Isolation and identification of Aeromonas caviae strain KS-1 as TBTC- and lead-resistant estuarine bacteria

Tributyltin chloride (TBTC)- and lead-resistant estuarine bacterium from Mandovi estuary, Goa, India was isolated and identified as Aeromonas caviae strain KS-1 based on biochemical characteristics and FAME analysis. It tolerates TBTC and lead up to 1.0 and 1.4 mM, respectively, in the minimal salt medium (MSM) supplemented with 0.4 % glucose. Scanning electron microscopy clearly revealed a unique morphological pattern in the form of long inter-connected chains of bacterial cells on exposure to 1 mM TBTC, whereas cells remained unaltered in presence of 1.4 mM Pb(NO₃)₂ but significant biosorption of lead (8 %) on the cell surface of this isolate was clearly revealed by scanning electron microscopy coupled with energy dispersive X-ray spectroscopy. SDS-PAGE analysis of whole-cell proteins of this lead-resistant isolate interestingly demonstrated three lead-induced proteins with molecular mass of 15.7, 16.9 and 32.4 kDa, respectively, when bacterial cells were grown under the stress of 1.4 mM Pb (NO₃)₂. This clearly demonstrated their possible involvement exclusively in lead resistance. A. caviae strain KS-1 also showed tolerance to several other heavy metals, viz. zinc, cadmium, copper and mercury. Therefore, we can employ this TBTC and lead-resistant bacterial isolate for lead bioremediation and also for biomonitoring TBTC from lead and TBTC contaminated environment.     

Impact of long-term wastewater application on microbiological properties of vadose zone

Impact of wastewater irrigation on some biological properties was studied in an area where treated sewage water is being supplied to the farmers since 1979 in the western part of National Capital Territory of New Delhi under Keshopur Effluent Irrigation Scheme. Three fields were selected which had been receiving irrigation through wastewater for last 20, 10 and 5 years. Two additional fields were selected in which the source of irrigation water was tubewell. The soil bacterial and fungal population density was studied in soil layers of 0?C15, 15?C30, 30?C60 and 60?C120 cm depths. Groundwater samples were collected from the piezometers installed in the field irrigated with sewage water for last 20, 10 and 5 years. Results indicate that there was significant increase in bacterial and fungal count in sewage-irrigated soils as compared to their respective control. The population density of bacteria and fungi in waste water-irrigated soils increased with the duration of sewage water application and decreased with increasing depth. The bacterial and fungal count was also directly proportional to organic carbon, sand and silt content and negatively correlated to the clay content, electrical conductivity, pH and bulk density of the soil. Groundwater under sewage-irrigated fields had higher values of most probable number (MPN) index as compared to that of tubewell water-irrigated fields. All the shallow and deep groundwaters were found to be contaminated with faecal coliforms. The vadose zone had filtered the faecal coliform to the tune of 98?C99%, as the MPN index was reduced from ??18,000 per 100 ml of applied waste water to 310 per 100 ml of groundwater under 20 years sewage-irrigated field. The corresponding values of MPN were 250 and 130 per 100 ml of shallow groundwater under 10 and 05 years sewage-irrigated fields, respectively. Rapid detection of faecal contamination suggested that the Citrobacter freundii and Salmonella were dominant in shallow groundwater, while Escherichia coli was dominant in deep groundwater collected from sewage-irrigated field.     

Carbon dioxide adsorption and cycloaddition reaction of epoxides using chitosan–graphene oxide nanocomposite as a catalyst

One of today's major challenges is to provide green materials for a cleaner environment. We have conducted studies on carbon dioxide(CO2) adsorption and conversion to valuable products by an ecofriendly approach based in chitosan/graphene oxide(CSGO) nanocomposite film. Rheological behavior indicates that the CSGO has a better solvation property than the pure chitosan. An adsorption capacity of 1.0152 mmol CO_2/g of CSGO nanocomposite at4.6 bar was observed. The catalytic behavior of the CSGO nanocomposite in the presence of tetra-n-butylammonium iodide(n-Bu4 NI) as co-catalyst was evaluated for the cycloaddition of CO_2 to epoxides, to give cyclic carbonates, in the absence of any solvent. These results strongly suggest that the CSGO nanocomposite may open new vistas towards the development of ecofriendly material for catalytic conversion and adsorption of CO_2 on industrial scale.     

