Methodology for siting ambient air monitors at the neighborhood scale

In siting a monitor to measure compliance with U.S. National Ambient Air Quality Standards (NAAQS) for particulate matter (PM), there is a need to characterize variations in PM concentration within a neighborhood-scale region to achieve monitor siting objectives. A simple methodology is provided here for the selection of a neighborhood-scale site for meeting either of the two objectives identified for PM monitoring. This methodology is based on analyzing middle-scale (from 100 to 500 m) data from within the area of interest. The required data can be obtained from widely available dispersion models and emissions databases. The performance of the siting methodology was evaluated in a neighborhood-scale field study conducted in Hudson County, NJ, to characterize the area's inhalable particulate (PM10) concentrations. Air monitors were located within a 2- by 2-km area in the vicinity of the Lincoln Tunnel entrance in Hudson County. Results indicate the siting methodology performed well, providing a positive relationship between the predicted concentration rank at each site and the actual rank experienced during the field study. Also discussed are factors that adversely affected the predictive capabilities of the model.     

Estimating uncertainties and uncertainty contributors of CMB PM2.5 source apportionment results

The chemical mass balance (CMB) model was applied for source apportionment of PM_2.5 in Atlanta in order to explore levels and causes of uncertainties in source contributions. Monte Carlo analysis with Latin hypercube sampling (MC-LHS) was performed to evaluate the source impact uncertainties and quantify how uncertainties in ambient measurement and source profile data affect results. In general, uncertainties in the source profile data contribute more to the final uncertainties in source apportionment results than do those in ambient measurement data. Uncertainty contribution estimates suggest that non-linear interactions among source profiles also affect the final uncertainties although their influence is typically less than uncertainties in source profile data.     

Impact of using prognostic and objective wind fields on the photochemical modeling of Athens, Greece

A three-dimensional Eulerian photochemical model is used to follow the dynamics of ozone, NO_x, and CO over the Athens area, for 25 May 1990, the day considered in the APSIS project. A unique aspect of this work lies in the study of the impacts of the wind field preparation methods on the concentrations predicted by the model. Three sets of wind fields are developed. The first one used is derived from a prognostic meteorological model. The second one is calculated from available wind observations using objective: methods. For these two cases, a previous day is simulated, using the same conditions, to develop preconditioned initial conditions for the following day. For the third simulation, again two days are simulated, this time using the observed winds for each of the two days modeled. The predictions using the prognostically derived and the objective analysis wind fields are significantly different, particularly for the primary pollutants. Comparing predictions to the observations did not favor any particular method of wind field preparation. In this case, when using the prognostically derived field, the simulations are very sensitive to boundary conditions. In contrast, when using the wind fields constructed by objective methods, the simulations became most sensitive to emissions and initial conditions. This comes directly from the different residence times in the domain, which are governed by the wind speed.     

Uniformity of domestic wastewater effluent application in a subsurface drip distribution system.

An on-site wastewater treatment project with two separate drip fields was operated for 6 years and received no maintenance. The two drip fields (with different design configurations) contained pressure-compensating emitters (PC) and non-pressure-compensating emitters (NPC), respectively, and received wastewater with an average 5-day biochemical oxygen demand concentration of 23 mg/L. Flowrates of the PC emitters reduced from rated average of 3.50 to 1.00 L/h, and the average flowrate of the NPC emitters reduced from 2.00 to 1.53 L/h. The statistical uniformities were 48 and 71%, and the uniformity coefficients were 70 and 86% for PC and NPC emitters, respectively. Significant, but incomplete, recovery was achieved with field-flushing and consecutive shock-chlorination treatments of 500 and 1000 mg/L.     

