Deposition of atmospheric ammonia to moorlands

Micrometeorological methods were applied to measure fluxes of atmospheric ammonia (NH3) to moorlands. Measurements were made in a wide variety of surface conditions and included both Calluna vulgaris (L.) Hull and Eriophorum vaginatum L. dominated sites. NH3 was found to deposit rapidly to all the sites investigated, providing large deposition velocities (Vd, typically 10-40 mm s(-1)) and usually minimal surface resistances (rc). A small number of measurements were made in frozen conditions and suggest a possible exception to this pattern with mean rc of 50-200 s m(-1). The effect of vegetation drying was also investigated and a possible increase in rc observed, though this was small (< 10 s m(-1)). The results are interpreted in terms of the processes controlling exchange; it is shown that NH3 deposition is predominantly to the leaf surfaces and that the net NH3 compensation point approaches zero. Annual estimates show that dry deposition of NH3 is a major source of atmospheric nitrogen to moorland ecosystems. For two typical UK sites subject to background air concentrations, NH3 dry deposition is of similar magnitude to equivalent NH4+ inputs in wet deposition. In the vicinity of emission sources, NH3 dry deposition is expected to dominate inputs of atmospheric nitrogen.     

Comparative impacts of forest harvest and acid precipitation on soil and streamwater acidity

Annual H+ budgets were calculated for a catchment with a 65-year-old spruce-fir forest, and for an adjacent catchment at three years after a whole-tree harvest. In the harvested catchment sinks for H+ due to weathering and mineralization reactions were 85% greater, and sources of H+ due to biomass uptake were 60% greater than in the undisturbed catchment. There was an overall net consumption of 550 eq H+ ha(-1) year(-1) at year 3 after harvest compared to a net generation of 520 eq H+ ha(-1) year(-1) for the 65-year-old forest. Soil pH increased by 0.2-0.4 units soon after harvest, but there was little change in pH of streamwater from the harvested watershed. The whole-tree harvest resulted in a total production of about 30,000 eq H+ ha(-1) due to biomass removal. In contrast, wet and dry deposition at rates measured in this study could add more than 50,000 eq H+ ha(-1) in the 65-year period before the next harvest. Reducing the intensity of harvest may lessen long-term impacts of these sources of H+ on acidification of soils and streams.     

Response of the Plastic Lake catchment, Ontario, to reduced sulphur deposition

As a consequence of decreases in the emission rate of sulphur in eastern North America in the late 1970s and early 1980s, sulphate deposition in central Ontario declined by about 40%, but has remained constant for about six years. Plastic Lake, a small, dilute lake on the Precambrian shield that the authors have studied since 1979, acidified between the start of the study and about 1986, but since then has not changed. The authors also monitored the chemistry of streamwater draining the Plastic Lake catchment. Water quality of runoff from an upland site improved rapidly (pH and alkalinity increased, SO4(2-) and Al decreased), but two factors offset these improvements. A small wetland area downstream reversed most of these changes, resulting in a constant output of strong acid from the catchment. In addition, in extremely dry years (1983, 1987, 1989) there were very high concentrations of SO4(2-) in the streamwater, suggesting substantial re-oxidation of reduced S in the catchment.     

Effects of atmospheric ammonia and ammonium sulphate on Douglas fir (Pseudotsuga menziesii)

Three-year-old Douglas firs (Pseudotsuga menziesii) were fumigated with 180 microg m(-3) NH3 or clean (charcoal-filtered) air. During these fumigations the plants received 15 mm artificial rain weekly, supplemented with 20, 500 or 2500 micromol litre(-1) (NH4)2SO4. Exposure to NH3 and NH4+ for 14 weeks resulted in a change of the nutrient status of the needles. The most remarkable effect was the increase in the N/K ratio, due to both uptake of N and leaching of K. The action of NH3 was stronger than that of NH4+. Both NH3 and (NH4)2SO4 affected the epicuticular wax layer and decreased mycorhiza frequency. Following fumigation and artificial rain treatments, needles were incubated for 8 h in a medium containing 0, 50, 250, 500 and 2500 micromol litre(-1) (NH4)2SO4. Almost no exchange of Ca, Mg and K for NH4+ was found. Therefore this ion exchange probably explains only a minor part of the changes in nutrient status of the whole trees.     

On the behavior of approaches to simulate reactive transport

Two families of approaches exist to simulate reactive transport in groundwater: The Direct Substitution Approach (DSA), based on Newton-Raphson and the Picard or Sequential Iteration Approach (SIA). We applied basic versions of both methods to several test cases and compared both computational demands and quality of the solution for varying grid size. Results showed that the behavior of the two approaches is sensitive to both grid size and chemistry. As a general rule, the DSA is more robust than the SIA, in the sense that its convergence is less sensitive to time step size (any approach will converge given a sufficiently small time step). Moreover, the DSA leads to a better simulation of sharp fronts, which can only be reproduced with fine grids after many iterations when the SIA is used. As a consequence, the DSA runs faster than SIA in chemically difficult cases (i.e., highly non-linear and/or very retarded), because the SIA may require very small time steps to converge. On the other hand, the size of the system of equations is much larger for the DSA than for the SIA, so that its CPU time and memory requirements tend to be less favorable with increasing grid size. As a result, the SIA may become faster than the DSA for very large, chemically simple problems. The use of an iterative linear solver for the DSA makes its CPU time less sensitive to grid size.     

