生物炭基固定化菌剂对石油类污染物的高效降解

以生物炭为载体,采用吸附法制备固定化菌剂,通过分析不同材料生物炭的结构差异,探讨了不同生物炭的结构在固定化中的影响机制。SEM和EDS分析表明,降解菌主要固定在生物炭表面。生物炭内含有C、N和P成分,能为降解菌提供营养物质。生物炭的多孔结构能促进石油污染物的降解。结果表明,经玉米芯和秸秆生物炭固定化后F-3、R-7及其混合菌的除油率显著提高,分别为41.7%和29.5%、52.5%和42.8%、63.8%和53.2%。玉米芯生物炭固定化菌剂的除油率比秸秆生物炭固定化菌剂高10.6%。玉米芯生物炭表面比秸秆生物炭粗糙,其固定的微生物量为4.2×1010 cfu·g-1,固定效率达71.2%;秸秆生物炭固定的微生物量为2.5×1010 cfu·g-1,固定效率为57.6%。固定化菌剂的最佳制备条件为：选择500℃下热解3 h的玉米芯生物炭为载体,微生物接种量为10%,载体投加量为10 g·L-1,置于35℃、130 r·min-1摇床中固定18 h。     

不同菌种组合对发酵残余物好氧堆肥进程及氮素变化的影响

适宜菌剂组合对于初始电导率（Electronic conductivity,EC）较高的发酵残余物二次干化腐熟效果具有重要影响。通过在发酵残余物（猪场沼渣、城市生活污泥）好氧发酵过程中添加不同菌种组合,研究堆肥腐熟指标变化,特别是不同形态氮素指标变化,以期更好提升发酵残余物的干化和腐熟程度。结果表明：F3菌剂组合处理高温期达16 d,最高温度为69.5℃,最早进入腐熟阶段,全氮损失比例最少,为8.72%;对照组在高温期（14 d、69.3℃）及全氮损失比例（9.21%）指标上仅低于F3处理组,表明自然堆体存在耐盐菌种;在促进堆肥腐熟效果方面,霉菌起着关键的作用,堆肥后期酵母菌的存在促进堆体腐熟度的提升;菌种比例和种类的合理设置对于堆体腐熟度提高的重要性要高于活菌添加量;在堆肥保氮过程中,真菌（霉菌和酵母菌）起着重要作用。F3处理（即芽孢杆菌：霉菌：酵母菌=1：2：2）,是实现发酵残余物快速高效堆肥的理想菌剂配方,其他复配菌种组合保氮效果改良侧重点各不相同。     

催化湿式氧化技术处理山梨酸生产废水的研究

采用催化湿式氧化技术处理生产山梨酸过程中产生的高浓度有机废水,对催化剂组分进行优选.对反应温度、O2分压(Po2)和废水pH等工艺条件进行考察.实验结果表明:采用自制CuO-Cr2O3-La2O3/TiO2为复合催化剂处理该有机废水时表现出较好的催化活性;在190℃、Po2=2.1 MPa、pH=6.1、COD=10 030.0 mg/L时,反应90 min的COD去除率达到98.3%,而在相同条件下未加催化剂的湿式氧化的COD去除率只有60.1%.     

中低温厌氧处理城市污水污泥颗粒化的研究

用高径比为3：1的UASB反应器分别在35℃和室温条件下处理模拟城市污水,研究了污泥的颗粒化过程.比较了在不同温度、浓度下形成的颗粒污泥的特征.水温为9～25℃,进水浓度为100～200 mg COD/L,水力上流速度（Vup）在0.013～0.11 m/h的4^#UASB反应器在60 d内在形成了成熟的颗粒污泥.研究表明,进水中低的有机物浓度,低的Ca^2＋、Mg^2＋浓度和低的Vup没有抑制颗粒化进程.     