Determination of levoglucosan in atmospheric fine particulate matter

A microanalytical method suitable for the quantitative determination of the sugar anhydride levoglucosan in low-volume samples of atmospheric fine particulate matter (PM) has been developed and validated. The method incorporates two sugar anhydrides as quality control standards. The recovery standard sedoheptulosan (2,7-anhydro-beta-D-altro-heptulopyranose) in 20 microL solvent is added onto samples of the atmospheric fine PM and aged for 1 hr before ultrasonic extraction with ethylacetate/ triethylamine. The extract is reduced in volume, an internal standard is added (1,5-anhydro-D-mannitol), and a portion of the extract is derivatized with 10% by volume N-trimethylsilylimidazole. The derivatized extract is analyzed by gas chromatography/mass spectrometry (GC/MS). The recovery of levoglucosan using this procedure was 69 +/- 6% from five filters amended with 2 microg levoglucosan, and the reproducibility of the assay is 9%. The limit of detection is approximately 0.1 microg/mL, which is equivalent to approximately 3.5 ng/m3 for a 10 L/min sampler or approximately 8.7 ng/m3 for a 4 L/min personal sampler (assuming 24-hr integrated samples). We demonstrated that levoglucosan concentrations in collocated samples (expressed as ng/m3) were identical irrespective of whether samples were collected by PM with aerodynamic diameter < or = 2.5 microm or PM with aerodynamic diameter < or = 10 microm impactors. It was also demonstrated that X-ray fluorescence analysis of samples of atmospheric PM, before levoglucosan determinations, did not alter the levels of levoglucosan.     

Volatile hydrocarbon emissions from a diesel fuel-contaminated soil bioremediation facility

Concerns have been expressed that emissions of volatile hydrocarbons (HCs) from bioremediation facilities containing soils contaminated with petroleum HCs may negatively impact regional air quality or human health. Little information is available regarding the emission of HCs from bioremediation sites, and few field studies have been performed during which the flux of HCs has been directly measured during bioremediation. To aid in answering questions about the impact of bioremediation facilities on the atmospheric environment, a two-part field study was conducted over summer 1996 at a remote landfarm in northern Ontario where diesel fuel-contaminated soil was undergoing bioremediation. Volatile total hydrocarbon (THC) atmospheric flux measurements were successfully taken over 18 days using a flux gradient micrometeorological technique incorporating a THC detector constructed in-house. Peak THC emissions reached 131 microg C/m2/sec shortly after implementation and tilling of the landfarm soil. The influence of soil temperature and tillage on THC emissions was examined. Off-site inhalation exposure was considered with the aid of an areal source model and results from speciated air samples collected on sorbent tubes and analyzed via gas chromatography/mass spectrometry (GCMS) techniques.     

A Large-Eddy Simulation Study of the Convective Boundary Layer over Philadelphia during the 1999 Summer NE-OPS Campaign

This study presents a large-eddy simulation (LES) study of the convective boundary layer on August 1, 1999 over Philadelphia, PA during a summer ozone episode. The study is an evaluation of the Colorado State University's Regional Atmospheric Modeling System Version 4.3 (RAMS4.3) with the LES option using Northeast Oxidant and Particulate Study (NE-OPS) data. Simulations were performed with different imposed sensible heat fluxes at the ground surface. The model was initialized with the atmospheric sounding data collected at Philadelphia at 1230 UTC and model integrations continued till 2130 UTC. The resulting mean profiles of temperature and humidity obtained from the LES model were compared with atmospheric soundings, tethered balloon and aircraft data collected during the NE-OPS 1999 field campaign. Also the model-derived vertical profiles of virtual temperature were compared with NE-OPS Radio Acoustic Sounder System (RASS) data while the humidity profiles were compared with NE-OPS lidar data. The comparison of the radiosonde data with the LES model predictions suggests that the growth of the mixing layer is reasonably well simulated by the model. Overall, the agreement of temperature predictions of the LES model with the radiosonde observations is good. The model appears to underestimate humidity values for the case of higher imposed sensible heat flux. However, the humidity values in the mixing layer agree quite well with radiosonde observations for the case of lower imposed sensible heat flux. The model-predicted temperature and humidity profiles are in reasonable agreement with the tethered balloon data except for some small overestimation of temperature at lower layers and some underestimation of humidity values. However, the humidity profiles as simulated by the model agree quite well with the tethered balloon data for the case of lower imposed sensible heat flux. The model-predicted virtual temperature profile is also in better agreement with RASS data for the case of lower imposed sensible heat flux. The model-predicted temperature profile further agrees quite well with aircraft data for the case of lower imposed heat flux. However, the relative humidity values predicted by the model are lower compared with the aircraft data. The model-predicted humidity profiles are only in partial agreement with the lidar data. The results of this study suggest that the explicitly resolved energetic eddies seem to provide the correct forcing necessary to produce good agreement with observations for the case of an imposed sensible heat flux of 0.1 K m s^–1 at the surface.     