Surfactant enhanced recovery of tetrachloroethylene from a porous medium containing low permeability lenses. 1. Experimental studies

A matrix of batch, column and two-dimensional (2-D) box experiments was conducted to investigate the coupled effects of rate-limited solubilization and layering on the entrapment and subsequent recovery of a representative dense NAPL, tetrachloroethylene (PCE), during surfactant flushing. Batch experiments were performed to determine the equilibrium solubilization capacity of the surfactant, polyoxyethylene (20) sorbitan monooleate (Tween 80), and to measure fluid viscosity, density and interfacial tension. Results of one-dimensional column studies indicated that micellar solubilization of residual PCE was rate-limited at Darcy velocities ranging from 0.8 to 8.2 cm/h and during periods of flow interruption. Effluent concentration data were used to develop effective mass transfer coefficient (Ke) expressions that were dependent upon the Darcy velocity and duration of flow interruption. To simulate subsurface heterogeneity, 2-D boxes were packed with layers of F-70 Ottawa sand and Wurtsmith aquifer material within 20-30 mesh Ottawa sand. A 4% Tween 80 solution was then flushed through PCE-contaminated boxes at several flow velocities, with periods of flow interruption. Effluent concentration data and visual observations indicated that both rate-limited solubilization and pooling of PCE above the fine layers reduced PCE recovery to levels below those anticipated from batch and column measurements. These experimental results demonstrate the potential impact of both mass transfer limitations and subsurface layering on the recovery of PCE during surfactant enhanced aquifer remediation.     

Biosurfactant-enhanced solubilization of NAPL mixtures

Remediation of nonaqueous phase liquids (NAPLs) by conventional pump-and-treat methods (i.e., water flushing) is generally considered to be ineffective due to low water solubilities of NAPLs and to mass-transfer constraints. Chemical flushing techniques, such as surfactant flushing, can greatly improve NAPL remediation primarily by increasing the apparent solubility of NAPL contaminants. NAPLs at hazardous waste sites are often complex mixtures. However, the equilibrium and nonequilibrium mass-transfer characteristics between NAPL mixtures and aqueous surfactant solutions are not well understood. This research investigates the equilibrium solubilization behavior of two- and three-component NAPL mixtures (containing akylbenzenes) in biosurfactant solutions. NAPL solubilization is found to be ideal in water (i.e., obeys Raoult's Law), while solubilization in biosurfactant solutions was observed to be nonideal. Specifically, the relatively hydrophobic compounds in the mixture experienced solubility enhancements that were greater than those predicted by ideal enhanced solubilization theory, while the solubility enhancements for the relatively hydrophilic compounds were less than predicted. The degree of nonideality is shown to be a nonlinear function of the NAPL-phase mole fraction. Empirical relationships based on the NAPL-phase mole fraction and/or micelle-aqueous partition coefficients measured in single-component NAPL systems are developed to estimate values for the multicomponent partition coefficients. Empirical relationships that incorporate both the NAPL-phase mole fraction and single-component partition coefficients yield much improved estimates for the multicomponent partition coefficient.     

A tracer study of headspace ventilation in a collector sewer

A field-scale tracer test was conducted to evaluate in-situ ventilation rates in a major collector sewer. The sewer under study was approximately 11 km long and ranged from 0.61 to 2.1 m in diameter. For the purposes of the tracer testing, the collector was divided into four reaches, each of which was tested individually. The tracer test involved injecting a measured volume of CO gas into a manhole over a short time period. CO concentrations were then measured in the collector headspace at selected manholes along the length of the reach. The technique employed successfully measured average headspace velocities over extended lengths of the collector. In a section that had a relatively stagnant headspace, approximately 1.1 km of sewer could be evaluated, with substantial tracer loss attributed to losses to manholes. In a section of the sewer with elevated headspace velocities, a section approximately 7.0 km long was successfully tested with one injection of tracer gas. The velocities observed in the collector varied substantially with time and location in the collector. The lowest velocities measured were in the upstream sections, with a minimum observed value of 3.8 m/min. The highest velocities were observed in the downstream sections, with a maximum value of 31.5 m/min. The presence of a substantial drop structure appeared to reduce the headspace velocity in the upstream reach. In general, there was an increasing trend in gas-phase flows with distance along the length of the collector. Flows at the discharge end of the collector were almost 2 orders of magnitude greater than those at the beginning.     

Performance evaluation of laser-induced breakdown spectrometry as a multimetal continuous emission monitor

Laser-induced breakdown spectroscopy (LIBS) has been evaluated as a multimetal continuous emissions monitor (CEM) at the U.S. Environmental Protection Agency (EPA) rotary kiln incinerator simulator (RKIS) facility in Raleigh, NC. Two detection systems with a bifurcated optical fiber bundle were used for simultaneously monitoring the concentrations of Be, Cd, Cr, and Hg in the test. Two calibration techniques were evaluated in the laboratory for the field measurements. On-line calibration of relative metal concentration was also performed in the simulated incinerator gas stream. Toxic metal concentrations measured with LIBS have been compared with the EPA reference method (RM) results.