出租车为主,分别占各时段车流总量的48%～72%和15%～43%;VSP分布与平均车速存在较好的规律,各车型VSP峰值随平均车速的上升向高负荷去移动,且峰值逐渐降低;当前上海市车辆以国2和国3车型为主,经过年检站调查结果的校正,国2和国3车型分别占各车型的11%～70%和17%～51%.模拟案例结果显示,道路机动车CO、VOC、NOx和PM日排放峰谷比可达3.7、4.6、9.6和19.8左右,CO和VOC排放主要来自轻型客车和出租车,与车流变化的相关性较好,而NOx和PM排放主要来自重型客车和公交车,且主要集中在早晚高峰时段.采用建立的动态排放模拟方法可实时反映实际道路的机动车排放变化,获取高排放路段和时段,为交通环境管理提供重要的技术手段和决策依据.     

呼和浩特市可镇污水处理厂工程设计

呼和浩特市可镇污水处理厂近期建设规模1.0×104m3/d,远期总规模2.5×104m3/d。污水处理主体工艺采用组合式A2/O生化池+砂滤,污泥处理采用污泥贮池+带式浓缩脱水一体机,尾水采用液氯消毒,设计出水水质执行GB 18918—2002《城镇污水处理厂污染物排放标准》一级A排放标准。介绍了该工程的工艺流程、设计参数,总结分析了工艺设计的技术特点。同时阐述了针对低温条件下的运行保障措施和要求,为寒冷地区同类污水处理厂的设计提供参考和借鉴。     

Cost-performance analysis of nutrient removal in a full-scale oxidation ditch process based on kinetic modeling

A full-scale oxidation ditch process for treating sewage was simulated with the ASM2d model and optimized for minimal cost with acceptable performance in terms of ammonium and phosphorus removal. A unified index was introduced by integrating operational costs (aeration energy and sludge production) with effluent violations for performance evaluation. Scenario analysis showed that,in comparison with the baseline (all of the 9 aerators activated), the strategy of activating 5 aerators could save aeration energy significantly with an ammonium violation below 10%. Sludge discharge scenario analysis showed that a sludge discharge flow of 250–300 m3/day (solid retention time (SRT), 13–15 days) was appropriate for the enhancement of phosphorus removal without excessive sludge production. The proposed optimal control strategy was: activating 5 rotating disks operated with a mode of "111100100" ( "1"represents activation and "0" represents inactivation) for aeration and sludge discharge flow of 200 m3/day (SRT, 19 days). Compared with the baseline, this strategy could achieve ammonium violation below 10% and TP violation below 30% with substantial reduction of aeration energy cost (46%) and minimal increment of sludge production (< 2%). This study provides a useful approach for the optimization of process operation and control.     

关于抑尘剂开发及其存在主要问题的探讨

基于化学抑尘剂与粉尘之间的润湿、粘结、凝聚作用机制,综述了近年来各类化学抑尘剂的合成技术及原理,概述了化学抑尘剂在矿山粉尘抑制中的应用现状,并对化学抑尘剂研究方向的主要问题和应用前景进行了探讨。     

Influences of perfluorooctanoic acid on the aggregation of multi-walled carbon nanotubes

The aggregation of multi-walled carbon nanotubes (MWCNTs) in the aqueous phase not only inhibits their extensive utilization in various aspects but also dominates their environmental fate and transport.The role of surfactants at low concentration in the aggregation of MWCNTs has been studied,however the effect of perfluorinated surfactants at low concentration is uncertain.To understand this interfacial phenomenon,the influences of perfluorooctanoic acid (PFOA),and sodium dodecyl sulfate (SDS) as a control,on MWCNT aggregation in the aqueous phase were examined by the UV absorbency method.Influences of pH and cationic species on the critical coagulation concentration (CCC) value were evaluated.The CCC values were dependent on the concentration of PFOA,however a pronounced effect of SDS concentration on the CCC values was not observed.The CCC values of the MWCNTs were 51.6 mmol/L in NaCl and 0.28 mmol/L in CaCl 2 solutions,which suggested pronounced differences in the effects of Na+ and Ca2+ ions on the aggregation of the MWCNTs.The presence of both PFOA and SDS significantly decreased the CCC values of the MWCNTs in NaCl solution.The aggregation of the MWCNTs took place under acidic conditions and was not notably altered under neutral and alkaline conditions due to the electrostatic repulsion of deprotonated functional groups on the surface of the MWCNTs.     

我国工业固体废物的产生特征及控制对策

工业固体废物是固体废物的重要组成部分。根据我国最近10年发布的工业固体废物统计数据,全面分析了我国工业固体废物的产生特点,研究了工业固体废物产生量、利用量和处置量、工业固体废物区域和行业分布特点以及与工业产值的关系,并针对我国工业固体废物管理存在的问题,提出了相应的对策和建议。     

Effects of physical and chemical characteristics of surface sediments in the formation of shallow lake algae-induced black bloom

Surface sediments are closely related to lake black blooms. The dissolved oxygen （DO） distribution and its penetration depth in surface sediments as well as the migration and transformation of redox sensitive elements such as Fe and S at the sediment-water interface are important factors that could influence the formation of the black bloom. In this study, dredged and undredged sediment cores with different surface properties were used to simulate black blooms in the laboratory. The Micro Profiling System was employed to explore features of the DO and ∑H2S distribution at the sediment-water interface. Physical and chemical characteristics in sediments and pore waters were also analyzed. The results showed that sediment dredging effectively suppressed the black blooms. In the undredged treatment, DO penetration depth was only 50 μm. Fe^2＋ concentrations, ∑H2S concentrations, and ∑H2S production rates were remarkably higher in surface sediments and pore waters compared to control and dredged treatments. Furthermore, depletion of DO and accumulation of Fe^2＋ and ∑H2S in surface sediments and pore waters provided favorable redox environments and necessary material sources for the blooms. The study results proved that physical and chemical characteristics in surface sediments are important factors in the formation of the black bloom, and could provide scientific guidance for emergency treatment and long-term pre-control of black blooms.     

γ-Fe_2O_3/膨胀石墨复合材料吸附废水中六价铬的应用研究

介绍了采用溶胶凝胶法合成新型的复合材料-磁性的γ-Fe_2O_3膨胀石墨(MEG)复合材料。通过采用X-射线衍射(XRD)、扫描电子显微镜(SEM)、透射电子显微镜(TEM)以及X-光电子能谱仪(XPS)对该复合材料MEG进行了表征,结果表明MEG中γ一Fe_2O_3的粒径约为50nm,而且其中γ一Fe_2O_3和膨胀石墨通过C=O相互作用。复合材料MEG作为新型的六价铬吸附剂,通过吸附时间、初始溶液的pH值以及再生性对该吸附过程进行了考察。结果表明:在40 min内MEG吸附六价铬的过程基本达到平衡;在初始溶液的pH为3.5时,MEG对六价铬的最大吸附量可以达到16.4mg/g;而且该复合材料MEG重复使用3次后吸附效果基本没有下降。因此,复合材料MEG对于废水中六价铬的处理有选择性吸附作用,而且初始溶液的pH值对其吸附过程起着重要作用。