Carbon Monitoring Costs and their Effect on Incentives to Sequester Carbon through Forestry

Technically, forestry projects have thepotential to contribute significantly tothe mitigation of global warming, but manysuch projects may not be economicallyattractive at current estimates of carbon(C) prices. Forest C is, in a sense, a newcommodity that must be measured toacceptable standards for the commodity toexist. This will require that credible Cmeasuring and monitoring procedures be inplace. The amount of sequestered C that canbe claimed by a project is normallyestimated based on sampling a number ofsmall plots, and the precision of thisestimate depends on the number of plotssampled and on the spatial variability ofthe site. Measuring C can be expensive andhence it is important to select anefficient C-monitoring strategy to makeprojects competitive in the C market. Thispaper presents a method to determinewhether a forestry project will benefitfrom C trading, and to find the optimalmanagement strategy in terms of forestcycle length and C-monitoring strategyA model of an Acacia mangiumplantation in southern Sumatra, Indonesiais used to show that forestry projects canbe economically attractive under a range ofconditions, provided that the project islarge enough to absorb fixed costs.Modeling results indicate that between 15and 38 Mg of Certified Emission Reductions(CERs) per hectare can be captured by thesimulated plantation under optimalmanagement, with optimality defined asmaximizing the present value of profitsobtained from timber and C. The optimalcycle length ranged from 12 to 16 years andthe optimal number of sample plots rangedfrom 0 to 30. Costs of C monitoring (inpresent-value terms) were estimated to bebetween 0.45 (Mg C)^-1 to 2.11 (MgC)^-1 depending on the spatialvariability of biomass, the variable costsof C monitoring and the discount rate.     

Positive perceptions of green and open space as predictors of neighbourhood quality of life: implications for urban planning across the city region

The provision of green and open space in the face of wider development pressure is a key urban challenge. Despite this, few studies have critically investigated the quality of life implications of such provision. This paper focuses on perceptions of built environment factors and their influence on neighbourhood quality of life. Data are drawn from a household survey questionnaire completed by 483 residents living in three neighbourhoods in Dublin, Ireland – an inner city neighbourhood, a suburb and a peri-urban settlement. Positive perceptions of green and open space were identified as important predictors of high levels of neighbourhood satisfaction, surpassed only by dwelling characteristics. This suggests that development strategies which fail to provide for properly planned green and open spaces may be detrimental to neighbourhood quality of life. Furthermore, the results suggest a need for design solutions which consider neighbourhood typology in achieving improved neighbourhood quality of life.     

The geographic variation of silver in the black tuban snail, Tegula funebralis

The geographic variation of silver concentrations in the black turban snail, Tegula funebralis, along the California coastline indicates an anthropogenic influence. Relatively elevated levels of the metal occur in organisms adjacent to major wastewater outfalls compared to those from less populated areas. This parallels the distributions of silver concentrations in other molluscs within the area. It, therefore, substantiates the proposal that the pattern is primarily due to external factors, such as wastewater discharges, rather than intraspecific differences among the samples.