Organochlorine and mercury residues in Swainson's and ferruginous hawk eggs collected in North and South Dakota, 1974–79

Residues of organochlorine pesticides, polychlorinated biphenyls (PCBs), and mercury were measured in eggs of Swainson's hawks (Buteo swainsoni) and ferruginous hawks (B. regalis) collected in North and South Dakota during 1974–79. DDE was the most common compound detected in the eggs, but residues were below levels known to have adverse effects on reproduction. Other organochlorine compounds and mercury were found at low levels. Eggs of ferruginous hawks tended to contain more compounds with higher residues than eggs of Swainson's hawks.     

An evaluation of in situ microcosms for validating aquatic fate and transport models

The fates of two compounds, 2,4 Dichlorophenoxy Acetic Acid Butoxyethyl Ester (2,4-DBEE) and 1,4 Dichlorobenzene (1,4-DCB), were examined in in situ microcosms placed in a pond and compared with the fates in the pond itself. Results also were compared with predictions of an aquatic fate and transport model (EXAMS). Decay rates of 2,4-DBEE were not significantly different among the microcosms, pond and model predictions. The decay rate of 1,4-DCB in the microcosms was significantly lower than the rate for the pond, and lower than the rate predicted by the model. The low volatility of 1,4-DCB in the microcosms is attributed primarily to lack of water surface turbulence in the microcosms.     

Second derivative spectroscopy for the determination of volatilized ammonia from urea-amended soil

A second derivative spectrometer custom fitted with a 1 m stainless steel White cell and maintained at 105°C is used to make real-time measurements of volatilized NH₃ from urea-amended soil. Comparison of the technique to impinger data shows a 5–16% discrepancy between the two techniques; however, other experiments presented suggests that this is not real. Sulfur dioxide and nitrous oxide interferences are discussed, though they were not found to be present in this study. Instrument response time is shown to be fast if 67% of the total response is achieved in less than 5 min. Fast response is achieved for ammonia if wall-adsorption effects are minimal and if ammonia mass flow is maintained at 0.2 μg min^-1.     

Transportation and fate of cationic surfactant in river water

The degradation, sorption, transportation and material balance of cationic surfactants discharged from domestic waste into river water was studied. Ion-pair solid-phase extraction behavior showed that the sorption of cationic surfactants as an ion-pair with anionic surfactant onto river sediment was so strong that little cationic surfactant was found in the bulk water. Cationic surfactant was found in river sediment at more than 500 times higher concentration than that in the bulk water. The degradation of the cationic surfactant was very slow in river water and much slower in the sediment. A material balance of cationic surfactant was estimated for a river running through Toyama City by measuring the flow rate and the concentration of cationic surfactant in the water at several points. It was found that more than 30% of cationic surfactant introduced to the river was lost during the river running through ca. 3 km in 3 h. This reduction probably comes from a quick transfer of the cationic surfactant from river water to sediment and water weed by means of adsorption or precipitation with suspending solids.     

Survey of the occurrence of residues of methyl tertiary butyl ether (MTBE) in Dutch drinking water sources and drinking water

An indicative survey has been carried out in The Netherlands investigating the presence of methyl tertiary butyl ether (MTBE) in drinking water and the corresponding sources. In total, 71 different sites used for the preparation of drinking water in The Netherlands were sampled in two successive seasons in 2001 involving the analysis of 156 samples. (ground water (n = 88), surface water (n = 17), bank filtrate water (n = 6) and drinking water (n = 45)). To combine high sample throughput with high selectivity and sensitivity, off-line purge and trap for sampling and gas chromatography mass spectrometry equipped with an automated thermal desorption sampler (TDS-GC-MS) was selected as the preferred analytical methodology. The developed procedure enabled the analysis of at least 40 samples per day and provided a limit of quantification of 2 ng l(-1). In the first period 63 samples of raw water were analyzed. Concentrations ranged between < 10 ng l(-1) and 420 ng l(-1) with a median concentration below 10 ng l(-1). The second period was focused at the re-sampling of positive locations (MTBE > 10 ng l(-1)) and a few additional drinking water utilities of which both the raw and drinking water of the utilities were analyzed. The median concentration of MTBE in the selected set of drinking water samples was 20 ng l(-1) (n = 45). At one location MTBE was found at a level of 2900 ng l(-1) caused by point source contamination of the ground water (11 900 ng l(-1)). Special attention has been paid to the quality of the results by analyzing all samples in duplicate and the analysis of control samples during each series of analyses.     

A new device for measuring fluctuations in plant stem diameter: Implications for monitoring plant responses

An electrical device capable of continuously measuring micronsized changes in stem diameter of woody and herbaceous plants is described. Fumigation of sunflowers with automotive exhaust was used to test the ability of the device to detect short-term plant responses.     

Determination of biomass burning emission factors: Methods and results

Biomass burning, in a broad sense, encompasses different burning practices, including open and confined burnings, and different types of vegetation. Emission factors of gaseous or particulate trace compounds are directly dependent both on the fuel type and the combustion process. Emission factors are generally calculated by stoichiometric considerations using the carbon mass balance method, applied either to combustion chamber experiments or to field experiments based on ground-level measurements or aircraft sampling in smoke plumes. There have been a number of experimental studies in the last 10 years to investigate wildfires in tropical, temperate, or boreal regions. This article presents an overview of measurement methods and experimental data on emission factors of reactive or radiatively active trace compounds, including trace gases and particles. It focuses on fires in tropical regions, that is, forest and savanna fires, agricultural burns, charcoal production, use of fuelwood, and charcoal combustion.     

Ammonia uptake by plants

The paper considers the methodology and results of experimental determination of dry deposition and ammonia uptake by isolated plant leaves. Analytical expressions are proposed which allow a transition from rates obtained in an isolated chamber to dry ammonia deposition by standing crops leaves.     

Heavy metals in the SPM of air in the environment surrounding a ferro-alloy industrial plant in India

Prices for ferro-alloys have hardened due to the closure of plants in developed countries on account of increasingly stringent pollution control legislation, resulting in a higher cost of production. A ferro-alloy industry with a capacity of 80000 MT per annum was selected to study the nature of pollution. Because of the objectionable nature of polluting air in and around the plant it was located in a rural area where there was no other industry. The area was agriculturally active and there was no effective control system for this plant.The quality of ambient air around the plant site is discussed in this paper along with the meteorological conditions. The maximum concentration of suspended particulate matter (SPM) was 768 µg/NM³ downwind of the plant, minimum 184 µg/NM³, and the average was more than 446 µg/NM³. The presence of heavy metals, viz. Fe, Mn, Cr and Pb, was also assessed. The concentration of Fe was 50 µg/NM³ downwind and 10 µg/NM³ upwind. The concentration of other metals followed a similar trend.     

Matrix diffusion effects in the cleanup of heterogeneous aquifers

Simple mathematical models are developed to account for the rather slow mass transport of nonaqueous phase liquid (NAPL) into aqueous solution in groundwater during flushing operations. The models are based on the assumption that this bottleneck in the process is associated with diffusion in the aqueous phase in the porous medium from the location of the NAPL drops/ganglia in a region of relatively low permeability out into a region of substantially higher permeability, somewhat analogous to diffusion from a block of porous rock into a nearby fracture, where the fracture system overwhelmingly dominates the overall permeability. The models include batch flushing, flushing in a laboratory column, and a one-dimensional model for flushing by means of a single recovery well.