Barriers and guidelines for public policies on climate change adaptation: A missed opportunity of scientific knowledge‐brokerage

Progress in formulating and implementing effective adaptation policies is often hampered by a wide variety of barriers that are well documented in the literature. Among the barriers are lack of awareness, certainty, resources and political commitment. Since these and other barriers can be overcome (e.g., by raising awareness, closing knowledge gaps, and increasing resources), numerous decision‐support frameworks (mainly written guidelines) have been developed for this purpose. The present paper takes stock of both the barriers in adaptation policymaking, as documented in the literature, and the guidelines that aim to facilitate public policies on climate change adaptation. It then compares to what degree selected adaptation guidelines serve as knowledge‐brokerage tools that provide guidance on how to overcome the barriers addressed in the scientific literature. The comparison shows that adaptation guidelines address barriers of adaptation policymaking neither comprehensively nor systematically. Since most adaptation guidelines focus on (subjective) experiences with good practices than on empirical research findings, we conclude that they represent a missed opportunity of scientific knowledge‐brokerage in climate change adaptation.     

Market-based approaches and tools for improving water and air quality

Nitrogen (N) losses from agriculture are negatively impacting groundwater, air, and surface water quality. National, state, and local policies and procedures that can mitigate these problems are needed. Market-based approaches where waste treatment plants (point sources) can purchase nutrient credits from upstream agricultural operations (non-point sources) to meet their National Pollutant Discharge Elimination System permit requirements within the Clean Water Act are being explored. This paper reviews these market-based approaches for enhancing air and water quality at a lower cost than simple command-and-control regulation, and describes new tools that are being developed, such as Nitrogen Trading Tool (NTT), that can be used to assess nitrogen losses to the environment under different management scenarios. The USDA-NRCS, EPA and several other state and local agencies are interested in these new tools. The NTT, though primarily designed for water quality markets, also estimates savings in nitrous oxide (N₂O) emissions that can be traded in carbon markets. For example, an analysis using NTT shows that for 100 ha of crop land, a C sequestration equivalent of approximately 25–38 Mg C y^?1 for a farm in Ohio, and 13–21 Mg C y^?1 for a farm in Virginia could be achieved with better nitrogen management practices. These numbers across a watershed could be much larger with improved N and conservation management practices that contribute to better water quality and lower global warming potential. There is a need to further develop, calibrate, and validate these tools to facilitate nitrogen and carbon trading future markets around the globe to increase environmental conservation across agro-ecosystems worldwide.     

Presence of hydrocarbon-degrading bacteria in the gills of mussel Mytilus galloprovincialis in a contaminated environment: a mesoscale simulation study

A number of previous studies have shown that the relationships of symbiosis existing between mussels and microorganisms are directly dependent on the environmental conditions. However, little is known about existing relationships between mussels and bacteria in hydrocarbon-impacted marine environments. The aim of this preliminary study is to investigate the presence of oil-degrading bacteria in the mussel Mytilus galloprovincialis during growth in polluted ecosystems. All the experiments were carried out in a mesocosm system designed to simulate chronic pollution and to enable direct exposure of mussels to chemicals. Quantitative (4′,6-diamidino-2-phenylindole, colony-forming units, Most Probable Number) analyses and screening (presence/absence) of metabolic functional genes were performed to analyse bacterial populations inside the gills of mussels exposed and not exposed to hydrocarbons. The data obtained show that the presence of hydrocarbons affected the abundance of bacteria inside the gills of specimens and determines selection for specific (hydrocarbon-degrading) bacteria (i.e. Alcanivorax sp. and Marinobacter sp.). However, is not yet clear whether the presence of such genera of bacteria inside the mussel is due to symbiosis or as a result of filtration.     

Application of a novel modeling tool with multistressor functionality to support management of organic contaminants in the Baltic Sea

Organic contaminants constitute one of many stressors that deteriorate the ecological status of the Baltic Sea. When managing environmental problems in this marine environment, it may be necessary to consider the interactions between various stressors to ensure that averting one problem does not exacerbate another. A novel modeling tool, BALTSEM-POP, is presented here that simulates interactions between climate forcing, hydrodynamic conditions, and water exchange, biogeochemical cycling, and organic contaminant transport and fate in the Baltic Sea. We discuss opportunities to use the model to support different aspects of chemicals management. We exemplify these opportunities with a case study where two emission-reduction strategies for a chemical used in personal care products (decamethylcyclopentasiloxane) are evaluated, and where the confounding influence of future climate change and eutrophication on the impact of the emission-reduction strategies are assessed.     

