三维电极电化学反应器深度处理焦化废水

为探索焦化废水深度处理新途径,采用了焦粒、活性炭负载Mn（NO3）2和Zn（NO3）2化合物粒子电极为第3极的三维电极反应器对二级生化处理后的焦化废水进行深度处理。考察了焦化废水中有机物去除的影响因素及处理效果,并探讨了有机物的降解动力学。结果表明,以焦粒为载体的粒子电极三维电极系统在pH为6.5,电导率为4 580μS/cm,电流密度为16 mA/cm2,投加量大于25 g/L时,降解20 min,COD去除率超过35%以上。焦化废水的降解的动力学研究表明,焦化废水降解符合表观一级反应动力学规律。该研究可为三维电极反应器在焦化废水深度处理工程应用中提供参数依据。     

蛋白酶和EDTA-2Na协同作用对剩余污泥水解的影响

采用投加蛋白酶和螯合剂乙二胺四乙酸二钠(EDTA-2Na)联合预处理剩余污泥,研究了蛋白酶浓度、温度和EDTA-2Na浓度对污泥酶法水解释碳效果的影响.结果表明,蛋白酶浓度、温度和EDTA-2Na浓度对剩余污泥水解的影响具有协同效应.在最佳蛋白酶浓度20 mg/g TS条件下,剩余污泥释放的SCOD为1 318.82 mg/L.同时,在最佳螯合剂ED-TA-2Na浓度0.20 g/g TS下,SCOD为9 014 mg/L.在20 mg/g TS的蛋白酶和0.20 g/g TS的EDTA-2Na的联合作用下,SCOD达到12 628.98 mg/L.在20 mg/g TS的蛋白酶、0.2 g/g TS的EDTA-2Na和55℃条件联合作用下,SCOD达到最大值16 878 mg/L,多糖浓度达到最大值2 695.3 mg/L,NH4+-N的浓度达到最大值156.73 mg/L.此外,在不同蛋白酶和EDTA-2Na浓度条件下,剩余污泥水解释放的SCOD符合一级动力学.     

Spatial variations of concentrations of copper and its speciation in the soil-rice system in Wenling of southeastern China

Copper (Cu) is one of the essential elements for plant growth, while excessive Cu in soils has potential environmental risks. There is little information on spatial variation of Cu in practical paddy fields. This is now important for appropriate agricultural management. The spatial patterns of Cu, its fractions in soils, and its concentrations in rice were investigated in a typical rice production region—Wenling of southeastern China. A total of 96 pairs of rice grain and soil samples (0–15 cm) were collected. The total concentration of Cu and its fractions were very variable, with large skewness, kurtosis, and coefficient of variation (CV) values. Compared to the guideline value (50 mg kg^?1), Cu pollution in paddy fields was observed in the study area. All the measured Cu concentrations in rice were lower than 10 mg kg^?1, suggesting that they remained at a safe level. Spatial analyses including Moran’s I index and geostatistics results indicated that high-high spatial patterns for both Cu in soils and rice were found in the northwest part, which was mainly related to industrial and E-waste dismantling activities. The low-low spatial patterns of Cu in the soil-rice system were located in the south part of study area. The cross-correlogram results indicated that Cu concentration in rice was significantly spatially correlated with total Cu in soils, its fractions, and soil organic matter (SOM), but significantly negatively correlated with pH and electrical conductivity (EC). Most of the selected variables had a clear spatial correlation range with Cu in rice. The ranges of significant spatial correlation (p?<?0.05) could be obtained and further used for dividing agricultural management zones.     

Annual input fluxes of heavy metals in agricultural soil of Hainan Island,China

The accumulation of heavy metals in farmland has become an important issue related to food security and environmental risk. The annual inputs of heavy metals (As, Cd, Hg, Pb, Cr, Cu, and Zn) to agricultural soil for a full year in Hainan Island have been studied. Three fluxes through the cultivated horizon were considered: (1) atmospheric depositions, (2) fertilization, and (3) irrigation water. The corresponding samples were collected and analyzed on a large regional scale. The total input fluxes show obvious spatial variability among different regions. The inventory of heavy metal inputs to agricultural land demonstrates that agricultural soil is potentially at risk of heavy metal accumulation from irrigation water. The potential at risk of heavy metal accumulation from atmospheric deposition and fertilizer is relatively low compared to irrigation. The results indicate that Hg is the element of prior concern for agricultural soil, followed by Cd and As, and other heavy metal elements represent little threat to the environment in the study area. This work provides baseline information to develop policies to control and reduce toxic elements accumulated in agricultural soil.     