超声前处理强化活性炭吸附活性艳红X-3B染料废水

探究了超声前处理活性艳红X-3B染料废水强化活性炭吸附降解性能及不同超声参数的影响规律,包括超声功率和超声时间。研究结果表明,超声前处理活性艳红X-3B染料废水可通过空化效应使有机大分子裂解为小分子易于被活性炭吸附,同时可强化其到活性炭微孔中传输,提高了活性炭吸附降解性能,最佳超声功率为320 W。浓度越高,所需超声时间越长,当超声达到一定时间后,继续超声不会影响染料分子的吸附。超声前处理虽然不会改变吸附平衡时间,但可有效增加活性炭处理活性艳红X-3B染料废水的饱和吸附量。     

CNTs/TiO2/CS光降解苯的动力学

综合光催化氧化苯的动力学过程、光辐射场模型和质量守恒定律,采用平板型反应器建立了碳纳米管/二氧化钛/壳聚糖(CNTs/TiO2/CS)催化薄膜光催化氧化气相苯的数学模型;该模型考虑了光强、相对湿度、初始浓度与气体流速对气相苯光降解的影响。结果表明,建立的数学模型与实验结果吻合较好。     

Bioaccessibility of polychlorinated biphenyls in workplace dust and its implication for risk assessment

Human exposure to bioaccessible PCBs via indoor dust is limited around the world. In the present study, the workplace dust sample from commercial office, hospital, secondary school, shopping mall, electronic factory and manufacturing plant were collected from Hong Kong for PCBs analyses. Total PCBs concentrations ranged from 46.8 to 249 ng g⁻¹, with a median of 107 ng g⁻¹. Manufacturing plant showed the highest concentration among all of sampling sites. PCB 77 was found as the dominant congeners. The bioaccessibility of PCBs in small intestinal juice ranging from 8.3% to 26.0% was significantly higher than that in gastric condition, ranging from 4.8% to 12.4%. In addition, significant negative correlations (p < 0.05) were observed between K_OW and bioaccessibility for all workplace dust samples. Risk assessment indicated that the averaged daily dose of dioxin-like PCBs via non-dietary intake of workplace dust, considering the bioaccessibility of PCBs, were much lower than the TDI of dioxins (2.3 pg WHO-TEQ kg bw⁻¹ d⁻¹) established by Joint FAO/WHO Expert Committee on Food Additives.     

Assessing heavy metal pollution in the surface soils of a region that had undergone three decades of intense industrialization and urbanization

Heavy metals in the surface soils from lands of six different use types in one of the world’s most densely populated regions, which is also a major global manufacturing base, were analyzed to assess the impact of urbanization and industrialization on soil pollution. A total of 227 surface soil samples were collected and analyzed for major heavy metals (As, Cd, Co, Cr, Cu, Fe, Hg, Mn, Ni, Pb, and Zn) by using microwave-assisted acid digestion and inductively coupled plasma–mass spectrometry (ICP-MS). Multivariate analysis combined with enrichment factors showed that surface soils from the region (>7.2?×?10⁴ km²) had mean Cd, Cu, Zn, and As concentrations that were over two times higher than the background values, with Cd, Cu, and Zn clearly contributed by anthropogenic sources. Soil pollution by Pb was more widespread than the other heavy metals, which was contributed mostly by anthropogenic sources. The results also indicate that Mn, Co, Fe, Cr, and Ni in the surface soils were primarily derived from lithogenic sources, while Hg and As contents in the surface soils were controlled by both natural and anthropogenic sources. The pollution level and potential ecological risk of the surface soils both decreased in the order of: urban areas?>?waste disposal/treatment sites?～?industrial areas?>?agricultural lands?～?forest lands?>?water source protection areas. These results indicate the significant need for the development of pollution prevention and reduction strategies to reduce heavy metal pollution for regions undergoing fast industrialization and urbanization.     

白腐菌应用于堆肥处理含木质素废物的研究

白腐菌对木质素具有较强的降解能力。通过在含大量木质素的模拟垃圾堆肥中采取添加白腐菌菌剂与不添加该菌剂2组实验对比,在相同堆肥处理条件下,接种菌剂的堆肥中木质素总量由274988mg降至15438mg,降解率达4386%,远高于未接种菌剂的堆肥中木质素的降解率,表明白腐菌可有效用于含木质素废弃物的堆肥处理,并有望于加速堆肥腐熟,提高堆肥效率。     

基于可调二极管激光技术的汽车尾气遥感监测系统

汽车尾气排放已成为最主要的城市污染源之一。汽车尾气的遥感监测系统作为一种高效实时监测汽车正常运行状况下的尾气排放方法已越来越受到人们的广泛关注。本文主要介绍基于可调二极管激光(TDL)技术的汽车尾气遥感监测系统。首先介绍遥感监测系统的产生与发展以及TDL技术的基本原理,其次阐述遥感监测系统的组成、关键技术以及系统的优点,并分析遥感监测系统在国内外的应用现状,最后提出目前应用中尚待解决的若干关键技术问题。