Laboratory and field investigations of particulate and carbon monoxide emissions from traditional and improved cookstoves

We implemented a program in which emission characterization is enabled through collaborations between academic, US and international non-governmental entities that focus on evaluation, dissemination, and in-use testing, of improved cookstoves. This effort resulted in a study of field and laboratory emissions from traditional and improved biofuel cookstoves. We found that field measured particulate emissions of actual cooking average three times those measured during simulated cooking in the laboratory. Emission factors are highly dependent on the care and skill of the operator and the resulting combustion; these do not appear to be accurately reproduced in laboratory settings. The single scattering albedo (SSA) of the emissions was very low in both lab and field measurements, averaging about 0.3 for lab tests and around 0.5 for field tests, indicating that the primary particles are climate warming. Over the course of three summers in Honduras, we measured field emissions from traditional cookstoves, relatively new improved cookstoves, and “broken-in” improved cookstoves. We found that well-designed improved cookstoves can significantly reduce PM and CO emission factors below traditional cookstoves. For improved stoves, the presence of a chimney generally resulted in lower emission factors but left the SSA unaffected. Traditional cookstoves had an average PM emission factor of 8.2 g kg^?1 – significantly larger than previous studies. Particulate emission factors for improved cookstoves without and with chimneys averaged about 6.6 g kg^?1 and 4.5 g kg^?1, respectively. The elemental carbon (EC) fraction of PM varied significantly between individual tests, but averaged about 25% for each of the categories.     

Occurrence of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs), polychlorinated biphenyls (PCBs) and polybrominated diphenyl ethers (PBDEs) in Lake Maggiore (Italy and Switzerland)

Samples of air (gas and particulate phases), bulk deposition, aquatic settling material and sediments were collected in Lake Maggiore (LM) in order to determine their content of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs), polychlorinated biphenyls (PCBs) and polybrominated diphenyl ethers (PBDEs). Air (gas and particulate phases) concentrations were 0.5 pg m(-3), 80 pg m(-3), 13 pg m(-3) and 106 pg m(-3) for SigmaPCDD/Fs, SigmaPCBs, Sigma dioxin-like PCBs (DL-PCBs) and SigmaPBDEs, respectively. Deposition fluxes ranged from 0.7 ng m(-2) d(-1) for SigmaPCDD/Fs to 32 ng m(-2) d(-1) for SigmaPCBs. Aquatic settling material presented concentrations of 0.4 ng g(-1) dry weight (dw) for SigmaPCDD/Fs, 13 ng g(-1) dw for SigmaPCB, 3.4 ng g(-1) dw for SigmaDL-PCBs and 5.7 ng g(-1) dw for SigmaPBDEs. Mean sediment concentrations were 0.4 ng g(-1) dw for SigmaPCDD/Fs, 11 ng g(-1) dw for SigmaPCB, 3 ng g(-1) dw for SigmaDL-PCBs and 5.1 ng g(-1) dw for SigmaPBDEs. Similar PCDD/F and DL-PCB congener patterns in all the environmental compartments of LM point to an important, if not dominant, contribution of atmospheric deposition as source of these pollutants into LM. In contrast, PBDE congener distribution was not similar in the different environmental compartments. BDE 47 dominated air and settling material, while BDE 209 was the predominant congener in the bulk atmospheric deposition. Moreover, sediments showed two distinct PBDE congener profiles. Lower PBDE concentrated sediments were dominated by congeners 47 and 99, while BDE 209 dominated in higher PBDE concentrated samples. This suggests the influence of local sources as well as atmospheric input of PBDEs into LM.     

Thermal waste treatment and resource management — a petrologic approach to control the genesis of materials in smelting processes

Primary stores in the sense of geogenic mineral deposits (ores and stones) are diminishing, while the coresponding stocks in urban settlement are increasing accordingly. In this situation, concepts are required to use both the remaining primary resources and the secondary resources more efficiently. Petrologic evaluation is an approach in this context. Petrologic evaluation includes the combination of know-how and tools from geosciences and materials sciences. Additionally, engineering knowledge as well as material flow analysis methods are necessary. The issue to evaluate is the genesis of the flow of materials. The mode of operation of specific compounds on the genesis path is to be pursued. Based on a petrologic approach, it is possible to differentiate between essential (or favorable) and indifferent and disrupting compounds or reactions (disrupting with respect to technical means and environ-mental impact). Such an approach permits a product design in the sense of a material arrangement that is adapted to the function. The approach is illustrated with the example of a new generation of thermal waste treatment (smelting processes), which combines treatment of municipal solid wastes with production processes and mining in order to contribute to better resource management.