Temporal trends (2005-2009) of PCDD/Fs, PCBs, PBDEs in rice hulls from an e-waste dismantling area after stricter environmental regulations

Primitive e-waste dismantling activities have been of increasing concern due to serious environmental and human health problems, and therefore authorities in China have strengthened the regulations on illegal e-waste recycling activities. In this work, we used rice hull as a passive sampler and investigated temporal trends of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs), polychlorinated biphenyls (PCBs), polybrominated diphenyl ethers (PBDEs) in areas near e-waste recycling sites after the stricter regulations. Furthermore, the distribution patterns and composition profiles of these contaminants were also discussed. The average concentrations of the three groups of persistent organic pollutants (POPs) in rice hulls have markedly decreased during the period of 2005-2009. Specifically, from 12.9 (average value in 2005) to 0.37 pg WHO-TEQ/g (dry weight, dw) (in 2009) for PCDD/Fs, 47.6 (2005) to 7.10 ng g⁻¹ dw (2009) for PCBs, and 2.51 (2005) to 0.89 ng g⁻¹, dw (2009) for PBDEs. The significant decrease of combustion markers 2,3,4,7,8-PeCDF, 1,2,3,6,7,8HxCDF and PCB126, and the PCDD/PCDF ratio from 1:9 (2005) to 7:3 (2009) is likely a result of stricter regulations on open combustion activities. This study suggests that stricter control measures, strengthened laws and regulations and more environmental friendly techniques could be effective measures in reducing the release and formation of related POPs in typical e-waste dismantling sites, and these measures could further improve the quality of the environment and health of the local inhabitants.     

The behaviors and fate of polycyclic aromatic hydrocarbons (PAHs) in a coking wastewater treatment plant

The occurrence, behaviors and fate of 18 PAHs were investigated in a coking wastewater treatment plant in Songshan coking plant, located in Shaoguan, Guangdong Province of China. It was found that the target compounds occurred widely in raw coking wastewater, treated effluent, sludge and gas samples. In raw coking wastewater, high molecular weight (MW) PAHs were the dominant compounds, while 3-6 ring PAHs predominated in the final effluent. The dominant compounds in gas samples were phenathrene, fluoranthene and pyrene, while they were fluoranthene, pyrene, chrysene and benzo[k]fluoranthene for sludge. The process achieved over 97% removal for all the PAHs, 47-92% of eliminations of these target compounds in liquid phase were achieved in biological stage. Different behaviors of PAHs were observed in the primary tank, anaerobic tank, aerobic tank, hydrolytic tank and coagulation tank units, while heavier and lower ones were mainly removed in anaerobic tank and aerobic tanks, respectively. Regarding the fate of PAHs, calculated fractions of mass losses for low MW PAHs due to transformation and adsorption to sludge accounted for 15-50% and 24-49%, respectively, while the rest was less than 1%. For high MW PAHs, the mass losses were mainly due to adsorption to sludge and separation with tar (contributing 56-76% and 22-39%, respectively), and the removal through transformation was less.     

On-site and off-site atmospheric PBDEs in an electronic dismantling workshop in south China: gas-particle partitioning and human exposure assessment

Gas samples and total suspended particle during work and off work time were investigated on-site and off-site electronic waste dismantling workshop (I- and O-EWDW), then compared with plastic recycling workshop (PRW) and waste incineration plant (WIP). TSP concentrations and total PBDE were 0.36-2.21 mg/m³ and 27-2975 ng/m³ at different workshops, respectively. BDE-47, -99, and -209 were major ∑PBDE congeners at I-EWDW and WIP, while BDE-209 was only dominant congener in PRW and control sites during work time and all sites during off work time. The gas-particle partitioning result was well correlated with the subcooled liquid vapor pressure for all samples, except for WIP and I-EDWD, at park during work time, and residential area during off work time. The predicted urban curve fitted well with measured φ values at O-DEWD during work time, whereas it was slightly overestimated or underestimated for others. Exposure assessment revealed the highest exposure site was I-EDWD.     

Model of municipal solid waste source separation activity: a case study of Beijing

One major challenge faced by Beijing is dealing with the enormous amount of municipal solid waste (MSW) generated, which contains a high percentage of food waste. Source separation is considered an effective means of reducing waste and enhancing recycling. However, few studies have focused on quantification of the mechanism of source separation activity. Therefore, this study was conducted to establish a mathematical model of source separation activity (MSSA) that correlates the source separation ratio with the following parameters: separation facilities, awareness, separation transportation, participation atmosphere, environmental profit, sense of honor, and economic profit. The MSSA consisted of two equations, one related to the behavior generation stage and one related to the behavior stability stage. The source separation ratios of the residential community, office building, and primary and middle school were calculated using the MSSA. Data for analysis were obtained from a 1-yr investigation and a questionnaire conducted at 128 MSW clusters around Beijing. The results revealed that office buildings had an initial separation ratio of 80% and a stable separation ratio of 65.86%, whereas residential communities and primary and middle schools did not have a stable separation ratio. The MSSA curve took on two shapes. In addition, internal motivations and the separation transportation ratio were found to be key parameters of the MSSA. This model can be utilized for other cities and countries.     

分点进水A/O工艺处理低碳源生活污水的脱氮性能研究

针对低C/N比污水脱氮的难点问题,在缺氧段不同点设置进水口,采用分点进水A/O工艺处理校园生活污水.考察了在污泥回流比为100%,硝化液回流比为200%,分流比为1∶1,缺氧池水力停留时间(HRT)分别为2、2.4和3 h情况下,分点进水A/O工艺的反硝化性能,并与传统的A/O工艺进行比较.结果表明,当缺氧池的水力停留...