Sensitivity analysis of ground-level ozone concentration to emission changes in two urban regions of southeast Texas

Air pollutant emission is one of the predominant factors affecting urban air quality such as ground-level ozone formation. This paper assesses the impact of changing emission inventory scenarios, based on combinations of point, mobile, area/non-road and biogenic sources, on the tropospheric ozone concentration in two southeast Texas urban areas, i.e. Houston-Galveston and Beaumont-Port Arthur, during the rapid ozone formation event (ROFE) on August 25, 2000. The EPA's Community Multiscale Air Quality (CMAQ) modeling system with 1999 national emission inventory (NEI99) estimates and updated SAPRC99 chemical mechanism are used in the sensitivity analysis for twelve different emission scenarios. Based on model results, it is found that the point source emission of NOx and VOC contributes the greatest ozone peak in the ROFE. Removing Texas point sources of VOC and NOx emission from the inventory results in a reduction in peak O3 concentration by 128 and 70 ppbv in Houston urban area, respectively. Similar but less drastic impact from point source is also observed in the Beaumont-Port Arthur area. The effect on peak ozone concentration due to mobile, area and non-road sources emissions are less significant compared to that of point source emission. Reducing VOC emission appears to be more effective than reducing NOx emission in lowering peak O3 concentration in the studied region. Although biogenic emission can contribute up to 37 ppbv of peak ozone level over a large area, the affected area is away from the urban region of concern, and should not be the main cause for O3 non-attainment in the two urban areas. Removing CO emission from mobile sources does not lead to significant reduction (< 1 ppbv) in ozone concentrations. The modeled data also show that the transport of O3 precursors from adjacent states can cause a significant ozone plume near Beaumont due to its proximity to the state border based on the conditions during the August 25, 2000 O3 episode.     

Ferrate(VI) oxidation of ibuprofen: A kinetic study

The kinetics of ferrate(VI) (Fe^VIO₄ ²⁻, Fe(VI)) oxidation of an antiphlogistic drug, ibuprofen (IBP), as a function of pH (7.75–9.10) and temperature (25–45°C) were investigated to see the applicability of Fe(VI) in removing this drug from water. The rates decrease with an increase in pH and the rates are related to protonation of ferrate(VI). The rates increase with an increase in temperature. The E _a of the reaction at pH 9.10 was calculated as 65.4±6.4 kJ mol⁻¹. The rate constant of the HFeO₄ ⁻ with ibuprofen is lower than with the sulphur drug, sulfamethoxazole. The use of Fe(VI) to remove ibuprofen is briefly discussed.     

Variations of physicochemical properties in Kalpakkam coastal waters, east coast of India, during southwest to northeast monsoon transition period

A significant variation in physicochemical properties of the Kalpakkam coastal waters, eastern part of India, was observed during the event of southwest to northeast monsoon transition. Increase in nitrate, total nitrogen, and silicate concentrations were noticed during post-transition period. Ammonia concentration was at peak during transition period as compared to pre- and post-transition periods. Hypo-saline condition (~23 psu) was observed during post-transition as the surface water salinity decreased by ~10 psu from the pre-transitional values. Turbidity, suspended particulate matter, phosphate and total phosphorous values decreased marginally, coinciding with northward to southward current reversal. A drastic decrease (eightfold) in chlorophyll-a concentration was observed in the coastal water during post-transition period.     

Balancing fuelwood and biodiversity concerns in rural Nepal

An agent-based model is developed to explore the pattern of fuelwood collection in an 1178 ha forest area in rural mountainous Nepal. The model relates fuelwood collection intensity and amount of dead wood available for collection to the diversity of polypore species, a group of strictly dead wood dependent fungi which can be used as indicators of the biodiversity associated with dead wood. By analysing scenarios of increased collection the model shows that the relative impact on polypore diversity is rising more rapidly than the time used for collection. This indicates that better market access in the future could potentially imply a major threat to biodiversity associated with dead wood.     

Iron-based flow batteries to store renewable energies

The development of cost-effective and eco-friendly alternatives of energy storage systems is needed to solve the actual energy crisis. Although technologies such as flywheels, supercapacitors, pumped hydropower and compressed air are efficient, they have shortcomings because they require long planning horizons to be cost-effective. Renewable energy storage systems such as redox flow batteries are actually of high interest for grid-level energy storage, in particular iron-based flow batteries. Here we review all-iron redox flow battery alternatives for storing renewable energies. The role of components such as electrolyte, electrode and membranes in the overall functioning of all-iron redox flow batteries is discussed. The effect of iron–ligand chemistry on the performance of battery is highlighted. Additionally, a brief contextual background and fundamentals of redox flow batteries are provided. The design aspects, progress in research, mathematical modeling, cost estimations and future prospects of using all-iron energy systems are discussed in the context of future grid-level energy storage.